Ford - Explorer :: 2002 - No Crank Just Click
2002 explorer 4.0l. No crank just click new starter in and cables hooked to battery...
View 1 RepliesFord - Explorer :: 2002 Won't Start Or Crank (even Manually)
I've been working on this explorer for a week now and I figured it's time to ask around. My explorer won't start/crank, I've replaced the starter, battery terminals, tested voltages/amps/relays and fuses, still nothing. All i get is a heavy clunk, like the starter is engaging but the flexplate won't budge. It's a 2002 4.0 xlt automatic.
I'm fearing the engine is seized as I've tried manually turning the engine with a socket on the crank pulley bolt and even with a breaker bar I can't get it to move. The thing ran fine a week ago and I can't imagine this thing would seize at barely over 100k miles, not hydrolocked or anything I can think of, are these engines prone for spontaneous seizure or am I missing something?
Ford - Explorer :: 2002 V6 - Long Crank Time Before Start
So my 2002 ford explorer with the 4.0 L V6, has been cranking along time before it starts. I thought i had this figured out already, i put a brand new fuel pump in it from the ford dealer. That seemed to work, but the problem came back.
Especially when it is cold, it cranks a lot longer than normal to start. and when it does start RMPS go way up briefly and come back down. Seems to only act up when its cold out, say 35 degrees and lower.
So the remote start wont work because it only cranks for a few seconds and then stops. it tries this three times and it gives up. i go out there to start it and cranks for 10 seconds it seems like, sometimes i have to feather the fuel pedal.
Ford Excursion :: 2002 5.4L - Truck Start With Starting Fluid But Will Not Crank On Its Own
Having some problems with my truck.... First off I bought a 2002 excursion and drove it for one day. Then I was at the car wash cleaning up the truck. Then I saw the window fogging up so I turned the car off. Now it won't start.
I had previously installed a new stereo, but had some problems, so I ran the remote wire to the fuse box, because the wire in the harness wasn't getting power.. So after a little trouble shooting we found out that the fuel pump wasn't working or was bad.
We replaced it, now it has pressure but will not start, will start with starting fluid but will not crank on its own. someone told me it may be a bad PCM? and a dealer can only replace it... I don't have tons of cash, as i bought this truck on 8/30/12 and this happened the day after i bought it.
The previous owner has paid or the fuel pump replacing but I don't think its right on my part to have him pay more money as this may be a mess up on my part with hooking the radio up to the fuse box... we have tried the fuses,realys, crank sensors...
Ford - Explorer :: 2002 - Won't Start / Crank Till Battery Dies But Is Not Getting Fuel
I've got a 2002 Ford Sports Trac that won't start ! It will crank till battery dies but is not getting fuel. I have had it towed 4 times in the past year. of the 4 times,this last time it wont start. Every time that I have had it towed back to my house and dropped in the driveway it has started up with no problems. It will run for a few months or more.This last time it would not.
Could this be an electrical problem.Maybe loose ground somewhere or something else. Would like to rule out some things before investing in a fuel filter or fuel pump. Would hate to buy new FuelPump and that not be the problem. Can't find free wiring diaghrams for this issue.
Ford :: 2002 Explorer - RPMs Going Up And Down And Ultimately Truck Died
I have a 2002 Ford Explorer and besides the seemingly oh-so-common annoying crack in the tail gate, I have another issue I consider to be major. Recently, on a short trip to the store, I hit an incline in the road of a slight degree. At this point I noticed the RPMs going wildly up and down and ultimately the truck died. I tested this out on a few drives and what I've noticed is that if I'm on a flat surface, the truck seems to be okay. OR if I do hit an incline, either lifting of the gas or powering through it seems to work...although neither of which is a long-term solution. I just lost my job a couple weeks ago and the idea of taking it to a mechanic scares me as I'm very limited on savings. I don't really know where to start.
View 6 RepliesFord - Explorer :: 2002 - Shudder In First Gear / Truck Shifts Into 4wd By Itself And Stays There After New TCM
Replaced the 2002 ford explorer 4x4 traction control module because of a shudder in first gear. With the new module the shudder disappeared but now the truck shifts into 4wd by itself and stays there. I am now on my 2nd new module because I returned the first one thinking it was defective.
If I cycle the 4x4 high switch and the 4x4 auto switch, the truck switches back int 2wd but on for a moment then goes back into 4wd. I don't get a 4x4high indicator light but I can hear and feel it is in 4wd. Almost like it thinks the truck needs work with the traction. I have now disconnected the module completely and the trucks runs/shifts beautifully in 2wd. I know my transmission is good. BTW, I have no trouble codes.
Do I have a bad speed sensor somewhere? and How do I trouble shoot for it?
Explorer :: 2002 V6 Crank Then Completely Stops / Starts Cranking Again And Fires Up
I have a 2002 Explorer 4 door with the flex fuel V6 engine with 157k miles. This has happened twice in a month. You got to start the truck and it starts to crank for a second and half and then it completely stops for a half second and then starts cranking again and fires up. The kicker is after it did this the instrument gauges, all of them, stayed at nothing when it started and then they all at the same time went to the highest level and then they all dropped back down to nothing and then rose to their perspective positions. My trip gauge reset it self to zero as well..
View 3 RepliesFord - Explorer :: 2002 - Truck Having Hard Time Going Into Reverse Intermittently / Trans Slip In Normal Driving
He has a 2002 Explorer 4.6. The truck is having a hard time going into reverse intermittently, hard shift in normal driving and thinks it has slipped in first gear going up his driveway that is steep. He is worried that he put slightly over sized tires and this may hurt his tranny. The overdrive has blinked twice with in the year. Possible problems that could create this he is thinking solenoid pack, servos, torque converter. The truck has 110k and never done fluids, Would lucas slip fix or hurt we have heard that these tranny's are finicy.
View 1 RepliesFord - Explorer :: 2001 - Crank But Not Firing?
Been battling this for several months. Sometimes, the truck will crank but not fire. Several attempts, then apply gas pedal, eventually will start. I have read through and searched much of this forum. Let me start with this, every part I have replaced has been with Motorcraft parts. I have done the following:
1. Replaced IAC. Ports are very clean.
2. Replaced fuel pump & filter.
2. 5 Voltage at pump connector is good AND it lights a heavy bulb. Not losing voltage to pump.
3. Replaced MAF sensor. This changed it. Stopped doing the no start for about one month. Then began doing it again.
4. Replaced MAF connector, soldered in a motorcraft connector. Good for 3 days.
5. Have checked connector pin tension and condition at crank sense. Good.
6. No codes.
7. Always shows RPM on scan tool while condition is present.
8. Once it starts, it never dies, not rich, not lean. Fuel trims are great and runs mint.
9. Technician is now in loony bin.
Ford - Explorer :: 1994 - Hard To Start Up / Just Won't Crank
We have a 94 ford explorer and every now and again it has issues on the start up. It will sound like it will want to crank over but just won't. If we wait 20 mins it will start up no problem. We have changed the fuel pump, fuel filter, ignition coil, and fuel pump relay but it still has this problem. Also occasionally the a/c blower wont turn on. Tonight it happened again and I pulled the fuel pump relay out and it was really hot, after it cooled down and was put back in the car started. I am beginning to think it maybe an overheating issue that is affecting the relays but am not sure. I was also wondering about changing out the relay box...
View 6 RepliesFord - Explorer :: 2001 Sport Will Not Crank Nor Start
I have an Explorer Sport 2001 that will not crank nor start. I have replaced the following:
Crankshaft, camshaft sensors
Ignition coil
Ignition switch, neutral safety switch
Fuel filter
Fuel pump
Starter
The battery is less than 6 months old .. Still, the car will not crank, will not start. I have spark, voltage and fuel.
The PCM does NOT communicate with the scanner. I purchased a used PCM off of eBay. This one does communicate with a scanner and gives the following DTC codes:
P1120-- Throttle Position Sensor out of range
B1601-- Unprogrammed Pats Key
Since the car is in the Caribbean I can't tow it to a dealer.
Ford - Explorer :: 2006 - No Crank When Turn The Key To Run Position
My wifes explorer will not attempt to turn over. When I turn the key to the run position the dash does not do anything. I dont get any indicator lights or anything from the dash. And also the PATS light in now a steady dim light. So now I am confused and don't know where to start on this one. Is this a PATS issue or is my instrument cluster the problem? I did read the TSB on the cluster.
View 2 RepliesFord - F150 :: 1997 Truck Won't Crank Or Start
I left the keys in the ignition last night. I didn't think it was left on, but apparently it was. This morning when I tried to crank the truck, it wouldn't start. The dash lights came on, but it didn't make any sound. I tried to jump it off, and it still won't turn over. What it could be??
The truck that wouldn't start was a 97 Ford F150, the car I was trying to jump it with was a 96 Honda Civic. Someone told me that might be the problem, that the small car wouldn't give enough power to a truck...
Ford - F150 :: 1987 - Truck Won't Crank After Going Over Sidewalk
I have a 1987 ford F150 302 we were ran off the road and went over a side walk. When we came to a stop the truck cut off. The truck was towed back home and have been unable to crank it since then. We have checked the inertia switch, checked the firing, and changed plugs in it. The trucks will turn over but won't crank.
View 5 RepliesFord F-150 - 1997-2003 :: Truck Will Turn Over But Won't Crank
If I turn on my ignition switch and my gauges go to where they're supposed to be, the truck will crank. If I turn switch and , lets say gas needle for example, the needle goes to full then drops back to empty, the engine will turn over but will not crank.
View 2 RepliesFord - Explorer :: 2004 4.0L - No Start / Crank Rough Like A Few Cylinders Are Zero
Picked up a super nice 03' as is with a no start. It cranks over nice and smooth, sounds like it has proper compression, and has proper fuel pressure. Tried spraying either in it and it will almost catch.
Tried putting a known good coil pack on it, no dice. Usually when other engine slip timing chains, it will crank rough, like a few cylinders are zero. This is not the case.
Ford 7.3L Power Stroke (1999-2003) :: Truck Will Not Crank Over
Started truck 3 times in 30 min. no issues with truck before tonight nice well cared for truck. Went to get a pack of buns at store came out --NO CRANK--all lights are on dash, etc, new starter a month ago, relay changed out in fuse panel just to see if there was a change. Bought two new Motorcraft batteries installed , NO CHANGE, so is it natural safety, key switch, electrical ignition switch, solenoid on starter, is there a solenoid between key and starter?
View 12 RepliesFord 6.0L Power Stroke Diesel :: 2006 Truck Would Not Crank At All
So I went to start my 2006 this morning and it would not crank at all. Like the battery was dead ( all the light in the cab and headlights were working fine. ) so I tried to jump it and still nothing no clicks not crank no nothing. Just for fun I went ahead and jumped the starter (using the same method as when I prime the hpo system) starter cranked no problem so I put the key in the on position and cranked the key again still nothing. So I put the key in the on position again and jumped the starter truck fired right up. So I went back in the cab and tried to start it with the key and it started right up like nothing ever was wrong. What was causing this? Also my voltage was at 11.5 with the key on and engine off when it was running the volts were at 12 to 12.5
View 5 Replies