Ford F-150 (2004-2008) :: U-joint Replacement At The Differential Side Of Shaft
how hard is it to replace the U-joint at the differential side of the shaft on an 04 FX4? Any special tools needed? At low speed (5-10mph) sounds like someone tapping on the rear end with a ball peen hammer, I guess it is the u-joints.
View 2 RepliesFord F-150 (2004-2008) :: 2007 - Front Struts Replacement?
Looking for a link for a novice to see how to replace the front struts on my 07? I'm thinking I'm capable of getting them out, but will take them to a shop to compress the spring and do the switch.
View 3 RepliesFord F-150 (2004-2008) :: 2007 - Spark Plugs Replacement Every 60k?
My '07 had the check engine come in the other day, engine misfire. I took it to the dealer hoping it was a coil, due to the 100,000 mi warranty from Ford I was hoping would be covered. Sadly, and of course, all coils tested fine, turns out 2 plugs were bad. They replaced all 8 plugs, plus a plug boot. Not one plug broke (truck had 80k on it) so no extra cost there. So much more, but peace of mind that all the plugs are new one piece plugs is great. He recommended that they should be replaced every 60k to avoid any issues.
View 7 RepliesPrius (2004-09) :: Front End Shakes After Having Intermediate Shaft Replacement
My Front Suspension NOW SHAKES; After Having the Prius Intermediate Shaft Replacement Recall done!!
I took my PRIUS to the dealer this past week and had the Prius Intermediate Shaft Replacement Recall done.
Ford Transmission :: Take Off Output Flange Without Changing Tail Shaft?
Can I take off the output flange on the tranny and use a slip joint, with out changing the tail shaft?
View 1 RepliesFord Transmission :: Small Leak Around Tail Shaft Seal
I got a fmx mated to 351w, trans was on back of a 302 and no problems other than small leak around tail shaft seal but shifted great. Now I decided to install mildly built 351w so figured it'd be a good time to build tranny. Installed after build and immediately it was slipping. Pulled trans out took it back to shop and he said the forward seal was blown. Installed again, after about 15 miles same result! What could be causing this. It is fine in reverse, but slips bad in forward gears.
View 2 RepliesFord F-150 (2004-2008) :: Vibration On Acceleration That Seems To Come From Drive Shaft
2007 XLS Crew Cab 2wd. 60K miles When going through the 35 to 60 mile per hour range there is a vibration that seems to come from the drive shaft. Let off the gas and it goes away. After 60 mph it seems to be gone. I am thinking Trans support, motor support? One of the postings on this sight made me wonder about the transmission. By the way, I just bought this truck used and love it. Can I run flex fuel in the 4.6L engine?
View 1 RepliesLexus RX 2004-09 :: 330 / Tail Light Bulb Replacement?
Lexus IS: How to Replace Your Tail Light Assembly
Step by step instructions for do-it-yourself repairs
Browse all: Lexus IS Lighting Guides
Ford Aerostar :: Transmission Has Vibration Damper Mounted To The Lower Side Of Tail Shaft With 3 Bolts?
On my ongoing project, I have a replacement trans out of an Explorer. I have swapped over the bracket and will be changing the shifter shaft, but I noticed that the new trans has what appears to be some sort of vibration damper mounted to the lower side of the tail shaft with 3 bolts.
It is just a bracket that has a cast weight mounted in rubber. It was not a mount of any kind as the only bolt connection is to the trans itself.
The trans I took out did not have one of these, nor can I find any mention of it in the factory manual. The Explorer I pulled the trans from was a 92, my Aerostar is a 91. It doesn't appear that this device will conflict with mounting.
It is possible that the whoever installed the trans that I have removed forgot to install the damper, or it is possible that it is used only on the Explorer but not on the Aerostar.
Ford F-150 (2004-2008) :: OEM Steel Brake Line Rubbing On The Steering Shaft
Im working on my buddies 2005 F150 FX4. In the midst of buttoning everything up and calling it a day I happen to see fluid dripping. The OEM steel brake line had been rubbing on the steering shaft and while doing the brakes, must of busted through all of the way.
I have been to Advance and Napa at least 4 times trying to match stuff up. Nothing works from either of them.
Called Ford and talked to a parts guy who lacked general automotive knowledge and finally had to pull up there diagram to show him the correct part. He told me that part is discontinued and cannot be ordered.
It is #2264 in this diagram.
2005 Ford F-150 Front Brake Hydraulic Hose | FordParts.com
I have the factory fittings and everything to make a new line. I cannot find tube that is 5.20mm or .20". Everything I find in a roll is either 3/16 or 6mm.
The fitting is a 12mmx1.00 on the ABS brain. The caliper hose appears to be a 3/8x24. A 10mmx1.00 which is standard metric 3/16 tube nut is to big for the OEM caliper hose. A standard 3/16 flare wont seat on the caliper hose.
So it seems like what Ford did here was.... a 12mmx1.00 on a 5.20mm tube to a 3/8x24 to a caliper hose that wont seat with out 5.20mm tube.
Ford F-150 (2004-2008) :: Clip Holding Shift Cable To Trans Selector Shaft Broke?
On my 04 150 auto, the clip that holds the shift cable to the trans selector shaft broke, Ford says i need to buy the whole cable and what did you do?
View 2 RepliesFord F-150 (2004-2008) :: 2006 - Right Tail And Brake Lights Don't Work
I have a 2006 King Ranch and right tail and brake lights don't work. The bulb is good. The fuse diagram in the owners manual is not the fuse box I have, so I cannot id the correct fuse to see if its bad.
View 4 RepliesFord F-150 (2004-2008) :: Mount Of Weight Tail Gate Can Support?
I'm wondering what the safe limit is for the amount of weight the tail gate can suppport ?
I need to get some 4x8 sheets of dry-wall and instead of leaving the tail gate down i'd rather have it up and support the pieces, but at 50-60 pounds a sheet I'm somewhat concerned about how many sheets the tail gate can support without causing issues.
Ford F-150 (2004-2008) :: 2005 - Tail Light And Turn Signal Not Working?
I have a 2005 F-150 and the tail lights and turn signals stopped working. Only the park light seems to work and it very dim. I replaced the bulbs and that did not fix the problem, so I checked with a volt meter and I'm only getting 6 volts to the socket. Fuses appear to be good.
View 1 RepliesFord F-150 (2004-2008) :: 1998 4x4 -Tail Light Stays On When Truck Turned Off?
My sons 98 F150 4x4. First off he had a head light go out and replaced the bulb. Then a day or so later his tail lights would not go out after he turned the truck off. I had him to replace the pressure switch(I think that's what it is called ) anyways, that didn't work. So now he takes out the fuse every time he turns off the truck, just so the lights will go out. But, when he puts the brake fuse back in, the brakes work fine, but his windows will not roll down. I am totally confused with what is going on.
View 1 RepliesFord F-150 (2004-2008) :: Tail Light Does Work For Hazards / Turn Signal Or When Braking
I have a 2004 F150 XLT and the passenger side tail light doesn't work whatsoever. The light does work for hazards, turn signal, or when braking. The passenger front turn signal works, so does the front and the driver sides tail light. Only the 1 tail light doesn't work. I bought a new brake light bulb and it didnt't fix it, so i swapped the drivers and passengers bulbs out, and it still didn't work. I replaced the 10 amp fuse (#36) in the fuse box. What is causing the problem.
View 2 RepliesFord F-150 (2004-2008) :: Tail / Turn / Backup / Flasher / License Plate Light Won't Working?
No tail, turn, backup, flasher, license plate - NOTHING. i checked fuses - cleaned both connectors under the truck by drivers door, cleaned connectors by the spare tire (2) one large one and one small round, the cleaned ground lug on top of spare tire bracket, all bulbs are new. cleaned with LPS contact cleaner, they were new and shiny and reinstalled. NOW - turn is very weak and when i push on brake they go off and the front blinkers blink twice as fast? I a aircraft technician and know my way with an ohm meter but totally stumped.
View 8 RepliesFord F-150 (2004-2008) :: Intermediate Steering Shaft Replaced - Hard Steering
Replaced the Intermediate Steering Shaft at 114,000 miles. Symptoms felt like power steering going out but no pump noise or low fluid. Steering became hard to turn and it sometimes felt like a tie rod was letting go.
Temporary resolution was to spray the two steering shaft joints with penetrating oil (PB Blaster). That freed them up pretty well. Then I ordered Dorman part 425361 (425-361) from Rock Auto. Simple enough job. Lots of good vids on YouTube.
I don't recommend spraying the steering shaft joints as preventative maintenance. Penetrating oil will get into the needle bearings and break down the bearing grease. That will cause the joints to fail over time.
Two side benefits, the truck steering is much smoother and small road bumps and potholes are much less noticeable. Feels like it was when new.
Ford F-150 (2004-2008) :: Auto Light Sensor Does Not Activate Headlights
2004 f-150. When I put the light switch in "auto" position and it gets dark, only the parking lights come on. The headlights do not come on. The headlights work when I put the switch in the "on" position, however. This makes no sense to me.
View 1 Replies