Ford F-150 - 1997-2003 :: 2002 - No Cruise Control / Fluid Coming Out Of Brake Control Switch
I have an 02 f150 5.4 and since I got it it hasn't had cruse control. I went to a local ford dealership and they ran the vin and didn't find any recall on it. Under the hood on the master cylinder there is brake fluid coming out of the brake control switch. Would I have to do something with the harness too?
View 9 RepliesElantra HD (2006-10) :: Cruise Control Does Not Work After Changed Brake Light Switch
I just discovered my cruise won't "SET" (light goes out after 1/2 second) anymore after having the brake light switch done yesterday.
View 2 RepliesFord F-150 - 1997-2003 :: Brake Bleeding After Putting In A New Master Cylinder?
...Is there anything special that needs to be done for brake bleeding after putting in a new master cylinder? I decided today to flush my system with my vacuum bleeder and now my pedal slowly falls to the floor at a light...No problems in a panic stop or otherwise, just falls to the floor slowly when braking...no leaks, so I'm assuming a master cylinder is an order....
View 14 RepliesFord F-150 - 1997-2003 :: 2001 - Cruise Control Does Not Work
Ok replaced the front brakes, tie rod ends, and all ball joints today. Also flushed old brake fluid and replaced with new. Now my cruise control does not work. Light on the dash momentarily flashes when I try to set the speed. I have checked all the fuses and the connections and everything appears normal.
2001 Ford F150 5.4L 4x4 off road pkg stock height and tire size.
Ford F-150 - 1997-2003 :: 2002 - Brake Light On After Changing Master Cylinder?
ll, I changed out the master cylinder on my 2002 F-150, disk brakes front and back w/ ABS. Bleed all the air out and bench bleed the master cylinder. I have good pedal but the brake light will not go out.
View 6 RepliesFord F-150 - 1997-2003 :: Winded Brake Lines From Master Cylinder To Front Splitter Block?
What kind of brake line is it and if is replicable with regular brake line? I'm just replacing long line between front and back splitter block and just would like to know what is it. What is purpose of that braiding (?) at front brake lines and why they wind down instead of going straight. Part of that long line is braided too, part that go across frame.
View 3 RepliesFord F-150 - 1997-2003 :: 2001 - Cruise Control Passes Self Check But Doesn't Work
I am stymied by a weird Cruise Control problem on a 2001 F150 Lariat SuperCrew with 5.4L V8 engine that I just purchased. Long story short, the cruise control does not work. That is, when I push the "On" button at any time while the engine is running (even when traveling at highway speed), the dashboard CRUISE light does not come on.
I ran the cruise control "self check" procedure. The first time I ran it, we failed with 3 flashes. So I checked the cutout switch on the brake master cylinder, and it was indeed leaking brake fluid. So I purchased a new switch and cable (Motorcraft SW-6350 Speed Sensor Switch Repair Kit) and installed them.
With the new cutout switch, we seem to pass the self test. That is, after pressing all the buttons in order , I see all the quick flashes of the CRUISE light
(1. On (flash), 2. Resume (flash) 3. Coast (flash), 4. Set/ accel (flash)). Then the accelerator pedal is pulled away from my foot.
However, unfortunately, the cruise control still does not work. That is, when I push the "On' button at any time while the engine is running (even when traveling at highway speed), the dashboard CRUISE light does not come on. What to look at next? I note that horn works, in case that's useful info.
Ford F-150 - 1997-2003 :: 2000 - Replaced Booster / Master Cylinder / All Calipers Still Spongy Brake Pedal?
I have replaced booster, master cylinder, all four callipers, and bled the brake system a number of times on my 2000 F-150 4x4. and still the pedal is wicked spongy, is there some other problem?
View 6 RepliesFord Super Duty (1999-2016) :: Brake Fluid Leak At Switch On Master Cylinder
I have replaced the cruise control cut off switch and post-recall pig tail twice in two years for fluid leaks. Whats the deal do they all leak?
View 6 RepliesFord Excursion :: Cruise Control Will Not Work / Deactivator Switch Is Open Or Circuit Defective
I bought a 2002 Excursion 2wd V10 at an auction with 105,000 miles. I've been working through the little problems and I'm down to one last small item.
The cruise control will not work. I found a thread to diagnose the problem. My diagnosis is:
After doing the self test I received: 3 flashes - deactivator switch is open or circuit defective.
What does this represent and what shall I do to correct it?
Corolla / Matrix 2009-13 :: After Installing Cruise Control Horn Won't Work - Cruise Lights Up On Dash Borad?
I'm at my wit's end trying to install cruise control in my 2009 Corolla. I thought it was a relatively easy install, but then after putting the airbag in place, I find that the horn no longer works. I test out the cruise control, and the green "Cruise" lights up on the dashboard..but it doesn't actually work.
View 9 RepliesGolf IV / Jetta IV :: Cruise Control Does Not Work When Turn Switch To On Position
So noticed my cruise control does not work when I turn switch to on position the green light in cluster does not come on what are some problems that I could look into and also any example of using turn signal Bulbs in the head lights as drl lights instead of it running off of the actually headlight bulb?
View 9 RepliesFord 7.3L Power Stroke (1999-2003) :: Removing Brake Master Cylinder?
I tried to replace my brake master cylinder today but wasn't able to because of a plug
It's the black plug on the drivers side, the connector is upside down so I can't see how to unplug it I tried for an hour then got too frustrated I had to come inside
My Haynes manual says "unplug" obviously
Nisan - Sentra :: 2010 - Brake Lights Out - ABS On - Cruise Control Won't Work?
We started having problems first with the car dying at stops, and having to be restarted. We had the oxygen sensor cleaned, and it stopped that problem. Then my ABS lights came on, and my cruise control stopped working. When the car was cold and I tried to take off (forward or reverse) the rpms would not go above 1000, and the car would only move like it was idling. I read in a closed discussion on this forum that it was the stop light switch under the brake pedals so we got one and changed it out. Same problems.
So we thought we had a bad one, so we exchanged it, and the tech at the Auto Parts store said "Maybe you have a fuse out." We changed the stop light switch again, same problem. We found a blown fuse marked "stop light." It is a $2.70 fuse, 10 amps. We put it in, and the brake lights worked. I planned to put it in the shop the next day, having read that it could be the air inlet sensor, the throttle body needing cleaning, the transmission, the transmission fluid....anyway, I had to go to the store this morning, and the ABS light was out, the cruise control was working, and the car no longer ran in "limp mode."
Before you do anything else, change the fuse!
GTI 337/20th Anniversary :: Master Cylinder Is Sticking Somewhere Inside And Causing Pedal To Hang Up
Car: 03 20th with 6spd 02m trans.
Problem: Go out in the morning esp when really cold, and the clutch pedal drops to the floor. No resistance at all on it as if it's no connected to anything. I pull it back up and pedal starts to build pressure.
I thought slave cylinder searching on here shows a high probability of that being the issue. But the strange thing is the pedal feels like it's sticking at the midway point. Once pressure is built up to normal pedal pressure, if I opush it down and slide my foot off it, it will literally rise fast and the feels like it catches on something and pops to the normal top position.
So my thought here is that the Master cylinder is sticking somewhere inside and causing the pedal to hang up. The weird part though is that once the car is warmed up the problem starts to diminish. But if I drive long enough on the highway (not shifting gears) the clutch seems to start losing pressure all over again.
I have also had to top off the brake fluid reservoir about 3 times in 2 months. What is the root cause here?
Ford Super Duty (1999-2016) :: 2003 F250 - Cruise Control Does Not Work At All
Just bought a 2003 5.4 6 speed 4x4 F250 .. The cruise control does not work at all. The only fuse I can find in the owners manual is a 2 amp one .. it is in good shape .. Where do I look now to solve the problem??
View 8 RepliesHonda - Accord :: 2003 - Cruise Control Switch Will Not Stay Engaged
The "Cruise Main" switch on my 2003 Honda Accord will not stay engaged. When I push it, the Cuise Main lights up in the dash board and I can operate cruise control, but when I release the Cruise Main switch it doesn't stay on. I've tried electrical tape to hold the switch in (holds for limited time), and am thinking about bypassing the switch altogether. I don't mind if the Cruise Main is on all the time. I know I could replace the switch, but am looking for a zero cost solution.
View 1 RepliesFord 7.3L Power Stroke (1999-2003) :: Airbag Light On / Cruise Control And Horn Won't Work
Airbag light flashes on dash and then stays on. Cruise control and horn wont work. I cant find a blown fuse.
View 9 RepliesCivic - Honda :: 2003 - Cruise Control Does Not Work?
My cruise control does not work and the mechanic has diganosed the cruise control servo as the problem. The shop gave me an estimate of $700 (parts & labor) to replace it. Given the age of the car and the cost of repair, I am leaning towards doing it myself. I am handy with tools but have not done this type of repair before.
My question: Is there a downside to doing this repair myself. If I elect to do it myself, what do I need to watch for?