Ford F-150 - 1997-2003 :: Brake Bleeding After Putting In A New Master Cylinder?
...Is there anything special that needs to be done for brake bleeding after putting in a new master cylinder? I decided today to flush my system with my vacuum bleeder and now my pedal slowly falls to the floor at a light...No problems in a panic stop or otherwise, just falls to the floor slowly when braking...no leaks, so I'm assuming a master cylinder is an order....
View 14 RepliesFord F-150 - 1997-2003 :: Winded Brake Lines From Master Cylinder To Front Splitter Block?
What kind of brake line is it and if is replicable with regular brake line? I'm just replacing long line between front and back splitter block and just would like to know what is it. What is purpose of that braiding (?) at front brake lines and why they wind down instead of going straight. Part of that long line is braided too, part that go across frame.
View 3 RepliesFord F-150 - 1997-2003 :: 2000 - Replaced Booster / Master Cylinder / All Calipers Still Spongy Brake Pedal?
I have replaced booster, master cylinder, all four callipers, and bled the brake system a number of times on my 2000 F-150 4x4. and still the pedal is wicked spongy, is there some other problem?
View 6 RepliesFord F-150 - 1997-2003 :: Cruise Switch On Brake Master Cylinder Is Bad And Causing Cruise To Not Work
The cruise switch on my brake master cylinder is bad and causing the cruise to not work. I have it bypassed with a jumper wire and it works fine. is there any reason not to do this?
View 11 RepliesFord 7.3L Power Stroke (1999-2003) :: Removing Brake Master Cylinder?
I tried to replace my brake master cylinder today but wasn't able to because of a plug
It's the black plug on the drivers side, the connector is upside down so I can't see how to unplug it I tried for an hour then got too frustrated I had to come inside
My Haynes manual says "unplug" obviously
Ford F-150 (2004-2008) :: 2006 - Brake Light On Intermittently - Master Cylinder?
My son's 2006 F-150 4x4, with 107,000 miles, has in intermittent brake light on. I replaced the rear pads, as they were nearly into the rotors. The brake pedal feels fine in all braking conditions. Could the master cylinder still be going bad? Anything else to check?
View 4 RepliesHonda - Accord :: 2002 - Old / Weak Brake System - Replacing Master Cylinder?
I have a 2002 Accord with about 130k miles on it and the brakes don't have nearly the power that they used to. The pads and rotors are due for replacement but even then, the system is pretty weak. Would replacing the master cylinder? What about simply replacing the brake fluid (I doubt it has ever been changed)? And/or the calipers? The car is in great condition and I really like it so I don't mind investing some time and money to get more years out of it.
View 10 RepliesFord 7.3L Power Stroke (1999-2003) :: 2002 - Replacing Clutch Master Cylinder
I am looking for a how to vid or resource on doing the job right. I purchased the complete replacement master cylinder from Napa. 2002 7.3 Powerstroke
View 3 RepliesLexus GX 2004-09 :: 2003 GX470 Brake Master Cylinder Leakage
Just purchased a 2003 GX470 with 160k and after the low brake fluid light came on I noticed the master cylinder had a leak. After removing the cover it appears the fluid has leaked for quite some time as the paint has started pealing from the frame. The brakes however appear to be working correctly. Upon purchase the front calipers were seized and I replaced both front calipers.
After having someone depress the brake pedal while I watched, the fluid leaks from the end of the master cylinder each time pedal is pressed in.
After doing some research it appears there is a rebuild kit for the master cylinder.
Sonata NF (2006-10) :: Red Parking Brake Light Come On - Master Cylinder Level Was Low
So my May 2007 V6 Sonata with 143,000 km (89k miles) had the red parking brake light come on. Master cylinder level was low and there was evidence of something leaking on the driveway. Below the very back of the driver seat.
At the dealership they say I've got a leak in my brake lines. Say that the fuel lines should be replaced too since they are in the same compartment. So if one goes the other may not be far behind.
I was out of town and the car couldn't be driven safely so I was pretty much stuck there.When the dealership did the work a rusted bolt snapped near the fuel tank and they said that added an additional hour of labour to the work. In the end I wasn't charged for it. Tech said he had never seen a Sonata have the brake lines rust out like that. I got the brake and fuel lines done cause I plan on owning it for 6+ years.
Elantra XD (2001-06) :: 2003 - Brake Fluid Leak Coming From A Part Near Master Cylinder
I recently noticed that my brake fluid was leaking in my 2003 Hyundai Elantra and upon further inspection I found the leak was coming from a part near the master cylinder. I looked online and couldn't figure out if this part was part of the master cylinder or brake line or a part all on its own. I tried tightening it but It still leaks some. I read a similar post online and that it could just be that the washer needs replaced but I just wanted to check on here to see what the part is called and if I should just replace the whole thing. I included photos as well.
View 7 RepliesLexus GS 2013+ :: Brake Warning Light - Fluid Level In Master Cylinder At Minimum Line
Yesterday the brake warning light came on in my 13 350. I checked, and the fluid level in the master cylinder was at the "min" line. I don't think I've ever had to had brake fluid in any car before. Seems to be Ok today, but I was wondering if other folks have had this happen? Of course if it happens again I'll have to check the brake system. Just wanted to check.
View 8 RepliesMazda - B2600 :: 1992 - No Power To Start After Changing Master Cylinder
I have a 1992 mazda b2600i, recently lost all brakes. Changed the master cylinder, but now I have a major problem!! I have no power to start it. I have head lights, dome lights, horn, buzzer when key is in start position. Nothing when try to start, no click, no trying to start nothing!! I have changed the main relay, all fuses. broke down and contacted a mechanic and he is telling me that I have to have the 2 computers replaced... there is one under the kick panel on the pass side and one under the driver seat!!
View 7 RepliesFord Aerostar :: Brake Master Cylinder Cap Leaking
I replaced my MC cap and gasket less than a year ago with a Dorman replacement and I'm leaking again, already. I don't want this to be an annual thing! Any good quality replacement? Is there any tip or trick to get the gasket to seal better?
View 9 RepliesFord F-150 - 1997-2003 :: 2002 - Brake Light Started Flashing After Start Up?
The brake lights on my '02 F150 have started flashing spontaneously ie - with no one in truck. This lasts for a few minutes, then stops, but can start again a few minutes later. The fear of course is that someday lights could come on and stay on, resulting in dead battery.
I do have a trailer brake controller that has been on truck ten years. Read something on internet that brake pedal switch might be going bad (??). Any one else observed this strange behavior?
Ford :: Brake Fluid Leaks From Top Of Master Cylinder Reservoir
Early 70's Ford truck. The brake MC fluid is filled but not overfilled, and doesn't leak at all when the truck is parked. It can sit there for a month and never leak a drop, parked. But when I drive the truck, even just around the block, then park, and look inside the engine compartment immediately the brake MC is dripping brake fluid. It appears the leaking mode is by the fluid somehow jumping up and coming over the top edge of the MC when the truck is in motion or when the brakes are applied. All my diy'er years of replacing brake master cylinders on Ford Galaxies, VW Rabbits, Corollas, and this truck, I've never seen this kind of weird brake problem before. On this MC design it seems there's sort of a rubber baffle inside the lid of the MC, and that's present and accounted for.
View 17 RepliesFord Brakes/Suspension :: Why Are The Brake Lines Coiled Near Master Cylinder
Why the brake lines have 2 or 3 coils in them near the master cylinder? Makes it a real pain to work on anything down in that area. Always snags ratchets and stuff...
My brother and I were discussing it the other nite, and the conclusion we came up with was, the first guy ever who was installing a brake system had tubing that was a couple feet too long, and couldn't find a tubing cutter, so he coiled them up.
Then the next guy saw that and figured "hmm, so THAT'S how it's done", and so on... Kinda like the story about the lady who always cut off both ends of her ham before she put it in the broiler..
Ford Brakes/Suspension :: 1979 - Changed Brake Lines And Master Cylinder But Still Soft?
I have a 79 f150. I changed two brake lines and master cylinder and bleed,and more bleed,but still very soft all most to floor? wheel cylinders look good.
View 2 RepliesFord Brakes/Suspension :: 1987 - Brake Pedal Slowly Going To The Floor - Master Cylinder?
1987 F-350 460 Auto Trans. Brake Pedal slowly going to the floor. Stopped at a red light yesterday on a slight down hill and I noticed the brake pedal slowly going to the floor. I had to put the truck in Park to avoid bumping into the car in front of me. I checked brake fluid level and still at the full level, check rims for brake fluid leak from brake cylinder, none. Could my master cyclinder need rebuilding or is my vacume diaphragm going. Not sure thats what its called.
View 14 Replies