Ford Super Duty (1999-2016) :: Clunk At Rear End When Hit A Bump
When I am driving and hit a bump in the road, especially when the rear tires contact it square. I hear a clunk at the rear end. Sounds like suspension, loose tailgate...
My truck is a 2016 F250 Crew Cab Short Bed. It has a factory installed fifth wheel hitch. I have looked at the obvious, spare tire, loose bolts... I removed the tailgate and it still makes the sound. I removed the insert in the receiver, still makes the sound. No goose neck ball in fifth wheel hitch. Checked bed bolts. Cant find it. Drives me crazy.
I also have a 2008, exact same truck, 200,000 miles, no clunking. I have driven in my friends 2014 F350 Crew Cab Long Bed, it clunks. Dealer pulled a new truck off the lot today, took a drive, it clunks. Dealer can't find it and confirms there is a clunk.
Ford Super Duty (1999-2016) :: Significant Shake In The Front End
My truck is a 2000 F-350 (with front leaf springs). It has developed a significant shake in the front end. I have read much information about "Death Wobble," but I am not sure that's what my problem is. The truck shakes back and forth and the steering wheel moves what feels like several inches as well. I have already replaced the tie-rod and drag link, thinking this would solve the problem. The truck seemed better at first, but the shimmying came back.
The reason I replaced those particular parts was that I noticed the heim joints at both ends of the drag link had a lot of play in them. So, now I am trying to re-diagnose the problem. With the wheels off the ground, I cannot detect any play in either wheel when I try to move the tire by grabbing it at the top. I did notice that there is 1/4'' to 3/8'' of play in the steering box arm that connects to the drag link.
I am not sure if this is normal or not. The truck has a little less than 150,000 miles on it, so I am sure several different parts could be worn. However, after examining it quite a bit, I cannot see any obvious problems.
Ford Super Duty (1999-2016) :: 2000 F350 Front End Vibration When Hit A Little Bump On The Road?
2000 F350. 4x4, V10. 153,xxx miles. Here's the story. Whenever I hit a little bump in the road, I get a vibration directly under my feet and in the gas pedal, NOT in the steering. It will go away pretty quick or when I hit another bump. It only happens when the front driveshaft is not spinning. Hubs locked in in 2WD, it doesn't vibrate. Hubs unlocked and in 4x4 High it doesn't vibrate.
View 8 RepliesFord Super Duty (1999-2016) :: 2010 F350 - Front End Shakes Violently When Hit A Bump
Problem: 55-60+ mph hit a bump front end shakes violently. Slow down to 40 mph it stops. DOES NOT happen every time, and may only happen once a week, but when it does my whole front end feels like it will come loose.
Solutions to date that have not worked:
1. Rotate and balance tires. (tire shop)
2. New shocks. (me)
3. New steering stabilizer. (me)
4. Changed ball joint and bushing in track bar. (Dealership)
5. Check ball bearings and seem to be ok. (me)
6. Check tie rod ends and are ok. (Dealership)
The only other options people have given me:
1. Dual Steering Stabilizer. (Have had truck since Jan and hasn't done it in about 19,000 miles. Why would it need it now? Truck has 109,000 miles on it.)
2. New tires. (If it were the tires wouldn't it do it all the time? )
Ford Super Duty (1999-2016) :: Front End Clunk - Tie Rod Rotation?
2009 F350 4x4 DRW. Just replaced rod ends, drag link, sway bar bushings and end links, ball joints, and shocks. I have a clunk when the axle travels downward on bumps. The only thing I see is that the tie rod assembly will rotate easily by hand and I can make it clunk when I rotate it. It does not rotate in the ends, the ends rotate with it. Thinking this may be flopping around over a bump. Does tie rod rotate easily?
View 14 RepliesFord Super Duty (1999-2016) :: Terrible Noise When Hit A Bump / Front Axle Shaft Removal
I have a E99 F350 7.3L 4x4 I know some or most of you have already probably replaced this part and or pulled a front axle shaft out. So here is my question...In the pictures provided you can see what I think everyone is calling a "Dust Seal" and as you can see it is bad and making a very terrible noise when i hit a bump...I was wondering what parts I would need to replace this seal? I tried looking it up and just get lost in all of the other things....I have found write-ups for the axle being removed while changing ball joints but none by it self to just replace this seal.
[URL] ....
Ford Super Duty (1999-2016) :: Front Driver Side Wheel Making Clunking Noise When Hit Bump?
My front driver side wheel is making a clunk noise when I hit a bump. I replaced the wheel bearing hub assembly and discovered both axle seals were bad.
View 10 RepliesFord Super Duty (1999-2016) :: 2000 F250 - Clunk In Front / Leaf Springs Bad?
As the title says are my front leaf springs bad? I got this truck 2 years ago and replaced all the ball joints, shocks, sway bar links,front hubs, rotors and brakes along with all the seals. I have a clunk in the front and I can't figure out what it's coming from. Could my leaf springs be clacking together? Truck
is a 2000 F250 SD v10.....
Driverside front
Rear spring
Ford Super Duty (1999-2016) :: 2001 F250 - Rear End Slip / Bump When Initially Starting From A Dead Stop
I am experiencing what feels like a "bump in the rear" when initially starting from a dead stop. It feels like a car behind me tapped the bumper or that the truck "hunkers down" first, then moves. Tranny seems fine also. Once moving, there is no problem whatsoever. There atre no noises, leaks, or other symptoms. Also, when coming to a stop, it feels the same way just before the truck completely stops. If I drift forward a little, then apply the accelerator, it does not "slip" or hunker down.
Took it to the dealer and they claim that they can't find anything wrong and may just be the suspension releasing? The truck does this whether loaded or not?
2001 F250 CC Lariat SB 7.3
Ford Super Duty (1999-2016) :: 2006 F350 - Clunk In Left Front End - Radius Arm Bushings Bad?
I drive a 2006 Ford F350 4x4 Crew Cab. I think the radius arm bushings on my truck are bad. I get a clunk going over bumps on the left side in the front end.
I'm assuming it is the bushing in the rear of the radius arm, but I haven't taken it apart yet because I want to have the parts in hand. I ordered a bushing, part number 5C3Z3B203AA. But it looks too small when I hold it up to it. What is the part numbers for the radius arm bushings?
Or am I looking at the wrong thing for the clunking in the front end? I just did the ball joints with Moog both sides top and bottom. The shock bushings look alright. I have replaced the front sway bar bushings thinking that was it. What else could it be?
Ford Super Duty (1999-2016) :: 2002 F250 - Clunk In Front End / Felt In The Floor And Steering Wheel
I have a 02 F250 4x4 5.4. As I drive and when pulling into a driveway I hear a clunk that can be felt in the floor and the steering wheel. I've replaced the wheel bearings and seals, shocks, ball joints, sway bar links and bushings, tie rod ends at the gear box and "right hand inner". The other two tie rods are tight and so is the track bar. I cannot duplicate the sound if I jack it up and move parts around with a pry bar. I can however move the steer box sector shaft upwards about an 1/8. I've adjusted the screw but it didn't do anything. Could it be the steer box or the springs? I've even mounted a GoPro underneath but everything moves and I can't tell why it is.
View 14 RepliesFord Super Duty (1999-2016) :: 2007 F250 - Front Wheel Clunk When Turn Sharply In Either Direction
2007 F250 4WD 5.4l ... when I turn sharply in either direction I am getting a light clunk sound similar to when you are in 4WD on blacktop and try turning. The engine also seems to wanna stall when I cut the wheel too sharp.
View 4 RepliesFord Super Duty (1999-2016) :: 2005 F250 - Significant Reduction In Power After Hooking Up
I've got this 05 F250 5.4 liter V-8 w/ 118K miles on it. I've noticed a significant reduction in power after hooking up my 24' enclosed car hauler to move some furniture to a new house. I mean this has turned into a real dog.
It has a new serpentine belt, a new fuel filter in last 4 months, new air filter, recently started using Lucas Upper Cylinder lube w/ injector cleaner.
It does have a cracked R exhaust manifold which is being replaced in two weeks but it's not too loud at start up.
I mentioned this loss of power while have the belt replaced this morning and he thought without looking at it, it could be a failed camshaft sensor.
Ford Super Duty (1999-2016) :: 2003 Excursion - Cracked Front End Part
I was just in the middle of doing the V Code leaf spring swap and noticed a broke part where the u-bolts sit and what looks to be attached to the trac bar. The piece is broken in half and I am not sure how this happened or when. The piece is welded to the axle.
2003 Excursion 4x4 6.0...
Ford Super Duty (1999-2016) :: Spark Plug Replacement On 2001 Excursion
So my 2000 F250 has 182k and I am not sure when plugs were changed. Its got the 5.4. My 2001 Excursion has 102k on the v10 and I've read a few threads about blowing plugs and now I am scared out of my mind. Do I need to worry about breaking them or stripping anything?
View 6 RepliesFord Super Duty (1999-2016) :: 2001 Excursion Won't Start Unless Jump The Starter Relay
I have a 01 Ford excursion 7.3 auto and it will not start unless you jump the starter relay, I have replaced the starter, starter relay and swapped out batteries from my 2000 F250 auto, not sure what to do and this is my daily driver. Not sure if this matters but just had the transmission rebuilt. I have tried searching other threads but still not finding what I need. Once it starts it runs and drives. When you turn the key you hear a click like a relay is engaging and all of the lights and gauges work it just won't start with the key.
View 2 RepliesFord Super Duty (1999-2016) :: Thump / Bump While Accelerating
So lately I have noticed that my 99 F-250 has a bit of a "bump" while accelerating. Think of it as accelerating with a trailer and something is loose on the hitch, making a sort of bump or thump. I talked to the guy at the parts store and he said to put it in neutral and wiggle the driveshaft up and down, side to side.
When I did that it moved up and down, but not side to side, but I'm not sure if that's because it's just positioned that way or what. The wobble was coming from the slip yoke back by the rear diff. Is this something I should be concerned about? Also, I have an ext. cab and short box, 1 piece driveshaft.
Here's a video (a very crappy video at that), not sure if it gets enough info through or not but hopefully you kinda get how much play is in there.
Ford Super Duty (1999-2016) :: 2001 F350 - Front Rim Broken?
Tonight I went to check the air in the tires on my 2001 F350 Dually and saw that the front right rim is broken. Two of the five spokes are completely broken all the way through. So this means I am looking to buy at least one good stock rim for the front. Might buy two if the price is right. Didn't want to spend the money for 4 custom rims right now unless it is really a super deal. If you have some sitting there in your way send me a message. My Zip is 46347.
View 4 RepliesFord Super Duty (1999-2016) :: 2001 F350 - Front End Bottoming Out
I have a 2001 f350 super duty with the 7.3 diesel. It seams lately I'm noticing the front end seams to be taking a beating when going over bumps or rail road tracks. It feels like the front is bottoming out. I replaced the shocks in april, and just recently replaced the sway bar links to see if that will work. My thought is the front springs have lost there arch, but I'm not sure. They do look like there almost flat. Don't know if this is a problem on other trucks.
View 8 Replies