Santa FE SM (2001-06) :: 2003 Car Lurches When At A Complete Stop With Brake Fully Applied
Just got a 03 Used Santa Fe 2 weeks ago... 79,000 miles
1. Car "lurches" when at a complete stop w brake fully applied out of no where, so strong that I could easily rear end someone...
2. told dealership car was pulling to right, they said (after some teeth pulling) that a ball joint was replaced and Santa Fe's don't need alignments but in MA this is part of state inspection and considered a safety issue, needless to say, they say I have to pay for it...
3. Rear brakes seem to be hanging up...
All I want is the issues fix.
Santa Fe (CM - 2007-12) :: 2009 - Rear High Mount Stop Lamp Bulb Replacement
How to replace the bulbs of the rear high mount stop lamp on a 2009 Santa Fe?
I got the bulbs already, located the 2 nuts on the inside directly behind the brake light, but when I remove them, the assembly won't pop out.
I know the manual says they recommend getting these particular bulbs replaced at an authorized Hyundai dealer, but since I already bought the bulbs, I'd like to try and do it myself if at all possible.
Ford Wiring/Electrical :: 2010 - No Brake / High Mount Brake Light / Rear Turn Signals?
2010 F-250 14,000 miles, gas engine with Knapheide utility bed. Tilt wheel has been kept in the up position from day 1.
The problem:
No rear brake lights.
No high mount brake light.
No rear turn signals.
No rear hazard flashing lights.
All trailer lights work.
All other truck lights work.
Things checked: Fuses all OK. Visual inspection of multi-function switch. Looks clean. Brake switch at brake pedal has power on one wire. Jumpered the other wire-no brake lights.
I need to haul my trailer and am nervous when I see a Savannah, GA metro police car.
Passat (B5) :: High Mount Center Brake Light
Can this be changed easily by a non-dealer? The local Autozone doesn't list any replacement bulbs or assemblies, and I can't see a simple way of accessing the light assembly from the trunk.
View 1 RepliesAurora :: 1995 - High Mount Brake Light Not Working
Someone mentioned to me this week that my high mount brake light was not working. No big deal, just a burned out bulb I assumed. Well, I replaced the bulbs (two bulbs) and it still does not work. The sockets look fine, no corrosion. The wiring that I can see looks good. I used a volt meter & found I'm getting no juice at the socket . . ? Is there an in line fuse or something else simple I should check. I'm thinking this should be an easy fix & am frustrated I can't figure it out. By the way, my lower brake lights are working fine.
View 3 RepliesFord Aerostar :: 1995 - High Mount Third Brake Light
Trying to replace the burnt bulbs. Did the obvious: removed the two screws but in no way could I take the red lens off. I pried hard almost broke it but it's not coming off. It feels like some other mechanism holding it down. It is the one on top of the lift gate. The inside is just a hole with wires going through. What's the trick?
View 12 RepliesSanta FE SM (2001-06) :: High Pitched Whine - Parking Brake And Battery Light Came On
First I noticed that the parking brake light and battery light came on, which would indicate an alternator problem. I took it in, they cleaned up the engine, replaced a few hoses and said the alternator was fine. Two days later I'm driving home, I make it to my driveway and the battery dies. I was able to charge it up and dive it back to the station where they told me the alternator had burned out...
A few days later I notice my brake lights weren't working, but that was just a blown fuse.
Starting today, there is a high pitched whine when I'm driving. I can barely hear it when I'm idle, but going up to 20 or 30 it gets very loud, then kind of dies off. It definitely gets louder when I'm accelerating, vs going a steady speed. As I was driving earlier, the air bag light came on for a brief second, and I didn't think anything of it, until later tonight when I was driving home and it came on again, but this time it stayed on.
Santa Fe GLS, 135,000 miles
Lexus ES 2007-12 :: 2010 ES350 - High Mount Third Brake Light Removal?
My wife's 2010 ES 350 third brake light has an intermittent LED issue. The last 3 LEDs on the pass side flash on/off when the brake is depressed. My understanding is there may be a broken solder joint. My problem is I can't seem to get the assembly out. How the high mount assembly is mounted and how to remove it?
View 2 RepliesCamry :: 2002 - High Mount Brake Light On Spoiler Half Burnt Out
Just bought an 02' camry and the high mount brake light on the spoiler is half burnt out. Tried removing what I'm guessing is an LED assembly but the screws are stuck and the angle is really awkward. Am I going to have to replace the whole LED bar?
View 2 RepliesAvalon 2005-12 :: 2007 - High Mount Brake Light Works Sporadically
My high mount break light works sporadically. When I break, sometimes you can see it as bright as it can be, other times it is dim, and then sometimes no light comes on. The dealership could not even figure out how to get to the led unit.
View 8 RepliesLexus SC430 :: High Mount Brake Light Assembly - Intermittent Connection?
Lexus has diagnosed a ground fault with an intermittent connection.... I am not sure how to proceed ... Could it be a light bulb connection... or does it even have these? Can the part be serviced in place... or must I replace the whole assembly?
View 4 RepliesSanta FE SM (2001-06) :: Error Code U0D00 - Engine Will Rev Really High When Moving After Stop
I got an Error Code of U0D00. What this is or means. The scan tool says to refer to your manual but I don't have one.
What the vehicle is doing is that it will work fine for a while then when you stop (in park) the engine will rev really high and back down all by it self for example. It will go up to 3.5 and back to 1 rpm repeated. Then when you start moving the car it will continue to idle higher like you are pressing the gas. During all of this the check engine light will appear?
Santa FE SM (2001-06) :: 2003 - Odd Noise From Brake Pedal In Stop And Go Traffic
I've been noticing an odd noise in the brake pedal in our '03 Santa Fe. I don't hear it all the time (almost never on the highway), but especially hear it in stop-and-go traffic. It's sort of a whirr, a "RRrrr". I've googled and watched YT videos and it's definitely not a hissing sound or a grinding sound, nor do I notice any difference in the brakes' responsiveness.
I'm apprehensive of taking it to the dealer for service because I only plan to have this vehicle for at most three more weeks. Have only held onto it this long because we couldn't afford to replace it until we sold our house-- which we've just done, and are about to move to a city about an hour away on 7/5. We'll trade in the car within a couple of weeks of moving.
The noise is definitely from the pedal and isn't anything like squeaking brake pads (I currently live in the DC metro area, so squeaky brakes become very familiar with all the stop-start traffic!). The videos I've found that point to a booster problem have a decided hiss, and it's not that either. Don't want to be unsafe in the time we've got left, but also don't want to throw another thousand bucks (every time something breaks in that darn thing, it always seems like it's about $800) into a car we won't have in a month's time.
Santa Fe (CM - 2007-12) :: High Mounted Stop Light Bulb Replacement
I need locating the locking clips that hold the high mounted stop light assembly in place. Are there any diagrams?
View 6 RepliesSonata NF (2006-10) :: Brake Pedal Sinking If Pressure Applied After A Stop
I have only 42k km or 26 k miles. Brake stops but soft. The brake pedal sink if you apply pressure after a stop. Feels like someone open a valve. The pedal go to very low. I am find the stopping power is poor. Brake fluid is brownish. I hope it is not the master cylinder.
View 20 RepliesSanta FE SM (2001-06) :: 2004 - Rough And Smokey Start Up / CRDI Glow-Plug Location
I want to change the glow-plugs on my 2004 Santa Fe CRDI to see if it cures its rough/smokey start up, but I am not sure of their location. I think they might be under the intercooler, but I don't want to strip it all down to find out they are not there.
View 8 RepliesElantra GD (2013+) :: Spoiler High Stop Brake Light Has Heavy Condensation
Noticed water droplets or heavy condensation in their high stop brake light (2015 model)?
I've noticed a small crack. The crack seems internal and not completely through so I don't think that is the reason. There also seems to be a vent around the water washer nozzle which should allow the light to dry out. It just seems to be taking days! Do that gap around the washer nozzle is intact a vent or are theses lights sealed. My one is the LED version.
Santa Fe (DM - 2013+) :: Front Left End Clunk Noise When Brake Applied
Notice a clunk noise when brake applied and first it seems when the car is turning right, but now I think as long as the surface is uneven it would do that as long as the brake is applied at the same time. It's a 2014 Sport Ltd.
View 4 RepliesFord Wiring/Electrical :: Driver Side Brake Light Goes Out When Brake Pressure Is Applied
I have a 1962 ford falcon ranchero. The driver side brake light, goes out when brake pressure is applied, but is on when lights are fully on, but even then brake pressure is applied and goes out. Right brake light is fine. And turn signal on right works. But driver side back light goes out when brake pressure is put on and when turn signal is put for left side. Right makes a turn noise left side doesn't. I recently replaced the turn signal switch. So its brand new. But older wires every where else. No cuts anywhere on wires. Fine. And replaced the bulb also.
View 8 Replies