Caravan/Voyager :: Town And Country Starts And Dies When Moving
2002 T&C, starts and idles fine. When we put in gear (drive or reverse) it dies. Then we can restart and it drives fine the rest of the day. This only happens when it has been sitting a long time, such as over night. However, I've let it sit until mid-day and it does it so it doesn't appear to be Temp or humidity related as it issue is repeatable at any time of the day as long as the vehicle has been sitting 12 hours or so.
The remainder of the day it drives without issue and we can restart 8-10 times during the day without issue, then the next day when we restart it, no matter how long it idles it cuts out when you first start to move and apply the gas. When you restart, it, it often doesn't happen again and I've never had to restart more than twice. Again, it runs fine other than this issue.
I've replaced the fuel filter and I put a pressure gauge on the fuel rail. The pressure is within specs. I also watched the gauge as my wife backed the vehicle up and it died, but the fuel pressure didn't drop out. It is now showing a O2 Sensor code per Advance, but in reading other post, those can be misleading, so I wanted input before I just start throwing money at the problem
Caravan/Voyager :: 2005 Town Country - P0032 Oxygen Sensor Heater Circuit High Voltage
P0032 Oxygen Sensor Heater Circuit High Voltage (Bank 1, Sensor 1)
I have read that in 2005 chrysler changed the ohms levels for the oxygen sensors and may need to have bcm reflashed to get a new oxygen sensor to work wheither its dealer item or not, is this true if i were to buy a mopar oxygen sensor? aftermarket is out of the question being the ohm readings would require me to spend some time at the dealer. is this code a defective sensor? or could it be related to the thermostat being faulty? am not low on antifreeze and temp gauge reads normal.
Caravan/Voyager :: 2004 / 3.8 - Significant Intermittent Missing
I recently acquired a 04 grand caravan with 130k on it today i got off freeway and was sitting at light and i felt a pretty significant intermittent miss so i had it scanned and came back with those 2 codes and a previous evap code in wich i was aware of. Im gonna change plugs and wires in a.m. and possibly run sea foam threw brake booster vacuum. If there's something elese i should look at for those codes p0300 & p0302! I tried to clear codes and cel stayed on didn't go off and come back on it stayed illuminated??
View 1 RepliesChrysler :: 2005 Town And Country Dies When Idle Now Won't Fire At All
I have a 2005 town and country that was running fine and when my wife picked me up today and was waiting idle it died. She didn't try to start it right away and when I got out there tried to start it and it fired then died and now it won't fire at all. It turns over fine but just won't fire.
View 2 RepliesCaravan/Voyager :: 3.3L Van Won't Accelerate (Code P0132)
142k, having some problems lately, the van won't accelerate now and again, moreso when the engine isn't up to temp, but lately it's gotten more and more prevalent. I have done some recent and needed maintenance in hopes of fixing the issue, but to no avail so far. I've replaced the plugs and wires, air and fuel filters, and both upper and lower O2 sensors (first replaced the upper with a Bosch, almost immediately had problems with P0134 code, so instead went with a Denso, hasn't come back yet). I checked fuel pressure, 60 psi sitting in the shop, the cat doesn't seem to be clogged, and it idles fine all day long.
Problem resembles running out of fuel, or more maybe like I'm letting off the gas, but my cheap scanner says the TPS is working fine, and I was watching the TPS percentage as I was driving it was reading normally. As I'm accelerating slowly from a stop, it'll start to cut out around 30 mph, but speed doesn't seem to matter, if I accelerate sharply it just bogs and slows down, if it does shift up a gear, the rpms will jump to about 5k, then slowly decrease even if I've got my foot on the floor. I keep coming back to the fuel pump, but I don't have a long enough hose to have it connected while test driving. Considering removing the hood so I can prop the gauge up so I can see it while driving. I am getting a P0132 code now, but I'm more concerned with the accelerating issue.
Caravan/Voyager :: 2014 - Oil Light Comes On At Low RPM Goes Out When Accelerate
Changed oil on the 2014 grand caravan, replaced the filter. afterwards the oil light comes on at low rpm goes out when u accelerate, and the engine light is on. Took it to autozone, it is saying, that the oil sensor switch is stuck.
View 5 RepliesCaravan/Voyager :: 97 Dodge Engine Fuse Blown When Start To Accelerate
I have a 97 dodge caravan engine 3.0. When I start to accelerate my engine fuse 20amp blows. I does not occur every time but yesterday, it did it 6 times and is now getting looked at. I am just curious on what causes this. I did recently have my spark plugs changed so I am thinking something may be arching.
I do have codes that previously came up for my fuel injectors (P0203, p0206). Another code I have is p1294 idle speed performance.
Caravan/Voyager :: 2006 / 3.8 Just Stalled At A Set Of Lights
I have a 2006 Grand Caravan 3.8 that just stalled at a set of lights yesterday and have had it towed back to the shop here. I turns over and starts briefly then will die and then just turn over strongly. I cleaned the throttle body and IAC but this did not work. I connected fuel pressure tester and have no pressure when turn key on or turn it over.
The fuse and relay check out ok, so I'm thinking bad or clogged fuel pump.
I have a 2004 Caravan out back that I have used for other small parts to interchange before and was wondering whether or not the fuel pumps between these two are compatible. Be a lot of work to pull the one off the one in the yard, only to find out its not going to fit.
Caravan/Voyager :: 2006 Grand / Only Runs With Foot On Gas Pedal?
Have a 06 Grand Caravan 3.8L that suddenly quit and would start back up easily enough, but one had to keep foot on the gas to keep it going.
I pulled two codes:
P0123-throttle postion sensor 1 high
P0508-IAC valve sensor circuit low/undercurrent
So far I have removed the IAC and cleaned it with throttle body cleaner, cleaned throttle body out as well with the spray, installed new EGR since it got mangled trying to remove it for cleaning. Removed the TPS connector and with key on, took measurements and I am getting a reference voltage proper ( almost 5 volts). I then back probed the connector once it was plugged back in and again things checked out, the reference lead was varying between .7 and 4.7 volts as I manually moved the throttle plate.
I had switched out the IAC with a used one, from an engine that had been running before being parked, but it made no change.
Note: I have a new TPS but am holding off on changing it until I investigate whether or not it may have a clogged fuel filter causing it to stall at idle speed. Now if can just locate where it is..the sketchy diagrams in my Alldata program are useful.
Caravan/Voyager :: 2006 Dodge Heater Only Work For 2 - 3 Minutes
I have a 2006 Dodge Caravan, My AC unit works great. With the heater, it will work for 2-3 minutes, at which point it starts to blow cool air. I can leave it running, but it never gets warm again, if I turn the fan off for 3-5 minutes, when I turn it back on, I get a good amount of heat that goes for about 2-3 minutes before blowing cold air again.
View 1 RepliesCaravan/Voyager :: 2006 Dodge - Windshield Wiper Not Turning Off
I'm having electrical issues in my 2006 Dodge Caravan. It started with the radio not working (even though the lights around the nobs and buttons light up) and the lock button doesn't work until the van is started. Now, the windshield wiper won't turn off, even after the van has been turned off.
View 1 RepliesCaravan/Voyager :: 2006 - Engine Light Is On After Water Pump Replacement
I had to replace the water pump on my dodge Grand Caravan, which was challenging, but I got it done. But now the engine light is on.... why would that happen? I did take off the filter hose, and unplugged the cord to move the air filter housing, but I plugged it back in when i re-hooked everything up. So now I am nervous that i did something wrong. Why the engine light would come on and stay on? water pump works, put coolant in etc.... no leaks.... so now i just need to figure out the engine light.
View 9 RepliesCaravan/Voyager :: 2006 Dodge Doesn't Run When Drive Through Large Puddles
When I drive through large puddles, or in the rain, my car doesn't turn. I believe this may be because my Splash Guard is missing.
I keep looking online to get a replacement, and they have one that looks exact, and another I have no clue if this would be the same or if it is a different piece all together.
The picture attached at 1.jpg is the one that looks exactly as the one that is gone from my car.
The second, is the one that I keep finding when I type in replacement splash guard.
Can this one be a proper substitute?
Caravan/Voyager :: 2006 Dodge SXT Hard To Shift From Park When Hot / Wait For It To Cool Down
I have a 2006 Dodge Grand Caravan SXT with the 3.8 and 135,000 miles. Whenever it is hot out and the engine has been running it is hard to shift either from park or back into park. Today it completely froze on me and I had to wait for it to cool down before it would shift into park. Temp out is about 80 today.
View 2 RepliesCaravan/Voyager :: 2012 - Programming New Key
We just purchased a 2012 Grand Caravan and was wondering where to get a key and program it. I know the key will be an arm and a leg if i get it from the dealer. Is there a tutorial that tells how to program it as well?
View 3 RepliesCaravan/Voyager :: Heat Comes And Goes Every Minute Or So
2006 Caravan. Heat comes and goes every minute or so. Also noticed the temp gauge goes from normal operating range to cold and back again frequently. Hasn't overheated. Does that sound like a thermostat problem?
View 2 RepliesCaravan/Voyager :: ABS Light Keep Coming On
On my 2005 3.3L Grand Caravan the ABS light keeping coming on. I inspected the sensors for the front and used my compressor to give them a quick puff of air to get rid of dust. The light went off for about 5 days. Now it is back on.
How does one read ABS codes? If I knew for sure that the problem is a speed sensor and which one I could clean or replace the faulty sensor.
If I clean to sensor are there any special precautions I need to take? As far as I could see they didn't look very dirty.
Caravan/Voyager :: 05 - Clunk In Front End When Hit Bumps
What am i missing i have a terrible clunk in the front end when i hit bumps. I thought it was the struts and mounting plates so they are new . no change Stabilizer links were tight but i replaced them as well. Everything else seems tight but the noise has not changed with any of the above mentioned repairs.
View 13 RepliesCaravan/Voyager :: 1996 / 3.0L - Scanner Does Not Link With ECU
I'm having trouble with my 96' 3.0L, its kind of crazy its intermittent and while driving the engines surges one or twice and then dies... when I try to crank it up again cranks but don't starts if I try again it wont even crank ( no starter winding up ) what I noticed is that is I'm driving when it dies my check engine light disappears for a while and if I connect my OBD 2 reader does not link up with the ECU if I wait a while and I crank it up again its starts and the while cranking up I can hear a bang noise from the engine compartment drives side and then after a couple of minutes dies again...
View 4 Replies