Ford 7.3L Power Stroke (1999-2003) :: Adding USB Power To Rear Of Cab?
Was thinking of running a USB to each of the back doors (through the flip out ashtray) in my crewcab. Was looking at using something like this.
View 14 RepliesFord 7.3L Power Stroke (1999-2003) :: Found Some Cut Wires Under Dash?
I opened the panel to plug in my new clock spring and found some cut wires hanging down. I don't have a wire schematic to try and look them up. It's not a trailer controller that's plugged in.
View 6 RepliesFord 7.3L Power Stroke (1999-2003) :: What Gauge Wires The Battery Cables
What gauge wires the battery cables are on these trucks? Son in law has some really corroded cables on the Excursion. I was going to pick up some welding cable and replace them, but a quick glance looks like different sizes for different cables.
Looking for a list of gauge and length for each one to save me a little time?
Ford 7.3L Power Stroke (1999-2003) :: 2002 - Cleaning Rear Differential?
...when changing the fluid and RTV'ing the rear differential cover?
Usual suspects: Brake cleaner, Simple Green, soap and water, gasoline, etc.
I've never serviced one, but figure it is like this:
1. Drain
2. Remove cover
3. Spray, clean, rinse, whatever all the innards
4. Wipe and dry
5. Inspect. For what, I have no idea
6. Black RTV cover back on, replace drain plug, remove fill plug
7. Refill with 75w-140w Mobil 1 Synthetic (not sure what it is, but I looked it up here some time ago and bought enough)
8. Fill to within a finger tip's dip in the fill hole
I've had the RTV and oil for a while, but it's supposed to hit 59F here on Saturday with no rain!!! Time to crawl on the floor and get it done.
I didn't see any problems with my cover, so going to forgo the new aluminum finned cover this time
Guess the biggest question is what should I use to clean/flush the rear end?
This is 2002 Excursion WITH LSD rear differential. 4WD.
Ford 7.3L Power Stroke (1999-2003) :: 2002 - Lowering Rear To Level?
I'm fresh out of the perverbial womb to this place and only about a toddler when it comes to my truck. However I do want to learn! I just recently invested in an 02 XLT F350 7.3L. I'm in love with the truck except the leaning forward aspect. I am debating on leveling it via lowering the rear. Any thoughts? Things I need consider that will happen if I do? How would you do it? Would you do this over raising the front? I've heard raising the front can mess with the suspension geometry and that's not a good thing to do!
View 10 RepliesFord 7.3L Power Stroke (1999-2003) :: 2002 F350 - Leaking Rear Differential
I'm trying to figure out what axle I have on a 2002 f350 single wheel 4x4 so I can order a replacement seal. So this morning I got to work and noticed that am oily guild was dripping from the front of my rear differential where the drive shaft hooks into it. I figure it the seal, so when I went to look up the repair kit they list several different axle options because of gearing, what axle I have as there wasn't a in owners manual with the truck. Who can I find out what axle I have so I can buy the repair kit for it...
View 5 RepliesFord 7.3L Power Stroke (1999-2003) :: Adding LEDs - Wiring Harness?
I am going to add some led's to illuminate the steps getting into my truck at night. I plan on putting them directly under the door over the steps. Is there a wire under the door threshold I can tap into at each door? If so what color? If not, where to get the power from. I want them to turn on and off with the interior lights when doors are opened.
View 1 RepliesFord 7.3L Power Stroke (1999-2003) :: 2002 - Vibrates When Throttle - Rear Differential Rebuild
My truck (02 7.3L cc) started making a grilled ding type of vibration when I would let if the throttle. I felt the axle going into the rear differential was a bit loose, so I took the cover plate off. The pictures below show where the pinion I think is hitting, sort of like the bearing is allowing front to Rear differential scaring from movement. Rear movement.
How difficult is a rebuild, and is there anything I should be careful of?
Ford 7.3L Power Stroke (1999-2003) :: Adding Turn Signals To Manual Mirrors
Ok, I am looking to update to the square style mirrors with turn signals (nothing else) is this possible and is the wiring for my E99 already in place or would I need to add any thing else? Here is a link to the mirror set I am looking at :
99 15 Ford F250 Rear View Tow Towing Mirror Manual with Functional Signal Pair
Is what I am wanting to do possible, I know I could wire in the auto folding style with the stupid add a fuse crap and a button (easy enough)... or these...(power fold). [URL] ....
Ford 7.3L Power Stroke (1999-2003) :: 2000 - Oil Bone Dry After Adding 2 Gallon Overnight?
I have a 2000 F-250 super duty. It's a 7.3 and Powerstroke. Replaced my fuel filter and when i removed old one fuel is solid black. Needless to say, filter didnt solve my problem. Checked oil it was bone dry. A couple days ago it was topped off. Added 2 gallons of oil to get it home (less than 2 miles) and parked it until next morning. Check oil again and bone dry, no oil spots on driveway or engine block.
View 4 RepliesFord 7.3L Power Stroke (1999-2003) :: 2002 F250 - Rear View Camera In Head Unit Comes On When Step On The Brake
2002 F250 diesel ... I found these two plastic pieces yesterday on the floor near the 4X4 shifter. I noticed the other day when i step on the brake the rear view camera in the head unit comes on, so i am thinking they are either a part of the brake switch on the pedal assembly, or something to do with the shift tube.
View 2 RepliesFord 6.7L Power Stroke Diesel :: 2013 - Adding Rear Wheel Well Liners?
I first saw them on the 2013 build and price and was thinking that I should look into adding them to my 12. I never got around to looking up part numbers. So, recently I thought of it again and after a little poking found that they could be had as a Ford accessory kit for around $110 depending on your dealer. MSRP is 133 I think. So, I hit the dealer and grabbed a set they had in stock. Install took 30 minutes. Very easy. They give the wheel wells a finished look and offer lots more protection than the small plastic strips on the rear that came with the truck. A hundred or so bucks well spent if you don't have them. There are aftermarket ones that are a touch cheaper on eBay by Rugged Liner but they don't work with the 5th wheel prep which I have.
View 14 RepliesFord 7.3L Power Stroke (1999-2003) :: Will Cluster From 2003 6.0L Work In 2002 Model?
I have a 2002 7.3L Screw 4x4. Will a 03/04 6.0L instrument cluster work in this truck? The 2 clusters appear identical. I put the 6.0 cluster in and the trans temp, and coolant temp gauge will not work. All the gauges sweep when it is powered on, but the coolant and trans temp lay flat, and the check gauge light is on. All other gauges and functions work. When I put my other cluster in, all gauges work fine. Is there a difference in the VSM, PCM, or the SCP communication?
View 6 RepliesFord 7.3L Power Stroke (1999-2003) :: 2002 F250 - No Power To PCM Fuse
I just finished a cab swap and I'm having a little trouble. Here's a link to what I've done : [URL] ....
KOEO the WTS light, battery light, SES light all stay on and no power to fuel pump. No communication with PCM (using AE). All fuses are good, but no power to PCM fuse (#22). When I apply 12v to #22, the truck will start and idle - but poorly because I still don't think fuel pump comes on. The idiot lights all stay the same.
I did get to pull codes while it was running and got stuff like IAT circuit high (its not plugged in), fuel pump relay short to batttery, and a few other short to battery things (park assist stuff IIRC). I thought that might have something to do with the redneck idea to boost the fuse with an external power source?
Just thinking while typing, I don't have 3rd brake light hooked up yet (just thought of that, I'll hook it up first) and bed/bumper are not installed, so no tail lights or park assist stuff is hooked up. I'm also not using overhead computer, so it's not plugged in.
My next step is to go back through all of the connectors and make sure something isn't 1/2 way plugged in or possibly plugged into the wrong place(s).
Looking thru the wiring diagrams is not a strong subject for me, but I was trying to figure out how power gets to the fuse and how PCM relay works (does it complete circuit to ground to energize the coil?).
Ford 7.3L Power Stroke (1999-2003) :: 2002 F350 - Lack Of Power
My issue I'm having - 2002 F350 7.3L has an 8 inch bds lift with 37/13.50 tires. I realize these tires are big but... while driving 100kms/hr or 60 miles per hour and I hit the gas the truck barely wants to move (without pulling a load). Thought maybe a turbo but I have no mechanical skills so here I am!
2nd issue, there's a bullydog chip in that truck when I bought it. he said he always ran it on extreme. I found it puffs way to much black when on extreme and on performance it seems a lot better so that's where I have it?.
3rd issue, the transmission gauge on the dash goes into red when climbing up hills ( I live in the rocky mountains so a lot!) but the bullydog chip says the tranny is only at its hottest 140C? I don't believe that's to hot but I do believe my truck is derating a little while the tranny gauge on the dash is in the red? is there any quick fixes out there for these issues.
Ford 7.3L Power Stroke (1999-2003) :: 2002 - Loss Of Power?
I have a 02 f350 7.3 with 296,000k its been running ruff lately with a serious loss in power. The truck sounds good at idle starts up fine but when im on the throttle under load it almost crackles and sometimes bucks. I thought its was injectors replaced them all with stock ford remains but didn't fix the problem. I have AE and it passes a buzz test but i did a KOER test today and it started what seemed like a misfire during the test my ICP went to 2400-2500 and my IPR was at 38%. I have already put a new hpop in a couple month back along with new hpop lines do to a burst, ICP sensor, and i rebuilt the IPR valve. Not sure if this is a problem with fuel or the hpop I have also cleaned the screens in the tank and replaced the fuel pump which were pretty bad....
View 9 RepliesFord 7.3L Power Stroke (1999-2003) :: 2002 F250 - No Power Getting To Fuel Pump
There was no power getting to the fuel pump on my 2002 Ford F250 73 diesel traced it back to the inertia switch no power in or out but I'm getting power at the fuel pump relay put the code scanner to the PCM and no communication....
View 9 RepliesFord 7.3L Power Stroke (1999-2003) :: 2002 - CEL - Rough Idle - Loss Of Power?
I have a 2002 F-250 7.3, 159k on it. I bought it in March, ran AWESOME up till now. I was driving to work last week, check engine light came on, truck lost power and started idling rough. I have a buddy who works for a Ford dealer as a diesel mechanic, he came over with his scanner and laptop. #2,#4,#8 cylinders kept coming up saying possible problems are injectors, harness, rings.. He also did an electrical check, that all checked out. He told me to get injectors, so I got 4 injectors (yes I got the correct #8 injector), valve cover gasket, injector harness and 4 glow plugs.
The parts came last Friday, we did the job and it ran great. Drove it Friday night, Saturday, Sunday morning, no issues. Sunday afternoon we were on our way to a birthday party, truck started doing the exact same thing... Check engine light, rough idle, loss of power. After I got home from the party, my buddy came back over, put it on the scanner again, getting the same codes again. Deleted the codes, ran the tests again, same codes, deleted the codes, rant the tests again, same codes.
He said he is going to come by tomorrow with the box to check each individual cylinder.
Ford 7.3L Power Stroke (1999-2003) :: 2002 - Power Windows And Radio Go Out Occasionally?
I now have a 2002, 7.3, 250, 4x4 and love it. Everything but the milege. All in all it's a great ride. I have one little problem that's driven me nuts.
The power windows and the radio go out occasionally. Both at the same time. They come back on...... sometimes. Sometimes it takes a day or two. I've checked the fuses and then saw that there is a breaker in the 601 location in the fuse box that's probably causing the problem.
But I thought that it was supposed to shut off to protect that circuit when there is a short somewhere. I don't know where to go or how to locate the short if in fact this is my problem.