Ford 7.3L Power Stroke (1999-2003) :: 2002 F350 - Outside Temperature Gauge Reading Wrong
I have an 02 f350 7.3 power stroke...Yesterday I noticed the outside temp was reading wrong,it was jumping from 67 to 86 to 92 back to 67..Temp was prob around 90 with high humidity and my a/c was on..So I got to where I was going and when I restarted my truck to go home the fuel gauge dropped to empty(I just fueled the day before) and fuel light came on and outside temp still wrong on the overhead digital display...Are these two things related???
Stopped the truck restarted it and fuel reads correctly again....Went out today and fuel light back on and on empty...Outside temp wrong again,a/c is on .....I disconnected the batteries when I got home to "reset the system"if there is such thing, fuel gauge working but outside temp wrong..?? Where is the outside temp sensor ?could condensation be running onto the sensor and throwing off my temp gauge? Just strange that both these things happened at the same time......I don't think its a fuse or they wouldn't work at all. I should mention all the other gauges work correctly...
Ford A/C :: 1997 - Temperature Gauge Quit Working After Changing The Thermostat And Coolant?
Temperature gauge quit working after changing the thermostat and coolant.
With the engine off, I disconnected the single wire from the temperature sending unit and switched on the ignition without starting engine. The gauge pointer stayed in at the Cold mark. Using a Jumper wire, I grounded the sending unit wire and the needle on the gauge went to the Hot mark.
I quickly turned off the ignition, and replaced the sending unit with a SW-2328 (F1SZ-10884-A) Temp Sender. Warmed up the engine, but still no reading on the dash gauge.
Ford 7.3L Power Stroke (1999-2003) :: 2002 F350 - RPM Gauge Randomly Stopped Working
I have stock 02 F350 7.3 with 74,000 miles ... Today i looked down and noticed my RPM gauge sitting there at 0 ... It was working just fine yesterday. I figured before i go digging around looking for the issue id see what is causing it not to read ..
View 3 RepliesFord 7.3L Power Stroke (1999-2003) :: Fuel Gauge Stuck - Brake Light Quit Working
I recently had my fuel gauge stuck on full and at around the same time, my left rear brake light doesn't work. I do have LED brake lights in the rear so I am not sure if that changes anything. I thinking something with a ground or is it possible that these aren't even related.
View 2 RepliesFord - Explorer :: 2002 - Temperature Gauge Not Working After Replacing Engine Coolant Temp Sensor
2002 ford sport trac.I have been having an ongoing issue that started with the engine cranking but would not turn over until an hour passed. After replacing multiple parts (cam shaft sensor, crankshaft sensor, ignition pack) I am now down to poor fuel economy as the last of the issues (roughly 12 in the city and 15 highway). I was told the issue may be the engine coolant temperature sensor going bad so I decided to replace it. I found this was very difficult due to it being a plug and locking pin design and in a very tight spot in the engine.
I tried to purchase a replacement and the parts store kept trying to insist on selling me a part with threading. I finally found someone that figured out the issue and found the part for the 2001 sport trac had the same plug style with clip that did fit but was shaped a little different on the sensor end which I assume was due to being aftermarket. I noticed that there were two plugs side by side and the one easiest to access was on the left and I was told the one on the right was the sensor that gave the temperature reading to the gauge.
After installing the engine coolant temperature sensor I found the temperature gauge on the dash now will not respond and is sitting below the cold end of the gauge completely off. Is it possible this is because the part was for a 2001? Is the sensor on the left (passenger side) the engine coolant sensor?I would hate to put the old sensor back in just to test if that's the issue due how difficult it was to put that locking pin back on. What to check that could resolve the gauge issue before pulling this sensor back out?
Ford - Explorer :: 1999 - Temperature Gauge Barely Working
Having a problem with my temperature gauge inside the truck. No matter how far or long I drive, the needle barely moves off of cold. Would the thermostat be the likely suspect? If not, what else could it be? There is no "check engine" light on and my ODB2 reader reads a temp of around 70c solid. If it is the thermostat, where is this part located in the car and would I need to replace JUST the thermostat or are there gaskets/housing-type things involved as well.
View 7 RepliesCentury :: 1999 - Coolant Light Blinking / Temperature Gauge Inside Is Ok
I have replaced radiator and thermostat, awhile back.. I checked and there is antifreeze in the radiator and the reservoir. I don't drive it unless i really have to. and not to far,lots more work to do on it. But the coolant light started blinking the other day. Temperature gauge inside is ok. What could this be? what should I do? Still haven't got the blower working, heater / ac / defrost.
View 5 RepliesPassat (B5) :: 1999 - Coolant Temperature Gauge Reaches At 190 Within 5 Minutes And Stays?
I have a '99 1.8T Passat. The coolant temperature gauge normally reaches operating temperature of 190 degrees within about 5 minutes and stays there. For some reason, after reaching 190, it sometimes drops by 20-30 degrees and is running cooler than normal. Once time it dropped down, then came back up again, while driving a steady 65 mph. The coolant level is full and nothing else has changed.
I guess there are a few possibilities: a thermostat stuck open too far, a failing temperature sensor, bad gauge, or loose connection at the sensor. The car has 145K miles and the thermostat and water pump were replaced at about 100K miles. What is going on? If it runs a little too cool, is that a big deal? How would I diagnose it? Where is the temperature sensor?
Malibu :: 2003 Chevy Temperature Gauge Not Working
2003 Chevy Malibu 3.1 temperature gauge stopped working last night, this morning having trouble starting, no check engine light fans do turn on have heat, replaced the coolant temperature sensor but gauge still not working?
View 1 RepliesFord 7.3L Power Stroke (1999-2003) :: Rough Start At Cold Temperature?
I am intrigued by this engine and it's cold start issues so I am trying things out to see what works. If I plug it in it starts like summertime. If it's as cold as 30* out I run the glow plugs for two minutes and it starts without much effort and once running purrs like a kitten, no chug a lug, no romping, little smoke. When it gets down into the 20's I run the glow plugs for two two minute cycles, a little more cranking time but starts same as above. Down to 18* and I cycle the glow plugs twice for two minutes and it cranks, tries to start but won't. Key off, back on for two more minutes and it starts right up like a warm summer day. It hasn't been colder than 18* here this year so this is the end of my report for now. I haven't taken the time to check the glow plugs which is on my list but this summer it'll get done.
View 14 RepliesFord 7.3L Power Stroke (1999-2003) :: Mounting Temperature Sensor On Manual Transmission?
Where can a transmission temperature sensor be mounted on a 1999 manual powerstroke transmission? What is the part number for an applicable sensor that will work?
View 2 RepliesFord 7.3L Power Stroke (1999-2003) :: 2000 - Take 10 Seconds To Crank At Operating Temperature?
I have a 2000 F250, 300k. Starts beautifully when cold, takes 10 seconds of cranking when at Operating Temperature. Did the injectors and plugs in September, kept doing it and now that it's summer it's getting harder and harder to start. Just replaced the ipr, still doing it. Gonna do an overdue oil change tonight or tomorrow, I'm hopeing that will improve it. I can understand 3 or 4 sec of cranking, but not 10. Truck hads no drivability issues whatsoever. Will an ICP fix it? Change to a heavy-duty 20w-50? (Last oil change was delo 15w-40) The code reader that I have is really basic, and only shows me RPM and map.
View 14 RepliesFord 7.3L Power Stroke (1999-2003) :: 2002 - Hard Start On Cold - Temperature Sensor / PCM?
I have a 2002 f350 that has had cold starting issues since I bought it. I have replaced the glow plugs twice, the glow plug solenoid four times. When I put a new solenoid on it it works fine for a short time. I know the solenoids are bad because I get battery voltage on one side and nothing on the other. If I jump the solenoid with a jumper wire I can get the truck to start. I thought I was getting bad solenoids but I have recently tested the activation circuit and am getting constant power there. I.e. It never shuts off. I think this is what is causing the solenoids to burn up. From the tracing of wiring diagrams I have done, the only thing before the solenoid is the Pcm. So now to the question,
1) What controls the activation of the Glow plugs? Is there a temperature sensor or something before the Pcm.
2) Is this a case of my Pcm going out on me? I am a mechanic in the army so I have a decent understanding of mechanics.
However I am at a loss for these systems.
Ford 7.3L Power Stroke (1999-2003) :: Electrical Power Fluctuations EGT Gauge Failure
I am on my third EGT gauge. My mechanic installed it as per "auto meter" specifications. He told me, the only reason he could find that the gauges have been failing is low voltage output. I have an onboard compressor for my airbag suspension and every time I start my vehicle it runs to fill up the air system. The voltage drops to 11.1V. It comes up once all is running and the compressor quits. is there any such thing as surge/brownout protection for these systems?
View 1 RepliesFord 7.3L Power Stroke (1999-2003) :: Gauge Went Up When Jumped It
I need a part number for the temp sensor for my truck. The dummies at advance have sold me the wrong one 2 times now. I used a jumper wire on the plug to make sure I didn't have a broke wire somewhere. The gauge went up when I jumped it. Went and got a new one and it still don't work
View 14 RepliesFord F-150 - 1997-2003 :: 1998 V6 - High Beams And Coolant Gauge Not Working
I just bought a 98 F150 V6 Manual transmission 2wd truck. Its a clean truck and I'm liking it so far but its got a couple minor issues. Whats the point of buying a truck if you don't get to work on it??
The High Beams don't work at all. Low beams are fine. I've put new bulbs in, and fuse 16 in the passenger compartment has continuity. I'm suspecting the multiple function switch, because when I pull out to engage the high beams, nothing happens. The indicator on the dash doesn't come on, and the low beams don't turn off either.
The second issue is the coolant gauge doesn't read. When I turn the key to the on position, the needle on the gauge moves up just a bit, but it never moves after that. Anything to check?
There are a couple other minor things like the e-brake light on the dash doesn't always turn on, but I can deal with that.
Ford 7.3L Power Stroke (1999-2003) :: Oil In Coolant / Oil Level Drops But Coolant Level Stays The Same
My friend bartered for a '99 F250, 2wd/auto, 4 door, 7.3, 258k miles.
It had reportedly sat for one year, though the expired registration sticker and other things point to it sitting for two.
It ran low on oil, sputtered and died. Oil in the degas tank. Filled to oil to mid way on the hatch marks on the dip stick.
I drove it 25 miles to my house, and the oil level is not reading on the dip stick.
The sludgy fluid level in the degas tank is unchanged. Where is the fluid going?
I will refill the oil to see just how much it lost in the 25 miles if it important to someone, but I prefer to not waste the oil.
My first plan is to remove, inspect and replace the oil cooler o-rings. Even though the dealership charged him for this, I don't trust that they did it right. I think it is the easiest and mostly likely place for oil getting into the coolant.
It does have a really long crank before there is enough low pressure oil for it to start. At the moment I think this is a separate issue.
The dealership also charged him for a replacement injector. No idea if they replaced the cup or not.
Ford 7.3L Power Stroke (1999-2003) :: Coolant In Oil - Engine Is Out
Had coolant in oil, so pulled motor. Got used motor to replace it with, thinking about doing some work on it before reinstall.
Got bellowed up pipes, injector o-rings, front and rear main seal, and will use best parts from both motors to make one. I'll also shim injector armatures back to spec.
Should I do injector cups too? What else is recommended to do at this time? Both motors are 350k or so, I was on a budget at a moment and have to make it work with what I got.
Ford 7.3L Power Stroke (1999-2003) :: Oil In The Coolant - Normal?
What is the effect will some oil contamination is the cooling system?
Does it significantly affect the cooling efficiency? I have some oil the coolant on my boat. I do not believe it is a lot maybe a few oz, but I have been chasing some unexplained overheating issues. Will adding water wetter solve oil issues (if there are any). The other option is Dawn and several cycles of flushing the system. ie until the cows come home!