Ford F-150 - 1997-2003 :: 1999 - OD Light Started Flashing While Going Down The Interstate
I got a 99 f150 with a 4R70W and 311,000 miles on it and last year the od light started flashing while I was going down the interstate so I checked the fluid when i got home and it was beyond burnt so i changed fluid and filter. So a month or so ago it started doing this thing where on take off it will rev up like its in neutral for a couple seconds then reengage and drive normal till i stop and start to take off again. It don't do it every time and it drives/pulls just fine other than that.
View 4 RepliesFord 7.3L Power Stroke (1999-2003) :: 2002 F250 - OD Light Started Flashing
I have a 02 f250 4x4 7.3l.... I drove it all weekend and no problems. It sat till yesterday I got in it to go to church. It started up and had a little miss was around 60 f. Then the od light started flashing. Not in any code just constant flash. I was parked down in my drive way. It idled fine but acted like it wouldn't take fuel. So looked around and found the hose on the map sensor was broke.
So today I fixed the hose. Checked the oil level and battery connections. Still running weird and flashing od light. I got under the hood and wiggled plugs I unplugged the ice. It revved up then back down and started running smoothly. Got in it and it backed out of the drive way. It ran and drove fine. What I need to know is why??? The ice is a new one from Ford.
Ford F-150 - 1997-2003 :: Check Engine Light Started Flashing / Running Rough Then Went Off
Ok on the way the my 1997 f150 4.6 L 180,000 check engine light started flashing and running rough and then the light went off, Also we took the Aftermarket Dynomax muffler off of it earlier today if that makes any difference, it still has the Cat Converter, New Plugs and Napa Wires.....
View 12 RepliesFord F-150 - 1997-2003 :: CEL Code P0707 - Tranny Started To Slip / OD Light Flashing
I have a 97 f150 (built 96 as 97 model), 4.2l 4x4, auto tranny. Here's the problem, when I turn my key forward to run position my starter kicks on and starts the truck, and stays engaged. I have a constant 14v at the signal wire on the starter relay (yellow red stripe). Also tranny started to slip, od light flashing. I replaced ignition lock cylinder, ignition/ starter switch, starter relay, starter, and today transmission range sensor (neutral safety switch 8 pin), same problem. Cel code that I had 2 days ago was P0707 tr sensor low input.
View 8 RepliesFord F-150 - 1997-2003 :: 2002 - Brake Pedal Fade / Started Going To Floor When Stopped
Last week my brake pedal started going to the floor when I stopped, it still stopped and felt fine on the top half of the pedal travel but then it would just slowly fade to the floor. I took it to a local shop and they said the master cylinder was leaking internally and my rear brakes were shot. I have 75,000 miles and the rear brakes were original so I told them to fix it. This is basically what I expected it to be.
They kept thinking they were getting defective master cylinders but after the two Napa parts and two Carquest parts they realized they misdiagnosed it and said I needed to take it to the dealership. I paid for the rear brake job since it needed done anyways and have an appointment for next week at the dealership. What might be causing the problem? I see no brake fluid leaks, no vacuum leaks, the booster was replaced 25,000 miles ago due to noise, no ABS light on, no CEL on, no other symptoms.
Ford F-150 - 1997-2003 :: ECM Changed But Still Won't Start And Theft Light Is Flashing
My alarm and lights started going off one night. By the time I got to it, everything stopped. When I tried to start the next morning, I got nothing. After several tries, horn and lights started again. The only way to stop it was to disconnect battery.
One person told me that it was the key or the ignition not recognizing the key. I was then told that my truck, 97 f150, had no chip in the key so the problem was the computer.
I replaced my computer with a refurbished one. Once I hooked up the battery, the horn was still going, lights flashing and theft light still blinking. Also, not sure if its related, but when I try to use the key in the passenger door it turns, but there is very little resistance and the door does not unlock.
1997 F150
4.6L V8
4x4
6" Fabtech Lift
235,000 Miles
Ford F-150 - 1997-2003 :: 2001 - Cranks But No Start / Theft Light Flashing Fast And CEL On
01 F150. Cranks but no start, will fire with starter fluid spray. Theft light fast flash, Check engine light on. Only have one key and don't know what the kid that had owned has done.
View 5 RepliesFord F-150 - 1997-2003 :: 2002 - Brake Light On After Changing Master Cylinder?
ll, I changed out the master cylinder on my 2002 F-150, disk brakes front and back w/ ABS. Bleed all the air out and bench bleed the master cylinder. I have good pedal but the brake light will not go out.
View 6 RepliesFord F-150 - 1997-2003 :: 1999 - Truck Won't Start / Theft Light Just Started Blinking
I recently changed the heater core on my 99 F-150 which meant i had to remove the dash. I got everything back together turned the key to start it and nothing it wouldn't start it wont even turn over. All the electronics come on like normal it just wont start. I have chased every wire every connection into madness. It has an aftermarket remote start someone said that would have bypassed the PATS but i dont know about that the theft light just started blinking.
View 1 RepliesFord Transmission :: 2002 - OD Light Started Flashing When Pulling A Trailer On Highway - Codes P0705 And P0783
2002 7.3 4R100 ... The truck started flashing the O/D light pulling a 9K lb trailer on the highway.
The transmission codes read were P0705 (Range Selector) and P0873 (bad 3-4 shift - RPMs did not drop).
On the highway, the TCC seemed to lock up fine in 4th (OD button was set to leave O/D ON). When the truck would downshift (not often) then it would sometimes would rev high when it downshifted. It was like 3rd was slipping or it was downshifting into 2nd instead of 3rd. I think it was doing a 4-2 downshift but not 100% sure.
What confuses me is that if it is doing a 4-2 downshift then it would have to change state of both valve body solenoids. Is it possible that it was doing a 4-3 shift but solenoid was sort of sticking? Trans fluid looks fine.
I have read other posts where people had same problem (titled 3rd gear slipping), but they never seemed to resolve the problem in the thread. How likely is it that the solenoid is the problem? It seems to drive fine in 3rd when the O/D OFF button is pressed and O/D is not allowed.
Subaru - Legacy :: 2015 - Brake Light Started Flashing At 40 Mph
On the way home from purchasing this 2.5i Premium the BRAKE light started flashing when I got to 40mph. - yes, the emergency brake was off. Car was roaring like the brake was on-ablut 5 mi. to home. When I drove it back to dealer/service to get a few minor "We owe" things done, same thing happened again when up to 40mph. This was reported to service and car was driven by service manager. They reported a bad wheel bearing front R, and later in day found out rear R wheel bearing also bad. Yes, to be replaced..
View 19 RepliesGrand Prix :: 2002 GT Started Then Died - Security Light Flashing
Having an issue with my 2002 GP GT. I started it, but then it died after a couple of seconds while the "Security" light was flashing.
I actually had both original keys with and tried each to no avail (same thing: starts, but engine kills after a few seconds). I checked the PassKey III fuse and even replaced it - still no luck.
Called two different dealer service departments and they suggested turning the key to the "ON" position and leaving it for 15 minutes. I tried this 3 times and still the same issue.
I understand this can be a VERY expensive repair as I've read it requires replacing the ignition module and perhaps the Theft Deterrent Module. How to at least temporarily by-pass or reset the system so I don't have to get it towed (of course it's no where near my place).
Sierra :: 2002 - Alternator Started To Make Some Noise And Battery Light Flashing
I have a 2002 with a 4.8 ... My alternator started to make some noise, and my battery wasn't holding a charge very well so i decided to change the alternator today before it went some were out in the boonies. After i put the new alternator in, the battery light started flashing in the "message center" but everything seems to be running fine. The voltage gauge in the dash is reading about 15. So from there I turned everything on in the truck and the gauge barely dropped. At this point I'm not sure what to do, I'm going to put the old one back on and see if it goes out, oh I also put some tension on the belt to make sure it wasn't slipping.
View 3 RepliesFord F-150 - 1997-2003 :: 2002 - Truck Is Hard To Get Started And To Keep Running
Sometimes the truck is hard to get started and to keep running, Once it warms up it will run fine. The next time it is started it will start fine but when you are going down the road if I try to accelerate it will start backfiring and not pick up any speed. I am getting a lean code on both banks. I have changed the IAC, the throttle position sensor and mass air flow sensor. 2002 F150 with 6 cyl
View 1 RepliesFord F-150 - 1997-2003 :: 2000 - 4x4 Trying To Start By Itself / Lights Flashing
My truck is trying to start its self the lights flash and one of the relays makes a loud buzzing sound. I can take the relay out the sound stops but they truck still tries to start/lights flash.
My wife has been saying she's been hearing a clicking as she drives it coming from the drivers side somewhere she thinks under the dash. But at this point nothing happen. And it had not been raining any when this was happening not for a long time.
The first time anything mechanical happen was only the lights came on and stayed on and drained my battery about a week after wife heard the clicking noise. I recharged the battery and chalked it up to my wife maybe bumping the light switch slightly causing them to stay on and not auto on and off. truck ran fine for a couple of weeks then wife drove it again the other day and after she got home she called me at work saying it was making a bad buzzing sound lights were on and its trying to crank, while it was sitting in my driveway with no one in it (sacred her to death).
That day it was raining. Now I had a small drip coming from driverside window inside so I thought maybe went down on my fuse box. So today I tried to get it out but having a hard time getting cables to disconnect so i left it and inspected really well and it does not appear to have been wet at all. Dust on top no water trails or marks same from side bottom and in the fuse holder. So i really don't know whats going on. Maybe still is fuse box?
2000 f150 5.4l 4x4 ......
Ford F-150 - 1997-2003 :: ABS Light Trigger A Flashing OD Light?
Just wondering if this is possible, if the ABS light come's on now and then,
And the speedo bounces, as it does, could it trigger the dreaded OD flashing light.
Ford F-150 - 1997-2003 :: 2002 - Code P1289 Since The Temperature Started Cooling Off
I just started recently getting this code on my '02 F150 with the 5.4. It only started doing this since the temperature started cooling off. The light, next to the oil pressure gauge comes on only at initial start up. Once the motor warms up, it goes off. I'm due for an oil change, which I'm getting today.
View 4 RepliesFord F-150 - 1997-2003 :: Airbag Light On / Flashing
Yesterday I replaced the bulbs in my heater controls, today I have the Airbag light on, flashing 2/7. And when I turn off the passenger airbag, the "OFF" light does not come on. I've heard if the "OFF" light goes out, you replace the switch, would that possibly cause this code?
View 14 RepliesFord F-150 - 1997-2003 :: Passenger Side Brake Started Making A Grinding Noise
I have a 1997 F150 (truck in signature). In December my passenger side parking brake cable broke so I replaced both rear cables (front cable appears in good condition).
This past Friday the passenger side brake started making a grinding noise so I pulled the drum to find the self adjuster cable broken and the ratchet jammed between the shoe and the drum. I pulled everything apart and put new shoes (the pin the ratchet pivots on was broken off the rear shoe)and all new adjusting hardware (adjuster screw, ratchet, cable, and cable guide). The rest of the hardware looks in good condition (still paint on the springs and retainers). I got everything put together and took it for a test drive, it had a nice firm brake pedal (it's been a while since this truck has had a firm pedal) and great stopping power.
Took it to work today, and on the way back I stopped to pickup a package from the UPS store. I set the parking brake and put the truck in 1st like I always do. When I got back out to the truck to drive home, I released the parking brake but there was still obvious drag as I drove home (no good place to stop during rush hour), got out of the truck and it reeks of burning brakes. I pulled the driver side drum off (after it cooled), which was rather difficult, and everything looks to be in order except the rear shoe was not touching the post at the top of the backing plate. I checked and the adjuster was still all the way in, so that isn't the issue.
I pulled the parking brake cable out to slack the drum side of it (with the pedal released there is some spring tension from the pedal mechanism) and clamped it with vice grips so the cable was slacked and the shoes were then touching the post, and the drum could be installed and turned relatively easily, I then removed the vice grips and let the spring pull the tension out of the cable and the brake held firmly (requiring considerable effort to turn the drum). Is there anyway to adjust the spring tension on the parking brake cable when the parking brake is released?
Additional notes: when setting the parking brake, the pedal will only go down an inch or 2 before the brakes are locked up tight and the pedal won't move, it used to go down several inches before. also I noticed that the feral on the end of the drivers side cable (that locks into the lever attached to the rear shoe) is deformed, like the cable has too much tension on it. The cables are the correct ones for my wheel base according to Autozone but I'm starting to wonder if they are too short. Spring tension on the parking brake cable (when the brake is not set) causes the parking brake to drag. How do I get the parking brake to stop dragging? ("star" adjusters are new and adjusted all the way in).