Ford - Explorer :: 1995 - Replaced Fuel Pump / Filter / Pressure Regulator / Crank Position Sensor But Won't Start?
1995 Ford Explorer, 4 ltr. engine, pushrod. Will not start. Replaced fuel pump, fuel filter, every relay, pressure regulator, and the crank position sensor. I realize there's a whole bunch more parts under the hood, but I am ready to give up. Before the fuel pump would not run. Reason for replacing the parts. Now it won't stop running and you can feel the fuel by-passing at the pressure regulator. When checking the pressure at the rail I get zero !! I used a tire pressure tester for this. And, like I said no pressure. This vehicle has around 170,000 miles on it.
View 8 RepliesGolf IV / Jetta IV :: Key Turn Itself To Off Position After Sudden Crank When Driving On Highway
Yesterday driving on the highway, i hear a sudden "clank" and out of the corner of my eye i see my key turn itself to the off position. which i think is really strange... my rpms went to 0 and everything died.
I pulled over, put it in park. I tried to start it but the key wouldn't turn cause it locked. So I took it out and tried again. It started just fine.
Ford - Explorer :: 2001 Won't Crank - No Click When Turn The Key - Dash Powers Up
My son has a 2001 explorer sport that he keeps at college. The vehicle sits alot more than it runs these days. Recently it some times does not want to start, no click when you turn the key. He got it home today, and after I changed oil, it would not start. I have no ground to the starter relay in the power distribution box.
I have no electrical schematics, where the ground for the starter relay comes from ? If I remove the relay and run jumper wires from the box to the relay, i can make the vehicle crank when i apply another ground source to the relay....but it just cranks, will not start.
Accent MC (2006-11) :: Hard Starting - Crank Position Sensor
2007 Accent GLS, US-market, Automatic, 140k miles
This is my wife's car. She called me from the side of the road while I was on a job out of town. The car had stalled while driving. She was able to re-start the car with check-engine lamp showing and took the car directly to a garage. It ran normally during that trip.
The garage diagnosed the problem as a failed crankshaft position sensor. They cleared all codes from the ECU without telling us what they were. My wife told them I would fix it when I got home. She drove the car home, parked it there and used my car until I got back.
When I got home, I replaced the crank position sensor with a new beck-arnley part. It was a poor fit, but it did go in. Now roughly every other start takes a few extra cranks. It always starts. It does not stall once started. No check-engine light since the initial episode. I just don't like the random hard starts.
Normal fuel consumption & power output. All other maintenance is up to date.
Elantra HD (2006-10) :: When Wipers Are Turn Off They Park At Up Position
When I turn my wipers off, they park or stop in the up position on the windscreen rather than lie flat at the bottom of the windscreen. Why this is happening and what the solution might be?
View 3 RepliesFord - Explorer :: 2006 - No Brake And Turn (Left / Right Blinkers) Lights
I have a 2006 Ford Explorer Eddie Bauer with Towing Package. I just recently bought a Trailer and when they tested my 7 pin plug, I was only getting Running lights and 12v Charging. Im not getting Left/Right Blinkers or Brake. There is NO power. I checked all Fuses. The problem is, I cant find the Blinker/Brake fuse. The manufacture book does not show one.
View 5 RepliesSonata NF (2006-10) :: 2007 / 2.4L - No Crank When Turn The Start Key
I Have a sonata 2007 2.4L automatic and I just had a start problem today. I turned the start key and nothing no crank, all the light in the dashboard are ok, i can hear the fuel pump and my batery is fine. I tried 5 time to start it and nothing I wait 10 minutes and the car started ..
View 10 RepliesAccent MC (2006-11) :: 2008 Will Intermittently Crank But Won't Turn Over
My 2008 Accent will intermittently crank crank and will not turn over. You can hear it trying to start but it seems like its not getting fuel. Then I will stop turning the key, try again and it will start. It may do this two or three times before starting. I have no codes.
View 6 RepliesFord Excursion :: Crank Position Sensor Location
Where does the CPS located on my truck? Knowing mine is 5.4 L 2000 model. 121,000 miles on clock.
View 6 RepliesAccent MC (2006-11) :: GLS Stalling At Stops / Engine Will Crank But Doesn't Turn Over Right Away
I have an automatic 2006 GLS Accent that is having a few problems. The engine will crank, but doesn't turn over right away. It might take a few tries, but will always start. This happens intermittently. Sometimes it will do it first thing in the morning, or sometimes it will happen later in the day after several start ups.
It has recently starting stalling while coming to a stop or sitting idle at a traffic light. This is also an intermittent problem. Always starts back up after a few tries.
The check engine light is not on. I have not taken it to a mechanic yet since it doesn't always do it, and will most likely be tricky to diagnose. What the problem might be? I was thinking it might be a crankshaft sensor?
Chevrolet - Colorado :: 2006 - Engine Will Turn Over But Not Crank / Start After 10 Minutes
Fuel Pump and Fuel Pump Relay replaced after 115,000 miles. On occasion, engine will turn over but not crank ... wait 10 minutes and the engine will start. No security light (passlock) or engine trouble codes displayed or recorded. Once the engine starts, it runs smoothly and normally. Problem of starting did not occur until the fuel pump and relay were replaced.
View 4 RepliesFord 6.0L Power Stroke Diesel :: Running Rough / Crank Position Sensor Codes
It's an 04 F250 with the 6.0, and has been there about five months now. The backstory I have been given is that it drove in running rough, gave crank position sensor codes, and the CPS was replaced. That was the last time it ran. Since then, it has had the CPS replaced five times, the FICM rebuilt then replaced three times, the engine harness replaced, and spent some time at Ford. It would only show about 30rpm while cranking. The engineer came and looked at it, said it must be the tone ring on the crank and that's it.
Here's where it's at for me: Cranking RPM peaked out at 57, but the fan rpm was about 180 while cranking and it sounded like it was cranking pretty quick. I disconnected the glow plug module, had another guy crank it while I gave it a quick shot of starting fluid, which it caught and started to run on. It sounded like it was running on fuel for a second, then shut back off and now cranks unevenly.
According to the owner this thing has seen lots of starting fluid in the course of diagnosing it, and there were no odd noises before it shut down so I suspect stuck valves from sitting so long. It did give me a whole bunch of codes which I will post tomorrow, including injector #4 high. I tried to do a buzz test but just got a message saying "unknown code, please wait" and then nothing.
Ford - Explorer :: 2001 - Wipers Do Not Go Into Rest Position
Heres the problem hi and low work fine but the wipers don't go into a rest position, they intermittently work sometimes but stop at the top of the rotation when I turn them off the stop wherever they were when I turned them off. I've replaced the turn signal wiper control switch and the wiper motor. (2001 explorer sport)...
View 2 RepliesFord - Explorer :: 2000 - Engine Continued Running Even When Key Is In Off Position
The other day I went to turn off my vehicle and it continued running even when key is in off position. I took the key out and it still continued running. I had to disconnect the battery and turn key in on position for vehicle to stall. I do not want to buy any unnecessary parts nor do I want to take apart any unnecessary components.
View 1 RepliesFord - Explorer :: 2000 - Engine Won't Shut Off / Running Even When Key Is In Off Position
The other day I went to turn off my vehicle and it continued running even when key is in off position. I took the key out and it still continued running. I had to disconnect the battery and turn key in on position for vehicle to stall. I do not want to buy any unnecessary parts nor do I want to take apart any unnecessary.
View 3 RepliesFord 6.0L Power Stroke Diesel :: 2003 F350 - No Crank / Does Not Even Try To Turn Over When Turn The Key
A month ago I got into my truck in the morning and when I turned the key to Run everything lit up like normal and after the glow plugs warmed up, I turned the key and there was about a two second delay between me turning the key and the engine cranking over.
The next couple times I tried starting the truck that same morning I had to try to start it a couple times because it wouldn't try to crank over the first couple times but it would always eventually start.
It's been continuing to give me problems but never stopped running once it was started and then this morning I tried starting it for 45 minutes with no luck.
What I have tried so far is:
Resetting batteries
Jumping the truck
Checked to see if the starter is getting power. ( I put wire testers on it while someone else started and I didn't get a good reading even when it did start. New starter was put in 9 months ago.)
I also made sure wire going to starter wasn't corroded
Battery terminals are also not corroded
Checked fuses
Tried starting truck with fan clutch disconnected
Cussing at it
Tapping starter with a hammer while trying to start it
Also, everything sounds perfectly normal when I turn the key, it just doesn't even try to turn over.
Ford 6.0L Power Stroke Diesel :: 2005 F350 - No Start / Crank Position And Cam Portion Sensor Codes
I have an 05 f350 6.0 that I recently bought. It was fine until a few weeks ago when it died while I was driving down the road. I pulled to the side and it started right back up like nothing happened and kept driving like normal. Skip to last weekend it did it to me twice but the second time it would not start so I plugged my programmer in and it showed p0336 crank position sensor and cam portion sensor codes (I can't remember the number of the second code) I have read a few posts that said maybe it's the icp sensor so I went ahead and replaced that with no luck. The batteries went dead from excessive cranking which I know isn't very good for my starter but I was getting a little upset.
View 11 RepliesFord Super Duty (1999-2016) :: Miss - Crank Shaft Position Sensor - CSPS Location?
I got an f-350 drw it is sluggish on take off feels like a miss. Higher speeds when you step on it. It seems o.k I have been told it could be a crank shaft positioning sensor any in put on this. I have changed the fuel filters, cleaned the e.g.r. valve and yes it was pretty clogged,air filter seems to be good. And 1 last thing for now where would c.s.p.s. be located...
View 4 RepliesFord - Explorer :: 1997 - Shaking From Inside When Car Is On Position D And Apply Brakes
I just got my first car: 1997 Ford Explorer XLT 130k miles, drives great and I drove like 1200 miles already, got balljoints changed but still have a problem: when car is on position D and i apply brakes it starts shaking from inside: seats, main console and steering wheel vibrating (kind of tough when i drive a lot). And one more question: how can i increase MPG i got 4.0L but it consumes a lot: 9MPG CITY and 16MPG HIGHWAY.....
View 8 Replies