Ford F-150 - 1997-2003 :: Slight Misfire / Hesitation And Possible Backfire
I have a 2001 f150 5.4 with 200,900 miles. Just bought the truck about six months ago off my dad when he got a new one. I am now experiencing what seems to be a slight misfire. With the hood up pulling the throttle around 2200 rpm starts making a loud knock. Above that rpm nothing and below that nothing. Standing by the tailpipe it sounds like a small backfire. It Idles really rough and when you get that sound out of the tailpipe it jumps like its hiccuping. And tailpipe is vibrating quite a bit.
Things I have done in the past month include replacing the pcv valve, changing spark plugs, cleaning throttle body, cleaning MAF, took down exhaust to check cats because i was experiencing a power loss and bogging. When the exhaust was off i punched the two rear cats. I ran a bottle of iso heat in the gas. Everything seems to have supported the power problem but now less than a week later i am starting to experience the knock and backfire type sounds.
Ford F-150 - 1997-2003 :: Slight Miss / Rough Idle - Hesitation Or Stumble On Acceleration
2003 F150 5.4 72852 miles
I have a Rough Idle & sometimes a hesitation or stumble on acceleration. I cleaned the MAF & IAC motor & Air & Fuel Filters are new. I got a 20890 scanner & ran test 6 53 as suggested in many posts by BlueGrass. Here are My results & what They Convert to.
1 00F5 .3675
2 0051 .1215
3 0000
4 0000
5 00A3 .2445
6 0000
7 0000
8 0000
I'm guessing the cop's are ok & probably need plugs? I was hoping to just swap a coil. Too cold to do plugs & truck won't fit in my garage.
Ford F-150 - 1997-2003 :: Trans Slipping - Won't Shift Right?
Ok so when I come to a full stop my truck doesn't want to shift right when I take off where do I need to start looking
View 7 RepliesFord F-150 - 1997-2003 :: 4r70w Trans Won't Shift Past 2nd Gear
My 4r70w is having some issues. It drives/shifts fine in reverse, 1st and 2nd but wont shift past 2nd gear. Doesn't even act like it tries. No CEL. I dropped the pan yesterday and there wasn't any metal chunks or any other debris in the pan and only the normal fuzzes on the magnet and there wasn't even an abundant amount on the magnet. This is a junkyard trans that was put in before I purchased the truck (2001 F150 supercrew 2wd).
I've ohm'd the shift solenoids and they seem to be within spec (below 30 ohms) so i want to rule them out, but still thinking of replacing all 3 solenoids just to be safe. Also, the filter just fell out with the pan so I'm assuming that might be part of the problem. My next thing to check is the 2-3 accumulator and spring to see if its stuck or broken.
Ford F-150 - 1997-2003 :: Trans Shift Into 2nd With Heavy Jerk When Accelerating From A Stop
2003 F150 XLT 7700 4x4 5.4 Triton. While accelerating normally from a stop the transmission? shifts into 2nd with a heavy jerk. All other gears normal. It doesn't do this under hard acceleration or under very gentle and slow throttle application. Is this a COP issue, a transmission issue or just a driving style thing?
View 7 RepliesTrailBlazer :: Slight Hesitation And Clunks When Trans Downshift
After braking down to 15 or 20 mph my 2004 Trailblazer transmission has a slight hesitation and clunks when I start to give it the gas. Could this be due to a sticking modulator or some other issue?
View 1 RepliesFord Super Duty (1999-2016) :: 2004 F250 - Slight Hesitation When Trans Is Engaged And Tow Haul Light Blinks
I have a 2004 F250 Torqshift trans, 155,000 miles. It has had a slight hesitation when trans is engaged for about 4 years, not a problem the dealer has no fix they said.
Now today for the first time I had a tow haul light come on while driving on the freeway. It would not go into overdrive and the light keep blinking. Later in the day, I let it cool down and it drove fine to the store about 2 miles. When I got in to drive home it had tow haul light go blinking and check engine light came on this time.
I hooked up my code reader and it's giving codes: P0720, P0751 and P0766.
Should I take it to the Ford dealer, a Transmission shop or have a friend who worked at Ford Dealer do the Work? I see that some people have changed out the TFT sensor and corrected the problem. While the pan is down should I just have all the shift solenoid sensors changed?
Ford Transmission :: Cruise Control - Shift Or Lock / Unlock Trans On Ever Slight Downhill
Just picked up an Excursion with the V10 and 4R100 (2001). Drove it in to work to day and while on the freeway cruising on cruise control about 60 it seemed to shift or atleast lock/unlock the trans on ever slight downhill you encounter on a city freeway. Just light humps in the road. Does this seem normal? RPM's would be just shy of 2000 then I'd hit a small decline and would shift to 1600 or so then back up when it leveled out.
View 14 RepliesGTI 337/20th Anniversary :: 2002 VW Automatic Shift - Slight Hesitation When Slowing Down
I have a 2002 1.8 Turbo VW GTI. Lately I've noticed that the car would hesitate slightly when slowing down. It would go up to at least 5000 RPM's or higher before it shifted over. The hesitation when slowing down and accelerating tend to happen when I drive. What to do, I went to the vw company they said if i want to change the transmission would cost me ~6k$ and f*ck me twice if if am paying 6k on a 2002 car.
View 3 RepliesFord F-150 - 1997-2003 :: Can't Get The Truck Into Gear With Clutch Pushed And It Doesn't Even Grind
Well here it is I just put a new slave cylinder in my 02' F-150 and once we figured out all the little issues we were having we finally got the truck to fire up!!! Now my problem is that when the truck is running I can't get the truck into gear with the clutch pushed and it doesn't even grind. But when the truck is off it goes through the gears no problem what so ever. When we did the slave cylinder while we were in there we just replaced everything clutch, pressure plate, flywheel, rear seal, and pilot bearing. We figured that since all the shops were quoting me 800 and up for just doing the slave that since were in there we might as well do everything since nothing has ever been replaced yet. My question is why will the truck not let me shift into gears when running but no problem when off. Oh and yes the system was bled after doing the slave actually twice so far.
View 5 RepliesToyota - Tacoma :: 1997 - Slight Stumbling / Hesitation Sensation
I have a '97 Toyota Tacoma, two-wheel drive. It has 154,000 miles on it. During the last three weeks, there's been a hesitation/ stumbling sensation happening occasionally in the first three gears. It doesn't happen in 4th or on the freeway. At first, I thought it felt more like a "slipping", like a clutch going bad (since I still have the original clutch).
I had my mechanic check it out, and it's fine. Here's a brief history of recent work done. Three months ago: injectors removed and cleaned out on a special machine. I replaced the cap & rotor and spark plugs. The wires were replaced last year. I replaced the fuel filter and PCV valve. I cleaned out and replenished my K&N air filter. Last week, I checked the connections where the spark plug wires connect to the cap. They seem fine.
Ford 7.3L Power Stroke (1999-2003) :: Slight Hesitation In Throttle While Cruising / Truck Stalled Won't Fire
Last night I bought 2000 F250, 346k on it... Crew cab short bed 4x4 with ranch hand bumpers like I wanted .... Headed back home (Miami FL ~1100mi) and covered about 200 miles @70-75mph before i ran into few problems ....
First off, while cruising I noticed slight hesitation in the throttle, with loss of speed regardless of pedal pressure, noticeable on inclines. It would go away on downhill and get smooth response again and pick up speed. This went on for about 40 miles.
Then I noticed heater blower stop blowing hot and start blowing cold, without me changing any settings. At the same moment, I noticed temp gauge move up and I hit next exit offramp to check what's up. During right turn at the end of off ramp truck stalled. Pulled to the shoulder, and popped hood.
Noticed empty degass/overflow bottle. Carefully opened lid and water gushed up to the top. When all pressure slowly released, water pulled down and emptied the bottle. Both upper and lower radiator hoses are empty. Engine oil has no traces of water tho. There were no leaks under the truck. I then tried to fire up the truck to get me to the gas station 1/8th mile away.
No crank in Park. WTS comes on and goes off. Cranks in Neutral, RPMs come up some, oil pressure shoots up to normal running position, but won't fire. Tried a while then gave up as not to kill starter and batteries completely.
Fuel pump works 20 sec then shuts off. There is fuel in bowl. I covered 140 miles since last full fill up, so not fuel pickup issue I don't think.
Summary
Have crank
Have RPM
Have oil pressure
Have fuel
Have (had) batteries, now not so hot
It's cold out ....
Ford - Explorer :: 2003 - 5R55W Trans Does Not Shift Into 2nd Or 5th Gear
2003 Ford Exploreer 4x4 5R55W Auto Tranny. From driving the car it does not shift into 2nd or 5th gear. The O/D light flashes, and the check engine light comes on. Gives Code P0775, which indicates a problem with Solenoid 2.
This weekend I changed the Shift Solenoid Pack with a brand new one from Ford, and the exact same problems still exist. It's as if I hadn't done anything to the car. I have read somewhere that 2nd and 5th gears share a band in the tranny, could the the problem.?
Ford 7.3L Power Stroke (1999-2003) :: 2000 F350 - Slight Hesitation With Throttle While Driving Mostly In Lower Gears
(2000 F-350, 7.3L, 205k miles) Over this weekend, I noticed while driving mostly in the lower gears, that there was a slight hesitation with the throttle pedal depressed about half way or less. Seem to get worse as the day went by, but no lights or anything came on. Changed the fuel filter and added a fuel injection cleaner to the tank. Checked the oil and it was low, so I filled it to the correct amount.
Drove it around the next day, and it seemed to be good, until it warmed up some, and continued to hesitate. The hesitation seems as if it's not getting constant fuel, and the truck jerks a little. Once you get up to over 2000 rpms, it goes away. Looking up other reviews on similar issues, most have pointed to the throttle pedal sensor and just changed out the pedal assembly. Before I take it that far, I wanted to see what was the corrective action.
Prius (2010-12) :: Slight Hesitation At Slight Acceleration Or Constant Speed
I have a 2010 with about 166k miles. I am getting a slight hesitation at slight acceleration or constant speed. It does not matter if it's on highway or freeway speeds. Now I am not sure if this in junction with me changing the PCV valve, cleaning the EGR pipe, or cleaning the TB for carbon recently. It started happening a week after it though.
View 19 RepliesFord F-150 - 1997-2003 :: Possible To Put 351 Or 302 With 5.4 E40d Trans?
is it possible to put a 351 or a 302 in a 97 f150 with the 5.4 e40d trans is so what all would have to be done in order for everything to work rite??
View 9 RepliesFord 6.0L Power Stroke Diesel :: Torque Shift Trans / 4 - 5 Gear Shift Under Hard Acceleration
I have been having an issue with my 4-5 gear shift under hard acceleration and know that a rebuild is due soon but I was wondering if any high performance kit available with all the clutches and friction discs needed to rebuild.
View 6 RepliesPrius (2010-12) :: Slight Grind Noise When Press Power On Button
Just wondering if I should be concerned. It doesn't happen every time, but it sounds like grinding of a gear or something like that. I made a video .....
View 19 RepliesGolf IV R32 :: Brake Pedal Making Slight Grind / Clicking Noise?
Ok so I have done a complete brake overhaul with rebuilt calipers, new pads and rotors and a new master cylinder. Brakes stop on a dime and are solid when pressed firmly. When coming to a stop at a slow speed (5 mph) pedal gives in with slight clicking grinding noise. I have exhausted searches on google and here with no soild answers any clue what causes this or how to fix it?
View 24 Replies