Ford 6.7L Power Stroke Diesel :: 2011 - Right Brake Light Out - Fuse Diagram?
I was wanting a fuse digram for a 2011 f250 6.7. My right brake light is out and I don't have a way of knowing what fuses have to deal with the lights. If some one could tell the which ones or send me a diagram
View 2 RepliesFord 6.7L Power Stroke Diesel :: 2011 - Disc Brake Caliper Sticking?
Have 50,000 mile on my 2011 F350 6.7 and up until today the truck has been flawless. This is my weekend vehicle and sees very light duty hauling fishing gear to my boat (100 miles hwy) and pulling my 7x12 enclose trailer with goose decoys. On a couple of occasions pulling my 29 CC from marina to my home and back. Took truck in for oil change and tire rotation, service advisor informs me I have 2mm on rear brakes and 3mm on fronts. Not sure why rears have more wear than fronts. Schedule to have brakes done for today and now find out that front right caliper is sticky and they want to replace both front calipers. I cannot believe that a 2011 SD F350 with 50,000 miles and of that mostly highway needs brakes let a lone calipers are going bad. Service manger tried to tell me that brake fluid should be replaced every 2 years, to which I responded that I have Ford perform all scheduled maintenance. He went on to say that this is not scheduled maintenance, wtf bs is he telling me, if it is necessary then it would be scheduled maintenance. Truck gave zero indication of stuck caliper, no sound and no excessive brake dust on wheel.
View 14 RepliesFord 6.7L Power Stroke Diesel :: 2011 - Increase Trailer Brake Output?
I still have my 2011 6.7 f350 CC. I have a triple axle (single wheel) gooseneck tilt deck trailer that I pull my older dozer and backhoe on.
With the trailer brake gain set to 10 I don't have as much brake engagement as I would like. It actually wont lock them up at all when adjusting the gain. Loaded I don't feel any engagement when manually sliding the controller.
On my sons 99 f350, with after market controller he can adjust his output so that the brakes engaugelock at just about any adjustment (way over breaking) so I believe the trailer brakes work fine, I just don't get enough output from the factory controller.
Is there any additional adjustments the factory controller has or any suggestions to increase the output more so the brakes have a bit more engagement?
Ford 6.7L Power Stroke Diesel :: 2011 F250 - Vacuum Brake Booster Failures
Brake booster failures on 2011 and newer F-250's? I purchased a 2011 last august and the mechanic at the dealer I purchased the truck from stated that he had replaced the vacuum pump, vacuum brake booster and brake master cylinder on the truck just before I bought it as they were bad. Since then I have had two factory Ford vacuum Boosters fail on me. That makes at least three new factory Ford booster assemblies in this truck within the last year. What could be causing the problem? The truck is out of warranty and I am at a loss as to what could be causing them problem. Too much vacuum? Luckily the last two boosters have failed while sitting in a drive through and at a stop light, otherwise I may have had trouble stopping.
View 3 RepliesFord 7.3L Power Stroke (1999-2003) :: Series Of Clicks And Chirps And Acted Like No Power When Starting
About 10 days ago following a heavy rain, I went to start my truck. It made a series of clicks and chirps, and acted like there was no power. Like dead battery or something. After fiddling get with the key and trying to figure the issues, all the sudden started normal door chimes....and truck started...no issues after that for several days.
Had another rain storm...same issues only this time took longer to get it to act normal. Once it did....no problems till today. This time wasn't a big rain...still acting weird. Battery's have power. ..it's not a battery or alternator issue I'm sure. Seems like a grounding issue if I had to guess....but can not tell where...or if that's really it.? No codes or lights once it acts normal.
Ford 6.7L Power Stroke Diesel :: 2011 F350 Won't Start / Trailer Brake Module Fault
I'm having some electronic problem with my 350. I parked it and took both batteries out for about a week. I put 2 brand new ones in and hooked them up truck won't start. So I turned key on and left on and the fault that comes up is the "trailer brake module fault" also the abs light, parking brake light & passenger airbag lights are on. Sometimes if I leave key on long enough the lights go away and I can start the truck. But it shuts down during idle. I unplugged the tbc (indash) and the #22 fuse under hood and #31# on passenger side. Still showing the fault. I'm not being allowed to start the truck. I used my tuner and found one code (P0884 tcm power input intermediate)..
View 14 RepliesFord 6.7L Power Stroke Diesel :: 2011 F350 - Clunk / Clank At Both Wheels Around The Brake Area
I have a 2011 F-350 CCSB 4x4 w/ 20" Wheels and the electronic locker. I have had for some time a noise when I go over small bumps (pulling into garage up a 1" lip) at slow speeds. It sounds/feels like side to side movement. I have traced this down to what sounds like looseness inside the rear differential. To recreate, I lay down and shove hard on the spare tire. This pushes the truck side to side. I can hear a clank/clunk at both wheels around the brake area.
View 14 RepliesFord 6.7L Power Stroke Diesel :: 2011 F250 - Fuel Gauge Inoperative After Put Gas In Diesel
Purchased 2011 3 weeks ago. Due to not paying attention, put gas in diesel. Had tank dropped and drained but after reassembly, fuel gauge inop. When turn ignition switch on, get normal sweep of all dash gauges but fuel gauge does not read. 2nd tech says sender okay, must be gauge. Dealer ssays if it sweeps, it isn't the gauge. 011 F250 6.7L.....
View 7 RepliesFord 6.7L Power Stroke Diesel :: 2012 F250 Diesel Frequently Stalls Momentarily After Touch The Brake
My 2012 diesel frequently stalls momentarily after I touch the brake. This is very annoying as I drive in heavy traffic and often have to touch the brake then accelerate to merge into freeway traffic. The dealer service department said this was a 'feature' and not a flaw. Is there any way to eliminate this issue?
View 5 RepliesFord 6.7L Power Stroke Diesel :: 2011 F350 - Loss Of Power And Stinks?
My uncle was pulling his fiver to the beach yesterday with his 2011 f-350 6.7. He lost power, the truck got very loud, and there is a very strong stale kerosene smell in the cab. Strong enough to require the windows be down for ventilation. He was able to limp on into the campground and has an appointment with the dealership Monday. The truck has 19,000 miles and is still covered under the extended warranty.
View 8 RepliesFord 6.7L Power Stroke Diesel :: 2011 - Power Loss - No Boost And Codes?
Truck = 2011 F250 150,000 miles, no modifications, stock.
Truck lost power yesterday, no boost, and no codes. When driving on Friday, I started moving from a red light. The truck seemed very sluggish. Then I noticed it downshift going up a small hill that it never downshifts before. I looked, and noticed the turbo gauge at 0, no boost. I pulled over, turned it off, then restarted it, but still no boost, and the truck is very under-powered. I looked over the area, and do not notice any leaks, also no leaks underneath. I hooked up my OBD reader, and no codes., the boost gauge is on zero, and the truck has lost significant power. I no longer hear the turbo spooling.
I have spent the past several hours searching sites and forums (Started with FTE ), and it seems that most believe a restart of the truck has solved it for them. However, this is not the case for me, a restart, even after letting it sit overnight did not resolve the issue.
I did see one reference that replacing a NOX sensor solved their problem. This brings up some interesting truck history. Back in June 2017, my truck threw the following codes, P207F and P20EE.
P207F - Reductant Quality Performance
P20EE - SCR NOx Catalyst Efficiency Below Threshold (Bank 1)
The message said I have 200 miles until reduced power. Since it was a Friday, not much I could do at the time so I let it sit overnight, and then the next morning the message was gone. I plugged in the OBD reader and cleared the only remaining code (P20EE), and its been a very happy truck until yesterday.
So my question, can a bad NOX sensor cause the issue of loss of turbo boost, with no codes? Is there another possible cause?
Ford 6.7L Power Stroke Diesel :: 2011 F250 - Power Mirrors Won't Extend
2011 F250 6.7 Lariot Fx4. My factory Trailor mirrors won't extend. When I push the button it just gives me two chimes. The power fold and other options work, just not the extend. Not sure but don't think it's a fuse since everything else works.
View 9 RepliesFord 6.7L Power Stroke Diesel :: 2011 F350 - Lost Power Intermittently?
Currently truck is in the shop after having multiple episodes where it lost power. It has 47,000 miles on it. When pushing down gas pedal, just does not want to go. Very slow to shift through the gears and get to highway speed. Turbo was not there, and there was also a hard shift/jerking from 2nd - 3rd. Did notice the traction control sensor kick on a couple of times....which was just replaced since a hole rubbed through the wiring. (took it to Ford twice before they found the problem)
They told me today that the code generator said to look at wiring but they did not find anything (heard that before) and that the fuel is possibly contaminated with DEF. If that is the case, someone is messing with my truck! What I don't understand that if the DEF does turn out to be in the fuel tank, wouldn't we have the problem continuously and not intermittently over a month after driving thousands of miles and going through numerous tanks of fuel? We drive and average of 60 miles per day just for work, half interstate/city.
Ford 6.7L Power Stroke Diesel :: 2011 - Got First CEL?
Had the truck detailed. They do underhood cleanup as part of the service. Ended up with a CEL due to P0113 ITA Hi code. Truck goes back and forth between normal and reduced power. The A/C goes on and off as well. Truck is going in for service on Monday anyway. What they could have touched or how the A/C is affected?
View 11 RepliesFord 6.7L Power Stroke Diesel :: 2011 - DTC P0401 / Significant Loss Of Power On Hills
Getting DTC P0401 on my 2011 with 92K miles. First time I got the CEL, we were on vacation, so I read the code, took a screen shot, then cleared it. Called my normal dealer, setup an appt, verified that they thought the truck was safe to drive. Coming home from vacation, I was pulling the TT in my sig, and noticed significant loss of power on hills that I have pulled many times before that I couldnt even hold 55 on now. Transmission dropped into 4th a couple times, on hills that it would sometimes stay in 6th, or at most drop to 5th.
CEL stayed off for a week , and came back on again. The funny thing is that after a day or 2, the CEL went back out on its own. I read the codes the P0401 is still there as a stored code(I did not clear this time). Around town the truck drives fine, the only thing I noticed was the decrease in power when towing. Truck is at the dealer now. TECH "isn't convinced" yet that there is a problem. He is not finished diagnosing yet, and I am sure that he has specific tests to run, but I am starting to fear that I will be getting the call to come get my truck.
Ford 6.7L Power Stroke Diesel :: 2011 - Sudden Power Loss - Cylinder 5 Dropped
My 2011 6.7 suddenly lost power, started making noise and then stalled out.
After finding out that there are zero 24 hour service companies available in the LA area, I was able to get it towed to the local Ford dealer.the next day they told me it had dropped the #5 cylinder and that they would have to tear into it to find out what happened.
While I realize that any thoughts on the situation would be primarily idle speculation, what would cause this to happen at only 125,000 miles.
Ford 6.7L Power Stroke Diesel :: 2011 - Rough Idle - Surging And Loss Of Power?
I was driving my 2011 the other day home from work and experienced a rough idle. Normally the truck idles pretty smooth. I noticed when I was driving at highway speeds the truck seems to shake a lot. I pulled over and turned the truck off. I did a walk around and could find anything out of the ordinary. I started it back up and no more rough idle. However while i was driving at freeway speeds I could feel a momentary lack of power, then the truck would regain its speed. This would only last a sec or two.
I figured I'd give it a few days.... well now its gotten worse. Its doing the same thing but a noticeable difference in the lack of power. I still have boost pressure and the turbo seems to working fine. Im trying to figure out what it might be. I'll be taking my truck into ford again...
Ford 6.7L Power Stroke Diesel :: 2011 F250 Won't Start After Getting Reduced Engine Power Message
I have a 2011 Ford F250 6.7 Powerstroke. It has 107,000 miles on it.
The other day I was driving it down the highway and it got a Reduced Engine Power message on the dash. It lost power and I got off the highway to the service road. Then it died on me.
Had to get it pushed to a station then towed home. It wouldn't start. The starter cranks over for a few seconds but engine won't start. Checked all the fluid levels and batteries. My DEF fluid was only a half gallon low.
What I have noticed is that the DEF level indicator hasn't reminded me that it was low for over 4-5 months now. I had been putting in about 2-3 gallons every 3 months or so. But it hasn't reminded me lately and I just forgot. This is my first diesel.
Ford 6.7L Power Stroke Diesel :: 2011 F250 Crank But No Start / Reducing Engine Power
My 2011 6.7L F250 Superduty died on interstate the other night. Picking up throttle pulling onto interstate when a message came on the dash "reducing engine power" and the truck died. It will crank but will not start. It will start on ether but dies when that runs out. Has the following codes... p1249 Wastegate control valve, p0087 fuel rail/system pressure too low, p1291 & p1292 injector high side short to ground or battery (bank 1 & 2), p2291 injector control pressure too low-engine cranking. The codes are telling me I don't have enough fuel pressure but scan tool says I have 4000 w/ key on and 6370 while cranking and I thought 5000 was the pressure needed.
View 9 Replies