Ford F-150 - 1997-2003 :: 2000 - Trans 3rd Gear Out / Revs Up But Does Not Pull At All
I recently purchased a f150 with a reg cab short bed 4.6 4x4, and when you put it in drive the it shifts up to second fine, but when goes to third just revs up doesnt pull at all. Have to shut o.d. off and goes steady but run 2500 rpms to go 40 mph. I was told to check the solenoids but i dont know, if i do need a new trans how do i identify my trans. I know it has the code "U" on the door sticker, but its an 4r70 w code-w. But the junk yard has a YL3P-FA and a YL3P-JA?
View 1 RepliesFord F-150 - 1997-2003 :: Trans Stuck In Drive And Does Not Downshift When Pull Up To A Stop Light
My truck is starting to shift strange. As it warms up and I'm in drive, it will shift between drive and 2nd by itself. When I pull up to a stop lite, it's like it's stuck in drive and doesn't downshift. Ultimately it dies. I've checked my fluid and its fine. Any ideas? Oh and my engine light is on. Can a parts store find the code for the issue I'm having?
View 1 RepliesFord Super Duty (1999-2016) :: 2003 F250 4R100 Trans Blowing 10a Fuse When Pull Selector Into First Gear
Whenever I manually pull my gear selector into first gear it blows one of the 10a fuses (not sure which number). I lose all gauges and accelerator pedal. It's about the fourth fuse from the right on the bottom row.
View 4 RepliesFord F-150 - 1997-2003 :: Significant Pull To The Right Most Noticeable On The Highway
My 98 F150 4WD with 83k on it has a significant pull to the right most noticeable on the highway. I have to keep the wheel turned to the left to be able to go straight. It use to be intermittent but now is constant. Had a frt end alignment done twice with no change. Recently after a long drive on the highway on a crazy hot day, I pulled into a rest area & noticed the L/F wheel was very hot to the point where I thought the plastic center cap might start melting.
The R/F wheel was only warm. This makes no sense to me because with something causing the L/F wheel to heat up I would think it would pull to the left. This has bothered me so much that I've driven with 10psi less in the L/F wheel hoping it wouldn't pull to the right so much but it had no effect. I did recently have the left upper control arm replaced because it was clunking. It was doing this pulling prior to that & it continues.
Ford F-150 - 1997-2003 :: Accessories Stay On When Turn The Key And Pull It Out
Have a 2001 F-150 with 4.6L. when i turn the key and pull it out the accessories stay on. What could be wrong and what can i do to fix so I don't have to keep disconnecting the battery?
View 9 RepliesFord F-150 - 1997-2003 :: Dies When Turning To Left And Pull Into A Parking Space
I just had my EGR valve and hose and DPFE sensor replaced and the truck is running better than it has in quite a while except that whenever I turn to the left and pull into a parking space it dies.
I've read that it could be a bad power steering pump. This would make sense because mine is pretty noisy when I make a left or right turn. However, it has never caused the engine to stall before. This didn't begin happening until immediately after the recent maintenance.
Is there something I should be looking for that my be related to the new EGR valve/hose or DPFE sensor?
Ford F-150 - 1997-2003 :: 1999 V6 - Engine Will Miss In A Pull And Die Sometimes But Start Back
Engine will start and run but will miss in a pull and die sometimes but will start back, we hooked it to a scanner and it said (intake wiring) it wasn't a dealer hook up just a gas station garage, we have already done plugs and wires.
View 2 RepliesFord F-150 - 1997-2003 :: 2001 Truck Is Down On Power / Kicks Down Just To Pull A Small Incline
Fuel mileage is terrible also but the truck really has no power. Running down the highway it kicks down just to pull a small incline. Check engine light is not on and there is no hessitation. The truck has 105k on it and i have put only 5k of those miles on. I did pull a couple plugs and they are autolites so plugs must have been changed at some point. Does this sound like a coil problem?
View 5 RepliesFord Super Duty (1999-2016) :: 2000 - Misfiring While Trans Shifts Under Slight Pull?
My daughter has this truck and I was driving it the other day I noticed it misfiring when the trans shifts down under a slight pull and/or going up hills. It looses power and speed when this happens but if you back off, it smooths out when it shifts into overdrive. I haven't had it to a mechanic to check any codes yet.
View 3 RepliesFord F-150 - 1997-2003 :: Possible To Put 351 Or 302 With 5.4 E40d Trans?
is it possible to put a 351 or a 302 in a 97 f150 with the 5.4 e40d trans is so what all would have to be done in order for everything to work rite??
View 9 RepliesFord F-150 - 1997-2003 :: Trans Slipping - Won't Shift Right?
Ok so when I come to a full stop my truck doesn't want to shift right when I take off where do I need to start looking
View 7 RepliesFord F-150 (2009-2014) :: Truck Started Knocking Like A Diesel Motor When Pull Up To Red Light
So earlier this week i took my truck in for a check engine light and a issue when i would pull up to a Red Light my truck started knocking like a Diesel motor. I quickly put the truck into neutral and the issue went away.
Is there an issue with the 5.4L motors mine only had 69000km and was properly maintained with an oil change every 8000km? 2009 F150 5.4L new motor after 69000Km
Ford F-150 - 1997-2003 :: OD Light Will Start To Blink When Trans Gets Hot
I have a 1998 f 150 v8 4.6 ltr xlt. A mechanic told me that if my tranny gets hot the OVERDRIVE LIGHT will start to blink. It sounds strange to me, should I have a guage installed? I will be towing a trailer this summer.
View 8 RepliesFord F-150 - 1997-2003 :: Trans Slipping Below 35 Miles An Hour
I have a 1997 F150 4 x 4 with the 5.4 overdrive transmission. When I accelerate from a stop I can feel the slip of the transmission until I reach exactly 35 miles an hour. Above 35 seems to be normal and have plenty of torque.
The funny thing about this is I have had a 2001 Windstar same 35 miles an hour. I have also owned a 1997 Ford Explorer with this exact same issue. Three different motor and trans combination that will not lock up until you reach 35 miles an hour.
The truck has 213,000 I have replaced all coils fuel filters catalytic converter and torque converter. Have exterior tranny cooler. engine runs good and strong. And no code I have a reader.
Ford F-150 - 1997-2003 :: 2001 - Trans Leaking - Where It Is Coming From
I have a 2001 f150 5.4 4x4 with the 4R70W trans. its leaking fluid from somewhere. its not the pan gasket or the seal. it seems to be coming from the top somewhere. the dipstick tube has new o-rings. and the cooler lines have been replaced and are not leaking either. Where else it could be coming from. the passenger side of the bell housing is wet with fluid.
View 11 RepliesFord F-150 - 1997-2003 :: Trans Is Starting To Surge And Buck But Won't Go In Rev
I just changed my 4.6L. Now my tranny is starting to serge and buck it won't go in rev. But when I put it in D it started to clunk and buck. RPM would go up speed went down.
View 1 RepliesFord F-150 - 1997-2003 :: Misfire On Cylinder 3 And 8 After Putting New Trans
I've got a 1997 f150, 4.6. It sat for year and a half, trans went out and it wasn't my primary vehicle so wasn't to worried about fixing it. Until now, well got a new trans put in it, fired it up. And had a misfire, #3 and #8. Changed plugs and wires, same thing. Getting spark at the plug. So I changed both injectors, still nothing! I'm kind of stumped now.
View 4 RepliesFord F-150 - 1997-2003 :: Slight Grind And Hesitation When Trans Shift Into Second
I have a 2003 screw 4x2 with the 4.6, 148,000 miles, and I'm not sure what kind of transmission. Recently when the truck would shift into second it would hesitate and I would feel a slight grind, but it only did it when it would shift at 2000 rpm, if it shifted at 2500 rpm it would shift fine. I checked the fluid level, it was full, it smelled okay, looked *fine.
After pulling a boat (19 foot bass boat...nothing too heavy) it started to shake violently when I'd take off from a red light. So I dropped the pan and changed the filter, The fluid was dark red and smelled a little burnt. I put 4qts of fluid in it along with some Lucas transmission fix. The shake during take off is gone, and the grinding while shifting into second got a lot better but didn't go away completely.
However, now the grinding into second has has gotten worse again, and if I make a right turn from a red light it grinds and feels like its slipping until it shifts. I am not sure why making a right turn would affect it but its definitely worse when i turn right, left turns are fine. I'm guessing my transmission is going out and I just need to get it rebuilt...
Ford F-150 - 1997-2003 :: 4R70W - Trans Has Hard Time Getting Into 1st Gear
The truck:
2000 4X2 F150
4.2l V6
280k miles/ some towing
The problem : The trans has a hard time getting into 1st gear. When you put it into gear you have to rev it to about 3k (when it's warm, 4k when cold) RPMs at which time you feel a definite engagement and it goes through the rest of the gears just fine. Once it's warm it will do stop and go traffic as long as you start it with the OD off.
The background : Orobably the stock motorcraft filter on there, and I don't think the oil has been changed in the life of the trans, but I do know that it's never been ran low on fluid. I took a gander at it and found a plug where a gear type speedo went on older models to be loose and leaking. tightened it up about two full turns. also noticed what looks to be a leak where the main case meets the output shaft housing. now I know neither of these are the cause of my headache but I do wonder if the second leak might be a sign.
The research : I've been looking for almost a week now for a solution. I've been all over TCCoA, Explorer Forum,10 pages of search here on FTE and various other Ford based websites and have come across a single thread with the same symptoms but the OP never came back with a solution.
The plan : A fluid/filter change (and flush) is definitely in the plans as well as inline filter for my own satisfaction. from what I've read the stock 1-2 accumulator is known to go bad on some of these and if I have the pan off might as well check anyways.