Ford Excursion :: P0720 Code - Output Shaft Speed Sensor
Okay, I have a P0720 code. I bought the Output Shaft Speed Sensor and read that it is on the back end of the transmission.
Need to confirm that it is on top of the transmission, near the tail end? Why are parts that go bad always in the most inconvenient places?
Ford Transmission :: 1998 F250 - Code P0720 For Output Speed Sensor Circuit - No Reverse
I bought late 98 F-250, 5.4 G, 4WD. OHad to replace the steering flange because they messed up the ignition cylinder and flange. Truck didn't run for 4 years. 249K miles, no history available. Got the engine running, no DTCs. D, 3, 2, 1 barely moved the truck forward but, R hauled butt in reverse. Checked transmission fluid it was good and clean.
Came back to it a few days later it threw a P0720 (output speed sensor circuit) and I have no reverse, park feels like it wants to move, R is neutral, N is forward, D is forward, 3 is forward, 2 is forward, 1 is forward. The N is full drive. I cleared the P0720 code after it came up and it has not returned. The instrument gauges work but the odometer display is intermittent. Linkage? Fluid? Sensor? Wires?
Accent LC (2000-05) :: Code For Output Shaft Speed Sensor - Transmission Rebuild
I had a rebuild done on my 2002 Accent. My question is now we get a code for the output shaft speed sensor. Would this have been replaced as part of the transmission rebuild?
View 2 RepliesSanta FE SM (2001-06) :: 2004 - CEL Code P0720 / Bad Output Sensor
My hyundai 2004 sta fe awd 3.5 LX engine light came on while cruising dwn the freeway. At the same same time i heard a loud thud and speed went down from 65 to 40mph and a high idle. I drove it home and hook up the obd2 scanner and got P0720 suggesting bad output sensor. So I decided to buy new sensor from the dealership, put it in and thought it will fix the problem. After few days the engine light came on (P0720)again with the same clunk noise and speed down from 65 to to 40 mph at high rpm. Took it home, did some experiment by putting back the old sensor. I Connected the harness back, but this time I wrap the female connector with the electrical rubber tape and electrical vinyl tape. Problem fixed. No more engine light,transmission shift smoothly. I think the connector (harness side) to the output sensor was crack that's why its not making good solid connection. The rubber tape technique held the female connector pins tightly together. New part didn't do anything but it was a learning experience.
View 1 RepliesFord Excursion :: Code P0720 And Engine Stall / Transmission Or Stray Voltage?
Long time Ex owner. This is my second 2000, 4wd, Limited, 6.8 V-10. Just bought this one last month and after two weeks of local driving the following problem showed up:
1. Week of July 5 through 11: With vehicle cold (65*) started and placed in reverse to back out of garage. After slight movement engine stalled like a locked up torque converter or turning ignition off. CEL illuminated. Turned off ignition and restarted. Again in reverse had same stall. Third time no problem but CEL still on. Code is P0720 using "Actron Auto Scanner."
2. Erased Code P0720 (OSS circuit malfunction) and P0307 (Cyinder 7 Misfire Detected). Drove car approx 20 miles without incident. No stumbling, no vibration, no detectable misfire, shifts okay, speedometer okay.
3. Next day with vehicle cold, started to back out of garage and stalled with CEL illuminated and O/D light in shifter blinking. Recycled ignition, started and no O/D light but CEL still illuminated. Vehicle did not stall. Checked code and P0720 set.
4. Replaced OSS on tail shaft of transmission. Same stalling problem with P0720 set.
5. Replaced #7 COP w/aftermarket type to test possibility of bad COP because of earlier P0307 DTC. Same problem exists, first start of the day the vehicle will stall as soon as it starts to move in reverse.
6. Replaced rear ABS sensor. While doing so noticed the ABS sensor wire harness was rubbing the tailpipe and the split, wire conduit was partially melted. Inspected wires (2) within and both appeared okay. Safety wired the harness away from the tailpipe.
7. Let the vehicle sit awhile. Outside Air Temp 84*. Started, placed in reverse, moved a couple of feet and engine stalled and O/D light on steady. Recycled ignition and started again, backed out with no stall or warning lights. No CEL on. Drove 10 miles without incident.
8. Allowed vehicle to cool, started and attempted to back out of garage. Engine stalled, CEL illuminated and O/D light flashing, code P0720.
9. Sunday morning 12 July: 71*, Allowed vehicle to idle in P in garage for 10 minutes before trying to back out. Vehicle did not stall. CEL still on from previous day, no O/D light. Erased P0720 code. Vehicle operating normally.
10. Sunday Noon 12 July: 85*, Started, placed in reverse, backed out and no stall or CEL or O/D light.
After considerable research online at ford-trucks.com found P0720 is a common problem but not easily diagnosed. In most cases the gremlin is COPs and or deteriorated plug boots but in this situation the engine appears to run smoothly and the failure/errors only show up when the vehicle is moved in reverse gear after a cold startup. Once it stalls then restarted it runs fine.
Made a quick check of alternator for failed diode using DVM since I don't have a scanner. Checked okay for voltage and AC ripple. I do have an appointment on Wednesday with my local auto repair shop for troubleshooting. Will have them do continuity check between OSS and PCM and an AC ripple test. Does this sound like an electrical circuit problem or internal transmission problem? Want to make myself as smart as possible when I talk with the techs.
Golf IV / Jetta IV :: Automatic Shifting - Code P0722 Output Speed Sensor
I just recently purchased my first mk4 golf 2.0 after having a mk3 jetta vr6 for two years. I've been having problems with the car shifting (automatic) i put a code reader on it and came up with p0722 output speed sensor which explains why it sometimes shifts at 4500. My two questions are where is the output speed sensor located? and what is a normal shifting range for properly running automatics?
View 2 RepliesFord Excursion :: Intermittent O/D Light Flash And Hard Shifting - Code P0720
Having this issue for a while. Finally have time off work to dig into it some more. 00 ex, v10. Intermittently flashes o/D light and shifts hard. I replaced 2 out of the three speed sensors. One at the output and the other on the axle. Only active code is the p0720 output shaft speed sensor circuit. Last weekend removed and inspected harness, did not electrically measure it tho. My question is: intermittent problem? I drove it today to see if it was still doing it and it drove like a dream! Haven't had the battery disconnected or anything, just sometimes it does it and other times it a smooth ride.
View 14 RepliesFord Excursion :: Transmission Output Shaft Play Slightly Up And Down - Torque Specification?
I removed my drift shaft to get balanced since I have felt a vibration at 55-60 mph. After removing the driveshaft I noticed there is some play in the output shaft when I grab a hold of the yoke on the transmission. The play is a slightly up and down. If my memory serves me right that should not be. Seal is not leaking but need diagram of this yoke off the output shaft. I know in past on other vehicles there is sometimes a crush washer. Also what is the torque specification for that output shaft nut?
View 3 RepliesFord F-150 (2004-2008) :: Airbag Light Code 24 - Sensor Output Feed / Return Circuit Open
I have a 2007 f150 sport. I am getting a 24 code on the airbag light and I do know that is Sensor output feed/return circuit open. What I do not know is where is this sensor located and what could it mean if I am getting the code...
View 2 RepliesFord Excursion :: 2001 V10 - Getting Code P0720?
I have searched and found a few threads of folks getting a p0720 code and truck revving and dying. Just wondering how to resolve the issue and what the cause was. I have an 01 ex with v-10
View 13 RepliesFord F-150 (2009-2014) :: 2011 - Wrench Light On With P0720 Code?
I'm having issues when shifting into reverse and I it goes into limp mode when the wrench light shows up. This will not happen when shifting into Drive. When in limp mode I get engine code P0720. This calls for a bad Output Speed Sensor and my research says the sensor is on the back of the transmission but I cannot find any sensors on the transmission. there are several connectors clipped to it but I don't see any bolted in sensors. Also I cannot find a replacement sensor anywhere so I'm wondering if this is a generic code.
View 3 RepliesFord F-150 (2009-2014) :: Wrench Light On Upon Starting And Trying To Put It Into Gear - Code P0720
The last few days I've started getting the Wrench Light on my dash panel upon starting the truck and trying to put it into gear. I first noticed this on a cold morning and got the wrench but the truck went into Reverse and once I got going I was only in 3rd gear. I started and stopped the engine a few times and finally got it going. Since then it seems to do it all the time whether hot or cold. Tonight I noticed that if i start the engine and just go directly into Drive. I don't have the issue but if I ever go into Reverse it goes into limp mode and i get the big yellow wrench again. I only have engine Code P0720 which seems to refer to a speed sensor. I can't seem to find the sensor listed on the typical auto part websites.
View 4 RepliesFord Aerostar :: 1996 - OD Light Blinking / Code P0500 Speed Sensor A Malfunction
Vehicle is a 1996 Aero* XLT, 4.0 engine with 155000+ miles. I'm getting the P0500 code with the OD light blinking. Tranny is not shifting properly. Did not look at the speedo or check the cruise due to worry about making it to my driveway. I have had ocasion to set the cruise to 45MPH and at times it will drop out. I don't know the lower limit on the cruise. Is this speed sensor the same as the VSS...
View 9 RepliesSanta FE SM (2001-06) :: Input Shaft Speed Sensor Connector
I have a 2001 Santa Fe GLS 4WD, I've had my Auto Transmission Speed Sensor replaced and will have the output speed sensor replaced to have speedometer/odometer and cruise control fixed. While having the first sensor replaced my mechanic noticed the Input Shaft Speed Sensor Connector (the plug on the wiring harness) was cracked. I've been looking everywhere for this connector. I don't want to buy the complete wiring harness because I've heard it is very expensive. I want just the connector. What is the part number of just the connector?
View 2 RepliesFord Super Duty (1999-2016) :: 2001 - O/D Light Flashing - Got Code P0720?
I have a 2001 F250 Super Duty with a 5.4L engine, regular cab. The truck has 149000 miles on it. I bought it about a month ago and had the transmission rebuilt, the spark plugs and coils replaced. Apparently the shady dealer I bought the truck from had power washed the engine and there was water in 3 of the spark plug wells on the drivers side. When I got the truck back from the transmission shop and backed it out of the parking lot, the OD off light started flashing and the SEL light came on. The code showed to be a P0720 to which the mechanic at the transmission shop replaced the speed sensor on the top of the tranny.
He said if it comes on again then the speed sensor on the rear differential could be the problem and that he would have to charge me to replace that sensor since it isn't covered under the warranty for the transmission.. I replaced the sensor myself on the rear differential yesterday and thought the problem was fixed. I drove the truck around for 30 minutes with no problems, until I put the truck in reverse, then the OD off light started flashing and the SEL light comes on giving the same P0720 code.
Ford Super Duty (1999-2016) :: ABS Light Came On And Throwing A Rear Speed Sensor Code
I've got a 2006 F350 5.4L.
The ABS light came on and it was throwing a 'rear speed sensor' code. I searched around and it seemed to be a common issue that the sensor goes bad and needs to be replaced.
I bought a sensor and replaced it, but in doing so, I saw that while the sensor was indeed bad (cracked) the wire right at the connector was corroded.
I replaced the sensor but the ABS light is still on the dash. Is it possible that they code simply needs to be cleared? I was able to read it with my OBD2 dongle and Dash Command App, but maybe I'm not able to clear it?
Or is it more likely that the corroded wire on the connector is the issue? (it wasn't fully corroded and I cleaned it up and sealed it.). It didn't look like I could pull the wires out of the connector, so I assume I'll need a new connector. What is the part number?
Ford Super Duty (1999-2016) :: Intermittent Tow / Haul Flashing Light When Going Up Or Down Hill - P0720 Code
I have a 2000 F350 7.3 4x4. It began giving intermittent tow/haul flashing light, when going up or down hill but would clear and drive next time truck was cycled off/on. No ABS lights and code reader generated P0720 for the output speed sensor, now I can get it to generate just driving slowly fwd and rev a few times. All of this has been in the last few days.
Truck will stall if I take it up a slight incline with the fault. I replaced the sensor on the top front of the 4r100 transmission and also replaced the sensor on the rear differential after giving up on looking for an output sensor on the transmission. I know the 2WD transmissions have an output sensor but is there one on the 4WD version? I have read several past threads discussing the P0720. I am hoping to confirm what sensor I need to be looking at and where it is located in this application.
Ford Transmission :: Take Off Output Flange Without Changing Tail Shaft?
Can I take off the output flange on the tranny and use a slip joint, with out changing the tail shaft?
View 1 RepliesFord Super Duty (1999-2016) :: F250 - Trans Shifting Hard / OD Light Flashing / Code P0720
Just got the transmission rebuilt in my truck and other then shifting hard sometimes it has been doing great, Hooked it up to the goose neck this evening and everything was fine then went to back it up and pull it forward and after a short distance the od light was flashing and when i ran a check on it it was p0720? The transmission has less then 1000 miles on it?!?!? 1999 Ford F-250 7.3 Automatic....
View 5 Replies