Ford Aerostar :: Changed Modulator But Van Still Will Not Shift Into Overdrive?
95 3.0 aerostar. There was plenty of ATF in the vacuum line, hopefully this modulator replacement will fix the loss of ATF and will stop the oil from over filling, I had like 3 quarts above the dipstick line, I am assuming this was ATF going into the crankcase because of the bad modulator...
View 3 RepliesFord Aerostar :: 1995 - Won't Shift From 1st To 2nd / 2nd To Third?
This van has the A4LD transmission. I know nothing about transmissions, so, when it wouldn't shift from 1st to 2nd, or, 2nd to third, I researched it on here and found a lot of bad reviews. I also found out that it was likely the modulator gone bad, and how to replace it. I replaced it, and although the new one was restricted and the old one wasn't, shifting was back to normal. So, I was thinking, that was easy enough, pretty good for the original tranny which has 297,623 miles on it, and hasn't been serviced since the first 1k!
Well, that lasted about 75 miles. Now it won't go forward or backward. Everything is still in place, no leaks, fluid level is full. I didn't change the fluid or do anything other than change the modulator. (My friend can't afford to service it properly. Now it may need replacing!) I have only seen problems shifting between gears and OD, TC lockup, etc., but, nothing about not moving at all. What might be the problem? Is the tranny history?
Ford Aerostar :: 1995 Won't Shift Out Of Park
I just picked up Aerostar #6 and am in the process of transferring parts etc. Got this one cheap as it was badly abused and has issues. Big problem, the shifter takes a lot of wiggling etc to get out of park. Is the interlock easy to disable? If so how? Or would a good column from my 93 be an easy plug and play proposition?
View 1 RepliesFord Aerostar :: 1995 - Hard To Shift Out Of Park
I have a 95 Aerostar that when in park it is hard to shift into reverse, drive etc. It is an automatic, 3.0 liter.
View 7 RepliesFord Aerostar :: 1995 - Automatic Transmission Won't Shift Into Overdrive
My 95 ford Aerostar 3.0 automatic trans wont shift into overdrive, here's what happened. a small hose on the side of the transmission came off, this must have popped off when I was stepping on the gas with the brake on in drive and reverse. It took 2 months to find the hose off, during those 2 months I had to shift the van manually, you had to get high RPMS before it would shift.
About 2 weeks before I found the problem I notice the van would not kick into overdrive. When I finally found the issue and reconnected the hose the trans shifted fine but still would not kick into overdrive though. Is there another vacuum hose that goes to the main vacuum housing? or an adjustment on the linkage area? This has been like this for about 6 months now and I can go on a highway..
Ford Aerostar :: 1995 - Loud Noise From Trans Area While In Gear
I'm not real sure what just happened this morning but my '95 Areostar stopped moving. While in gear there is a loud noise from trans area and the axles are no longer connected to the transmission. I think the trouble is in the electronic AWD portion. I thought at first the driveshaft fell off it was that loud. Where do I start tearing into it?
View 3 RepliesFord Aerostar :: 1998 - Transmission Won't Shift / Stay In 1st Gear
It's a 1988 with a 3.0 engine and an automatic transmission. It doesn't want to shift. I can make it shift manually, but if I leave it in OD, it wants to stay in 1st gear . If you fiddle with the accelerator, you can get it to shift. Then it wants to stay in 2nd, and so on.
Like I said, if I use the gear selector to manually shift, it will go to all four gears just fine.
My thoughts are a vacuum leak (a big one) or a faulty vacuum modulator at the transmission. No, the vacuum line to it doesn't have tranny fluid in it, but I replaced it, and I wonder if it's bad. Yes, I made sure to put the little metal pin/link back in it.
Ford Ranger / B-Series :: 1993 - Taking Longer To Shift Into 2nd Gear / RPMs Are Way Up
Recently my 93 Ranger 4.0 has started to take longer to shift into 2nd gear and the rpms are way up there. shortened 2nd gear then 3rd will be fine and so on. This only happens after the engine goes completely cold. I took it to a transmission shop and they said tranny is fine...Other than this issue the truck is fine.
View 6 RepliesFord Aerostar :: 1991 - Shift Cable Popped Off Gear Select Lever
I have a 1991 Aerostar 2wd 3.0. I recently had freeze plugs replaced and the mechanic had to drop the tranny to get to some. Now the shift cable has come off the gear selector lever. I have googled everywhere and can't locate the procedure for reattaching it. My mechanic was doing the work on the side and charged me only labor for his assistant. He is at work right now..
View 5 RepliesFord - Crownvictoria :: 1995 - Unable To Shift Gear If Start Car In Park?
I have a 1995 Ford Crown Victoria. If I start the car in Park, it will not shift. IF I start the car in neutral, I can shift gears with no problems. In conjunction, the turn signals work well, but I have no brake lights.
View 1 Replies4Runner/GX470 :: 1995 - Transmission Takes A While To Up-shift As Get To Last Gear
My transmission up shifts fine for the first couple of gears, but as I get to the last gear (I think it is the last gear), my transmission takes a while to up-shift. I am at 3000 RPM before it up-shifts then goes down to 2000 RPM on the next gear. Is there any fix that will not require a new tranny?
View 4 RepliesFord Aerostar :: 1991 - Running Rough / Very Low Vacuum
1991 aerostar 4.0 ... My van was running well til last week.it allegedly has 77000 miles on it. It started running really rough within a 50 mile period. I've quit driving it til I am sure. I am not harming it. I put a vacuum gauge on it. It wildly fluctuates between 3 and 7 pounds at idle. I've tried plugging the four vacuum lines one at a time to eliminate the accessories as the problem.the check engine light is off and my scan tool shows no codes.i unhooked the exhaust at the manifolds to make sure the cats aren't clogged.it doesn't have egr. There's no water in the oil or bubbles in the radiator.i have a compression tester but id like to avoid trying to get to the plugs unless necessary.
View 5 RepliesFord Aerostar :: A/C Blowing Through Defrost Only - Where Are Vacuum Hoses
My 2005 Freestar (not the Freestyle) a/c is working properly except that it is only blowing through the defrost. I've read other posts about it being a leaking vacuum system on other ford vehicles that cause this problem.
1) I'd like to confirm that this Freestar a/c works on a vacuum system to open the a/c duct doors.
2) If it is, where are the vacuum hoses located? I'd like to check them to see if they are connected or if they have a hole.
Trans Sport :: 1995 - Disable Auto Door Lock On Gear Shift
Is there an easy way to do this...???
View 2 RepliesFord Aerostar :: Vacuum Leak - Small Crack In The Hose
Searched several times over the winter. Finally tore each hose out one at a time and went carefully over it before returning or replacing.
Turned out to be the long formed semi flexible vac. hose that runs from the gas fumes purge tank control valve group to the throttle body across the top of the engine. Ripped it out, on one of the bends was a small crack all the way thru, apparently would open up wide when stressed and cause problems. Mainly on hill pulls or hard acceleration but not every time. NO hair left after this one.
Replaced, deleted the codes. Runs like a top.
Still amazed at how much power these 4.0L V6 OHV Fords have from low speed on an uphill on ramp drag race.
stirs the old hot rodder blood.
Ford Aerostar :: 1995 - Control Arm Bushings?
can you replace the upper control arm bushings (pass side) with the arm still in the truck?
View 8 RepliesFord Aerostar :: 1995 - ABS And Brake Light On
I have a '95 Aerostar where the two lights are always on. I'd like to pull the codes if i can. Does this year has the RABS or the RABS II module. Or is the diagnostic connector the same?
View 14 RepliesFord Aerostar :: 1995 - Outer Tie Rod Replacement
I was wondering how do i replace the outer tie rod on a 95 ford aerostar awd 4.0L. I have enough for the parts but not extra tools. Need a tutorial on how to do it?
View 6 RepliesFord Aerostar :: 1995 - Stalling When Hit The Brakes Hard
When I hit the brakes hard like seating the brakes the Aero would stall....
View 12 Replies