Ford F-150 - 1997-2003 :: Can Pull Motor And Trans If Still Bolted Together?
I have 97 f150 x-cab 4.6 auto 4x4. I'm gettin ready to pull motor & trans to rebuild both. I was wondering if I can pull both while still bolted together without having to remove the cab??? And what else will needed to be removed.
View 6 RepliesFord F-150 - 1997-2003 :: Trans Stuck In Drive And Does Not Downshift When Pull Up To A Stop Light
My truck is starting to shift strange. As it warms up and I'm in drive, it will shift between drive and 2nd by itself. When I pull up to a stop lite, it's like it's stuck in drive and doesn't downshift. Ultimately it dies. I've checked my fluid and its fine. Any ideas? Oh and my engine light is on. Can a parts store find the code for the issue I'm having?
View 1 RepliesFord Super Duty (1999-2016) :: 2003 F250 4R100 Trans Blowing 10a Fuse When Pull Selector Into First Gear
Whenever I manually pull my gear selector into first gear it blows one of the 10a fuses (not sure which number). I lose all gauges and accelerator pedal. It's about the fourth fuse from the right on the bottom row.
View 4 RepliesFord F-150 - 1997-2003 :: 2002 - Revs Then Goes In Gear But Reverse Is Fine
So my aunt has a 2002 ford f150 king ranch 5.4l and a night ago it started this problem which when you put it in drive which she has to put it in 2nd for it when she pushs on the pedal it will rev up to 2500rpms than jerks and goes and its usely fine till she stops than goes and it does it again...
Than today it wouldn't even go in anything but reverse... So than we herd about the Range Sensor on the side of the transmission and it seems like it was it so I unplug it when it was running and when i push on the pedal and it revs up to 2500rpms it will go forward and have power. So we went to get a new range sensor after like 4 hours trying to get the dam thing off and another 2 to get it back on.. I started it up and only reverse works again... So I unplug the harness to it again and we got the gears but 1st and 2nd will just rev and go.
We at a lost right now i even tighten the shift screws under the dash cause our expedition was loose at one time and the gear shifter was loose like hers. But even tighten the bolts it still don't fix the looseness or even the gears.. Is this a transmission problem? OR even the torq covertor?
Ford F-150 - 1997-2003 :: 4R70W - Trans Has Hard Time Getting Into 1st Gear
The truck:
2000 4X2 F150
4.2l V6
280k miles/ some towing
The problem : The trans has a hard time getting into 1st gear. When you put it into gear you have to rev it to about 3k (when it's warm, 4k when cold) RPMs at which time you feel a definite engagement and it goes through the rest of the gears just fine. Once it's warm it will do stop and go traffic as long as you start it with the OD off.
The background : Orobably the stock motorcraft filter on there, and I don't think the oil has been changed in the life of the trans, but I do know that it's never been ran low on fluid. I took a gander at it and found a plug where a gear type speedo went on older models to be loose and leaking. tightened it up about two full turns. also noticed what looks to be a leak where the main case meets the output shaft housing. now I know neither of these are the cause of my headache but I do wonder if the second leak might be a sign.
The research : I've been looking for almost a week now for a solution. I've been all over TCCoA, Explorer Forum,10 pages of search here on FTE and various other Ford based websites and have come across a single thread with the same symptoms but the OP never came back with a solution.
The plan : A fluid/filter change (and flush) is definitely in the plans as well as inline filter for my own satisfaction. from what I've read the stock 1-2 accumulator is known to go bad on some of these and if I have the pan off might as well check anyways.
Ford F-150 - 1997-2003 :: Auto Trans Gear Dash Indicator Is Off By One
My Daughter just bought a nice 99 F150 and the auto trans gear dash indicator is off by one so park says R and drive says N ... shes also having a little trouble with the key occasionally so I think the problems are related. Is this adjustable or not?
View 5 RepliesFord F-150 - 1997-2003 :: 4r70w Trans Won't Shift Past 2nd Gear
My 4r70w is having some issues. It drives/shifts fine in reverse, 1st and 2nd but wont shift past 2nd gear. Doesn't even act like it tries. No CEL. I dropped the pan yesterday and there wasn't any metal chunks or any other debris in the pan and only the normal fuzzes on the magnet and there wasn't even an abundant amount on the magnet. This is a junkyard trans that was put in before I purchased the truck (2001 F150 supercrew 2wd).
I've ohm'd the shift solenoids and they seem to be within spec (below 30 ohms) so i want to rule them out, but still thinking of replacing all 3 solenoids just to be safe. Also, the filter just fell out with the pan so I'm assuming that might be part of the problem. My next thing to check is the 2-3 accumulator and spring to see if its stuck or broken.
Ford Super Duty (1999-2016) :: 2000 - Misfiring While Trans Shifts Under Slight Pull?
My daughter has this truck and I was driving it the other day I noticed it misfiring when the trans shifts down under a slight pull and/or going up hills. It looses power and speed when this happens but if you back off, it smooths out when it shifts into overdrive. I haven't had it to a mechanic to check any codes yet.
View 3 RepliesFord F-150 - 1997-2003 :: Trans Swap Form 2000 To 2002 - Repin The Harness?
Ok so I've done a lot of searching but can't find any info on how to repin the harness to use the 2000 4r70w in my 2002. Both are 4x4 and came behind a 5.4.
View 4 RepliesFord F-150 - 1997-2003 :: 2000 - Engine Surging At Idle And In Gear
My truck is a 2000 model 2wd with the 5.4 engine. It has about 234000 miles on it. It suddenly started surging last night rpm jumping around approximately 4-600rpms each time. I noticed that once I got up around 50mph it would smooth out...
View 4 RepliesFord F-150 - 1997-2003 :: 2000 - Little Hard Jump When Shifting From 1st To 2nd Gear
I have a 2000 F150 with the 4.6L engine and I have a question about the transmission. When shifting from 1st to 2nd gear there is sometimes a little hard jump when shifting. All the other shifting through out the range is buttery smooth. The issue has been around for a long time and has never gotten worse. Is there anything simple I can do to fix this. Do those tranny additives work at all? Otherwise, I will just continue to live with it.
View 2 RepliesFord F-150 - 1997-2003 :: 2000 5.4L 4x4 - OD Hard Shift / Slams Into Gear When Give It Little Gas
I have a 2000 F150 5.4l 4x4. When I am going over 50 on the highway and I am in OD, if I let off the gas a couple of seconds later it feels as though the brakes come on because the truck slow down so drastically and when I give it a little gas it slams into gear. It feels as like there is a "gap" where nothing is engaged before it slams back in. This is a rebuilt tranny with less than 7K miles on it. I took it back once and they said it was the motor mounts. I had those replaced and still the same problem. I replaced the spark plugs 6K miles ago and the COPs 3K ago. There is 170K on the truck. I only drive about 8K miles a year.
View 2 RepliesFord F-150 - 1997-2003 :: Significant Pull To The Right Most Noticeable On The Highway
My 98 F150 4WD with 83k on it has a significant pull to the right most noticeable on the highway. I have to keep the wheel turned to the left to be able to go straight. It use to be intermittent but now is constant. Had a frt end alignment done twice with no change. Recently after a long drive on the highway on a crazy hot day, I pulled into a rest area & noticed the L/F wheel was very hot to the point where I thought the plastic center cap might start melting.
The R/F wheel was only warm. This makes no sense to me because with something causing the L/F wheel to heat up I would think it would pull to the left. This has bothered me so much that I've driven with 10psi less in the L/F wheel hoping it wouldn't pull to the right so much but it had no effect. I did recently have the left upper control arm replaced because it was clunking. It was doing this pulling prior to that & it continues.
Ford F-150 - 1997-2003 :: Accessories Stay On When Turn The Key And Pull It Out
Have a 2001 F-150 with 4.6L. when i turn the key and pull it out the accessories stay on. What could be wrong and what can i do to fix so I don't have to keep disconnecting the battery?
View 9 RepliesExplorer :: 2000 Ford Trans Slip Around 3rd Going To 4th Gear
I got a 2000 ford explorer with 151k on it... Since iv had the truck (5yrs) its always had a slight slip around 3rd going to 4th. The tran is auto!!
I use to be able to jump in and take off but here lately i have to let the truck idl for a few sec or up to a min before i can take off (warm or cold). This just started a month ago...
The trans fluid smells burned and it has be 2yrs since iv changed fluid and filter in the tran...Everything other then that iv kept up to par. What do you think should i start looking for something new or just change filter and fluid????
I know the truck has had a good life so I am starting to think the tran maybe trying to go.... My friend has a 85 dodge ram charger suv not sure the miles but its auto as well....It has a 318. Other then a small dent the thing look good... It has some kinda vacuum leak major but doesn't effect running. He told me the leak is from something he had removed when we left CA that they said he had to have for smog?
Ford F-150 - 1997-2003 :: Dies When Turning To Left And Pull Into A Parking Space
I just had my EGR valve and hose and DPFE sensor replaced and the truck is running better than it has in quite a while except that whenever I turn to the left and pull into a parking space it dies.
I've read that it could be a bad power steering pump. This would make sense because mine is pretty noisy when I make a left or right turn. However, it has never caused the engine to stall before. This didn't begin happening until immediately after the recent maintenance.
Is there something I should be looking for that my be related to the new EGR valve/hose or DPFE sensor?
Ford F-150 - 1997-2003 :: 1999 V6 - Engine Will Miss In A Pull And Die Sometimes But Start Back
Engine will start and run but will miss in a pull and die sometimes but will start back, we hooked it to a scanner and it said (intake wiring) it wasn't a dealer hook up just a gas station garage, we have already done plugs and wires.
View 2 RepliesFord Super Duty (1999-2016) :: 2003 F350 - Gear Shifter Very Tight And Hard To Pull Down
I'm looking at purchasing a 2003 F-350 from a Ford Dealer, Drove the Vehicle last night and the Gear shiftier was very tight and hard to pull down. Is this a real concern? The Sales guys said its better to be stiff rather than sloppy. But they will say anything, right. The vehicle is a deal and so I'm looking to find out why.
View 1 RepliesAccent LC (2000-05) :: Transmission Not Working In 1st Gear - Engine Revs
So I tried to launch my 04 accent today, but when I threw it into 2nd, all I got was engine revs. 3rd, 4th, 5th and reverse all work fine, but 1st won't work at all, and I can only get 2nd to work if I shift into 1st before hand. My question is what broke?
View 2 Replies