Celica :: 2003 - Missing On First And Third Cylinders
My car runs fine when it's cold, but once it warms up during idle it will try to cut out and start missing very, very badly. CEL came on and it wouldn't shift into third gear, so had the codes checked, and it said cylinder 1 misfire, cylinder 2 misfire, random multiple misfire. So, changed the spark plugs and air filter, but it's still doing the same thing. Almost didn't make it home, but once I turned the air conditioner off, it ran much better. What should I check next? what could the problem be?
View 5 RepliesCelica :: 2003 GT Misfiring On 3 And 4 Cylinders With Codes
According to the OBDII, I have a misfire on #3 & #4 cylinders. Im getting codes PO300, PO303, PO304 and PO171.
View 2 RepliesPassat (B6) :: Charger Ports Not Working?
My car ports that i use to plug in a phone charger are not working.
Can this be a blown fuze?
What fuze is it that I will need to change?
Nissan - Altima :: 1997 - Cleaning Egr Ports?
on 1997 Nissan pickup 2.4-liter engine do you have to take off the valve cover to clean out EGR ports.
View 1 RepliesPhaeton :: How To Clear Water Drain Ports
Looking for post with instructions on how to clear the drain ports for sunroof and any cavities that collects water such as in engine compartment where brake master cylinder is located.
Tried to look for front sunroof ports... cannot see it. Discovered that I have about 3/4" of water still trapped under the master cylinder area... cannot find the drainports underneath it. Probably have to use a wire to poke through from top.
Ford A/C :: Low And High Side Connection Ports Location
I just checked the HVAC FAQ sticky and found my symptom and problem listed there with corrective action. Extremely useful.
My issue is, I'm on crutches due to a recent foot surgery. Doctor's orders do not allow me to put any weight on that foot for at least another week.
Looking for a picture of these port connections for the truck listed in my signature? I'd like to see where they're located before I hobble on out to the truck. I have a feeling I'm not gonna be able to do this on crutches and my daughters need the A/C working.
Bonneville :: Coolant From Lower Ports Throttle Body - Gasket?
Took off throttle body on 3800 series1 S/C and coolant is leaking from both bottom ports from mounting area on motor. Is this normal ? Intake area into S/C was dry but very much build up. The 2 ports just end at bottom back of throttle body and are sealed by the gasket. Coolant comes out steadily from those 2 holes. Is this an intake problem, gaskets ?
View 1 RepliesFord - Taurus - Airconditioning :: 1995 - A/C Service Ports Leaking
The A/C in my 1995 Taurus SHO stopped working suddenly on my way to work. I found that the compressor clutch was no longer engaging. I tried tapping the clutch with a broom handle while the car was running and the A/C on to see if the clutch would engage and indicating that the gap my be too wide but I had no luck.
I then hooked up the guages to check the charge and performance of the system. When I removed the service hoses both service ports were leaking gas. I tried to poke them with a small scredriver to get them to seal but that didn't work. I ended up losing the entire charge.
The service ports in the A/C lines do not appear to be schrader valves. There appear to be small rubber balls in the port that seal. However I knocked one of the apparent balls loose and found simply a flat plate in the service port. I am certain that it is not a schrader valve unless one exists under this plate.
Are these service ports repairable/replaceable or do I need to replace the entire hose assembly?
Ford 6.0L Power Stroke Diesel :: Oil In Exhaust Ports 1 And 3 And Oily Film In 2
Long story short I am working on an engine that was already dismantled (down to the heads). I am trying to figure out why someone tore the engine down. Vehicle is a recovered theft and it was recovered with all parts.
I removed the exhaust manifolds from the heads to start cleaning them up and replacing the exhaust bolts (rust). When I removed the exhaust manifolds the front two cylinders on the right side (1 and 3) were oily wet. The back two cylinders were sooty and normal. The front cylinder (2) on the left side was not as bad but did have a oily film on top of the valve and valve stem. I do not see any indication of anti freeze or coolant.
I looked at the head gasket and could feel a oil film between layers on 1 and 3. No oil on 2 that I could detect. I'm thinking there was a head gasket problem but not totally convinced. The cylinders and pistons look good from the top and the cylinders still show the cross hatch honing. No ridge on the top of the cylinder either. The motor has 122k miles on it.
Other than head gasket would there be something in common that could feed oil to those cylinders? I have eliminated the turbo. There is no oily film on any intake runners. It could just be a blown head gasket but it is not obvious if it is.
Touareg :: Headlights Have Tiny Cracks In The Lenses
I have a 2005 V8 with Xenons. I noticed today whilst cleaning my Touareg the headlights have loads of tiny cracks in the lenses. I live in Houston TX, so it's probably caused by the heat.
View 11 RepliesGolf/GTI VII :: Repairing Small Bumper Cracks?
Is there a way repair a small bumper crack myself?If yes, what are the steps and the products?
View 4 RepliesCivic - Honda :: 1999 - Cracks In The Tires
Car is a 1999 Honda Civic.
My car was inspected yesterday. I needed the A pipe replaced (exhaust pipe connected to the muffler) and a radiator leak repaired or maybe the radiator replaced. I'm in dire straits, and this was paid for by a charity. I really need my car, as I will have nowhere to stay as of this coming Saturday. Anyway, the repairs were made and the car passed inspection.
I drove off, made a stop somewhere, happened to glance at one of my tires, and noticed deep cracks in it. Odd that I hadn't noticed these before, because I've had trouble with dry rot before. These are top-of-the-line tires (bought back when I had money as an investment against skidding accidents), but they're four years old now.
Granted, I needed it to pass inspection, but would it pass with tires that have dry rot? The first time I had dry rot, the cracks were barely noticeable and had to be pointed out to me. (That time, they were only one year old, within the warranty period and so got replaced.) This time, the cracks are much bigger and deeper, and in all the tires (easy to see, once I looked). Now I'm worried that I'll have a blowout very soon.
Not much I can do about it with no money, but I'd like to at least know what to expect. Seriously, if the cracks are that bad, wouldn't the mechanic fail it for inspection?
Last question: Is dry rot the same thing as weather cracking? Is weather cracking dangerous?
Toyota - Camry-solara :: Cracks On Dash Cover
As a new owner of a '04 Solara that is perfect in every way except cracks in the dash, replacement covers are available and where?
View 1 RepliesSubaru - Outback :: Small Cracks In The Sidewall Of Tires?
I drive a 2003 Subaru outback wagon. The roads are terrible during the six months of winter we have. The tires on my car are Michelin hydroedge from 2007 with a treadwear warranty of 90,000 miles, since the tires were purchased the car has gone almost 110,000 miles. In June the tread was measured at 6/32 for three of the tires and 4/32 for the fourth tire. I've started noticing some small cracks in the sidewall. This car has a brutal winter ahead of it and a long drive from the Upper peninsula to Connecticut in May, if I need new tires I would rather find out sooner than later. My question is do I need new tires or not?
View 19 RepliesLexus GS 2006-11 :: 07 GS350 - Cracks In Front Windshield / Replacement?
I have a couple of cracks in my front windshield and I'm thinking of replacing it.
A few years back I had the dealership work on the famous creaks and I know they stuffed felt in between the windshield cowl area. Would that need to be redone?
I would request a factory windshield but I'm concerned if it might make the creaking worse or if it would affect the integrity of the car.
Golf VI R :: Rear End Clunk When Going Over Medium Size Cracks In The Road
So with just me in the car i get a clunk in the rear going over medium size cracks in the road. but with the wife and kids in the car the clunk is not as prevalent. VMR springs...
View 5 RepliesPassat (B5) :: Front End Rattle Or Clanking Over Bumps And Cracks In The Road
I have this front end rattle or clanking. It happens over bumps and cracks in the road. The rattle seems to be more on the passengers side to under the middle of the car. The stats of my Wagon - lowered on Bilstien Sports/H&R springs. All The control arms have been replaced back in 04 and maybe 40k miles ago. Drive axles were replaced once a long time ago, before it was lowered.
View 8 RepliesLexus RX 2004-09 :: 2008 RX350 - Cracks And Chunks Are Beginning To Fall Off
Bought our first Lexus, 2008 Rx350 in March of 2012. Was fed up with our 2010 Ford Escape. Bought the Lexus because of their quality reputation. Shortly after purchase cracks began to appear in the dash. Now have 5 cracks and chunks are beginning to fall off. Contacted Lexus. Even though they know that they have a problem with the dashes they will do nothing.
View 2 RepliesFord F-150 - 1997-2003 :: Shake Through Steering When Hitting Road Cracks
My 02 F150 4x4 at times gets a shake through the steering when hitting road cracks, pothole fills, etc. Would installing a steering damper system work or am I missing something to check in the front end. Ball joints are good, all steering linkage good, new shocks all around, control arm bushings look good and don't seem to shift when prying with a bar. Also changed all sway bar bushings and links. Maybe the control arms just have to be changed with 103,000 miles on it even if they appear OK? What about using an aftermarket steering damper on a stock F150? My long gone 82 GMC 4x4 had one from factory but it was also a solid axle setup.
View 4 Replies