Ford Ranger / B-Series :: 2000 - Running Rough And Code For Misfire On Cylinder 3 / 2nd Coil Pack
2000 4.2....Last year I had to replace the coil pack when it started running rough and had a code for a misfire on cylinder 3. It is doing the exact same thing now, same code, same cylinder. Is there something wrong that is causing this?
View 5 RepliesFord Excursion :: 2000 V10 - Rough Idle - P0304 Code / Cylinder 4 Misfire
I recently bought a 00 Excursion v10 2wd everything looked right no major problems. I noticed it has a rough idle and i thought it could be the EGR i went under the hood and there's no EGR in sight. I plugged the OBD reader to see if it would give any codes since the there was no check engine light on and wanted wanted to make sure it worked, It showed a P0304 code its Cyl4 misfire i checked plugs/coils and i noticed there's a little insert inside Cyl4 plugs hole in the head that it has the plug screwed on. I decided to change all the plugs and the coils and i still have the rough idle and code i can hear a ticking noise around the engine in the passenger side.
View 7 RepliesFord Excursion :: Code P0304 Cylinder 4 Misfire - Broken Rocker Mount
6.0 .... Have a code Po3o4 Cyl 4 misfire. I pulled the valve cover to remove the injector and found the right half of the rocker mount and rocker arm laying in the head. What may have happened?
View 5 RepliesPassat (B5) :: Cylinder 2 Misfire / Does Not Move With Coil?
My brother has a 98 turbo passat which is reporting misfire on cylinder #2. We swapped the coils between cylinder #2 and each one of the other cylinders and the problem did not move, making me beleive the coil is not at fault. What else should we check?
View 8 RepliesTiguan :: 2009 - Cylinder Misfire After Coil Pack Swap?
I recently did a coil pack swap to determine if that was the cause for a cylinder 1 misfire. Left to right on my 2009 se tiguan, I changed 1 to 2, 2 to 1, 3 to 4 and 4 to 3. I recently ran into the cylinder misfire again, this time on cylinder 4. The problem is, I do not know which coil fires which cylinder. I've looked around quite a bit and can't seem to find it.
View 6 RepliesFord F-150 (2009-2014) :: 2013 - Check Engine Code P0355 / Cylinder 5 Coil Malfunction
I have a 2013 F150 6.2L and it wont start. It was running great and when I drove it around the corner it just shut down no clunk no warning just bam shut off. I had a engine code P0355 ( which indicated cylinder 5 coil malfunction). changed the coil and it will not fire the engine code has gone away but it will still not fire. I changed the oil just to be safe and no metal shavings in it.... Turns over just fine but will not fire. I added more fuel just to be safe ( thinking maybe I had bad fuel but that didn't work either.
View 3 RepliesFord Excursion :: 2005 V10 - Cylinder 4 Misfire
I recently purchased a 2005 Ex 6.8L V10 and I have been struggling to figure out the Cylinder 4 Misfire for close to 3 months. First thing I did was replace all 10 spark plugs with Motocraft plugs. Check engine stayed away for a few weeks... then came back. I next replaced just the #4 coli with a DG508 Motocraft coli I picked up at O'Reilly's. Again the check engine light stayed away for a few weeks.
Finally, I cleaned out #1-4 fuel injectors and swapped positions of #1 and #4. This time the check engine light stayed away for over a month. However, it just came back today, and again, it is #4. I am now at a loss for what to do. I assume it is not the fuel injector since I swapped the #1 and #4 injectors. If I have new plugs and a new coil pack, then what am i missing?
Avalon 2005-12 :: Engine Misfire On All Cylinders - Coil Code P0356
What to do Misfire Error all cylinders also coil code P0356 . It is 2006 Avalon Ltd with 37,000 miles always maintained and all recalls completed. Is there something I missed or is this for real or could there be a common problem that is causing all the errors. Car idles ok and no problem driving below 60 mph anything over and you can fell a shutter like it will lose power.
View 14 RepliesFord Excursion :: Check Engine Light And Cylinder 5 Misfire
So when I bought the car, it had a check engine light. I had it checked it said cylinder 5 misfire. I assumed it was the glow plug so I bought it and replaced the glow plugs myself. Check engine light went away for about a day then came back on. Got it checked again and still said cylinder 5 misfire. This is my first diesel and I'm clueless as to what's wrong.
2001 7.3 Limited with 232k miles Bergen County NJ.
Ford Excursion :: 2000 V10 Shaking On Acceleration / Cylinder Misfire Or Dead
Well, I have been through the tech folder and all over the forum reading but cant seem to come up with a good first step. When i accelerate the truck shakes, by the sound it seems that its missing a cylinder. I guess it could also be the motor mounts. Besides replacing the plugs and coils, is there something else that could remedy a misfires or dead cylinder?
View 7 RepliesFord - Taurus :: CEL Came On With P305 Code / Cylinder 5 Misfire Detected
Wife's car - 2005 Taurus, 6 cyl, 3L, OHV, 83K miles. CEL came on and code came back as "P305 - cylinder 5 misfire detected". The car had been running rough. I changed the plugs, wires and coil. After changing these (and clearing the code) the car seemed to run better for about a week. Today it suddenly started running rough again and the CEL came on with the same code. I'm guessing now this is probably fuel related as opposed to spark related??? As a side comment, the tachometer has been fluctuating as of late as well (again, intermittently).
View 5 RepliesFord - Escape :: 2001 - Misfire On Cylinder 4 / P0304 Code
I know I can fix this problem, but my question is which cylinder is #4? I don't see it marked on the engine. The counter guys at both my local parts supply stores (whose initials are A and O) can't even look it up for me. If #4 is on the front of the engine, then it's an easy fix. If it's on the backside, then the intake manifold has to come off to get to the plugs and coil packs. It's a bit more labor. I can do it, but I'd rather not have to.
View 1 RepliesFord - Taurus :: Misfire Code For Single Cylinder P0303
01 Taurus, 3.0 pushrod motor. Single 6 pack style coil. I replaced worn plugs 2 months ago for misfire. Car seemed to run fine. Now, I have misfire again. Code is for single cyl, 0303. Would u expect plug to foul, or bad wire, or possibly bad coil? I don't know how these ford coil packs fail. Can u lose 1 or more spark outputs with them?
View 11 RepliesFord F-150 - 1997-2003 :: Code P0306 - Cylinder 6 Misfire
So my 99 F-150, 4.2L started throwing a code a few weeks ago, P0306 #6 Cyl Misfire. This thing has got 238,000 and has been the most reliable commute vehicle I've owned.
Today I changed all the plugs and wires (they were due anyways) which didn't resolve the issue. After clearing the code, got about 3 miles out and it came back. Running SeaFoam through the system on this tank as well, but I'm leaning towards an EGR blockage like what is described here:
Sparky's Answers: 1999 Ford F150, P0306 Misfire Cylinder #6
I was about to buy a new coil pack but I'd rather not continue to throw parts at this, as I've read many others do with this same exact situation, only to end up with the same code. I've replaced the coil pack once already a few years ago when I lost a cylinder on the way to work.
Ford F-150 (2004-2008) :: 2007 - Cylinder 3 Misfire Code
I know there is a tun of info on the spark plug problem on the f-150. Here is the problem I have and I don't know where else to look.
Cylinder #3 misfires
1. swapped coil with #2 cylinder and still throws #3 misfire code.
2. Changed the plug on #3 and still the same code #3 misfire.
Where to look next?
Ford F-150 - 1997-2003 :: CEL Code P0301 / Misfire With Cylinder 1
My 97 F150 through a CEL Tuesday night P0301 so I picked up a new plug because it's cheap and simple, but that didn't do anything. Spark plug wires are about 3 months old, I also swapped injectors between 1 and 2, and misfire stayed with cylinder 1. It also gained a tap when the misfire started but only above idle, but it doesn't sound like a rod knock.
I also noticed if you unplug injector 1at idle it taps/knocks 3 or 4 times, however if you unplug any of the others it doesn't do that. I checked and I definitely have good spark from the plug. I plan on picking up a new compression tester tomorrow since mine never was returned. If you take the oil fill cap off it doesn't have any blow by at idle, however if you rev it you get a quick cloud out of it.
I thought about picking up a kit to check the injector pulse.
Ford F-150 (2004-2008) :: Code P0301 - Misfire Cylinder 1
This happened xmas shopping with the wife. Started misfiring on the highway,took the 1st exit to find a garage as I am 20kms from home. The vibrations were worse at stop, but made it to a garage. They gave me the p0301 misfire cylinder 1, said they don't touch 5.4 plugs, told me to go to ford 2kms down the road. NICE. 4 in the pm, FORD dealer worse case scenario. Nope gave me a loaner told me come back at 930am. Truck was just waiting for an injector when I arrived. Plug & coil were good injector was shot,changed the fuel filter & oil change.
View 6 RepliesFord F-150 (2004-2008) :: Cylinder 8 Misfire Code Randomly
Having a misfire problem I can't track down. First issue was random cylinder 8 misfire code. Checked everything, nothing obvious. Cleared code, problem stopped and engine ran fine. Then came back, cylinder 8 misfire. Swapped coil with #5 but problem did not return. Since I assumed it would come back, I went ahead and bought Accell supercoils and new Motorcraft plugs and replaced them all (120k miles, no broken plugs ). Truck ran great on the test drive! Then it sits overnight and bam, cylinder 5 misfire as soon as I start it next morning. Then after messing with it I get cylinder 5 bad coil (code 355 I think). Put one of the Ford factory coils back back on #5, no change and still misfiring. New plug, new coil on all cylinders... Why did it move from #8 to #5? If it was an in injector, seems it would still be #8 since I did not mess with those.
View 10 RepliesFord F-150 (2004-2008) :: Code PO306 Which Is Misfire On Cylinder 6
I have a 2004 f150 with the 5.4 and was wondering what would cause a spark plug to do this. Its on cylinder 6 and i have pulled the codes off of the truck before and one was PO306 which is misfire and can't remember other one but it was saying system was too rich. I have only has this spark plug in maybe 500 miles. but was getting a misfire code before that. Do you think it could be a coil or the injector?
View 3 Replies