Ford Excursion :: Cranks Fine But Does Not Start
Had the Excursion out today. Made a stop coming back and used the remote start. I entered the truck and by mistake pressed the brake pedal which shuts off the engine. When I tried to start the truck with the key...it cranks fine but does not start. It'll try to run, sputter...but will not run.
I cannot hear the pump running when the key is turned. It was towed home and it in the driveway. I assume it's the fuel pump....but wondered if the remote start/alarm could be killing the power to the pump? The cut-off switch in the passenger footwell is pressed in. Where do I start:?
Ford Excursion :: Truck Cranks Just Fine But Won't Start / Acts Like There Is No Gas
Been having an odd problem with getting my truck to start. Pass couple of days I've gotten out from work and gone to start the truck. It cranks just fine but wont start, acts like there is no gas. Let it for a minute or two and try again and it will start right up and keep running with no other problems. Go to leave for the work the next day and the same issue. Weird thing is the problem only seems to happen when its cold out 30F so or below. I was thinking fuel pump but I'm not sure. What to check?
Edit Its a 2002 Excursion XLT with the gas 5.4
Ford Excursion :: 2001 V10 Cranks Fine But No Start / No Sputter
2001 Ex V-10 4x4. Ran like a top yesterday. Turns over fine but not even a sputter today. Plenty of fuel & battery. Has spark. Tried starting fluid, but nothing. No codes. Checked fuses and relays in dash & under hood. Fast forward an hour...
Went out and tried it again - fired up like nothing ever happened. Plowed snow for the better part of an hour, - ran like a champ again, smooth, no missing or stutters - parked it and shut it off. Tried to start it again within a minute or so and it would start, run rough & die. Tried a few more times with same results. Now it cranks fine but no start, no sputter. Gonna try a fuel filter tomorrow.
If it were the fuel pump, wouldn't it throw a code?
Ford Excursion :: 2004 6.0 Just Cranks Over But Won't Start After Warming Up
I have researched a little and believe i have a leak in the high pressure oil system. My 2004 Excursion 6.0 will start when it is cold but after warming up will not start it just cranks over. So here is my question; the two wires leading from the Turbo had melted and shorted and in fixing that i loosened what i believe to be an oil line feeding the Turbo. Could this be the problem? Also is there an O-Ring that seats the line into the block that may need replaced?
View 2 RepliesFord F-150 - 1997-2003 :: Engine Cranks Over Fine But Won't Start?
The Engine cranks over fine, but won't start. When it does start everything is okay and it runs good with no codes. I noticed that by taking the key out of the ignition, I was checking under the hood, and put it back in the truck fired right up. Also it has never done this to the second driver who has a different key. The truck runs fine at all speeds and loads, even when hauling twenty bags of wet mulch. It's a 2001, 4.6 L, RWD. Could the PATS Chip be failing?
View 9 RepliesFord - Ranger :: 2003 Will Not Start / It Cranks Just Fine But Doesn't Fire
I have a 2003 Ford Ranger 4X4 4L AUTO. About once every 6 months it will not start. It cranks just fine but doesn't fire. After about 45 min. it start and runs great for an other 6 Months. I have replace the plugs, wires, distributor cap but it hasn't solved the problem. It has had this problem when it is cold and warmed up.
View 4 RepliesFord F-150 - 1997-2003 :: Hard To Start In Cold / Cranks Fine But Does Not Want To Fire
My girlfriend has a 2003 f150 4.6lt pick up its a great truck most of the time. Problem is when the temp gets in the neg double digits it becomes very hard to start it cranks fine but doesnt want to fire. When it does fire it might stall a few times before it stays running. The last cold snap we had I replaced the battery and in the summer the starter got changed. I have heard that this model of truck are known for hard cold starts. I am just wondering if this is true and any other thing besides block heater. It is strange that my 89 gm pickup will start no matter what temp and I'm having problems with the newer truck.
View 1 RepliesFord 6.0L Power Stroke Diesel :: Truck Won't Start / Cranks Just Fine Just Doesn't Try To Run
Went to the store came home no problems. Went out to go to work next morning truck won't start. Cranks just fine just doesn't try to run. Was not getting voltage at ficm replaced board in ficm have correct voltage now but still won't start
View 2 RepliesFord 7.3L Power Stroke (1999-2003) :: F350 - Cranks Just Fine / Slow To Start
It's a 99 f350 7.3 diesel powerstroke. About 180k miles I think.
It cranks fine. I just changed the glow plugs(all were dead) but when you try and start from cold, it takes about 7-10 seconds to fire. The oil res is full, tried disconnecting the EOP sensor, still fires up and takes just as long. There is one near the oil filter, and that seems to not be it either.
Doesn't smoke, no oil leaks that I know of. Not sure what else to check before sending it to another shop to get put on a diagnostics machine. I read about the IPR, but it has no problems when running. Only problem is a very long time to start. Also changed the fuel filter.
Passat (B5) :: Car Cranks Fine But Won't Start
First time ever, my Passat has stranded me. Won't start. 120K. Cranks fine. Fuel pump fuse is OK. Almost new plugs. New fuel filter. No codes. Almost a full tank of gas. No smell of fuel in engine compartment. Disconnect MAF, no difference. This started over a week ago. The car would not start on the first try. Always on the second try. Once started the car ran fine, did not stall or hesitate. Then, just once, it almost did not start; I think it was the fourth try it finally started. After that I replaced the fuel filter, just in case. It's been fine for several days. Now this morning, no go
View 6 RepliesFord 6.0L Power Stroke Diesel :: 2005 F250 - Engine Cranks Fine / No Cold Start
I'm TSing a no-start on my 2005 6.0L F250. Engine cranks fine. I've been working my way thru the TSing guide and using my new ScanGaugeII. No codes found. At glow plug warmup, (dash light goes off), I'm getting 40.5v FMP, 11.0v FLP, 14.8% ICP, and 0psi IPR. After cranking for 10-15 sec, get 35.5v, 10.0v, 84.7%, and 446psi. I've had a trickle charger on all night to keep the batteries charged. Have not seen FMP over 45 or IPR over 470.
View 14 RepliesFord 7.3L Power Stroke (1999-2003) :: F250 Cranks Fast And Fine But Won't Fire Up And Start
My dad has a 99 F250 with a no start issue. Everything was starting and running fine one day. The next he gets a no start. Cranks fast and fine but wont fire up and start. He has a scangaugeII hooked up to it and his oil pressures and volts look fine. His tach moves when he is trying to start it. He checked the icp sensor and it had oil through it so he replaced it with a Ford part. Unplugged it and the scangauge pressure goes up but no start. He also replaced the ipr with a new Ford one just in case. He checked and is getting low pressure and high pressure oil.
I am having him check the fuel heater fuse #22 to make sure it is not blown. He had the block heater plugged in all night along with a battery charger to make sure they are topped off as well. We have gone through a couple of the checklists on this site for a no start condition but nothing has solved it yet. I think he is sitting at about 200k on the motor. No major issues or problems until now. He is currently also pulling the ICM to check it out as well. No codes are being thrown.
Ford 6.0L Power Stroke Diesel :: 2007 F250 Would Not Start - Cranks Fine And Almost Started Once But Died
Went out to start my truck this morning and it wouldn't start. Cranks fine and almost started once but died. Checked all fuses all my voltages are good. Oil and coolant are good. When I turn the key on I can hear the fuel pump and sounds like it's priming correctly. Might be an issue with a clogged fuel filter? Maybe? Haven't had any problems or issues otherwise.
View 6 RepliesFord Super Duty (1999-2016) :: 2002 F250 Truck Won't Start / Cranks Fine But Just Will Not Turn Over
I have a 2002 F250 7.3L and it wont start. Its been sitting for the past few days in the cold because the batteries were shot but was plugged in the whole time. I replaced the batteries today and even poured diesel 911 5 hours before trying to start it in case the fuel was gelled. It cranks fine but just wont turn over.
View 2 RepliesPassat (B5) :: 2005 V6 Won't Start - Have Spark And Cranks Over Fine
I got a 05 Passat I am working on. The car was being drove and my customer when to eat lunch. Came out side and didn't start. Got it to my house threw it on the scanner and it brought up 2 cam sensor codes. Replaced them and still nothing. What to try next. The car cranks over fine and it does have fuel pressure and also has spark.
View 2 RepliesChevrolet - Tahoe :: 2002 Cranks Over Fine But Won't Start
My 2002 Tahoe cranks over fine (new battery), but, will not start. I have checked the fuel pump relay and have control power to energize the relay, but. no switched power from ECM to change relay state. Jumped rely 30/87 and pump runs. No DTC's. Gauge on instrument panel reads no fuel. Scanner shows 56% level. Tried to use my Snapon MT2500 to switch relay state and received error message "generic device control limit exceeded" ECM?
View 3 RepliesSonata NF (2006-10) :: Cranks Fine When Turned The Key But Won't Start
My 2008 Sonata finally let me down after 4-1/2 years of flawless service. Turned the key, it cranks fine, but won't start. I think it's the fuel pump. It has 63,000 miles now so the bumper-to-bimper warranty is over. Is the fuel pump (if that's it) covered by the 100,000 mile drive train warranty? I checked fuses and they are all fine. I don't know if there is a fuel cutoff switch. It might just be the pump relay...but I want to have it towed, and the choice is dealer or my regular mechanic.
View 7 RepliesGolf IV / Jetta IV :: Cranks Up Fine But Sputters To A Start
My 03 GTI 1.8 is having start issues. It cranks up fine, but it sputters to a start. It doesn't idle high and fall down to the 850 mark like normal, it just lugs itself into low idle. I have to then throttle it until it stops sputtering and I have a smooth rev. Then after that, the car runs fine. I can stop it and start it up again fine when it's warmed up. I have checked multiple things already.
-The Ignition coils are in excellent condition
-Spark plugs are normal, but not exactly perfect
-Fuel pump works fine
-Battery was tested and is clean and good
-Throttle Body is clean (at least to the eye, Im cleaning it next)
-Oil was changed when I changed the sensor along with filter.
I should mention I changed the crankshaft position sensor a month ago. The block at least from under the car is filthy, but I don't know if that affects anything.
I had a check engine light, so I got its codes read (I'm out rn, but when I get home I can show you) and decided to just take it to a shop. When I took it, the light went away, decided to start as normal, and the shop just charged a huge fee for the diagnostic and nothing was fixed. I really need to know what to do with this, I daily it every day and its starting to bother me a lot now.
Pickup - Chevrolet :: 1993 - Cranks Fine But Won't Start?
A friend is stumped by a problem with his truck, so I thought I might get some insight here. I haven't actually seen the truck, all that follows is from what he described, I'm just the messenger here.
The truck had been running fine on a used engine installed about six months ago. Then he ran it out of gas, it hasn't run properly since. It cranks fine, but won't start. He says it WILL start when spraying starter fluid into the throttle body, but only while the starting fluid is supplied. He also says he disconnected the fuel line somewhere near the engine, cranked the engine, and got good fuel supply (but no fuel pressure gauge reading). He's done some logical things: new fuel pump, fuel filter, spark plugs and wires. No luck. Figuring that he'd sucked something ugly into the injectors, he decided to replace those with no change (yes, I cautioned him about throwing expensive parts at it with no clear reason).
He reasons that he must be getting spark based on the engine running with starter fluid, and there must be fuel based on his test with the open fuel line, so he thinks it's an electronic problem, presumably the signal to the injectors. This is out of my league...and my friend is a carpenter, not a mechanic. If he could get a scanner would this kind of problem register a code?