Ford 6.0L Power Stroke Diesel :: 5r110w - Tow Haul Starts Flashing
So driving the other day and tow haul starts flashing. I come to a stop sign and goto take off and it barley takes off. It will barley roll if my foot is off the pedal sometimes wont even roll. Also won't shift into 6th. Once it gets rolling though say till about 25 it's fine. Just doesn't wanna take off? I scanned the trans but got no codes. And here are some pressures and stuff but I don't know what I'm looking for with the trans. This was all done in park.
View 14 RepliesFord 6.0L Power Stroke Diesel :: Tow / Haul Light Comes On Flashing At Random Times
My co-worker has an 06 F250 SC 4x4 and is getting a P0713 code. 2006 Ford F250 6.0L Diesel ... Tow/haul light comes on flashing at random times. Truck is reading a P0713 code which is the TFT Sensor Failure/Replacement
Ford dealership is telling me that I also have to pull the valve body and install the new upgraded wiring harness (3-3.5 hours labor) but a thread on this forum stated I just needed to replace the sensor in the tranny pan and reconnect the wire harness. Do I need to upgrade the wiring harness?
Ford 6.0L Power Stroke Diesel :: 2005 - Transmission Temp Gauge Dropped / Tow Haul Began Flashing
Okay so I just peaked 100k and (of course) my 6.0 has an issue. I was driving along when suddenly my Transmission Temp gauge dropped to nothing, the tow haul began flashing and my check engine light came on. My transmission hard shifted and wouldn't shift up from 3rd. I let the truck sit for a few days, no leaking was observed and no blown lines. I added 4qts of tranny fluid and went to take it for a spin. The truck did fine for about 20 minutes and the same issue occurred. I parked it and checked the dip stick and it was full. What could the issue be.
View 5 RepliesFord 6.0L Power Stroke Diesel :: 2003 F350 - Tow / Haul Light Started Flashing - Code P0730 Incorrect Gear Ratio
Have a 2003 F350 srw 4x4, 107,000 miles on it. Driving it last night tow/haul light started flashing, hooked up AE got a P0730 Incorrect gear ratio. Truck seem to do ok, cut it off went back out a little while later and the tow/haul didn't flash.... Only issues I've had is when shifting from P to R, it takes a second or two longer than it should and shifts hard when it does but it doesn't do it every time.
View 1 RepliesFord 6.0L Power Stroke Diesel :: 2004 F250 - Check Gauge Light Coming On And Tow Haul Light Flashing
2004 F-250 6.0 Turbo Diesel W/ Torque Shift Transmission. Im having a problem with my Check Gauge light coming on and Tow Haul light flashing on my 04 F-250. I got a Transmission Fluid Temperature Sensor from my local Ford Dealership. They also said i needed to replace the Transmission harness for this application because of an open circuit.
My questions are, Is Mercon SP the only ATF that can be used on the Torque shift transmission and do i really need to replace the harness or just the sensor? I have read up a little on this and so far everything say's drain the fluid, drop the trans pan, swap out the sensor, replace the trans pan (torque setting is 11flbs I believe, correct me if I am wrong, replace with Mercon SP ATF and your good to go.
Ford 6.0L Power Stroke Diesel :: 2004 F350 - Check Gauge Light Came On And Tow Haul Light Started Flashing
Friday I pulled my steel gn 3 horse trailer about an hour each way. with the horses it weighs right at 7000 pounds. no issues. Saturday morning I drove to town, no issues. Saturday evening, I got in it to run down the road and about 2 miles from the house, the check engine light came on and the tow haul light started flashing and the temp gauge is dead. drives and shifts normal, tow haul button still functions. Truck is stock except for an EGR delete. No tuner, FICM was rebuilt. I had it on a battery minder before I left and was thinking about pulling the batteries and letting it sit for a while to see if it clears. Scan Gauge II shows no codes.
Sunday: So I let it sit all night, batteries connected and it was completely normal this morning. will see what happens when I drive it to work tomorrow
Later Sunday evening: So I just took it out for a test drive, went a couple miles down the road, shifting normal for a cold start. Temp gauge is working, just as I am almost back home. 5 miles at the most, temp is coming up to normal, gauge goes dead and check gauge light comes on and tow haul starts flashing. I think it might be the sensor.
This morning: I got about 6 or 7 miles from home, trans just got up to temp, pulling up a hill, it shifted out of overdrive, tft gauge went dead, check gauge light came on and the tow haul light started flashing. still shifts like it always has and the tow haul button still functions.
I am thinking it is just the temp sensor. Truck has 159k on it.
Ford 6.0L Power Stroke Diesel :: TBC Fault Occasionally Pop Up On The Dash - Code C2803
Finally got back home and I have the TBC Fault occasionally pop up on the dash and sometimes the C2803 fault code (Brake Pressure Transducer Sense Circuit Failure). Both have happened without the trailer connected. Is it the OEM brake controller? Or possibly the sensor at the base of the Brake Master Cylinder?
View 7 RepliesFord 6.0L Power Stroke Diesel :: Non Flashing Wrench Light On Dash
Recently, we took a trip pulling our 5th wheel, even after suspecting another stuck unison ring, sticking turbo issue. When Climbing a gradual grade, we had the "wrench" light come on the dash. The truck seemed to go into the "limp" mode. I pulled over, let the turbo cool down for a minute, and then shut off the engine.
I let it sit for a minute, knowing we were on the freeway shoulder, restarted it without clearing any codes, and it started up without the wrench lit. No limp mode and continued home. I did this twice throughout the trip. I then tried to pull and OBD codes and found none such as a P0299. Seems like there should have been a code saved to evaluate the issue.
Ford 6.7L Power Stroke Diesel :: 2013 - Dash Lights Flashing / No Restart After Shut Off
6.7 with 19k . Drove about 2 miles and noticed dash lights were flashing and ac was not working correctly . Pulled into garage shut off and truck wouldn't restart, no crank ! All my dash lights were flashing & dash was giving numerous messages.. At least I wasn't on my road trip 2 weeks ago! 3400 mile round trip. Truck was towed to dealer! My 6.0 never left me stranded & I had 3 of them..
View 14 RepliesFord 6.7L Power Stroke Diesel :: Tow / Haul Mode Auto Engage?
Is there a way to auto engage the Tow/Haul mode when you plug in a trailer that requires brakes? Be nice since I sometimes forget to push the button after we stopped for lunch...
View 14 RepliesFord 6.7L Power Stroke Diesel :: Loud Noise With Tow / Haul Mode
How do you diagnose a bad fan clutch? When driving in tow/haul mode I get a noise like a jet engine. It starts going down grade or upgrade and does not stop after leveling out. I have switched off tow/haul and it is still there. Over on the Diesel Stop site I found a couple of guys who have had the same problem. Concern is everything I have read there are no codes thrown. Have not taken to my local Ford Dealer to see what they say.
Driving a 2011 F-250, August 2010 build date with 76,500 miles. Problem started about 6 weeks ago when pulling an 8000 lb travel trailer in the White Mountains of NH.
Ford 6.7L Power Stroke Diesel :: 2012 F350 - Tow Haul Mode Upshift
I have a 2012 ford f350 SRW 4x4 with the 6.7L. Problem I have just started to have. When going downhill in tow haul the truck at first will hold you back then all of a sudden it starts to up shift at 20 mph it reaches 6th gear pretty quick. I talked to the dealer and they suggested I was pushing the shift buttons, but I am not. They told me to drive it till next week and then they will see if there are any codes in it.
View 14 RepliesFord 6.7L Power Stroke Diesel :: Turbo Noise In Tow / Haul While Descending A Hill
In addition to significantly louder noise from the Turbo on start-up, we've started to hear a pretty concerning noise while descending a hill in Tow-Haul. Not sure that the T/H has anything to do with it other than getting the engine in a RPM range that causes the noise. We've taken it in and tech says "That's just normal noise"... What ever that is.
Here is a link to an example : Tow haul making a lot of noise in my F350 diesel. Pulling a very heavy horse trailer. - YouTube
Best next steps for a 64,000 mile 2012?
Ford 6.0L Power Stroke Diesel :: Chirping Coming From Under Truck When Decelerating With Tow / Haul Engaged
Title says it all. Chirping sounds almost like belt noise but appears to be coming underneath the vehicle (and from further back than the drivers seat). Goes away as soon as I turn off tow haul (which provides engine braking). A quick visual inspection finds nothing amiss. Trucks runs and drives normally with or without tow haul.
View 14 RepliesFord 6.0L Power Stroke Diesel :: 2005 - No Start - Tow / Haul Light Flash And Won't Shift Into OD
I have an 05 Excursion and I drove and parked it, no problem. Came back out and the trouble began. I looked on this site (always do for the best guidance and info) and replaced the trans position sensor, put tunes back to stock. Since then, I have had intermittent issues with the truck only starting with the code reader plugged in, idle jump to 750 rpm, and the tow/haul light flash and won't shift into OD. It also seems at full stops it is not in the low gear. I am driving it to the "stealership" today to have the computer flashed. Additionally, the blinkers won't flash, they only illuminate. All this started at once. Where all the ground straps/wires are??
View 6 RepliesFord 6.7L Power Stroke Diesel :: Automatic Exhaust Braking Working In Tow / Haul Mode
Quick observation: with the exhaust brake switch off, I notice it appears that the exhaust brake is still working automatically when you are in Tow/Haul mode and apply the brakes coming down a hill.
I notice the engine drone and turbo boost gauge rise...although neither the drone nor the boost are as noticeable as when the switch is turned on.
I know the 2011-2014 had "auto exhaust brake only" but it appears some of that functionality is still built in.
Another question: what is the consequence of turning the exhaust brake on and leaving it on for normal driving? Is mpg affected? Engine output? Engine wear?
Ford 6.7L Power Stroke Diesel :: 2015 F250 - Slightly Slows Down When In Tow / Haul Mode While Braking
It's on my 2015 f-250....dont know if this is a new thing ..... I know my 2011 f-350 didn't have it..... Really hardly notice its working ....it slightly slows me down when in tow/haul mode while braking......
View 14 RepliesFord 6.0L Power Stroke Diesel :: 2006 F450 - Blinking Tow / Haul Light And Shifts Are Real Slow
My friend has a 2006 F-450 and he said the Tow/Haul light blinks and the shifts are real slow. He has stopped towing now and it still drives.
I have read everything from toasted tranny to chaffed wire harness across tranny crossmember to the TFT sensor. My guess is the TFT sensor given his symptoms. If I am right the sensor is just to the rear of where the dipstick comes thru the tranny case. 1/4 turn and pull it out. Kinda like a bulb I guess.
Another question, is it necessary to replace the harness while in there as well? Is the Connection listed below the harness I am asking about? I found these parts on a thread from here:
Sensor (1): 3C3Z-7H141-AA;
Connection (1) 4C3Z-7G276-AA;
Gasket (1): 3C3Z-7C155-DA;
Fluid (10): XT-6-QSP
Ford 6.7L Power Stroke Diesel :: Wiring Fault On Trailer
Hooked up the toyhauler Friday and before we were off of our street I got the "Wiring Fault on Trailer", brakes on trailer worked, got out and verified the lights were working so we proceeded on.
When we got to the destination the manual says that if the fault stays on when disconnected it is an issue on the truck side, it is still on when the trailer is disconnected.