Passat (B6) :: Metallic Sounding Clunk Front Right When Went Over A Bump
I had my brakes done almost two weeks ago and last week I noticed a metallic sounding clunk front right (I think) when I went over a bump. It's hard to replicate but I've heard it a few times. On the weekend I reversed and heard that same clunk. When I went forward slowly, I could hear a sound that can only be described as a few screws in a rotating soda can. When I sped up, all sounds disappeared.
I took it to my tech yesterday on the way home. He found a bit of a loose fit between the new caliper and what it attaches to, which he fixed. However, the sound persists. Tech said all suspension components seem tight and normal.
Ford Excursion :: Front End Pop / Clunk Through Steering Wheel
On my way home from work I was turning a corner and felt a pop / clunk from the front end through the steering wheel, and the steering wheel was no longer centered going in a straight line.
With the truck not moving, when I turn the wheel left and right, I can hear and feel a pop / clunk through the steering wheel. I'm assuming this is a ball joint failure?
Ford Excursion :: Grinding / Clunk Noise And General Loose Feeling From Front End
But I'm still getting a grinding/clunk noise and general loose feeling from the front end. The only play I can feel is when I grab the u-joint/knuckle and pull up and down on it. I also noticed the seal at the end of the axle shaft tube is not there on 1 side... would this lack of seal cause the looseness?
View 9 RepliesFord Brakes/Suspension :: Steering Very Sloppy / Front End Wobbly At A Low Speed
I have a 2002 ford f350 sd crew cab, i have changed the front and rear brakes, since then the steering has gotten sloppy. I was driving around 30-40mph and making a sweeping right turn and the front end was wobbly at a low speed it is fine and on a left turn it is fine. It feels like it is the drivers side tire that is the problem. I have to change the tie rod that is attached to the pitman arm. I don't want to bring it to a shop.
View 7 RepliesFord Super Duty (1999-2016) :: 2001 Excursion - Front End Clunk When Went Over A Significant Bump
I bought this truck a little over a year ago and have put almost 30,000 miles on it. When I bought it, it had a clunk from the front end, but only when I went over a significant bump. It was most pronounced when I, for example, hit a speed bump at an angle and the body rocked back and forth. It's steadily been getting worse and now it's fairly concerning. It happens on pretty much every bump now. Additionally, I've developed a fairly significant shimmy under braking and a vibration over 65mph. I got into a fairly scary shimmy when trying to slow down as I was going down a mountain a few weeks ago.
The other day I started getting a grinding noise from the front right. It goes away when the brakes are pressed. I don't know if the grinding noise and vibration/shimmy are related to the clunking or if they are the result of a separate issue. I have plenty of brake pad and rotor on all corners and there is no perceptible play in any of the front end components (wheel bearings, ball joints, tie rods, shock mounts, etc.). I suspected the leaf spring bushings, but I supported the truck by the frame and still got no noticeable play when jerking things around by hand.
Pontiac - G6 :: Clunk Sounding Noise When Turn The Steering Wheel
This car has a V6 engine with 50000 miles. Nearly every time you turn the steering wheel you hear a clunk sounding noise. This has been going on for quite some time now. A mechanic said this is a common problem with this car. 2008 Pontiac G6....
View 2 RepliesDodge :: Clunk Or Heavy Sounding Thump Under Very Light Acceleration At 2 - 3 Upshift
I have a '74 Dodge B-100 van, 318 V-8, with a 3-speed A727 TorqueFlite tranmission (which was totally rebuilt about 20,000 miles ago). Overall, this old baby that we call "Blue Thunder" is in almost pristine condition. It starts well, runs great, and over the years has been highly reliable. It's been in the family for almost 38 years and is special to all of us. I've maintained it extremely well from day one.
Here is the big problem.....under very light acceleration at the 2-3 upshift, it makes a loud-sounding and aggressive-feeling "clunk" or heavy sounding "thump". Under hard acceleration, or accelerating on an upgrade (hill), it does not make this sound at all and I do not feel or hear it at all. There are no other accompanying symptoms such as whines, roars or vibrations. I recently took it to a reputable (in business for 35 years) transmission shop recently with the above problem description. He checked the fluid and adjusted the kickdown band. This same shop had serviced the transmission a year earlier. He recommended that I let him him take it to a general auto repair shop down down the street for a diagnosis on the "loud clunk" ....as he did not think it was a transmission problem.
I agreed for him to do so since, the shop "down the street" is also known for quality repair work. The written problem description was sent aong with the van. In a week or so, the auto repair shop called and said all they could find was a little wear in the spider gears in the rear differential. I gave them permission, since the differential was already open. to replace anything that looked like it needed to be replaced. It took a while to get the parts, but they replaced the spider gears, both side bearing cups, and 1 of the differential bearing adjusters. Of course the work included new gear oil and gasket for the differential cover. It was an onerous bill, but I didn't complain, thinking that the terrible "clunk" would be gone. I picked up the van and immediately noticed no difference at all. The loud "clunk" was still there under the exact same conditions.
I took it back and asked the owner to ride with me where upon I easily recreated the "clunk" by accelerating very lightly. He said, "Oh, that's in the transmission, because it's only makes the sound when it shifts from 2nd to 3rd gear". I called the transmission shop back and they want nothing to do with it....saying that a noise like that one is practically impossible to pinpoint. He said even if the transmission were rebuilt, he cannot guarantee the noise would not be there. Both shops say the U-joints, yokes, engine mounts, and transmission mount all look OK.
Ford Excursion :: Running Really Bad / Misfiring / Smoking And Sounding Real Rough
So Friday before last my ex laid down on me while i was headed to work. So I parked it in a walmart parking lot and caught a ride to work with a friend then had it towed home that evening. Problem i was having is it started running really bad, miss firing, smoking, and sounding real rough, but I wasn't getting any trouble codes. So after both uvch's, icp, ipr, icp pigtail, checking fuel for water contamination and pulling my hair out, i decided to check the oil and found it to be 4 quarts low. Talk about feel like a knuckle head.... While it was down it did receive a new water pump, a diesel site 203* thermostat, new billet thermostat housing, Gooch's Radiator Flush Procedure, and some fresh rotella etc.
View 5 RepliesPrius (2004-09) :: 2008 - Front Brakes Are Wobbly?
As I am coming to a stop it feels as if my front brakes (feels like it is coming from front right of the car) are "wobbly." There is a noticeable unevenness in braking force, it gets stronger than weaker, and as the car comes to a stop (this is with friction brakes applied), the car almost feels like it is hobbling. It's feel is similar to having misaligned brakes on a bicycle wheel.
I have no issues at any other point whilst driving (besides ratcheting clank, also suspected from front right). I still get 50+ MPG, and front pads were at 6 MM as of last service, due in 700 miles for next service. Car is a 2008, currently at 113,000 miles - new tires @ 95K, 4 wheel alignment @ 95K.
Online searches have said there could be a number of culprits: warped rotor, loose rotor, bad bearing, CV joint.
Ford Excursion :: Horn Started Sounding On Its Own / Cruise Control Stopped Working
I have a 2005 Excursion 6.0 ... .. A few months back the horn started sounding on its' own in the night, so I pulled the fuse... .. Then the Cruise Control stopped working. I have googled references to clockspring failure and these problems... ..
View 3 RepliesSonata I45 (YF - 2011+) :: Squealing Front Right Tire And Wobbly Ride
I have a 2014 Sonata GLS with only 4200 km on it, purchased new in August 2014. The car has been flawless...until yesterday. I took the car for its first oil/filter change and asked them to check tire pressure at the same time...this was at a Hyundai dealership, btw.
I left the dealership and immediately noticed that the car was swaying and more wobbly than normal (i can make it bounce from side to side by moving my body in the driver's seat), and when I make a right turn there is an awful squeal from the right-front tire.
I've done some online research today but couldn't get back to the dealer before they closed to look at it. Most posts I've read point to under inflated tires, but there are others that say wheel bearing and more.
Ford 7.3L Power Stroke (1999-2003) :: Loose Sounding Rattle In Front End And Thud During Braking?
I picked up a 2000 4x4 F250 on Saturday.
The truck rides pretty good but on bumpy roads there is a loose sounding rattle in the front end. Also when applying the brakes there is a thud in the front drives side. You can feel it in the drivers floor board a little. Once you start braking about halfway to complete stop is when the thud is, if that makes sense. I suspect bushings but how do I know which ones.
Ford Excursion :: Brakes Sounding Like Metal On Metal
The brakes were sounding like metal on metal. Three wheels in, some of the pads needed replaced but none were worn out. I got to the right rear wheel and the inside pad is worn to the bracket but the outside pad hardly looks worn at all.
I'm already replacing rotors, pads and calipers (I wasn't going to replace the rear rotors or calipers until I got to this wheel). Is there anything else I need to check because of such uneven pad wear?
Honda - Pilot :: Low Sounding Rattle In The Front End
Over the past few months I have been hearing a low sounding vibration that seems to be coming from the drivers side front. It only seems to happen when I am driving on a straight road, but not on the highway. Recently, I have been hearing the sound more frequently and within the last month the front end has been shaking. I took it to a mechanic and he told me that the front sway bar links were broken and the rotors were warped. He said replacing both of these (and the front brake pads) would eliminate both problems. $700 later and not 5 minutes down the road, the low sounding vibration came back! I've been paying attention to when I hear it and it happens on a straight road just as I am approaching 40 mph.
View 3 RepliesHonda - Accord :: Metallic Sounding Clank Coming From Front Wheels
I own a 2003 Honda Accord with approximately 90,000 miles. I've noticed a metallic-sounding clank coming from what sounds like the front wheels when I go over all potholes and road imperfections (which are frequent in NY). Additionally, if I travel over the same potholes or road imperfections while on the brakes, there's no noise. More recently, I've noticed an additional noise. If I am traveling at a slow speed, such as parking or driving in a fast food drive thru, I'll hear a loud clicking coming from the front wheels as they turn, when I have the wheel turned.
View 3 RepliesFord Excursion :: 2003 - Noticeable Clunk / Won't Go Into Reverse
On my 2003 6.0l Excursion, the 5R110 is having some issues with reverse lately. Sometimes when you put it in reverse it doesn't actually engage. The only way to make it "fall" into gear is by giving it a little fuel, which then sends it into reverse. Now here me out, I'm not hitting 3,000rpms when I do this, just a light raise in rpms will get it in gear. Solenoid issue, possibly?
I haven't noticed if it does this when it won't go into reverse or if it does it no matter what, but it will make a light clunk when going forward after using reverse. A very light, but noticeable clunk. Is this most likely a U-Joint related issue? Got under it and moved the driveshaft around, didn't notice any play at all, but perhaps I wasn't checking properly (wiggling it left and right).
Excursion is RWD (2WD) and has right around 183k miles on it, acquired in October with 172k miles, so not positive on previous history of the transmission. Also I know my gear selector mount is broke, so it cluster is off, but I certainly don't think that, in of itself, is the cause of my issues. Maybe I'm wrong?
Ford Excursion :: Sway Bar End Links / Loud Clunk
I've been having the loud clunk under the drivers side floor, that many others have as well. Did many hours of research and replaced the sway bar end links. Napa only had the left side in stock so I did it first last weekend and did the right side this weekend. One thing I noticed when doing the right side was the hole in the frame was all wallowed out. Drilled out the bushing in the upper end link and used a bigger bolt to fill the gap up. went for a drive and the clunk was way worse than it ever was still on the left side. So I took off the left one and went for a drive. Sure enough no clunk, the left one was wallowed out as well. So I did the same thing on that side and the evil clunk is finally gone. Just thought I would throw that out that if have a clunk after replacing the end links, Check the upper holes.
View 14 RepliesFord Excursion :: 2002 - Clunk Sound In Rear?
I did a search and most of what I found is about front end/middle body flex, not rear end "clunk" noises.
Bushings?
I'm already planning on replacing all four shocks.
Ford Excursion :: Clunk Sound From The Back Of Vehicle Intermittently
Went for a drive last night in my "new" 2002, 4wd and which brought up some newbe excursion owner questions. First of all it has 95,000 miles on it and it is a V10. I noticed a clunk sound from the back of vehicle intermittently. u joints?, rear springs? or rear end?
Noticed that the front springs looked like they were sagging, is this normal or do I have an excuse to lift it? Also the shocks appear to be the original units and I figure that they are going to be on their way out. In the past I had good results with KYB gas-a just on a old F250 2wd.