Ford F-150 (2009-2014) :: 2011 - Hesitation From Idle - Missing Or Running Lean / Rich During Spin Up Of RPMs
I have recently purchased a 2011 F150 Ext cab with 3.5L ecoboost with 69k miles. I have no experience with these engines prior to now. I've always wanted a full size truck and after driving my 98 S10 for 17 years, I decided it was time for a new truck. I hope I made the right choice in going for the 3.5 instead of 5.0.
On to my question. I've noticed that the truck hesitates from a dead stop or anytime the RPM's are under 1k. It feels like its missing or running lean/rich during the spin up of RPM's. When I drive it hard, it does seem to subside for a little, and I've heard people say that they run better when run hard. I can attest to that, but is this hesitation normal for an almost 70k mile engine? I am getting 15ish MPG on almost all city driving since I have bought it, but I do expect that to change (job hunting and current commute is less than 2 miles each way).
The only time I get to open it up is when I go run errands out of the immediate local area or visiting friends and family. On one of those trips, before I noticed the hesitation, I attempted to accelerate from 60 to pass on the expressway and it bucked and resisted like a horse. It finally took off up to 80 and completed that journey with no issue but the check engine light came on for a bit. The check engine light went off when I shut it down and hasn't come back on since.
New ride: 2011 3.5L Ecoboost....
Ford Aerostar :: Erratic Idle - Air / Fuel Ratio Is Too Lean Or Rich For PCM To Correct
97 shortie. 3.0 245,000 miles. I've already cleaned the throttle body and the idle air control valve. Throttle position sensor reads 5 volts, good ground, and a smooth voltage increase from idle to wide open throttle and back down. Which of these codes is most likely to cause erratic idle? Mostly in the morning.
P0340 Camshaft position sensor.
P1443 Evaporative purge flow sensor.
P0401 Insufficient EGR flow.
P0171 Air/fuel ratio is too lean or rich for PCM to correct.
I doubt it's number 1, and number 4 seems too general to be any use. I'm leaning toward number 3. Seems I read somewhere that the tube from the exhaust gets plugged up. This started when I disconnected a plug from the blue air bag box to get rid of that beeping. Coincidence?
Ford Super Duty (1999-2016) :: Lean And Rich Code At Same Time
My truck threw a check engine yesterday, P1151 and P1152. What could be the problem? 04 f350 with 5.4 with 142,xxx on her
View 14 RepliesPassat (B5) :: How Much Boost Without Running Too Rich / Lean
How much boost can you push on the stock turbo without it running too rich or lean?
View 3 RepliesGolf VI R :: CEL With System Too Lean And Rich Fault Message
How can one get a too lean AND a too rich error, within 150 miles? I'm guessing the too rich code was what through the CEL last night. For reference, the only mod is APR stage 1. That will teach me to drive "spiritedly" with a Porsche Turbo S. (which sounded amazing at WOT btw..)
2 Faults Found:
000369 - Fuel Trim; Bank 1
P0171 - 001 - System Too Lean
Freeze Frame:
Fault Status: 01100001
[Code] ....
000370 - Fuel Trim; Bank 1
P0172 - 002 - System Too Rich - MIL ON
Freeze Frame:
Fault Status: 11100010
[Code] ....
Ford Excursion :: 2000 - Truck Runs Bad And Don't Shift Right
It is a 2000 excursion its got codes # 135 155 443 743 755 1747 And overdrive light is flashing really....
View 14 RepliesFord Excursion :: 2000 - Hesitation / Surge And Stumble Over 1500 RPM
I recently picked up a 2000 Excursion with the 5.4 V8. Engine has 150,000. I got it cheap because it has a surging problem over 1500 RPM. This problem is intermittent.
I have 1 DTC. P1000 which is OBDII checks not complete. I cannot clear this even using the factory procedures. FYI..I have a snap on solus scanner. I think this is a voltage problem, If you try to start the engine with the scanner plugged in, the scanner shuts off, so I'm thinking the PCM loses battery power supply when the starter engages, resetting the PCM.
This problem is NOT a miss.... something isn't opening or shutting off above 1500 RPM. This truck doesn't have an EGR system, it has the EVAP system. This may be the problem, thats why I'm here. OK. heres a list of what I've replaced since I started working on it.
Engine oil and filter
air filter
fuel filter
8 COP's
8 plugs gapped properly
cam position sensor
IAC sensor
MAF sensor
Removed throttle body and cleaned.
Vacuum checks. 22" at purge valve,fuel dia, and vacuum canister
Checking with the scanner at 1500 RPM with problem
SFtrim1% bounces between5-15
SFtrim2% bounces between2-0
LFtrim1% bounces between11-13
LFtrim2% bounces between 5-6
O2S11(mv) bounces between 200-781
O2S21(mv) bounces between 200-800
Ssystem is in closed loop holding throttle at 1500 RPM... Note engine surges when at the RPM or above. I'm thinking the engine is lean, not sure how to read the trim numbers...
Idle is fine ... Problem is intermittent ... Also noticed that engine will only advance spark to 30 degrees @2000 RPM during this problem. I have seen it advance to 38-40 degrees when I do not have this problem, so I kind of understand the power loss,knock etc due to the timing, my question is whats causing it to do this?
EVAP question.... The purge valve should open according to PCM command a certain value, correct? I can monitor the duty cycle % but cannot activate and check proper duty cycle through scanner . When I try to I get an error message of module error -unspecified.
Disconnected hoses at purge valve,Full manifold vacumn on one, nothing on other, no flow through purge valve, but scanner shows 30% duty cycle. I would think the should be a little flow at 30% Maybe my problem? Troubleshoot procedure for the EVAP would be good.
Ford Excursion :: 2000 V10 - Engine Hesitation / Lope Once It Warms Up
I drive a 2000 Ex V10. My truck has been having an issue at idle after it warms up, almost every time after it sits and cools down.
My problem is that once the truck warms up, it will drop down to 500 rpm's and will have a hesitation/miss/lope for about 20 seconds. When it does this I can hear the exhaust making a sputtering sound. On two occasions during windy rain it would hesitate while driving but then straighten up within a half mile or so and be fine. I have changed all the boots, cop's and plugs and don't think that is where my problem is.
What I can't figure is why it seems to hesitate/lope once it warms up! This problem not related to a failing boot, plug or cop?
Ford Excursion :: 2000 Will Not Roll Backwards - Some Hesitation To Engage Each Gear?
I have a 2000 Excursion 7.3 4x4 with 237k miles on the original 4R100. Yesterday afternoon I went to back out of a parking space and the truck wouldn't move. When I put it in R, the transmission will engage and upon pressing the gas pedal it acts like it wants to move but will not budge. It rolls forward with no issue or noise. It will not roll backwards at all - not in neutral and not in reverse. The transmission shifts fine but with some hesitation to engage each gear. I have noticed some slippage but nothing crazy.
I 1st thought something might be wrong with the rear end but after some research I think it might be the transmission.
Ford - Ranger :: 1997 Runs Lean And Dies
1997 ranger 3.0 auto.. took it to a shop to have some work done. trans fluid valve covers leaking. had no real problems with the truck.
now, first start in the AM and only them, it runs lean and dies. second start Ok rest of the starts during the day OK ...
replaced ICV, tosses no codes. fuel pressure Ok ...
Volvo - V70 :: 2001/ 24T Vehicle Runs Smooth When Cold / Runs Rough With Delayed Acceleration On Warm Up
My 2001 V70 24T runs smooth when cold as it warms up it runs rough with delayed acceleration reaction ....
View 1 RepliesFord Excursion :: 2000 V10 - Ticking Noise When Cold Or Warm Only When Accelerating
I have a ticking noise that seems to be coming from the drivers side of the engine. 2000 Excursion. It only happens when accelerating in every gear between 1400-2100. No noise at idle or park. Same noise when cold or warm, again only when accelerating. Goes away when you take your foot off gas. New exhaust studs, exhaust does not seem to be leaking, no carbon build up anywhere. No engine codes. Truck runs great and no loss of power. V10 with 120 k on it. Really annoying.
View 14 RepliesFord Super Duty (1999-2016) :: No Idle / Just Dies And Runs Rough - Lean Codes
Getting these lean codes P1131, P1151, P0171, P0174. I was getting a knock sensor code before but not now. It will not idle it just dies and runs rough till I get at higher rpms gotta feather the brake and gas to go anywhere.
View 5 RepliesFord - Mountaineer :: 2000 - Rich On Idle Just Dumping Gas In The Exhaust
Have a 2000 mercury mountaineer that is crazy rich on idle, just dumping gas in the exhaust, fuel pressure is good, burning a ton of gas. Live data is as follows:
Fuel system 1 CL fault(if I shut it off and restart it will go to OL fault)
Fuel system 2-na
calc load 33.3
ect 174
stft b1 -23.4
ltft b1 0.0
stft b2 42.2
ltft b2 0.0
engine rpm 856
veh speed 0
spark advance 18.5
IAT(F) 66
MAF 1.7
TPS 18.8
02SLOC B1S12_B2S12
02S B1 S1(V) 0.920
STFT S1 -23.4
02S B1 S2 0.000
STFT B1 S2 99.202S B2 S1 0.765
STFT B2 S1 42.2
02S B2 S2 0.910
STFT B2 S2 99.2OBD SUP OBD2
Ford F-150 - 1997-2003 :: 2000 - Truck Will Barely Move / Running Full Rich
I have a 2000 F150 4WD 5.4 running Extremely rich to bank one. The O2 sensors for bank 1 are reading lean(0-50 mV) Bank two is completely unaffected. New plugs in Bank one, 3 new coils in bank one, all pvc lines checked with good vacuum. Previous codes : P0171, P0301-3. The Truck will barely move. Would a small leak up stream of the O2 sensors cause this?
View 10 RepliesFord Excursion :: Driver Side Power Seat To Lean More Forward
I am not liking this seat. Not sure if something wrong with control lately or I'm just noticing from sitting there more but I want it to lean more forward. I have messed with controls to get it to as forward as it will lean but still feel like it's only touching the very bottom of my back. Is there a spec on seat angle so I could check if it's proper? I'd like to avoid getting a grandma pillow..
View 14 RepliesFord Fuel System :: 1989 F250 5.8L Runs Great Then Dies After Warm
I just purchased a 1989 F250 with a 5.8 motor. Great truck for its age. Ive owned other Ford trucks in the past and my Dad had them as a kid. Love them.
When I bought the truck from the 2nd owner it had a problem so I bought this truck with the problem figuring with my past knowledge I could fix it. Not the case. When I got the truck it would start fine and run really great but when it got warm it seems it would die and I would have to wait till it was cooled down to start back up and again it would run fine. Well the problem got worse and worse and now it wont run at all.
It will run on starter fluid so that leads me immediately to the fuel pumps. I say that plural because none of them will run it seems. I did a fuel pressure test at the shrader valve at the top of the motor on the fuel rail and I get no pressure at all when I turn the key. The relay in the engine compartment seems to be working to as I can hear it. I put a new on of those on to to be sure. Leads me back to the pumps again. I replaced the external pump on the fuel rail and I know thats working. I replaced the fuel filter to while I was there.
Is it possible to have BOTH fuel pumps in the front and rear tanks go at once? Seems unusual. My other F150 with dual tanks worked great and when the back tank pump went I could just switch it over to the front tank.
Ford Excursion :: SES Light Came On About 15 Minutes Into Drive / Code P0174 - Bank 2 Lean
After installing Banks headers and full exhaust, I took my truck for another test drive this morning. SES light came on about 15 mins into drive and is telling me P0174 - Bank 2 Lean.
So that's the right/drivers side - my list of things to go check
O2 Sensor plug on that side
The MAF
The IAC
Vacuum lines ...
Ford 6.0L Power Stroke Diesel :: 2006 F450 - Runs Poorly When Cold / Better Once Warm
2006 F450 6.0 that I've owned since new. It has had 2 injectors replaced previously, EGR cooler with BPD, and a few other problem parts. As it is getting older, I have recently noticed it runs like absolute dog crap when it is cold. It can't even reasonably accelerate onto the hwy when cold. Once it is up to operating temp, it runs better. It still does not pull like it did when it was new and under 50k miles...but it is at least driveable once warm. I need to do some heavy trailer towing soon and need to get this thing back to accelerating good. What should I be looking at first for the horrible running condition when cold?
View 14 Replies