Ford Super Duty (1999-2016) :: Oil Change Soon Warning And Oil Change Required Message
Circumstances required me to make an emergency trip to Phoenix this week. On the way down, I first got the "Oil change soon" warning, followed by the "Oil change required" message a few hundred miles later.
I religiously keep my truck serviced on time, and have never had either of these warnings come up before. My truck had 2700 miles on it since last service was done when this first warning came up. My truck gets very little idle time, so it's not sitting idling for hours a day.
My question is, is this oil change message a result of an actual oil monitoring sensor that measures oil quality on-the-fly, or is it strictly based on a miles or odometer timer that gets reset when dealer changes the oil?
At this point I'm wondering if the kid that serviced my truck either forgot to reset a timer, or worse, just "pencil whipped" my oil change. I have to call my home dealer back, since the service manager wasn't in yet when I called.
Ford F-150 (2009-2014) :: Reset Oil Change Required Message?
I have a 2012 F150 XL. I don't have a message center, just a 2 line LED readout, and there is nothing in the owner's manual about resetting the "oil change required" message.
View 3 RepliesFord Super Duty (1999-2016) :: 2011 F250 - Oil Change Required Message Reset
For those of you struggling like I was a few minutes ago... Here is a procedure that worked for me.
1. Key ON.
2. Select OK to get rid of OIL CHANGE REQUIRED message.
3. Scroll down to SETTINGS and push OK.
4. Scroll down to VEHICLE and push OK.
5. Scroll down to OIL LIFE RESET and push OK.
6. Scroll to any % other than what you want and push OK.
7. Scroll to what % you want and push OK.
8. Key OFF.
Ford Super Duty (1999-2016) :: 2012 F250 - Coolant Change Required Message At 59 Kms?
My 2012 F-250 gas just started showing this message that a coolant change is required. I am just over 59k miles. Is this a timed message all F-250's get, or is it an indications something is wrong? The truck does not run hot, it keeps perfect temperature even when I am towing my 13klbs boat.
View 3 RepliesFord 6.7L Power Stroke Diesel :: Change Oil Soon Light Came On After Only 2000 Mile Since Oil Change?
I had my oil changed at 40,000. I am at 42,500 right now . My " change oil soon light " . Seem like a little soon ! Plus I am 5 hours from home on a ski trip. I have checked oil level it fine. Will I be fine to drive it home 5 hours back to my local dealership for oil change? Or should I find a place up here? What would cause the light to come on so soon ? I am new to this truck . My old 7.3 did not have all the BS that this truck has .
View 6 RepliesFord 6.7L Power Stroke Diesel :: Coolant Flush - Additives Required After Filling?
I'm planning on doing the regular scheduled coolant flush but not sure if it can be done without any special equipment.
One dealer said they don't do many diesels but have a machine to do the refill and quoted ~200$. The other does more diesels but hasn't done a flush in a while and quoted ~500$ and said he does it old school by draining everything out and then water flush followed by refilling the systems.
Which one is right? Can it be done in the driveway? Which is the correct coolant for the refill and are any additives required after filling?
Ford 6.7L Power Stroke Diesel :: Got Message - DEF Under 1/2 Full?
My truck gave me the message that "DEF under 1/2 full", so since we are on the road, I stopped by a dealer and picked up 5 gallons of motorcraft DEF. I did not want to get the countdown message in an unfamiliar area and have to look for it. While going out site-seeing, I forgot and left it in the back seat of the truck for about 8 hours in the heat of the day. I know you are supposed to store it under 86 degrees or so. Now, did I just ruin 5 unopened gallons or is it still safe to use?
View 9 RepliesFord 6.7L Power Stroke Diesel :: Reduced Engine Power Warning Message Pop Up
I have seen this pop up on the truck I think 3 times now over the first 4000 miles on the truck.
Usually it's when I'm on the highway around 70mph or so.
It comes on for a few seconds, then goes away. I do have an exhaust / tune on the car.
Ford 6.7L Power Stroke Diesel :: CEL On - Engine Power Reduced Message
I haven't had any issues with this truck before but last night I pulled out onto the highway and my check engine light came on and a message saying engine power reduced I finally got it to reset after 4 times of shutting the truck off, was wondering what this may be without knowing the code. I tried plugging my edge cts into it from my 6.0 but it wouldn't communicate guess it needs a update trucks a 15 f350 with only 30000km.....
View 2 RepliesFord 6.7L Power Stroke Diesel :: Low Fuel / Power Message Then Check Engine Light On
My low fuel light came on tonight. I drove about 2 miles, stopped and shut the truck off. When I restarted it and began to drive off to the fuel station a notice came on that isaid power reduced then a check engine light came on. I was about a mile or less from the fuel station so I filled up. I cycled the key but the engine light is still on. No low power message tho. The power is fine.
I came home and drained the water drain on the filter, didn't see any water but hoped it would solve the problem. I cycled the key a few times and started the truck but the light is still on. My truck is a 2013 f350 6.7 and has 211500 ish miles on it. I bought it a month ago with 18500 miles and haven't had any issue until tonight. My only thought is maybe the fuel filters need changed. I don't know if or when the previous owner changed them.
Ford 6.7L Power Stroke Diesel :: Reduced Engine Power Message - Code P164A
So I just went on a vacation pulling my horse trailer (first time leaving the state with this truck) and at about 5 hrs into the trip I had a message Reduced Engine Power and went from 70 on the interstate to 10 miles an hour and slowing rather quickly. I ended up shutting it off and restarting and it came back just like normal. I found the nearest ford dealer and they put the computer on it and it showed absolutely nothing, no codes and nothing wrong. The mechanic reset some things and we went on our way.
Then I ended up getting a check engine light saturday. I found someone to read the code and it came up with P164A which is an O2 sensor, he was able to clear it and I put on probably 50 miles today and no check engine light. I have about a 10 hour drive back home. Still debating if I take it to ford near here if they will do anything now that it doesn't show a light?? I hate to chance getting broke down on the highway with a truck that will basically shut down like that?? It just doesn't make sense to me.
Ford 6.7L Power Stroke Diesel :: Decreased Power Message Across The Dash Info Center
Got a Decreased Power message across the dash info center today and was limited to only around 5lbs boost. I stopped and pulled the codes and here is what I found:
P054E - Fuel Quantity lower than expected
P1249
P1247
P0471 - Exhaust pressure sensor range/performance
P02D7 - Injector learning @ max
P0402 - EGR flow excessive detected
I dumped the trailer and limped home to change the fuel filters. I could only go 35mph on the flats and 10mph on any kind of up hill slope. I switched out the filters, purged the air, fired her up and cleared the codes, all seemed well. I backed out and went for a test lap around the neighborhood, as soon as I turned the corner and rolled on the throttle and reached 35 the message came back and the codes returned. I will be towing it in to the dealer tomorrow for diagnostics.
Ford 6.7L Power Stroke Diesel :: 2011 F250 Won't Start After Getting Reduced Engine Power Message
I have a 2011 Ford F250 6.7 Powerstroke. It has 107,000 miles on it.
The other day I was driving it down the highway and it got a Reduced Engine Power message on the dash. It lost power and I got off the highway to the service road. Then it died on me.
Had to get it pushed to a station then towed home. It wouldn't start. The starter cranks over for a few seconds but engine won't start. Checked all the fluid levels and batteries. My DEF fluid was only a half gallon low.
What I have noticed is that the DEF level indicator hasn't reminded me that it was low for over 4-5 months now. I had been putting in about 2-3 gallons every 3 months or so. But it hasn't reminded me lately and I just forgot. This is my first diesel.
Ford 6.7L Power Stroke Diesel :: Reduced Engine Power Message Came Up On Dash And Truck Died
2015 F350 6.7L, 43,000miles
My family and I were driving into West Virginia this morning when the reduced engine power message came up on the dash and the truck died. I coasted off to the side of the road as best I could and got out. Immediately I smell diesel fuel. I look under the truck and there is fuel all over the passengers side frame and when I keyed it back up fuel started spraying down by the right front wheel.
Pulled the fender liner back and saw a small rubber hose that looks like it came off of a tee fitting down by the egr components. I tried to get it back on but wasn't able to get it seated 100% and when I tried to restart it blew off again. Truck is completely stock and ran perfect right up until it died.
Ford 6.7L Power Stroke Diesel :: Got Message DEF Range 500 Miles?
I know that's a normal msg, but what has me thinking is the fact I've had my truck just over 2 weeks and it only has 1350 miles on it. My understanding is that a tank of DEF should last at least 5000 miles (service interval), which means either my delivery prep guys overlooked filling it or it using way more DEF than it should.
View 14 RepliesFord 6.0L Power Stroke Diesel :: Low Fuel Message After Filling Up At Pump
After filling up today at the pump, the low fuel message is still coming on. My gauge is correct though. How to clear the message. I keep on trying to reset it with the reset button but it doesn't go away.
View 8 RepliesFord 6.7L Power Stroke Diesel :: Check Back Up Sensors Message
Nothing mechanical, fuel filter change and coolant check. While its there I am going to have them look at a few things:
1. Back up sensors - they work intermittently with a message that comes up saying "check back up sensors" or something to that affect on the display. The icon on the display that lets you check off or on will not let you put a check mark next to "on" after you push the "OK" button to get out of the check message. There is nothing coating the bumper/sensors (mud or anything).
2. Blinkers - sometimes, out of the blue, my left turn signal comes on and it doesn't like to go off. I have to push the blinker wand down to the second full position then back, or repeat if it comes back on. It is almost always the left blinker. It also happens sometimes when I start the truck.
3. Windshield wipers - sometimes if I go from the remote start to key power in the morning I get the windshield wipers going. So I will turn them on with the dial and back off. This is pretty rare.
4. The Ford emblems are starting to corrode.
5. I might have them look at the cruse control - sometimes I can get the light to come on the dash and go to green when I push the + button, but it doesn't hold the speed. I have to shut the truck off and restart all the electronics for it to start working again.
How to check the back up sensors? My gut tells me with the rest of the issues that unless they can repeat and verify my "complaints" they won't be able to do anything. There probably isn't a code thrown for the blinkers going on at will. Is there anything I might be able to do to fix it? Or do these issues require parts being replaced - which we're back to square 1 with being able to verify what it's doing at the dealer?
Ford 6.7L Power Stroke Diesel :: Check Park Aid Message At Startup
Get the message every time at start up and won't go away. It doesn't seem to be working when I back up near something. If one sensor goes does the whole system shut down? Also It won't let me check the "ON" box for the park aid.
View 6 RepliesFord 6.7L Power Stroke Diesel :: Cleaning Exhaust Filter Message
I got a 2 second "cleaning exhaust filter message" on my drive home tonight in my new truck with about 500km. I completed my drive and pulled off the highway into my yard. I don't know if it had finished cleaning yet but I unloaded the bed and then got back in the truck and drove another mile or two until the fuel economy was normal normal again.
The reason I did this was the underside of the truck was clicking and pinging as it cooled. You could smell the heat. Is it necessary to drive to complete this cycle? Or could I have just pulled in and shut it off. I'm sure it would finish on the highway in the morning. Other then the fuel economy increasing I couldn't tell anything else was going on.