Ford 7.3L Power Stroke (1999-2003) :: Engine Won't Working After Re Installation?
So I posted a while back about fixing all the leaks I had and what I was going to do. I finally completed all the repairs and reinstalled the engine and it won't start. Cranked a bunch and checked oil level in hpop its good so I pulled plugs in oil rails there is oil present there, cracked the yellow valve on fuel bowel there is fuel there. unplugged the icp sensor and cranked more still no indication of wanting to start.
View 14 RepliesFord 7.3L Power Stroke (1999-2003) :: Installation Of Remote Start System?
I've been looking for a remote start system to install on my truck it has no remotes of any kind now. I've been googling most of the day and i can't seem to find anything except something that hooks to a edge tuner of some kind.
View 6 RepliesFord 7.3L Power Stroke (1999-2003) :: Installation Of Fuel Pressure Gauge?
I bought an Autometer 4763 gauge that didn't come with the correct fittings to plumb the sender into one of the extra ports on the back of the bowl. I went to the Ace hardware store right across the street and they didn't have anything (not surprised) and then Napa. They couldn't find a fitting to match either. He found that the plug threads are 7/16 20 tpi and the sender is 1/8" NPT. He suggested getting a 7/16 20tpi bolt, drilling it rifle-style, and then tapping it for a 1/8" NPT. The alternative, and what I ended up doing, was to use brass fittings to tee it off one of the supply lines to the heads. I ended up going that route but wanted to know if I should have looked harder for the right fitting.
Here's a pic of what I have now. I've test fit it, and it seems to work although I will need to insulate the hard lines because they rub due to the offset.
Ford 7.3L Power Stroke (1999-2003) :: Fuel Pressure Gauge Installation
Looking for pics of where/how they mounted their fuel pressure gauge? I'm getting ready to install one.
View 11 RepliesFord 7.3L Power Stroke (1999-2003) :: 2002 - After Super Chip Installation Got Icp Code?
I have an 2002 7.3 powerstroke. It has a super chips installed, set on heavy tow mode. When throttle is on the foot and I start up a hill check engine light comes on. Code is for icp fault or uncontrollable. Also happens on cruise but more often on the foot. Have to reset to get check engine light off. Light stays off til I go to pull a hill again. I am also pulling a horse trailer with 1-4 horses. Could the programmer be causing this?
View 4 RepliesFord 7.3L Power Stroke (1999-2003) :: Injector Installation - Torque Hold Down Bolts
I have been reading here about alternate methods to torquing the hold down bolts for the injectors. This winter I replaced my old stock split shots with new alliant single shots. I installed the injectors into a cold engine and torqued the hold down bolts to 10 ft lbs. I did not ever go back and re-tighten.
Is it suggested to go in and re-tighten the injector hold down bolts to 10 ft-lbs after the engine has been heated up and cooled down? What are some symptoms of a loose injector? I am imagining premature wear on the injector cups, low compression and maybe some mixing of oil into the combustion chamber.
Did just throw the injectors in and go back later to retorque only to find they were all fine or were some loose?
Ford 7.3L Power Stroke (1999-2003) :: Power Come On But Won't Start - Broken Ignition Switch?
Went to start 'er up, key spun forwards, power came on but no start, no click, nada. Turn key back and power stayed on, back forward and no resistance whatsoever power stayed on. Took screwdriver, jumped starter relay and viola away we go. Get home, get cylinder out of hole and the tip is broken off down in the column. BTW, had to disconnect batteries to shut it off. I drilled hole in the tip still in the column, insert screw and no come out. Must need to be turned somehow first I'm thinking.
View 14 RepliesFord 7.3L Power Stroke (1999-2003) :: OD Switch Not Working / No First Or Second Gear
I have an early 99 f350. when i got the truck the OD switch(maybe light too) didn't work. i ran it for about 1k mi. yesterday i left work to come home and i didn't have 1st or 2nd gear but still had 3rd and od. the only way to get 2nd is to manually put it in 2nd gear. 1st seems to be nowhere around.
I do not have a code reader and wont for at least a month or so. I did install a simple ts6 in it, that's about all i did with the truck.
Ford 7.3L Power Stroke (1999-2003) :: How To Switch Out Of 4WD When ESOF Is Broke
My ESOF crapped the bed as the truck was stuck in 4 Low. I took the transfer case motor switch off to access the gear underneath it.
I'm able to get vise-grips on it but it only turns clockwise. It keeps turning to a point it won't turn anymore and, if I let go, it will switch back to its original position.
I can do without 4WD until I get ESOF fixed, but is there a trick to manually changing it to 2WD?
Ford 7.3L Power Stroke (1999-2003) :: Sticky Ignition Switch
I seem to have a glitch in my ignition switch box or column. Most likely in the column itself. Whats the recommended course of action here? Contact cleaner and then white lithium grease in the column? Can WLG be used on the ignition switch box itself, that's bolted under the column?
View 14 RepliesFord 7.3L Power Stroke (1999-2003) :: Headlights Staying On With Switch Off
So was replacing my power steering pump get all done and my headlights start flickering and then stay on the switch is off it does have DRL on it but they have been unplugged for about 10 years what do I need to check
View 3 RepliesFord 7.3L Power Stroke (1999-2003) :: Driver Window Switch Not Working?
New to these trucks so a quick question on the window switch controls. I put power to the truck for the first time in about 8 years. First thing i wanted to do is see if the power windows worked. Everything went down very nicely but getting them back up was a no go from the driver seat. They all worked well seperatly but not from the pilots seat? Is it a typical issue with these trucks? When rocking the switch I can hear a relay under the dash panel close to where the access panel for the fuses. Mirrors work as well as do the locks. I pryed up the switch panel and un plugged it and reinstalled it with no luck. As it is I cant get the driver side window up or the passanger window up from the driver side?
View 14 RepliesFord 7.3L Power Stroke (1999-2003) :: Switch From Manual To Auto Locking Hubs?
I know this is going to sounds lame, my wife can't turn them, they have cover over it that has to be unscrewed to get at 'em. It would be nice to shift in and out "on the fly" as weather condition change.
Is it a difficult change?
Ford 7.3L Power Stroke (1999-2003) :: 4r100 Transmission - How To Bypass Neutral Safety Switch
I have the 4r100 transmission how do I bypass the safety switch? Also what are your thoughts on starting the engine with the transmission out? I know to bolt the spacer plate to the engine.
View 7 RepliesFord 7.3L Power Stroke (1999-2003) :: Buzzing Sound When Flipping To Switch To Signal Turning
After disassembling what felt like the whole front end of the truck, I finally gain access to the danged thing. Mine has been acting up intermittently for about year and half I guess. When flipping to switch to signal turning, it started making a buzzing sound. At first it was doing it most of the time. Then it cleared up and started working right for several months, then act up, the act right. Well, now it makes the buzzing noise more often than not so i decided to address it. I went to Oreilly, they didn't have one, but told me the part number.
I went across the street to Autozone, that had one on the shelf that was same part number as Oreilly. I put it in and when flipping the switch, the relay does it tick tock sounds like its working, except for there is no indication on the dash cluster that its working, nor are the actual lights working. I swap back to original and buzzing, put in new one and tick tock but no lights. Whats the deal? Is this one of those things that you have to go back to Ford? Or maybe i got a bum relay from parts house and should exchange for another to see if it works?
Ford 7.3L Power Stroke (1999-2003) :: Dash Lights Not Coming On When Position The Switch Into 4x4 High Or Low
When I position the switch into 4x4 High or 4x4 Low the dash lights do not come on. Also, I have a vacuum leak at both hubs.
I tested the vacuum lines from the ESOF solenoid (or whatever it's called, the box on the fender where the vacuum lines originate) and I don't have any leaks in the lines. I put the Mighty Vac straight to the back of the hubs and I definitely have leaks at both hubs.
So, why am I not getting the light on the dash, and why do I have leaks at the hubs? FWIW, I replaced both wheel hub assemblies in March, and everything worked fine at that time. I'm hoping the yellow o-rings are still good. Is there a chance I lost torque on the four bolts behind the hubs causing a failed seal? Is there a seal on the outside of the hubs that could've failed?
Ford 7.3L Power Stroke (1999-2003) :: Way To Repair A Switch On Driver Side Master Window Switches?
Is there a way to repair an individual switch on the drivers master window switches, or do I I have to replace entire 4 switch and window lock set?
View 8 RepliesFord 7.3L Power Stroke (1999-2003) :: Battery Light Came On And Would Flicker
Battery light came on about two months ago it would flicker. So i had Auto zone check it out batteries were good just needed a charge. so i charged them no fix so i said alright ill do the Alternator did that and then beginning of this week it happened again so checked it went back got a replacement alternator since they said it tested bad. Put the new one on and didnt change anything. Check my batteries they were reading 10v each. I charged them and they wouldn't hold a charge. so i replacement both batteries.
So i have a new alternator and two new batteries light is still on. Contacted my tech (whose a friend) he said to check the wiring going to the alt he said both wires should read 12v on constant other when the key is turned on. Tested the constant it has 12v other reads 6-8v with key on.
He also said sometimes the wiring on the X pipe can short the alternator? i unhooked all the wiring from the Xpipe nothing changed per battery light being on or off. So what should i do.?
Also my dash lights don't work but that's been like that for awhile (bulbs are all good).. Forgot to mention sometimes the light goes off but seems to stay on 90% of the time.
Ford 7.3L Power Stroke (1999-2003) :: Battery Light Flickers On And Off
I have an odd issue, 2003 7.3L f250 ... My battery light flickers on and off, I had the alternator tested at a alt rebuild sale place here locally, I don't always trust the auto zone techs, also had the batteries tested at interstate batteries. both batteries good, alternator good.
I think my connector is bad on my alt, not the one that goes to the battery, output is 13.8 to 14.1 btw......there is another connector that is a PITA to get off. I think it is bad, I played with it and applied some dielectric grease had the light go out when I wiggled it.
Can just the connector be replaced?