Ford Super Duty (1999-2016) :: Rough Idle And Stalls But Runs Fine At Higher RPMs - No Brakes
Let me start with I have a 2003 f250 5.4. The motor blew on my truck and I had a 100k motor dropped in it. I've put new spark plugs, ohmd out the coils. I tried both sets of injectors. cat delete and new fuel pump. It has rough idle and stalls but runs fine at higher rpms. Also has basically no brakes. I am thinking vacuum but I've check all the lines. No codes either!! also cleaned throttle body.
View 4 RepliesFord Super Duty (1999-2016) :: 2005 F250 - Lean Codes From A Bad Cat?
05 5.4 F250 4x4. Keep getting those codes. Can't find any vacuum leaks. swapped rear O2 sensors. Fuel filter twice in last 11k miles last time was 1k ago. Will the 430 code cause the lean codes from a bad cat? I've been getting the 430 code for at least 4 mo's.
View 6 RepliesFord Super Duty (1999-2016) :: Left And Right Bank Lean Codes?
What would be causing my left and right bank lean codes? Truck still seems to run fine. I have also been getting number 6 misfire. all within the past week. I know Its due for a tune up but would a simple tune up fix these codes. Also besides plugs and primary fluids what else should I be changing. I don't want to be getting to involved just the main stuff.
View 5 RepliesFord Super Duty (1999-2016) :: After Auxiliary Tank Added Truck Runs Then Dies Out
I bought a 2003 F550 Super Duty 4WD, cab and chassis truck. It has a 7.3 TD. Real nice truck. I bought it to turn it into a wrecker. I removed the factory fuel tank (was behind the real axle inside the frame rails.) I installed a 50 gallon aluminum tank behind the cab on the frame rails. The rear tank has to be removed for the wheel lift.
Any way I have everything installed and now the truck dies out after a few minutes. It starts up fine then dies out like its starving for fuel. The tank I installed has a sump pickup (tank came off a freightliner, so its not some home made thing I just welded up in the garage)
I was thinking about installing an auxiliary lift pump as the auxiliary tank is a bit higher than the factory tank, but I want to solve the issue not throw parts at it. I thought at first injectors but it runs perfect after I prime it so my guess is its not the injectors.
Ford Super Duty (1999-2016) :: V10 Runs Rough With 1/2 Tank Of Gas
My truck started running poorly with an intermittent miss about 6000 miles ago. The miss gets more consistent when the tank is below 1/2. Fill it up and the miss goes away. No codes, shop that does a lot of V10 camper work could not figure it out.
My guess is that the fuel pump is going out and it overheats when the tank is low. The problem is getting progressively worse. Now it misses slightly with 3/4 tank and even a full tank sometimes.
Plugs have been changed, fuel filter has been changed, and the shop found 3 COPs that were bad before all this new intermittent miss started. The truck runs ok at wide open throttle.
Am I just nursing a bad fuel pump that will leave me standed soon? Truck has 170,000 mile with original fuel pump.
Ford Super Duty (1999-2016) :: 2004 F250 V10 Runs Rough When Warm
2004 F250 V10, runs good until it warms up whether it's hot or cold outside. While on freeway, it really shakes while cruising, but of you get in the gas enough for a kick down, seems to be pretty smooth. I've changed the coils, and 9 plugs (one wouldn't budge, but the others I took out looked fine) to no effect. Where else should I look? Also, no CEL, and no codes, which seems odd as bad as it feels...
View 11 RepliesFord Super Duty (1999-2016) :: 2004 F250 - Runs Rough At 1500 RPM
So, my truck runs really rough when I am @1500 RPM and lightly feather the gas. I have replaced all coils and plugs. Used dielectric grease. Replaced air filter, replaced ICU, changed transmission fluid. The thing still "shudders" ... 2004 f250 5.4 ....
View 14 RepliesFord Super Duty (1999-2016) :: 2006 5.4l Runs Rough For About 10 Seconds When Started
Have a 2006 F350 5.4l that is mainly used as a plow truck. I drive it at least once a week when not plowing just to make sure it runs ok, etc. Only put on about 2,500 miles per year. Keep it in good repair - not by me, but by the dealer or mechanics.
Problem - last two times I started it, it started ok but runs real rough for about ten seconds. Sounds like the engine is going to die. After about ten seconds, it "catches" and runs normal. Have no problems when driving it. If I restart it, it doesn't do this, so it seems to only happen when the engine is cold.
Battery was brand new back in Sept. All plugs were replaced maybe 3 years ago, as was the cat converter and muffler. Run non-ethanol fuel. What might be causing it before I bring it in.
Ford Super Duty (1999-2016) :: F250 Runs Rough / Stalls And No Start
I just bought this 99 f250 7.3 Powerstroke last week.. drove it all week fine, I car pool with a family member to work and asked his girlfriend to plug my truck in for me, well she didn't and it had stalled on the way home one morning but started up after cranking a few times i thought nothing of it. Drove it a little bit that day and it was fine, while I let it idle in my drive way as I prepared to go work it started running really rough then died. It took a long time to start again..now it's happening all the time. I changed the fuel filter and someones telling me there's air in the lines..
View 5 RepliesFord Super Duty (1999-2016) :: 2002 F350 Stalling Out / Runs Rough Like There Is Air Bubble Then Smooths Out
2002 f-350 diesel 4x4 7.3l. It stalls out a few times lately( and starts right back up) and it runs rough like there is an air bubble then smooths out. Changed 1 fuel filter and the pcv valve. 96,000 miles.
View 6 RepliesFord Super Duty (1999-2016) :: 2003 - Replaced Coil Packs Now Runs Rough - White Smoke?
I have a 03 250 5.4 with 160k. I just recently replaced #4&3 coil packs. Truck was running great again. Then a few days later the truck was running extremely rough and white smoke from the exhaust. I noticed the pcv valve was not all the way in(pretty much out) put it back in and ran fine for two days now running rough every now and then and the pcv valve is making a vibrating noise but stops if I pinch it slightly. I did replace the plugs a year ago.
View 14 RepliesFord Super Duty (1999-2016) :: 2003 F350 2WD Won't Idle - No Codes?
2003 f350 2wd 5.4 auto cab and chassis with 40 gal rear tank replaced fuel pump/fuel filter/spark plugs/IAC no codes
View 7 RepliesFord Super Duty (1999-2016) :: 2003 F250 V10 Never Dies Just Loses Power And Drops Truck To Idle
We have replaced 4 fuel pumps on a row.
Voltage is good...even ran a fresh circuit.
Ran new supply lines
But, can't seem to understand the continued drop in pressure. It usually takes about a day of driving to crater after a new pump/filter is installed.
It never dies, just loses power and drops the truck to an idle. Funny thing...if I shut the truck off and turn it right back on...full power for a short period!
The truck is used on a ranch that has plenty of rough roads...thought inertia switch maybe but i believe that would stop fuel completely right?
I am totally stumped and so is the mechanic.
Ford Super Duty (1999-2016) :: Running Rough - Check Engine Light Came On And Got Codes P0171 And P0174
My 1999 F350 SD V10 that would crank but not start. I ended up checking numerous things because before it decided to truly stop running, it would run rough for a time and then be fine. The check Engine Light came on and I got the codes P0171 & P0174. Well, I bought MAF Cleaner and took the air cleaner housing off, disassembled it and thoroughly cleaned the sensor and replaced the air cleaner. I continued to get those same error codes, but before I could go any further, the truck totally died. It sat for nearly 2 months with the bed in the air as I had decided to lift the bed to check the fuel pump vs. drop the tank.
Fast forward a bit and I have since replaced the fuel pump and put $40 of Premium Gas along with Royal Purple Fuel Treatment in the tank because I figured things got stirred up and could use a bit of cleaning. I do not drive much, and during the first few trips, it ran perfectly. Then today, it started again with the rough running and trying to die if I let it idle. If I pushed on the gas, it would completely smooth out. If this were a carbureted engine, I would think the low idle was set too low, but since it is not, I am guessing it is one or more of the sensor/s that is/are causing the issue.
I am disabled and can’t play parts swap until I hit on the right part, so I was hoping that I might get some guidance here to narrow things down to the most probably causes so that I won’t go broke changing things until I hit the “right one”. The truck has 153,000 miles on it and I had bought it from a retired couple who used it to pull their 5th wheel travel trailer, so it had mostly highway miles on it. It was immaculate when I bought it and ran perfectly, needing only normal maintenance (oil changes, etc.) over the past 12 years that I have owned it. In those 12 years, I have put about 60,000 miles on it.
Ford Super Duty (1999-2016) :: 2006 E350 Started Running Rough - Codes P0264 And P0276
I have a 2006 E350 van, just recently had passenger side injectors replaced along with dummy plugs and stand pipes. I was at the car was spraying it off and noticed it started running rough, just figured maybe some water made its way into the engine bay and something got wet as it was running great. Well its stayed that way and i am getting codes p0264 and p0276. Digging around on the net seems like its ficm or wiring, ficm is 48 volts and 13.5 volts, connectors are on tight and i dont see any wire chaffing kinda stumped. hoping its not 2 bad injectors at once.
View 2 RepliesFord Super Duty (1999-2016) :: Random High Idle Sometimes When Put Into Park - Codes P0300 And P0401
1999 F-250 V10 .... Truck was running perfectly fine except for a random high idle sometimes when put into park but if I gave it a good rev it would drop back down to normal. I assumed it was a dirty IAC or something and figured I'd get around to it later kinda deal. I also had a coolant leak from what I thought was the intake manifold to head gasket on the drivers side right in the front where the upper radiator hose meets the intake manifold so i added water here and there no issues.
One night I need to pull a trailer and didn't have the wiring set up for it in the back so I stopped at advance auto and bought one of those kits that plugs into your brake wiring harness and then plugs into the trailer. I tested it in the parking lot with the trailer and it was all sorts of messed up. My reverse lights stayed on my brake lights didn't work either etc. Turns out it was for the wrong years but plugs matched up coincidentally. I returned the kit and drove home just fine.
Next morning on my way to work truck started misfiring like crazy idle was bouncing all over the place lack of power etc. I took it to advance again after work even though no check engine light came on I still pulled 2 codes. P0300 which is multiple random misfire (no specific bank) and a P0401 which is an EGR Insufficient Flow code. I took it by a local shop I get my oil down at and they told me it was probably the fuel pump that they go bad in these trucks alot.
So I replaced the fuel pump and the fuel filter. Nothing changed so I thought maybe that coolant leak had dripped down to the plugs or possibly the intake gasket was getting worse and leaking coolant into the air flow ports since it was thought to already be a problem. So i pulled everything off the top and firgured id go through it all why I had it apart. I replaced the intake gasket but noticed when i took it apart that it wasnt the gasket that the head it self had a small pin hole leak in the very front where the coolant fed into below that upper neck that bolts to the intake manifold. I patched it with jb weld/ quick steel/ and rtv. Yes I know it wont last but just for the time being until I figure out the main issue. Replaced the plugs with motocraft plugs checked all my coils for grime and corrosion or what not and they all seemed fine and cleaner than expected. replaced the gaskets and threw it all back together. I also cleaned out the EGR and IAC with air and brake cleaner etc.
Blew all my lines out with air and everything seemed fine. I also replaced my DPFE sensor. Started it up ran fine at idle for like 5 min no coolant leaks or anything so I thought I was golden then about 500 ft through the neighborhood on a test drive the exact same misfire came back doing the same thing with the idle etc. I'm going to check my fuses tonight but I'm starting to think that maybe when I plugged in that wrong wire adapter for the trailer that I may have screwed up something with the PCM. Only because the lights were all out of wack and literally the next morning I started having these issues. I'm lost if its not a fuse. I would really hate to buy a PCM and not need it especially after all the parts I've bought and not needed already.
The vacuum lines all seemed fine and intact as well with no cracks or leaks.
Ford Super Duty (1999-2016) :: 6.8L V10 Rough Idle And Hard Misfire
My F53 motorhome has a rough idle and hard misfire but is not setting any codes. I've put new plugs in it and not change.
View 7 RepliesFord Super Duty (1999-2016) :: 2000 - Rough Idle - Low On Power
I have a 2000 F250, SuperCab, 5.4 triton, 100,000 miles. It's been a great truck - got it at 63,000 miles. Once engine warms up, it has rough idle, and shift rough. I can give it gas to RPMs up and it smooths out some but is low on power. If this was my 76 F150, I would guess the vacuum hose off the intake manifold to the transmission came loose.
View 6 RepliesFord Super Duty (1999-2016) :: 2003 - Rough Idle And Low Power
I've got a 2003 6.0 that's got a rough idle and low power situation. Doesn't matter hot or cold it has a hard start issue but when it finally starts it has a rough idle, sometimes it has low power on take off but not always. FICM has 48.8 volts coming out, exhaust just had a new y-pipe (had a cracked bellow) absolutely no smoke coming out. When I drive it hard it's like a rocket no rough spots just did oil with filters and fuel filters, blue spring upgrade, and cleaned out the turbo.
View 2 Replies