Ford Transmission :: Take Off Output Flange Without Changing Tail Shaft?
Can I take off the output flange on the tranny and use a slip joint, with out changing the tail shaft?
View 1 RepliesFord Transmission :: Small Leak Around Tail Shaft Seal
I got a fmx mated to 351w, trans was on back of a 302 and no problems other than small leak around tail shaft seal but shifted great. Now I decided to install mildly built 351w so figured it'd be a good time to build tranny. Installed after build and immediately it was slipping. Pulled trans out took it back to shop and he said the forward seal was blown. Installed again, after about 15 miles same result! What could be causing this. It is fine in reverse, but slips bad in forward gears.
View 2 RepliesFord Transmission :: Vibration Occurring During Deceleration - Pinion Shaft Play
I had some vibration occurring during deceleration and though it was either the slip joint or the rear u-joint because I could sense some movement back there.
After I replaced the u-joints and properly serviced the slip joint I still had the issue (although it was a little better). I now see that there is a little bit of play in the pinion shaft. I can't really shake it back and forth, but if I hit it hard upward it clearly has play.
What should I do next? I have read a bunch, but would like to get an expert to chime in.
Ford Aerostar :: 1995 - Oil Leak From Oil Filter Bolts To Block?
My van is leaking oil from where the oil filter extension bolts to the block. Is it an o-ring or a gasket that needs to be replaced? Any unexpexted upsets that I should expect when fixing this?
View 13 RepliesFord Transmission :: Driver Side Axle Shaft Replacement / Bearing Retainer Is Starting To Slide Off
I have a 73 F100 with a 9" rear end. I need to replace the drivers side axle shaft as the bearing retainer is starting to slide off and I'm not willing to take a chance a new bearing and retainer will do it again. They are 31 spline axles and have the ball bearings not the tapered rollers.
What year trucks can I find a replacement axle shaft? Any other thing I should be aware of in finding a replacement?
Golf IV R32 :: Transmission Leak At Passenger Side Shaft
Noticed fluid under the car two days after my dyno run but assumed it was from excess GumOut. I ran 3 tanks of fuel and the car is dripping fluid so the GumOut is not the problem. Closer investigation lead to fluid build up around the drive shaft on my passenger side. The driver side fits flush with the transmission housing but the passenger side has a gap.
Is the gap normal? It looks strange, kinda like the shaft is sliding out from the transmission. Again, the left sits flush. There is a small rubber gasket between the shaft and the housing. My passenger side has a 1/4 inch gap from the shaft to the housing and there is no rubber gasket. The undercarriage is soaked now. I will fill up THE transmission with fluid and take it to PTP.
What is the problem? Bad seals? Is there something missing? Did the dyno mess me up?
Ford F-150 - 1997-2003 :: F350 - Exhaust Manifold And Two Of Lower Intake Bolts Broken
I have a 97 f350 crew cab xl stock everything. 351 windsor in it I do believe. as of right now He is broken down pulled apart in my garage. Due to a much requested headgasket replacement. In any event long story short I got him all apart to discover that there was someone in it before me & had broken the infamous exhaust manifold bolts (5) and two of the lower intake bolts, (of course I've tried the correct route in removing these broken bolts/studs but again the year of the truck (1997) & its bone stock no way their moving...
So of course I tried the next best thing (on a budget) which is to drill them out, but I went to far into the exhaust manifold bolt holes, And now I believe that I've ruined the heads is this so? If so who knows where i can get a decent set of bolt on heads ready to go. yes this is my daily driver & since He's been down I've been going deeper in dept.
Ford F-150 (2009-2014) :: 2012 - Mounting New Shocks - Torque Specs For Upper And Lower Bolts?
Mounting the shock with the boot up or down? I know it doesn't matter according to Bilstein but one way has to be better than the other.
Second. What are the torque specs for the upper and lower bolts? I know the lower front is around 350lbs but haven't found anything for the rest. found out the rear bolts are torqued to 66lb.
Third. The front shocks didn't come with a boot to protect the shaft. Is one needed when the shock is installed?
Truck is a 2012 F150 FX4.
Ford F-150 (2004-2008) :: 2007 V6 - Auto Tail Shaft Replacement
I'm working on a 2007 F150 V6 with a 4 speed automatic.. which seems to be a 4R70W. It has 36,xxx miles on it and the transmission tailshaft is cracked by the mount and leaking fluid.
The tailshaft can be replaced by itself without disassembling and removing the whole transmission right? The part number/Ford Engineering number on it is "RF-F3LP-7A040-AA" and it says 42A below that. Can I look for any tailshaft or just this number? F3 is a 1993 number isn't it? I don't know the length of it but it doesn't have a hole for a speedo cable.
Ford 7.3L Power Stroke (1999-2003) :: Water Pump Lower Elbow Bolts Torque Specs
I read 18lbs for the water pump but it took a cheater bar (perhaps due to corrosion) to get the water pump lower elbow bolts off.
On reinstallation, what should the lower elbow bolts be torqued to? Checked the sticky (Ziggy's Torque Specs) but didn't see the specs for this item.
Santa Fe (CM - 2007-12) :: Violent Vibration Above 65 Mph After New Tires Mounted
Just had new tires mounted and balanced on my 2011 Santa Fe. I purchased Toyo Celsius tires. I purchased the tires on line and had Faulkner Hyundai in Harrisburg PA mount and balance them.
When I drove to work 2 days later, I found that the vehicle starts to vibrate above 65 mph. When I get to 80 mph (typical traffic speed on I83 in the morning), the vehicle vibrates so badly that I shake in my seat.
This shaking leads to a feeling of lack of control. I'm hoping the dealer just screwed up balancing the wheels. Faulkner Hyundai uses a road force balancing machine.
My old near bald tires (the factory original Bridgestones) had a tiny vibration around 65 that went away as speed increased. With the new tires, the faster you go, the worse the shaking gets.
My 2011 Santa Fe still has under 30,000 miles on it!
Ford Aerostar :: Lower Panels Rusty?
BTW, most also have the same problem mine has, rust cancer of the lower panels! One shorty I saw, the lower panels were not even there anymore! Just jagged, rusty metal that started 1/3 of the way up the body of the van!!
View 14 RepliesFord Aerostar :: Trailer Tail / Park Lights Don't Work
Okay, so all of a sudden my trailer tail/park lights don't work. Determined that relay wasn't working so replaced it. Wrong answer, still no lights. Further investigation revealed that relay ground was not grounded. Who would have thunk it? Anyway, the wiring diagram shows that the ground wire has a diode in it. Where it's located and where the ground, (orange) wire originates from?
View 3 RepliesPassat (B6) :: Changing Lower Control Arms / Driver Side Bolt Is Hitting Transmission Oil Pan
I changed the Passenger side with no problem , the driver side bolt is hitting the transmission oil pan. I am thinking of loosening the mounts and try to jack the pan up to get that 1 clearance or worst case drain the transmission take the pan off remove the bolt and put in fluid in. If I drop the the transmission pan is there a filter in there? also how much transmission fluid does it hold.
[IMG] ....
Ford Ranger / B-Series :: Top 2 Bolts Removal Of Transmission?
How in the heck do you get the top 2 bolts off of the transmission housing? They seem to be positioned in such a way that they are impossible to remove.
View 14 RepliesFord - Ranger :: Significant Vibration When Coast At 65 Mph - Drive Shaft?
I had the universal joints replaced on my 1999 Ford Ranger now it vibrates badly starting at 45 mph and when I coast at 65 mph the vibration is very significant. The mechanic does not know what is causing this. I never had this problem before changing the U-Joints and I have 171,000 miles on the truck.
View 4 RepliesFord F-150 (2004-2008) :: Vibration On Acceleration That Seems To Come From Drive Shaft
2007 XLS Crew Cab 2wd. 60K miles When going through the 35 to 60 mile per hour range there is a vibration that seems to come from the drive shaft. Let off the gas and it goes away. After 60 mph it seems to be gone. I am thinking Trans support, motor support? One of the postings on this sight made me wonder about the transmission. By the way, I just bought this truck used and love it. Can I run flex fuel in the 4.6L engine?
View 1 RepliesFord F-150 - 1997-2003 :: 1999 - Automatic Transmission Removal / Mounting Bolts To Engine?
How does one get to the top mounting bolts to engine? Are special tools required? Is there an access plate?
View 6 RepliesFord Super Duty (1999-2016) :: Vibration Starting At 60 MPH / Drive Shaft Balance
I have a vibration starting at 60mph. Its slight but there. I crawled under and found a very shiny rectangle of metal. Safe to assume I flung a shaft weight? It drives perfect around town just at freeway speeds.
View 14 Replies