Ford F-150 - 1997-2003 :: Driver Side Rear Sounds Like Brakes Are Dragging Against The Rotor
Went and got new tires on the supercrew. Went going through parking lots or simply driving i hear a loud squeal like brake pad squeal. I put brand new wagner ceramics on the truck. Also if i turn to the left the driver side rear sounds like brakes are dragging against the rotor. Whats goin on with this. The squeal will happen between 10 mph to 20 mph and the grinding noise will happen if I am cruising or turning to the left. It goes away when i apply the brakes.
View 1 RepliesFord 7.3L Power Stroke (1999-2003) :: Driver Side Rear Brake Metal Line Cracked
I had a brake line crack on my way home yesterday(that was interesting..) It was the drivers side rear metal line from the splitter to the rubber hose. I went to autozone and was like ok easy enough this line is the same length and appeared to be the same diameter. bend to fit and all was well or not.. the fitting on the end was a different thread pitch and size. 1999 f250 4wd if it matters....
View 4 RepliesFord Super Duty (1999-2016) :: Rear Brakes Sticking / Driver Side Rotor Glowing Red
Took the truck out the other night, got to town felt the slight drag but nothing alarming, got out of the truck and could smell it, rear drivers side rotor glowing red, pass side not glowing, pressed park brake then released, driver side freed on its own, pass side sticking, replaced pass side rotor and pads, found nothing out of the ordinary... Ford F250 4x4, 2005 ....
View 14 RepliesFord Super Duty (1999-2016) :: 2003 F250 5.4L - Axle Leaking On Passenger Side Rear Rotor And All Over
Here's my problem while replacing brake pads i found that my axle has leaked fluid on the pss,side rear rotor and all over .. I been looking for any info on repairing it myself . I found Everything for every other truck just not for this truck.
It's 2003 F-250 w/5.4L all Stock rear axle has 12 bolts and gears are 7.73 ... I believe its a Dana 60. No tags or markings on the Axle to go by..
I live in the Freak-en woods here so i like to order all the right parts once and do over the weekend .. its my only ride so once apart im stuck here.... I did check the Vent Tube its fine..
Ford 7.3L Power Stroke (1999-2003) :: Brakes Overheating - Front Right Rotor And Hub Very Hot
I was driving on a short business trip and I noticed what I thought at first was clutch smell, and then I realized I had a brake overheating. I pulled over and the front right rotor and hub were very hot. The caliber not so much. I let it cool while I was at the meeting. About 1 1/2 hours later I jacked the truck up to see if the bearings felt bad. Seemed fine so I drove home trying not to use the brakes and the heat did not return. I replace the caliber with one from Ford, but the only lines I could find were from CARQUEST and they are made by Raybestos. I am assuming that these lines are made in China.
I have been looking for some braided SS lines, but can't find any for a 2 wheel drive dually with 4 wheel ABS. Where I can order some better lines???
I hated my old 1994 F-350 that had those Metal/rubber pins, they would mess up and overheat also, I thought that my 2000 would not have this problem, I was wrong.
FYI, about a month ago I replaced the rear pads, and changed all the brake fluid with Valvoline synthetic DOT 3. I installed Akebono pads on the rear and just today Akebono on the problem front side. Will change out line and pads on driver side later this week. I hope I got if fixed.
Ford 6.7L Power Stroke Diesel :: Proper Way To Remove Driver Side Dash?
I'm sure I could start tugging on it and the clips would show themselves, but I'd rather not break any unseen clips or screw points. Is there a picture aided how-to for the removal of the drivers side of a dash on a 2012 f250? My tuner comes today and I'd prefer a clean install.
View 6 RepliesFord 7.3L Power Stroke (1999-2003) :: Different Battery Box For Driver Side?
Is there a different battery box or better battery holder for the driver side without all the air filter housing stuff. I had an AFE Big boost filter and when I modified the stock battery box it still had the bottom section of the air filter compartment well after about 4-5 years I was cleaning the filter today and there was a hole rubbed in the filter from moving around and the pre filter is getting holes wore through it. So I cut the air box part off so now the filter will sit on the fiberglass stuff on the fender well. I ordered a couple of the new Blue Donaldsons from RiffRaff to replace the Big Boost filter. The modified filter box looks kinda like a hack job because all I had was a cut off wheel and the plastic got hot and now I have melted buggers all over it. I thought I saw somethin a long time ago about a battery holder out of a van that was just the bottom plate but can't find it anywhere now.
View 8 RepliesFord 7.3L Power Stroke (1999-2003) :: Leaking Power Steering Under The Wheel Arch On The Driver Side
Initially had indications of a leak under the wheel arch on the drivers side.
About 3-4 months back replaced both PS lines and the leak stopped - briefly (maybe a couple a weeks).
Now the leak is back, but what's interesting is I lose more ATF fluid on a single long haul run than I do running round town for 3 weeks. I can't work out where the leak is coming from to identify what else to replace - short of just buying a pump and reservoir and replacing them as I've already done the hoses.
My turbo cooler pipe was hard up against the old PS pipe where it entered the side of the reservoir until I did the replacement hoses. Now I have it out the way but I'm wondering if it's caused some unseen wear or damage.
If I just do the pump to see if that works are the reman units any good out of Autozone or O'reilly's?
Ford 7.3L Power Stroke (1999-2003) :: Oil Leak Near Driver Side Up Pipe
Small oil leak looks like coming down by drivers side up pipe. I don't think it's the turbo o rings. Better not be. But could be I guess. Anyways. It runs down somewhere by the up pipe down onto transmission. I'm not loosing tremendous oil or anything.
View 14 RepliesFord 7.3L Power Stroke (1999-2003) :: 2002 - Oil Leak From Driver Side?
I have a '02 7.3 that has developed a severe oil leak in what seems to be a small line that runs from the drivers side head to the HPOP on the passengers side.
it seems to be leaking at the braket that secures it to the head on the drivers side.
what is this line called and where can i find one A.S.A.P?
Ford 7.3L Power Stroke (1999-2003) :: Driver Side Key Lock Recessed?
'99 F250 SuperDuty. Tumbler is recessed and the key slot is horizontal rather than vertical. I suspect the spring fingered clip has fallen off.
View 2 RepliesFord 7.3L Power Stroke (1999-2003) :: Drip Leak On The Driver Side
It is still a drip, but is getting worse, for several weeks. May be power steering fluid. I have not found the source. I think it is after the truck has run and has fluids operating under pressure.
View 14 RepliesFord 7.3L Power Stroke (1999-2003) :: Small Leak Under HPOP Driver Side Near The IPR
After cleaning entire valley on my 2001 f350 with 7.3 I have found what appears to be a small leak under the hpop drivers near the IPR. HPOP lines are clean and dry. Possible for IPR to leak at 120k miles and what will need to be done to fix.
View 2 RepliesFord 7.3L Power Stroke (1999-2003) :: Driver Side Back Door Won't Open
My driver side back suicide door won't open. It is the top latch that is not disengaging. I think I heard something loose in that door over the past month. Am I going to have to take off the inside panel to fix it?
View 14 RepliesFord 7.3L Power Stroke (1999-2003) :: Extended Cab Driver Side Door Won't Open
I can't figure out the problem with my extended cab door. Driver's side doesn't open with either door handle.
View 13 RepliesFord 7.3L Power Stroke (1999-2003) :: Driver Side Door Panel And Liner Off
I've taken the driver's door panel off, and unpeeled the liner. Now that the door is naked and exposed, I'd like to fix several things at once, rather than wearing the adhesive liner out by sticking and unsticking several cycles.
Here's a short list of some potential fixes I foresee taking care of while in there, how to :
1. The door ajar light. Mine went out over a decade ago, and the gallon of WD40 I sprayed into the latch did NOT fix it. In fact, it turned it from an intermittent issue into a permanent problem. I'd like to fix it now, as I miss having a light at night when the door is open. How do I fix it? Links, part numbers, tips, pictures, videos, search terms... all info welcome.
2. Bottom door rust. I don't really have much, but I see very faint hints of paint bubbling under the lower door weatherstrip barrier, which I have also removed. I've read about two schools of thought on preventative maintenance.
A. Pour oil or grease into the bottom of the door.
B. POR15 paint in the bottom of the door.
So basically, oil or paint? Obviously, one can't paint if one does oil, but on the other hand, some say that paint... especially thick paint like POR15, can actually do more harm than good by trapping moisture in the bottom pinch flange, or by creating craters or tunnels where water can burrow and then get trapped, rotting the metal away. What are your thoughts and experiences on this? I'd prefer a solution that minimizes the number of times I have to unstick the interior liner from the door.
3. I'm doubling the lower door weatherstrip with a combination of the older and newer designs. Ford sells the weatherstrip with clips attached, but neither those clips, nor the original clips, are really effective for what I'm trying to do. I've already done the rear doors, and made it work with the original clips, but they are brittle, and I lost a couple to breakage. Today, I broke three clips pulling the old weatherstrip off of the door.
I can't find these clips anywhere locally... I've tried every variety the auto parts and auto body stores sell, and Ford doesn't sell these clips separately from the weatherstrip... and even if Ford did, they OEM clips are not long enough to hold the double deployment of old and new styles of weatherstripping.
In searching this issue, it appears that a lot of people have broken these clips, which stands to reason with plastic in baking inside a hot door for 15 years. I'm sure I'm not the only one who would benefit from finding a good source of automotive clips.
4. Mirrors. I'm finally getting around to this, and this is what motivated the door panel removal in the first place. I need the dog bone harness that converts from a round connector to the flat style connector. Specifically, I need part numbers 1C3Z-14A411-AA and 1C3Z-14A411-BA. Ford didn't originally sell these dogbone harnesses separately, but included with the purchase of newer style outside rear view mirrors in case the translation harness was needed. Sometimes it was, sometimes it wasn't, so there would often be these unused harnesses left over.
5. Jimmy Jammers. Will they cause more harm than good? Does a better alternative exist? Thinking of installing these while I"m in there, but worried the door will be damaged worse as the thief tries to fight their way in. And, with body on shell doors, there appears to be much easier ways to break into an SD anyway, so part of me thinks, why bother
Ford 7.3L Power Stroke (1999-2003) :: Can't Undone Harness On Top Of Driver Side Valve?
I have what might be a big problem, the main harness on top of the drivers side valve cover I can't get undone, the bolt holding it together is stripped or the nut who knows? wondering if there is any way to take it apart otherwise.
View 11 RepliesFord 7.3L Power Stroke (1999-2003) :: Driver Side Brake Line Cut At Inner Fender
2003 Ford excursion 7.3. Above the drivers side front tire, the hard inner plastic made contact with the hard line above the frame.. Cut the line. I can't tell if this line is 1 piece towards the reservoir since its hidden from my quick inspection. Looking for a schematic on replacing this line?
This happened after my wife took the truck back to the sugar bush.. She must have been hitting jumps or something
Ford 7.3L Power Stroke (1999-2003) :: Oil Leak On Driver Side And Whole Engine Compartment Is Wet
I'm having a problem trying to locate what I assume is an oil leak. It is on the driver side and the whole engine compartment is wet on the side up on firewall beneath the master cylinder. And the whole underneath is wet also axles and leaf spring and can't find where it's coming from. I have sprayed it down with degreaser to try to pin point the leak still no luck. Truck has 236k on it also new hpop and turbo pedestal and checked the valley and its dry. Right now I'm at a loss. I'm leaning towards oil cooler but would a leaking oil cooler cause whole side of engine compartment to be covered?
View 9 Replies