Ford 6.7L Power Stroke Diesel :: Steering Stabilizer Shock Leaking?
Is this part covered by my premium care esp warranty? I thought that I read it was at one time might be mistaken.
View 8 RepliesFord 6.7L Power Stroke Diesel :: Death Wobble Still Present After New Shocks And Steering Stabilizer
Recently replaced the steering stabilizer with Rancho RS5415 and all 4 shocks with the adjustable Rancho 9000XL. The death wobble at 40-60 mph on rough roads has not gone away. The truck rides much better, however the death wobble is violent enough to shake the change out of the change holder and the only way to stop it is to pull over and slow to 10-15 mph. The steering wheel also has slight vibration when going over smaller bumps such as expansion joints.
2011 KR 6.7L 4x4
47k miles (no ESP)
20" wheels with stock size tires
100% stock no lift or modifications
Never wrecked & most driving is on the highway. The tires show no signs of abnormal wear and the truck drives straight.
Ford 6.7L Power Stroke Diesel :: DEF Tank Removal And Sending Unit Replacement
I figured I would try my hand at making a video because I find them useful.. Anyway, if you plan on dropping the DEF tank and /or replacing the heater/sending unit.
2011 -2014 Ford DEF tank removal / sending unit replacement - YouTube
Ford 6.7L Power Stroke Diesel :: Lower Knee Panel Removal Under The Steering Wheel
I know that to remove the lower knee panel under the steering wheel all that has to be done is to pull it off and the attachment snaps will pop free. However, How do I go about removal of the dash panel to the left of the steering wheel? This would be the narrow panel that also houses an ac vent, headlight and I believe it is the adjustable pedal control.
View 5 RepliesFord 6.0L Power Stroke Diesel :: 2006 - Power Steering Pump Replacement
When replacing the power steering pump on my 2006 should I go OEM on the pump or save some money and get a Napa or aftermarket remaned unit with the pulley installed? Also, whar is the fluid capacity of the power steering system?
View 14 RepliesFord Excursion :: Replacement Shocks Dual Steering Stabilizer
I'm looking to replace the worn out skyjacker or rancho steering stabilizers on the ex. Wanting to put bilsteins in there place. 5100 series to match the shocks for the truck. What are the part numbers for this setup?
View 14 RepliesFord 6.7L Power Stroke Diesel :: Steering Wheel Position Sensor Replacement?
Replacing Steering Wheel position sensor. How hard of job is it?
View 6 RepliesFord Brakes/Suspension :: 2008 F250 - Steering Stabilizer Replacement?
Looking to replace the steering stabilizer on my 2008 F-250. It has a 6" lift and 37" tires.
Also, does "dual" mean better?
Ford Super Duty (1999-2016) :: Steering Stabilizer Replacement?
Will replacement of the original OEM steering stabilizer with a higher quality stabilizer tighten up my steering wheel play, making is more responsive?
View 5 RepliesFord - Explorer :: 2003 - Power Steering Pump Removal / Replacement
I have a 2003 Ford Explorer with Power Steering problems. I have read and tried all the solutions I found here, except replacing the pump. Seems like it is the pump. Oil was burnt, I flushed twice. I checked the rack and lubed as identified in another post, same jumpy hard to steer issue. Anyway, now I am trying to remove the Pump. I have removed the reservoir and am trying to remove the pump. I have the top two bolts out, but cannot get to the bottom tow bolts. How do you access them? Do I need to remove the lower radiator hose, and / or the oil filter?
View 10 RepliesAccord :: 2005 V6 - High Pressure Power Steering Hose Removal / Replacement
How to remove the "high pressure" power steering hose. I have drained the fluid, disconnected from the pump, and also from the rack. Removed the center clamp, and got it all "loose". However, I cannot seem to figure out how to "fish" the hose out. There is a long piece of metal tubing that connects into the rack, and it seems to be resting above some cross member that is not removable. Went to the library, and searched the AllData Online manuals. On the "How to replace the High Pressure Hose" page, it only showed a diagram of the power steering system, with no written description on how to remove the hose. I am not on a lift, but jacked up and supported and on my back under the car with the right wheel removed. I am stumped, and the new hose is due to arrive soon.
View 2 RepliesFord 6.0L Power Stroke Diesel :: Cab Removal Without Shoplift?
Lifting a crew cab on an 05 6.0 with out a shop lift? I'm going to replace the head gaskets and install studs. I have removed many regular cabs with a tractor front end loader and a 4x5 timber thru the windows.
View 10 RepliesFord 6.0L Power Stroke Diesel :: Removal Of HUB Locking?
I posted about my steering issue and i went ahead and did the gear box and now on to the ujoints ...
HUB LOCK ASSEMBLY is in 2 i started to gently pry it out with a flat head in a star figure while jiggling and pulling the whole unit with my other hand well ...
The cover plate separated from the rest of the lock and I am lost ...
Ford 7.3L Power Stroke (1999-2003) :: Airbag / Steering Wheel Removal
Having searched I believe that I need to remove two torx screws from the back of the wheel to remove the air bag. These have that damned protrusion in the middle so I'll have to find and buy a torx driver just for that job. What size is it?
View 5 RepliesFord 6.0L Power Stroke Diesel :: Front Rotors Removal From The Hub?
What's the best way to remove front rotors from the hub without damaging them on my F350 4X4?
View 7 RepliesFord 6.0L Power Stroke Diesel :: Radiator Removal To Do Oil Cooler?
I thought I remember a posting about removing the radiator to do the cooler because it made it easier to work standing in the engine bay with the engine in front of you instead of leaning over and removing everything from outside ? I'm getting ready to do my 4th external oil cooler? And is it difficult to remove radiator, and/or worth removing it ?
View 14 RepliesFord 6.0L Power Stroke Diesel :: 2005 - A/C Compressor Removal?
2005 F350 6 liter.
AC compressor clutch was toast. Thought it was just the clutch. Started to notice the truck struggling to start, with some smoke on acceleration that was not present before.
Today, paid a guy to replace my AC compressor clutch. He called me out a bit ago to show me what he found.
Looks like it was not the actual clutch. Looks like the bearing on the pulley took a crap. Bearings got wedged between the face of the pulley and the clutch. Mangled up the compressor clutch coil as well. The actual pulley, snapped off the bearing part. Pulley was only held on by the center bolt on the clutch hub. So, long story short, the compressor is locked up. Have to replace it.
This guy tells me he cannot do it, because to remove the compressor ,the motor has to be unbolted from the motor mounts and raised. Is this true? I have a service manual, that does not say anything about that at all. It does indicate that the compressor has to be removed with the third bolt loosened but still in place.
Can I get some info on the removal of the AC compressor in this truck? The idler/tensioner pulley has already been removed. The fan shroud has been removed.
Ford 6.7L Power Stroke Diesel :: Rear Seatbelt Removal
I want to remove the 60% portion of the rear seat (seat and seatback) in order to make some room for my dog on a long trip this summer and I don't need him fighting with my daughter for space on the seat. Removing the actual seat back is easy enough, but I want to disconnect the middle seat belt at the bottom. It appears to click into the piece that attaches to the truck floor, but I can't figure out how to release it. There is a small hole in the "thingy" (yes, that's the technical term for it ) that I assume would be related to the belt release, but I can't seem to get it to release.
View 11 RepliesFord 6.7L Power Stroke Diesel :: Stock Exhaust Removal - Need DEF?
I want to get rid of the stock exhaust and run a 4' or 5' exhaust all the way back. Will I still need to use DEF? Completely remove the whole system.
View 9 Replies