Ford :: Buzzing / Rattling Noise When Clutch Engaged To Shift To 3rd Gear
My manual 2004 Ford Ranger XLT (4.0L) has been Buzzing/Rattling. (VIDEO LINK BELOW) She has 112k miles on her. Owned 1 month, no issues when I bought from my paps. Its my 1st manual so may have been a little hard on clutch 1st few days. Noise started abruptly 1 week ago when I engaged clutch to shift to 3rd. Its gotten worse over the few days and happens even when in gear. Its much more prominent from outside passenger window. Don't notice for 1st couple mins of driving & is intermittent but often. Noticeably louder when foot is taken off gas in motion. Does not make noise when idling. Generally only above 1500 RPM . Not coming from the back half so I don't think its the exhaust/heatshield
Heres the sound......
Golf/GTI VI :: Manual Transmission - Rattling Noise When Clutch Pedal Is Not Engaged
I currently own an mk6 gti with a manual trans... as of late I've been noticing a rattling noise when the clutch pedal is not engaged.. once engaged the rattling stops completely .. it seems to be getting louder and louder .. I am worried this could eventually turn into something worse than just a rattling noise .. i had a friend mention it could be the "throwout bearing" ..
View 9 RepliesCelica :: 90 Transmission Eventually Not Going Into 5th Gear
Had probs. with 5th tear to start. It started to pop out of 5th gear when I let off the gas, eventually not going into 5th anymore. You could put into 5th but when you let out the clutch it would just grind. Now the other day I drove it to work because I had no other car to take and I made it there with no issues using 1st-4th. My work is 42 mile away with a speed limit of 60 for about half of it Now when I am ready to go home from work I have no gears at all. It will not go into any gear at all. The clutch does not feel spongy it does have some pressure and linkage appears to be intact.
View 4 RepliesFord Transmission :: 1996 F150 - Rattling Noise As The Clutch Engages When Taking Off In First
1996 F150 4x4 with 300/6 and M5OD mazda tranny. 145k miles on it and looking really clean, and just the truck we wanted. It used to be well cared for, but has been a bit neglected since the owner passed away.
I spent a few hours searching the forums here and didn't find anything matching my symptoms exactly so I thought I would just jump in a post, but if I missed a thread feel free to redirect me.
I've got a bit of a rattling noise as the clutch engages when taking off in first. Once the clutch is fully engaged it's quiet and it shifts well and smooth. Noise also occurs (but less so) if I don't match RPM's and ride the clutch into second or third. I don't think its engine noise from lugging or anything because it goes away as soon as the clutch is fully engaged or disengaged.
Changed the trans fluid last night and no different, Clutch fluid reservoir is full, clutch travel feels good, master cylinder looks good, (slave is hidden, but looks dry though dust cover) a little play in the white bushing that holds the clutch pedal bar in place, and the plastic pushrod that goes into the firewall, thinking about replacing this linkage.
I work on big diesels for a living so i'm not scared of getting greasy. I'm almost inclined to think someone did a clutch job without resurfacing the flywheel. Is there an improved replacement for the pedal bracket and linkage? I don't mind just doing the clutch, but I don't want to be throwing my money away.
Ford Transmission :: 1987 F250 - Rattling Noise When In Neutral And Stops When Put The Clutch In
I just recently picked up a 87 F250 with a 6.9 and a ZF5 trans. The PO replaced the clutch, and mentioned that he replaced the clutch fork too
Since I bought the truck, I've had some nasty rattling noises. It rattles when in neutral, and stops when I put the clutch in. The noise also comes back on occasion when decelerating at highway speeds, in 2nd as soon as I stop accelerating, and at low speeds in 3rd.
What is causing this?
Celica :: 1997 Transmission Pops Out Of 1st / 3rd And 5th Gear
Got my 97 celica GT 5 speed, the transmission took a crap, pops out of 1st 3rd and 5th gear, grinds into 3rd when cold even before it pops out. first off I read somewhere that this could be just linkage bushings, but the transmission will pop out of gear in first, then will grind going back into 1st and same with 5th, which linkage bushings do I check? is it the ones on the selector shafts? also the trans has 250k on it, and it looks like the fluid hasn't been changed in 200k.
View 2 RepliesCelica :: 1988 GT Manual Transmission Grinding When Going In 3rd Gear
My 88 celica's manual transmission grinds a little, at times, when going in 3rd gear. I have atf fluid in it now as specified in the manual. Should I replace it with gear oil?
I don't want to damage the transmission or clutch.
Toyota - Celica :: Transmission Hangs Onto Third And Then Eventually Shifts Into Fourth Gear
I own a 2004 Toyota Celica GTS 4-speed automatic, 24,600 original miles. The car is maybe 11 / 12 years old now. I've noticed that in extremely cold Wisconsin weather it takes a while for my car to shift into fourth gear. It kind of hangs onto third and then eventually shifts into fourth at about 40 - 45 miles per hour. Not sure if that's anything to be alarmed about or not. Drives fine and shifts smooth in warmer weather. I am the second owner. I am going to assume the original owner never changed the transmission fluid, or for that matter, never had a reason to. I purchased the car several years ago. So... is slow shifting enough to change the fluid? Or age of the fluid anything to worry about?
View 7 RepliesCelica :: 1991 - Transmission Refuses To Change Into Highest Gear Until Warmed Up Enough
I have a 91 Celica that has a strange transmission problem. She hates the cold weather. No joke, she drives GREAT in the warm weather. But when its cold, she refuses to change into the highest gear until she feels like she's warmed up enough. But even then, she will randomly downshift again (all other things like speed, elevation, etc. constant.) When that happens, the RPMs (obviously) jump up. I always try to slow down when that happens, and eventually (5-7 minutes later) she shifts back into the appropriate gear.
I've owned it less than two years and have done A LOT of work on it. I am hoping to upgrade with a vehicle from a family member, and actually have the Celica for sale (and I hate selling cars......I don't think $1400 is too much for her!) Only 133,000 miles as she sat for a LONG time before I got her. I got all the kinks worked out except this transmission issue. Everyone I've talked to is stumped. And other than the "cold" issue, she shifts beautifully. I've been told to NOT flush or change the fluid at this point, so I haven't done that, but it's full.
I don't know if it's related, but the temperature gauge very rarely makes it off the 'C' mark. Sometimes when I'm idling it will climb to a whopping 15-20%, but generally it lives at or below the 'C.' I have never seen it at or above 50%.
Ford Transmission :: No Clutch / Truck Will Not Engage A Gear While Running
I have a 2001 m5r2 ford f-150 standard transmission. i have replaced the slave cyl., the entire clutch assy., the master cyl. pilot bearing. the trans. will engage all five gears plus reverse while truck is off but will not engage a gear while running. i have bled and bled and bled and still will not engage.
View 1 RepliesChrysler - 300 :: 2005 - Transmission Feel Slammed Into Next Gear Without Any Clutch / Car Shudder
My wife and I purchased our 2005 Chrysler 300 Limited in May 2004.Our 300 has over 117,00 miles as of May 2011. It has been a rather dependable automobile.I have enjoyed it almost as much as my HD. We have performed maintenance as close to the schedule as possible.
I failed to drive the car as often as our second car is an used 2002 S430 which had been my primary auto until about two months. My niece and nephew reported to my wife that the car was not "doing something right". No one could really explain, so I had drove the vehicle myself to determine the issue. The transmission had the feel that it was being "slammed" into the next gear without any clutch. Once the car was warmed up, it appeared that when it shifted at 38-40 mph or 48-50 mph, the car shudders. It almost resembles the feeling you get when you run a car across those strips in the road.
I took the car to the dealership where I have had it serviced locally. They replaced a module which had Technical Service Bulletin from Chrysler for noted similar problems. The first module replaced did not resolve the problem. I took it back and they tried again with the end result being same as before I took the 300 into the shop, transmission appeared to shudder when shifting at the midrange gears.
The dealership as another option recommended that the transmission be replaced. I was not confident with their assessment as I had the distinct feeling they were not clear on the real issue.
I took the car to another service shop which I had more confidence in their work. I asked that they check the car for the problem with the transmission as I wanted their assessment. At this point, I had pretty much decided that I would get rid of the car, but did not want to give anybody else the troubled vehicle nor did I want to have to rush to decide on an automobile to purchase.
The second shop recommended the transmission be replaced, as well several other items be checked as there appeared to be oil leaks. The CAM plugs had been replaced as part of the service the dealer performed though the engine area had not been cleaned of the previous oil. That news was alarming, as the price estimate for a replacement engine was around 6500-7000 smackeroos, way outside of my comfort for repair on the car.
I was able to locate a used transmission with only 86k on it through a very gratuitous turn of fate. I digress, however, as the source for the used transmission was available only to licensed shops.
Two shops had referenced a transmission repair shop as one of the best in our small county. I left the car with the transmission shop for their testing, and it came back with their recommendation that the problem existed in either the coil or spark or an area related there.
I again took the car to the second shop and asked that they check the engine thoroughly for any issues with the spark plugs, wires or similarly related issues. The shop reported that the motor compression was at 190 across all six cylinder and the spark plugs and wires were new and there were no issues with the coils.
I am most happy that the engine is in excellent condition. I have planned to take the car back to the tranny shop as I reported the findings to him of the other shop. I am concerned about the transmission, though I am driving it about 60 miles round trip to work about 2-3 days each week. It still convulses at the mid-range shifting but otherwise runs pretty good after that. The car body is in very good shape as is the interior.
Ford Ranger / B-Series :: 1986 - Transmission Overhaul - Hard To Get Clutch Into Gear From Neutral
Rebuild on the Mazda 5 speed transmission. My 1986 Ranger 2.3 Four cylinder has 280,000 miles and the clutch has never been replaced. It's not slipping but I'm having trouble getting it into gear from neutral. Was told that the release springs on the clutch plate have weakened causing the clutch to not release completely so figured it's time to replace it. It's done well the last 280,000 miles. The question I have : overhauling on one of these Mazda trans and how difficult was it. Any special tools required, etc...I see Autozone has a rebuild kit which appears to have bearings, seals and gaskets. Figured while it was out I would go ahead and rebuild it myself if I can. Rebuilt a few engines but never touched a trans.
View 4 RepliesCelica :: 2004 GT - Rattling Noise When Accelerating At Low Speeds
I have an 04 celica gt with around 168 k miles on it. Recently I have noticed a distinct metal on metal rattling noise whenever I accelerate at low speeds. It seems to be my exhaust as when I rev it up in park it makes the noise. But it doesn't ever make the noise when I'm on the expressway or cruising at back roads speeds. When I got under and looked at my exhaust everything looked normal?
View 3 RepliesCelica :: 2000 GT - Ticking / Rattling Noise From Engine Around 2k To 3k RPMs
I drive a 2000 Celica GT 5 speed. I am having an issue with my 1ZZ-FE.
I am hearing a ticking/rattling noise from my engine around 2k-3k RPMS. Anything before or after that, the noise dies down. I could hear it from the interior of the car as well. I at first thought it was valve chatter. Someone said It could be a piston or rod. What parts will be needed? Worst case, ill just swap in a 03+ 1ZZ or go with a 2ZZ.
[URL] ....
Celica :: Clutch Pedal Pressure Was Very Stiff
I have a 2002 Celica GTS with 80,000 miles. The clutch pedal pressure was very stiff. I had a 2001 GT, and it had a very soft and easy clutch. I just removed and rebuilt the clutch slave cylinder, using the CSK 2426 rebuild kit. The slave cylinders on 2000 to 2005 Celicas are all the same. After bleeding the cylinder, the pedal pressure is very much improved. It still takes some effort, but not like before.
View 1 RepliesCelica :: 1996 Toyota SX Making High Pitch Rattling Noise When Start It
i have a 96 toyota celica sx which makes a horrible noise when i start it, its almost like a high pitch rattling noise, usually goes away when it warms up but sometimes still making it accelerating, think the noise is coming from area which is in the photo, what it is?
View 7 RepliesCelica :: 1998 GT Manual Clutch Just Went Completely Soft
I'm a fairly new owner, and the 89 gt I just bought came in very good shape. Yesterday the manual clutch just went completely soft. I felt this for about a week when I first purchased it, but only in first gear and it worked itself out and hadn't recurred since then. Now the clutch will not disengage. Gears move well when the car is off though. I noticed the clutch fluid was totally empty when I looked under the hood yesterday. Is this indicative of a bad master or slave cylinder? Or do I just need to bleed and refill the fluid? I love driving this car and want to again soon.
View 1 RepliesCelica :: 1990 - Speedo Is Not Working After Clutch Replacement
I just replaced my clutch and now my speedo is not working ? It did work for about a day after the job, but now it just reads 0 all the time... would low fluid cause that ?? I put two quarts in after putting the trans back ....
View 4 RepliesGolf/GTI VI :: Rattling Noise Whenever Let Off The Clutch
I am a new owner of a 2011 Tomato Red GTI and was wondering if the sound my car makes is normal. Whenever I let off the clutch the car makes a rattling noise and i can feel it with my foot. Is that normal in our cars?
View 13 Replies