Ford 7.3L Power Stroke (1999-2003) :: Driver Side Battery Is Missing With The Cables Snipped
I purchased a 2000 7.3 dually 4x4 and the driver side battery is missing with the cables snipped.
I noticed the headlights do not function, neither do the brights, the air does not blow. Is this related to the missing battery? Someone said they are on same circuit and dont do separate tasks.
Still starts runs drives fine...
Ford 6.0L Power Stroke Diesel :: Positive Cables Of Battery Sparking?
I'm pretty new to working on cars let alone a diesel truck, so this could well be something simple and / or dumb. Hopefully it is.
Batteries recently replaced. Started cleaning terminals on driver side and realized I needed a couple of fasteners. Between getting them, the weather going bad and getting sick that battery was unconnected for several days, truck not driven.
Finished cleaning the terminals this afternoon, went to connect the positive cables and they're sparking. Driver side negative cable is unattached. Neither of the two positive cables sparks when touching positive battery post alone. They only spark when they are brought together.
Ford 7.3L Power Stroke (1999-2003) :: 2000 E450 - Low Voltage On Gauge With Good Battery - No Start Condition
2000 Ford 7.3 E450 120,000 miles...
I have changed the CPS twice
I have checked the resistance of the injectors at the IDM connector with a volt meter and the harness reports back good.
The truck will run with ether for a few seconds
I have changed the fuel filter.
The fuel bowl fills quickly
I have unplugged the ICP.
The truck is showing low voltage on the gauge with a good battery. Around 10v
I have connected my 200amp car starter and I never see over 10v. I plan to check the grounds, but I am at a loss.
Everything is difficult because this is a van body so space is limited. I have also plugged in the block heater for an hour and that hasn't made any difference. Where can I get the best price on an AE scanner.
Ford 7.3L Power Stroke (1999-2003) :: Found Some Cut Wires Under Dash?
I opened the panel to plug in my new clock spring and found some cut wires hanging down. I don't have a wire schematic to try and look them up. It's not a trailer controller that's plugged in.
View 6 RepliesFord 7.3L Power Stroke (1999-2003) :: 2002 - Adding Hide Away Strobes - Enter Wires From Rear?
I'm currently adding some hideaway strobes into my 02 POV and was wondering if any good place to enter wires from the rear of the vehicle? I'm not wanting to drill any holes and worst case I'll go through the firewall with my other runs and run down my door jam. All my connections are behind my rear seat.
View 6 RepliesFord 7.3L Power Stroke (1999-2003) :: Electrical Power Fluctuations EGT Gauge Failure
I am on my third EGT gauge. My mechanic installed it as per "auto meter" specifications. He told me, the only reason he could find that the gauges have been failing is low voltage output. I have an onboard compressor for my airbag suspension and every time I start my vehicle it runs to fill up the air system. The voltage drops to 11.1V. It comes up once all is running and the compressor quits. is there any such thing as surge/brownout protection for these systems?
View 1 RepliesFord 7.3L Power Stroke (1999-2003) :: Gauge Went Up When Jumped It
I need a part number for the temp sensor for my truck. The dummies at advance have sold me the wrong one 2 times now. I used a jumper wire on the plug to make sure I didn't have a broke wire somewhere. The gauge went up when I jumped it. Went and got a new one and it still don't work
View 14 RepliesFord 7.3L Power Stroke (1999-2003) :: Where To Install Oil Pressure Sensor For Gauge
I need to install an oil pressure sensor sending unit. I've already occupied the 1/8"NPT test port on the rear of the oil cooler, where else might I be able to tap into oil pressure? (LPOP)
View 4 RepliesFord 7.3L Power Stroke (1999-2003) :: Not Starting - No RPM Reading On Gauge While Cranking
Just bought this 1999 7.3 drove it a couple days now and got to walmart today. shut it off to go inside and came back out. turned on key waited for wait to start to go off. cranked the motor over but it didnt fire. i tried it again and nothing. oil is full, oil pressure is good while cranking. no rpm reading on gauge while cranking. no check engine light. batteries are literally brand new two weeks ago. Cam sensor?
View 4 RepliesFord 7.3L Power Stroke (1999-2003) :: Fuel Gauge Goes To Beyond Full And Stays There
Two years ago I acquired a very very nice 2001 F350 DRW crew cab. The person I purchased it from put a Remanufactured 7.3 in it and set the truck up to pull wedge trailers. He put 25K miles on it and put it on Craig's list where I found it. It just turned over 300,000 miles.
One of the changes he made was to install a 70 gallon fuel tank in the frame rails below the bed. He told me that when the gauge reads EMPTY there is still 20 gallons in the tank. I remember him telling me that this anomaly is due to using the stock Ford pickup in the larger tank.
I have never filled the tank because so far the truck is used locally. I usually put 10 to 20 gallons in and when it gets to E I do the same fueling.
Then one day I turned the key on and the needle went up and beyond the full indication.
I can get under it and maybe the tank has some name or model number on it.
The truck runs fine, but the gauge concerns me. Eventually the truck will be making round trips from Chicago to our retirement home in Santa Fe, NM. It would be nice to have a working fuel gauge!
I have spoken to the person I purchased the truck from. He installed the tank as part of a complete upgrade that included a re-manufactured 7.3. The fuel tank is a 67 gallon Titan mounted between the frame rails. He believes that the original Ford sending unit was installed. That means it has 300,000 miles on it. I had the truck on a lift yesterday and it is a very tight fit. The garage said the best way to do the repair is to remove the bed. Six bolts, disconnect the tail lights and the 7 pin trailer connector and it is off.
So, my questions now are... Should I stay with a new Ford sending unit or are there better ones to install? Are there any other updates to the fuel delivery system that should or could be done at the time?
Ford 7.3L Power Stroke (1999-2003) :: Some Gauge Reads Towing Light
Towed 3 axle trailer loaded with a 73 VW bug, two implement bars, plows and a small boat. I would guess total weight at 7,000 max. The ambient temp 97 degrees and very humid. I have a 2000 dually.
The following are from the ScangaugeII
TFT trans temp 175 max
EOT end oil temp 205 max
SLP trans slip 0.20 max and 0.0 in high gear
From glow shift
Water temp 196
The one I am worried about is the trans slip, from a stop taking off always went high 0.15 to 0.20 and then drop quickly. Once the TC locked 0.0 down the road. Also, when I reverse with no load on dirt I have seen 0.20 on the trans slip. I have Forscan but have not logged any temps yet....
Ford 7.3L Power Stroke (1999-2003) :: Fuel Gauge Stuck On Full
Well besides the pyro breaking friday BEFORE live tuning,and the exhaust leak I gained on the way to Texas(not inpart of the pyro not working). Now the fuel gauge is stuck on full. It looks good,200+ miles and still on full. Could it be the gauge,or possibly just the sending unit? Maybe a fuse?
View 14 RepliesFord 7.3L Power Stroke (1999-2003) :: Installation Of Fuel Pressure Gauge?
I bought an Autometer 4763 gauge that didn't come with the correct fittings to plumb the sender into one of the extra ports on the back of the bowl. I went to the Ace hardware store right across the street and they didn't have anything (not surprised) and then Napa. They couldn't find a fitting to match either. He found that the plug threads are 7/16 20 tpi and the sender is 1/8" NPT. He suggested getting a 7/16 20tpi bolt, drilling it rifle-style, and then tapping it for a 1/8" NPT. The alternative, and what I ended up doing, was to use brass fittings to tee it off one of the supply lines to the heads. I ended up going that route but wanted to know if I should have looked harder for the right fitting.
Here's a pic of what I have now. I've test fit it, and it seems to work although I will need to insulate the hard lines because they rub due to the offset.
Ford 7.3L Power Stroke (1999-2003) :: Fuel Gauge Reading Inconsistently
I've had an ongoing issue with my fuel gauge reading incorrectly, and now I'm trying to fix it! Basically, it will change all over the place while I'm driving (not erratically, but definitely moves occasionally). I recently fixed my overhead display, but the "miles to empty" display doesn't seem to be very consistent. It will read 450 miles to empty, and then the next time I look at it, it will have dropped 100 miles or something (after minimal driving).
So I'm wondering where I need to begin looking to fix this problem. I've replaced the dash cluster using Circuit Board Medics, so I'm fairly confident that's not the issue. I've read that it can be the fuel pump or the fuel tank sender, but how to check if these are actually the problem or how much time it will take. Luckily, I've never run out of fuel and been stranded, but I need to fix this or it's only a matter of time!
Ford 7.3L Power Stroke (1999-2003) :: Coolant Temperature Gauge Not Working
Basically my coolant temperature gauge either reads as the hottest it can be, or the coldest. It doesn't jump around a whole bunch, but it's always all the way to one end or the other. From what I've read there seems to be a lot of different temperature sensors, so I get a little confused with all of the abbreviations, but I'm fairly certain I checked the correct one, next to the thermostat housing.
Using a multimeter I checked the resistance of the sensor, and it was around 600 ohms about 30 minutes after it had been driven. I'm not sure if this is where it should be or not, but it was rising as the truck cooled off.
Anyway, I'm not sure if I just tested the sensor incorrectly or if there could be another issue. A friend of mine suggested that the thermostat may have gotten stuck or something, but it doesn't seem like the gauge would switch at all if that were the case. What I should check to try and fix this.
Ford 7.3L Power Stroke (1999-2003) :: Fuel Pressure Gauge Installation
Looking for pics of where/how they mounted their fuel pressure gauge? I'm getting ready to install one.
View 11 RepliesFord 7.3L Power Stroke (1999-2003) :: Temp Gauge / No Voltage At Sending Unit
I've read some treads on the temp gauge sending unit but I'm a little foggy on where to look for my problem. I just purchased a 2000 F250 7.3, temp gauge not working. It has a new sending unit. I read some threads about the voltage at the plug but I have no voltage on either side of the plug. The way I understand it red/white wire goes to the battery. Is there a fuse between them and which one is it? and if fuse is ok is there a cronic problem that someone might know of that I can look for?
View 7 RepliesFord 7.3L Power Stroke (1999-2003) :: Crank But No Start With 1/4 Tank - Bad Fuel Gauge
1/4 tank just kept cranking. Added some diesel and started right up thought it was bad fuel gauge. Went about a mile and shut down just off. coasted went got more diesel but this time cranked but no start. anti theft light was flashing too.
Towed home started right up after tow... Starting now... Tomorrow was going to change the fuel filter....
Ford 7.3L Power Stroke (1999-2003) :: 2000 F250 - Gauge Cluster Replacement
I just bought a 00 f250 cc that originally came out of Canada so the speedo and mileage is all in kilometers. I have bought a use cluster that is in standard units to replace it with. I am just curious if all I have to do is replace the cluster or if there is other thing that need to be replace as well to make it work right.
View 12 Replies