Golf V R32 :: Front Charger Not Working
Have a problem with their front 12V charger not working? Could this be a fuse issue? I couldn't find the specific fuse location in the manual for the front charger.
View 2 RepliesCamry 2012+ :: 2014 - Power Charger Not Working?
the 12V power charger by the cup holder in my 2014 camry stopped working. I checked the fuse and its not blown. Is it the actual socket itself I fried?..
View 4 RepliesPrius (2004-09) :: Hybrid Auto Charger Not Working
Finally got around to installing my new Hybrid battery charger from Hybrid Automotive in my 2007. Pretty easy & straight forward wiring install.
After installation I did the first test just hook up the charger to its dongle and no interlock and it looks ok shows 250 volts and 0 amps on there charger display but I have no battery fan. The fan is on in the charger but no hybrid battery fan..
No 12 volts from there charger to there fan control box input.
Install directions say all the fans should be running from the get go. Then I installed the interlock to see if it will charge and it does. Shows 222 volts and .337 Ma's which is correct but still no battery fan. No 12 volts form the charger.
Dodge - Charger :: 2007 - Heater Won't Working / Blowing Cold Air
My dodge charger 3.5L 2007 model have heater problem, The heat blows out cold air.
View 18 RepliesFord F-150 (2004-2008) :: Cigarette Lighter And Phone Charger Quit Working?
Why my cig lighter and cell phone charger stopped working. I changed the fuse but it did not solve the problem. I don't smoke but I love to charge my cell phone when I go hunting overnight.
View 11 RepliesDodge - Charger :: Cruise Control Stopped Working / Brake And Traction Control Lights Constantly On
My college son's 2014 Charger V6 has developed three issues since he purchased it used in late May. The cruise control has stopped working and the anti lock brake and traction control lights are constantly on. Any possible cause?
View 15 RepliesCelica :: Too Many Cracks Into Cylinders Going To The Ports
I run a 1984 Celica at my local short track in the mini stock 4cyl division.
I had a lot of hesitation & tons of overheating (especially later in the season) on the track late last year. Parked the car for the winter & a few sponsorships later, decided to tear the motor down. New intake and exhaust manifolds new water pump and new head gasket.
Everything came in over the past few weeks & we began to work. We got the head off smoothly and got to the head gasket, which we thought may have been the cause of the overheating. Didn't look THAT bad, but definitely needed replacing. Got it off, wiped the block down to just take a look at it and a half dozen fractures/cracks going from the cylinders themselves to the ports for the coolant.
What engine can I put in this car. Will the motor mounts take any 22r/20r block? Its a 1984 Celica. I'm trying to get the car ready for the track in April and don't have a huge budget. I've found some blocks, 86 pickup 22r, 91 pickup 22re.
Nissan - Altima :: 1997 - Cleaning Egr Ports?
on 1997 Nissan pickup 2.4-liter engine do you have to take off the valve cover to clean out EGR ports.
View 1 RepliesPhaeton :: How To Clear Water Drain Ports
Looking for post with instructions on how to clear the drain ports for sunroof and any cavities that collects water such as in engine compartment where brake master cylinder is located.
Tried to look for front sunroof ports... cannot see it. Discovered that I have about 3/4" of water still trapped under the master cylinder area... cannot find the drainports underneath it. Probably have to use a wire to poke through from top.
Ford A/C :: Low And High Side Connection Ports Location
I just checked the HVAC FAQ sticky and found my symptom and problem listed there with corrective action. Extremely useful.
My issue is, I'm on crutches due to a recent foot surgery. Doctor's orders do not allow me to put any weight on that foot for at least another week.
Looking for a picture of these port connections for the truck listed in my signature? I'd like to see where they're located before I hobble on out to the truck. I have a feeling I'm not gonna be able to do this on crutches and my daughters need the A/C working.
Bonneville :: Coolant From Lower Ports Throttle Body - Gasket?
Took off throttle body on 3800 series1 S/C and coolant is leaking from both bottom ports from mounting area on motor. Is this normal ? Intake area into S/C was dry but very much build up. The 2 ports just end at bottom back of throttle body and are sealed by the gasket. Coolant comes out steadily from those 2 holes. Is this an intake problem, gaskets ?
View 1 RepliesFord - Taurus - Airconditioning :: 1995 - A/C Service Ports Leaking
The A/C in my 1995 Taurus SHO stopped working suddenly on my way to work. I found that the compressor clutch was no longer engaging. I tried tapping the clutch with a broom handle while the car was running and the A/C on to see if the clutch would engage and indicating that the gap my be too wide but I had no luck.
I then hooked up the guages to check the charge and performance of the system. When I removed the service hoses both service ports were leaking gas. I tried to poke them with a small scredriver to get them to seal but that didn't work. I ended up losing the entire charge.
The service ports in the A/C lines do not appear to be schrader valves. There appear to be small rubber balls in the port that seal. However I knocked one of the apparent balls loose and found simply a flat plate in the service port. I am certain that it is not a schrader valve unless one exists under this plate.
Are these service ports repairable/replaceable or do I need to replace the entire hose assembly?
Ford 6.0L Power Stroke Diesel :: Oil In Exhaust Ports 1 And 3 And Oily Film In 2
Long story short I am working on an engine that was already dismantled (down to the heads). I am trying to figure out why someone tore the engine down. Vehicle is a recovered theft and it was recovered with all parts.
I removed the exhaust manifolds from the heads to start cleaning them up and replacing the exhaust bolts (rust). When I removed the exhaust manifolds the front two cylinders on the right side (1 and 3) were oily wet. The back two cylinders were sooty and normal. The front cylinder (2) on the left side was not as bad but did have a oily film on top of the valve and valve stem. I do not see any indication of anti freeze or coolant.
I looked at the head gasket and could feel a oil film between layers on 1 and 3. No oil on 2 that I could detect. I'm thinking there was a head gasket problem but not totally convinced. The cylinders and pistons look good from the top and the cylinders still show the cross hatch honing. No ridge on the top of the cylinder either. The motor has 122k miles on it.
Other than head gasket would there be something in common that could feed oil to those cylinders? I have eliminated the turbo. There is no oily film on any intake runners. It could just be a blown head gasket but it is not obvious if it is.
06 Charger Won't Start Sometimes - Going Into Limp Mode
I have a 2006 Charger R/T. My car used to not start (even thought the battery, starter, and alternator was good). I had it fixed, and the problem seemed to be electrical. However after that, it would always start, but would go into "limp mode". I let it sit for two days, and the limp mode disappeared. However, it will only start on occasion. It won't start after about 30 mins after use. It won't start for a few hours. All electrics work fine, it just won't even attempt to crank. Try to start it later, it will work fine. Even though the check engine light was NOT on, I was able to pull three codes out of it: U0100, U0103, P0700. I did have to replace the notorious "pink thingy", but everything (should be) connected fine.
View 1 RepliesNissan :: Alarm Going Off After Connected To Charger
The van's battery died all the way.
I went to jump it off and as soon as I connected the charger it's loud and annoying alarm started going off.
I tried pressing the Disarm button and the Arm button, nothing happened.
What do I do?
Camry 2012+ :: OEM QI Charger Installation Into 2015 XLE
Who has installed the OEM Qi charger into their 2015 XLE yet? My phone has it, so I am looking to do this when I can find the parts.
View 14 RepliesLexus ES 2013+ :: 350 / Where To Place Wireless Qi Charger
I've been wanting to get a wireless Qi charger for my Samsung Galaxy S5 and have thought of a few options:
1. Have somebody custom wire a Micro USB into my glove box.
2. Put it into my center console (no custom install needed).
What about the phone moving around when the car is in motion? Other pros and cons?
Prius (Gen 2) :: Add Solar 12V Charger To Optima Battery?
By hooking it directly to the battery, putting the solar panel in the sun to keep it fully charged? It's 1.5 watts. 12 volts. It has a built in over charge protection.
View 3 RepliesPrius (Gen 2) :: DC Charger To Test Battery Cells?
I found a decent deal on a 2nd gen prius. But I am going to need to repair the battery. I have already known that I can test and only repair the needed cells (since I looked into the situation when I was buying mine a year ago). Looking at the forums and saw there were a couple of chargers being recommended by the users; such as the supermate DC6 or the Hitec 44151 Quad X4.
I will likely want to charge 8 cells at time at least, as I would ideally like to get the car fixed in a couple of weeks.