Ford Excursion :: Cranks Fine But Does Not Start
Had the Excursion out today. Made a stop coming back and used the remote start. I entered the truck and by mistake pressed the brake pedal which shuts off the engine. When I tried to start the truck with the key...it cranks fine but does not start. It'll try to run, sputter...but will not run.
I cannot hear the pump running when the key is turned. It was towed home and it in the driveway. I assume it's the fuel pump....but wondered if the remote start/alarm could be killing the power to the pump? The cut-off switch in the passenger footwell is pressed in. Where do I start:?
Ford Excursion :: 2004 6.0 Cranks Fine But Will Not Start
My 2004 6.0 will not start. It cranks fine. History This happened once before about a year ago towed it into the shop and it stated fine.
The batteries were low yesterday and the truck would not start because the voltage was too low to run the starter. I charged them. Went to try again and I cranked it for close to 30 seconds with no results.
Only cods so far are #6 glow plug and EGR valve open. Whats next, check the FICA?
Ford Excursion :: Truck Cranks Just Fine But Won't Start / Acts Like There Is No Gas
Been having an odd problem with getting my truck to start. Pass couple of days I've gotten out from work and gone to start the truck. It cranks just fine but wont start, acts like there is no gas. Let it for a minute or two and try again and it will start right up and keep running with no other problems. Go to leave for the work the next day and the same issue. Weird thing is the problem only seems to happen when its cold out 30F so or below. I was thinking fuel pump but I'm not sure. What to check?
Edit Its a 2002 Excursion XLT with the gas 5.4
Ford Excursion :: 2000 - Engine Cranks / Turns Then Sputter And Dies Suddenly?
I also tried jump starting - get same same result. Engine cranks, turns, and then sounds like it is just about to start up normally but it just dies completely. It seems to want to start but just can accelerate the engine high enough to keep it running. Almost like it's flooded on a carb motor.. 2000 V10..
View 7 RepliesAccent LC (2000-05) :: 2001 GS Won't Start / Engine Cranks Fine But Doesn't Fire
My 2001 Accent GS (1.6L DOHC) wouldn't restart after a short 2 mile trip to a local store. The engine cranks fine but doesn't fire.
It has had a CEL issue for awhile and after it wouldn't start I checked the codes and got:
303
335
722
I replaced the Crank Position Sensor and Fuel Filter but it still just turns over.
I hear the fuel pump run when I turn the key on and I broke the fuel line and it is Pressurized, so I doubt it is a fuel issue.
The 722 code indicates the output speed sensor has an issue. Need to know definitively if that sensor is completely shot could this prevent the ECU from firing the engine?
I have had this car since it was brand new and I'd like to keep it going a little longer.
Suburban :: 87 Start Intermittent / Cranks But No Fire Not Even A Sputter
I have been checking on the automotive forums for Suburban no start problems and have tried some of the solutions, but my vehicle still doesn't start. Here is where I'm at: I have spark, fuel pressure at the throttle body, the fuel pump in the tank is working, new cap, rotor, coil, module, fuel filter, and ECM.
I just ran the truck 2 days ago for 10 minutes to flush the radiator, turned it off to install a new t/stat, then it wouldn't start again. I have tried starting fluid, gasoline, it cranks but no fire, not even a sputter. The pump has been replaced probably 9 years ago. The only other thing not replaced is the pickup coil in the distributor, although the distributor was rebuilt about 10 to 12 years ago. This vehicle just sits until needed, can't afford to drive it daily. The truck is a 1987 Suburban 1/2 ton 350K engine, automatic, 4wd.
Ford F-150 - 1997-2003 :: Engine Cranks Over Fine But Won't Start?
The Engine cranks over fine, but won't start. When it does start everything is okay and it runs good with no codes. I noticed that by taking the key out of the ignition, I was checking under the hood, and put it back in the truck fired right up. Also it has never done this to the second driver who has a different key. The truck runs fine at all speeds and loads, even when hauling twenty bags of wet mulch. It's a 2001, 4.6 L, RWD. Could the PATS Chip be failing?
View 9 RepliesFord - Ranger :: 2003 Will Not Start / It Cranks Just Fine But Doesn't Fire
I have a 2003 Ford Ranger 4X4 4L AUTO. About once every 6 months it will not start. It cranks just fine but doesn't fire. After about 45 min. it start and runs great for an other 6 Months. I have replace the plugs, wires, distributor cap but it hasn't solved the problem. It has had this problem when it is cold and warmed up.
View 4 RepliesFord F-150 - 1997-2003 :: Hard To Start In Cold / Cranks Fine But Does Not Want To Fire
My girlfriend has a 2003 f150 4.6lt pick up its a great truck most of the time. Problem is when the temp gets in the neg double digits it becomes very hard to start it cranks fine but doesnt want to fire. When it does fire it might stall a few times before it stays running. The last cold snap we had I replaced the battery and in the summer the starter got changed. I have heard that this model of truck are known for hard cold starts. I am just wondering if this is true and any other thing besides block heater. It is strange that my 89 gm pickup will start no matter what temp and I'm having problems with the newer truck.
View 1 RepliesFord 6.0L Power Stroke Diesel :: Truck Won't Start / Cranks Just Fine Just Doesn't Try To Run
Went to the store came home no problems. Went out to go to work next morning truck won't start. Cranks just fine just doesn't try to run. Was not getting voltage at ficm replaced board in ficm have correct voltage now but still won't start
View 2 RepliesFord 7.3L Power Stroke (1999-2003) :: F350 - Cranks Just Fine / Slow To Start
It's a 99 f350 7.3 diesel powerstroke. About 180k miles I think.
It cranks fine. I just changed the glow plugs(all were dead) but when you try and start from cold, it takes about 7-10 seconds to fire. The oil res is full, tried disconnecting the EOP sensor, still fires up and takes just as long. There is one near the oil filter, and that seems to not be it either.
Doesn't smoke, no oil leaks that I know of. Not sure what else to check before sending it to another shop to get put on a diagnostics machine. I read about the IPR, but it has no problems when running. Only problem is a very long time to start. Also changed the fuel filter.
Passat (B5) :: Car Cranks Fine But Won't Start
First time ever, my Passat has stranded me. Won't start. 120K. Cranks fine. Fuel pump fuse is OK. Almost new plugs. New fuel filter. No codes. Almost a full tank of gas. No smell of fuel in engine compartment. Disconnect MAF, no difference. This started over a week ago. The car would not start on the first try. Always on the second try. Once started the car ran fine, did not stall or hesitate. Then, just once, it almost did not start; I think it was the fourth try it finally started. After that I replaced the fuel filter, just in case. It's been fine for several days. Now this morning, no go
View 6 RepliesFord 6.0L Power Stroke Diesel :: 2005 F250 - Engine Cranks Fine / No Cold Start
I'm TSing a no-start on my 2005 6.0L F250. Engine cranks fine. I've been working my way thru the TSing guide and using my new ScanGaugeII. No codes found. At glow plug warmup, (dash light goes off), I'm getting 40.5v FMP, 11.0v FLP, 14.8% ICP, and 0psi IPR. After cranking for 10-15 sec, get 35.5v, 10.0v, 84.7%, and 446psi. I've had a trickle charger on all night to keep the batteries charged. Have not seen FMP over 45 or IPR over 470.
View 14 RepliesFord 7.3L Power Stroke (1999-2003) :: F250 Cranks Fast And Fine But Won't Fire Up And Start
My dad has a 99 F250 with a no start issue. Everything was starting and running fine one day. The next he gets a no start. Cranks fast and fine but wont fire up and start. He has a scangaugeII hooked up to it and his oil pressures and volts look fine. His tach moves when he is trying to start it. He checked the icp sensor and it had oil through it so he replaced it with a Ford part. Unplugged it and the scangauge pressure goes up but no start. He also replaced the ipr with a new Ford one just in case. He checked and is getting low pressure and high pressure oil.
I am having him check the fuel heater fuse #22 to make sure it is not blown. He had the block heater plugged in all night along with a battery charger to make sure they are topped off as well. We have gone through a couple of the checklists on this site for a no start condition but nothing has solved it yet. I think he is sitting at about 200k on the motor. No major issues or problems until now. He is currently also pulling the ICM to check it out as well. No codes are being thrown.
Ford 6.0L Power Stroke Diesel :: 2007 F250 Would Not Start - Cranks Fine And Almost Started Once But Died
Went out to start my truck this morning and it wouldn't start. Cranks fine and almost started once but died. Checked all fuses all my voltages are good. Oil and coolant are good. When I turn the key on I can hear the fuel pump and sounds like it's priming correctly. Might be an issue with a clogged fuel filter? Maybe? Haven't had any problems or issues otherwise.
View 6 RepliesFord Super Duty (1999-2016) :: 2002 F250 Truck Won't Start / Cranks Fine But Just Will Not Turn Over
I have a 2002 F250 7.3L and it wont start. Its been sitting for the past few days in the cold because the batteries were shot but was plugged in the whole time. I replaced the batteries today and even poured diesel 911 5 hours before trying to start it in case the fuel was gelled. It cranks fine but just wont turn over.
View 2 RepliesPassat (B5) :: 2005 V6 Won't Start - Have Spark And Cranks Over Fine
I got a 05 Passat I am working on. The car was being drove and my customer when to eat lunch. Came out side and didn't start. Got it to my house threw it on the scanner and it brought up 2 cam sensor codes. Replaced them and still nothing. What to try next. The car cranks over fine and it does have fuel pressure and also has spark.
View 2 RepliesChevrolet - Tahoe :: 2002 Cranks Over Fine But Won't Start
My 2002 Tahoe cranks over fine (new battery), but, will not start. I have checked the fuel pump relay and have control power to energize the relay, but. no switched power from ECM to change relay state. Jumped rely 30/87 and pump runs. No DTC's. Gauge on instrument panel reads no fuel. Scanner shows 56% level. Tried to use my Snapon MT2500 to switch relay state and received error message "generic device control limit exceeded" ECM?
View 3 RepliesSonata NF (2006-10) :: Cranks Fine When Turned The Key But Won't Start
My 2008 Sonata finally let me down after 4-1/2 years of flawless service. Turned the key, it cranks fine, but won't start. I think it's the fuel pump. It has 63,000 miles now so the bumper-to-bimper warranty is over. Is the fuel pump (if that's it) covered by the 100,000 mile drive train warranty? I checked fuses and they are all fine. I don't know if there is a fuel cutoff switch. It might just be the pump relay...but I want to have it towed, and the choice is dealer or my regular mechanic.
View 7 Replies