Dodge - Dakota :: 2002 - Throwing P0132 / P0158 / P0135 / P0138 Codes

My 2002 Dodge Dakota Extended Cab pickup is throwing several different 02 sensor codes. The first one was P0132. I reset the CEL and it ran good for about 1800 miles (100,140) on the odometer now. Now I'm getting a P0158 code and CEL went off after a few miles. Now it's back to a P0135 and P0138 code. Are the 02 sensors really bad or is there an underlying problem with the wiring or the computer. The truck runs like new when the CEL is off. The P0132 has never shown up again. The engine is the 3.9 V6 and is 2WD.

View 3 Replies

Lexus GS 2006-11 :: VSC Check / Skid And Emission Lights Turned On - Code P0158

I got the Check VSC light on today along with the Skid Light and the Emission light. I got garage to read code said P0158 High Voltage on O2 sensor Bank 2 Sensor2.

He said O2 Sensor looks like its gone he Knocked it off and it has not returned as yet but the car still run right

However it went into service at Lexus Sheffield UK about 2 month ago and they said there is a crack in the rear exhaust pipe at the Y junction i said cant you weld it he said no you need new rear boxes as they are one unit.

I have noticed it is starting to blow a little now could this affect the o2 readings

GS300 Gen 3 2006 82000 mls serviced every 12 month...

View 2 Replies

Dodge - Ram :: 2007 - Check Engine Light Emission Code

My dad has a 2007 dodge ram 5.7 hemi and recently the check engine light has been staying on at first it was fuel door open now that's gone but the check engine is there went to get the code read and was told something about a fuel leak evaporator leak the cap or a vacuum line the cap was tested it was good?

View 1 Replies

Camry :: 2007 XLE 4 Cylinder - P2195 Code (A/F Sensor B1 S1)

2007 camry xle 4 cylinder engine, 2.4 liter I'm getting a P2195 code, which is the A/F sensor B1 S1. I have a few questions:

1. Any diagram of the location?
2. I've been trying to figure out the correct part number, so I can search for a replacement. I've found 4 or 5 different numbers already. What is the correct part number?
3. Should I only by the OEM part? Or do the aftermarket brands like Denso work?

View 4 Replies

Chevrolet - Colorado :: 2007 - CEL Code For Cam Shift Sensor Came Up

Check engine light has been on and when I checked the code it came up as the cam shift sensor. How do I know if it is the upper or lower and where are they located? I'm fairly mechanical so can I do this myself?

View 1 Replies

Santa Fe (CM - 2007-12) :: Error Code P0057 - O2 Sensor Replacement

I need to replace O2 Sensor which is Bank 2 Sensor 2 which needs to be replaced.

Where is this located on a 2009 Hyundai Santa Fe 3.3L

View 12 Replies

Santa Fe (CM - 2007-12) :: 2011 - PO198 Code / Oil Temperature Sensor?

I took my 2011 Santa Fe, 3.5 liter, in for the tail light water thing, and a cracked fitting down near the thermostat (all warranty). I bought a rad flush while they were in there.

I picked up the car, drove for 1/2 hour and got a CEL. Plugged in my code reader and got three PO198's, oil temperature sensor. The dealer was closed by then, so I left it in their lot and will call them tomorrow. Their repair performance to date has been poor, and that's being polite. How a rad flush could cause a PO198? Could they have forgot to plug the sensor in? Is it located anywhere near the thermostat housing? Did they not get the air out of the rad, and maybe the engine did get hot?

View 2 Replies

Camry :: 2007 - P0340 Code Appeared / Cam Shaft Position Sensor Bad

P0340 code appeared on my camry 07 said cam shaft position sensor was bad what other things can be the problem ? Also I just replaced alternator because car wouldn't start with out getting jumped once I replaced alternator it started up good for a couple of days then when I wanted to start it up it would crank then stop and crank again till it would turn on also car stereo would turn off while running and dashboard gauges would go off and would make the gauges go Dow to zero then it would go back to normal while still driving.

View 1 Replies

Lexus ES 2007-12 :: Vehicle Speed Sensor Location - Code P0500

Where the vehicle speed sensor is located on the 2007 es350. Reomoved battery and air filter box but just can't find it.

View 1 Replies

Toyota - Sienna :: 2007 - Code P2195 For O2 Sensor Signal Biased

I have a p2195 trouble code with my 2007 Toyota Sienna CE. This is O2 Sensor Signal Biased/Stuck Lean Bank 1 Sensor 1. I am assuming I'll need to replace this sensor. It's a little confusing but if I am reading my Haynes manual correctly, the repair goes as follows:

The sensor for 2007 and later models will be in the exhaust pipe after the catalytic converter. To remove it, it's necessary to remove the passenger seat, disconnect and snake the pigtail through the grommet in the car floor. Then, disconnect the O2 sensor from underneath the van and replace.

View 12 Replies

Lexus ES 2007-12 :: Code P0368 - Camshaft Position Sensor Error

2007 Lexus ES350 with 177k miles. Getting a P0368 (Camshaft Position Sensor B Circuit High Bank 1) Error. I can't seem to find online where this sensor is located at.

View 2 Replies

Santa Fe (CM - 2007-12) :: Code C1209 - Faulty Right Rear Wheel Speed Sensor

My mother in laws 2012 Santa Fe had a number of dash lights on (ABS, hill decent, stability control). I put my scanner on it and came up with fault code C1209 which showed up as a faulty right rear wheel speed sensor. I have replaced this module and then cleared the codes.

However, the dash lights still light up and the vehicle continues to throw the same code. I don't work on Hyundai's very often so I am at a bit of a loss.

View 1 Replies

Lexus ES 2007-12 :: Code P0365 - Camshaft Position Sensor Circuit Malfunction On ES350

I have a 2007 ES350 with 90k miles. Purchased in August. I had ignition coil go out and decided to change them all and the spark plugs. When changing cylinder 5's coil and plug, I tried to push the wiring harness out of the way to remove the coil. Result, I moved the wiring harness too far and disconnected the 3 wires (black, yellow and red) that were connected to the cam position sensor connector. (I should've just removed the sensor SMH) I disassembled the connector, got it down the internal pins, soldered the pins to the wires, placed the pins back in the connector and reassembled it with the wires in the order that they appeared to originally be.

Plugged it back in and put everything back in place. Started the car and code P0352 was cleared but replaced with code P0365 Camshaft Position Sensor B - Bank 1 Circuit Malfunction. I'm thinking, either I put that pins back in the wrong order or one of the wires isn't properly soldered in. Either way, I ordered another connector and it should be here tomorrow. I need Either a wiring diagram or a picture of the camshaft position sensor closest to cylinder 5 connected with the wires in the proper order .

View 14 Replies

Corolla / Matrix 2009-13 :: 2010 Does Code P0037 Is For Bank 1 Sensor 2 Oxygen Sensor?

I have a 2010 Toyota Corolla 1.8L, the base model.

I recently had a check engine light, VSC off light (blinking) and traction control light come on. I took it to Autozone and had a p0037 code ring up for a new Bank 1 Sensor 2 oxygen sensor (downstream). I believe I have found the correct sensor (located under car, approximately near drivers seat) and it looks simple to replace, aside from the fact that the wires go through the car body.

Can confirm that I have located the correct sensor? And if so, what is the best way to get to where the wires connect?

Is it located under the drivers seat? What should I do about the rubber grommet located under the car where the wires appear to pass through?

View 2 Replies

Ford 6.7L Power Stroke Diesel :: 2015 F550 - CEL Code Oxygen Sensor Performance Bank One Sensor One

The service truck threw a CEL, and i pulled oxygen sensor performance bank one sensor one code. That would be driver side sensor between the manifold and cat, rite? Don't want to change the wrong one...

View 11 Replies

Ford Super Duty (1999-2016) :: Code P2195 (Bank 1 Sensor 1 O2 Sensor Stuck Lean)

So I just replace my Cat. Converter with all new sensors in them. I just replaced my spark plugs. (I'm knocking out these check engine light problems) and I think I'm getting close to the root as to why these other parts went bad. Why my o2 sensor would be stuck on "lean" ....

View 5 Replies

Sonata NF (2006-10) :: Check Engine Light With Codes P0160 / P2273 And P0158

I just picked up my 'new'/used 2006 sonata! unfortunately, about 11 months in now, i have a check engine light and some codes; a local store told me what the codes were (i haven't got a code reader yet) and as i was researching them it sounds like either a bad O2 sensor or just the wiring going to it.?.? Codes are P0160, P2273, P0158. How can i tell what is actually bad? I am 'ok' at 'fixing'; just trying to save from an expensive garage repair if at all possible.

View 4 Replies

Accent LC (2000-05) :: 2002 - Code P0106 / Map Sensor Code

Ok had a check engine light. It directed me to replace the IAT sensor.. After some research I found it was integrated into the MAP sensor. Purchased a new sensor and replaced. Drive about 15 miles CEL throws another code. P0106 (sensor i just replaced) faulty Map sensor.

Followed procedure to replace sensor.. unhook battery cable reset ecm. After reset engine is hard to start. Followed by RPM changes (assuming its the ECM re-adjusting). Then CEL flashes 5-6 times and goes out, Drive 15 miles. Map sensor code reappears. (note i only purchased one sensor But repeated install 2 times).

My thought is against wiring. since the codes refer to different signal wires one for IAT one for MAP sensor. Faulty replacement sensor?

2002 Accent 1.6L

View 3 Replies

Dodge - Ram :: 2006 - Brake Fluid Sensor Stuck?

This last week my brake fluid light comes on my 2006 Ram 1500 but my fluid level in the reservoir is at max..fluid is a yellowish color when I look at it out of reservoir (looks darker in the reservoir).

If I unplug the sensor to the reservoir, the light still stays on which puzzled me, but I'm not honestly sure what I'm hoping to see happen. I am no positive if I'm due for a brake job, but the pads still looked to be good to me (not sure if that could trip the sensor). Where to start?

View 18 Replies