Caravan/Voyager :: 2006 Town & Country Missing While Trying To Accelerate
The other evening my 2006 Town & County 3.3L would not accelerate well and I though I detected a miss while trying to accelerate. Also, when I got it up to around 55mph and would try to accelerate to pass, the engine would kick clear up to over 4000rpm and barley accelerate. I checked the plugs, the were fine, changed the plug wires didn't make any difference. The van had about a half a tank of gas in it, so I went ahead and filled it up, and that didn't change anything. I let the van sit overnight and the next afternoon took it out on the road and it seems to accelerate fine now.
The only thing I'm still noticing at this point is that with the transmission in park, when I try to rev the engine up to around 3000 rpm, it starts cutting off/missing very badly at around 2800 rpm.
My 99 grand voyager with 3.3L does not do, so I'm wondering if still have some kind of issue on my 06 or is there something on the newer vans that limits the rpm in park, it doesn't seem to be cutting out or missing at that rpm range now while driving.
Caravan/Voyager :: Town And Country Starts And Dies When Moving
2002 T&C, starts and idles fine. When we put in gear (drive or reverse) it dies. Then we can restart and it drives fine the rest of the day. This only happens when it has been sitting a long time, such as over night. However, I've let it sit until mid-day and it does it so it doesn't appear to be Temp or humidity related as it issue is repeatable at any time of the day as long as the vehicle has been sitting 12 hours or so.
The remainder of the day it drives without issue and we can restart 8-10 times during the day without issue, then the next day when we restart it, no matter how long it idles it cuts out when you first start to move and apply the gas. When you restart, it, it often doesn't happen again and I've never had to restart more than twice. Again, it runs fine other than this issue.
I've replaced the fuel filter and I put a pressure gauge on the fuel rail. The pressure is within specs. I also watched the gauge as my wife backed the vehicle up and it died, but the fuel pressure didn't drop out. It is now showing a O2 Sensor code per Advance, but in reading other post, those can be misleading, so I wanted input before I just start throwing money at the problem
Lexus GX 2004-09 :: Fault Codes P0037 And P0057 - Oxygen Sensor Heater Control Circuit Low
What can be done regarding these faults? P0037 and P0057
Description:
Oxygen Sensor Heater Control Circuit Low (Bank 1, Sensor 2)
Oxygen Sensor Heater Control Circuit Low (Bank 2, Sensor 2)
The catalytic converters have been removed but the fault was present before that anyway. All I want is the VSC function to work again and the lights to go off. I have heard you can put dummy sensors in.
Chrysler :: 2005 Town And Country Dies When Idle Now Won't Fire At All
I have a 2005 town and country that was running fine and when my wife picked me up today and was waiting idle it died. She didn't try to start it right away and when I got out there tried to start it and it fired then died and now it won't fire at all. It turns over fine but just won't fire.
View 2 RepliesCaravan/Voyager :: 2005 Heater Blower Doesn't Seem To Be Working
I have a 2005 Dodge Caravan with a heater blower that doesn't seem to be working. Whether the heater knob is on low or high, it does nothing, but you can feel a little heat coming out, though. I was told it may be a resistor behind the glove box. I've already checked the fuse, and it seems OK. What do I do?
View 6 RepliesLexus SC430 :: Oxygen Heater Circuit Malfunction - Code P0155
SC430 came up with the check engine light, showing a "Oxygen Heater Circuit Malfunction", code P0155 (bank 2, sensor 1). Searching, I found out this is the oxygen sensor in the passenger side exhaust manifold.
My car is high mileage (over 130K), it's hard to justify purchasing a $230 sensor and paying for installation. My only goal is to keep the check engine light from turning on and passing state inspection/emission (the check engine light will prevent passing inspection/emission in my state).
Lexus SC430 :: New Oxygen Sensor Reading Zero Voltage - Code P0430
Replaced my post cat drivers side O2 sensor tonight because I was getting zero voltage and a p0430 code. This is bank 2 sensor 1.
But I'm still reading zero voltage!! How could I still be getting zero voltage?? I checked the connections and they are firm. Checked every single fuse in car.
After my recent accident, the center console lights don't illuminate. My nav door doesn't close too. Could these all be related?? The connector for the O2 sensor is right next to the console, so maybe there is a loose connection or plug or perhaps a stray ground?? I do have wires all over the place in under the shifter bezel from aftermarket stuff..
Caravan/Voyager :: 1999 - Whirring Sound / Low Voltage When Idling
I have a 99 voyager that has started making a whirring sound this last week. The water pump, serpentine belt, tensioner have all been replace several months ago. The battery light came on for about a minute and then went off the last night. I checked the voltage with the engine running and it measured 12.5, the same as when it is off. When I revved it up the voltage went up to 14.4 volts. Is this normal? What could be making the whirring sound?
View 2 RepliesCaravan/Voyager :: P0700 And P0740 - Trans Control System / TCC Circuit Malfunction
The first is a trans control system malfunction and the 2nd code(0740) is tcc circuit malfunction- but what exactly do these codes mean? and the o2 sensor needs to be replaced, it said bank 1 sensor 1- does that mean the one BEFORE the catalytic converter?
View 4 RepliesCaravan/Voyager :: 2001 - Short In Hazard Circuit / Instrument Cluster Is Dead
My problem is similar to that of coyote54 back in 05. I have a 2001 Grand Caravan Sport. Instrument Cluster is dead, Information lights on top of dash are dead, Turn signals and Hazard lamps are not working. Found Hazard Lamp fuse to be blown. Replaced fuse and blows immediately indicating a short. Haynes describes a Turn Signal/Hazard Lamp and Daytime Running Light Module located on the junction block but there is no such animal that I can find. One of the responses to coyote54 described a Hazard relay located within the steering column........again, I do not see anything on the column that resembles a relay. Is there a hazard flasher/relay on the 2001 GC.
View 14 RepliesDodge - Caravan :: Check Engine Soon Light Appeared - Oxygen Sensor
The "check engine soon" light appeared yesterday on this nice running 1997 van with 167K. An auto parts store code check indicated a problem with the oxygen sensor. Is this something I can replace myself--a lightweight shade tree mechanic? I never seem to have any luck asking questions on the Mopar website.
View 10 RepliesCamry :: CEL On With P0606 - PCM Processor Fault / P0157 - O2 Sensor Circuit Low Voltage
2 weeks ago a check engine light came on with P0351-Ignition Coil "A" Primary/Secondary Circuit Malfunction, took the car to Toyota dealer and replaced ignition coil for cylinder No1. I drove the car for about 10K and check engine light came on again with P0606-PCM Processor Fault.
For the past week I was monitoring the DTC's using INNOVA- CanOBD2 Code Reader 3030 (ordered ODB2 USB tool to check live data on a laptop, on it's way...). I had P0606 on all the time, about everyday. For 3 times I had P0157-O2 Sensor Circuit Low Voltage (Bank #2 Sensor #2) on.
What's the link between the two DTC's? Why not P0157 alone? Or P0606 alone? What is the procedure to diagnose this?
Ford Ranger / B-Series :: 1999 - P0135 O2 Sensor Heater Circuit (Bank 1 Sensor 1)
1999 Ranger 4x4 4.0 - P0135 O2 Sensor Heater Circuit (Bank 1 Sensor 1)
I have replaced the 02 Sensor, Passenger Side (Pre-Cat), with a Motorcraft DY831...
I reset the Check Engine fault codes, and took it out for a 50 mile journey... Check Engine light is back on, with the same exact code... What next?
I understand that it may be a fuse, and/or it may be a short in the wiring... Exactly how to test the wiring from the connector at the 02 Sensor all the way back to wherever I need to test?
I really need detailed directions, like wire colors, voltage required, or ohms, or whatever is included in this process...
Caravan/Voyager :: 1998 - Heater Fan In Van Only Work On Full Blast
The heater fan in the van will only work on full blast and the rear wiper/ ac button lights flash which I had another 98 caravan that I was driving that had the same issue with the flashing lights. What is that all about?
View 2 RepliesCaravan/Voyager :: 2006 Dodge Heater Only Work For 2 - 3 Minutes
I have a 2006 Dodge Caravan, My AC unit works great. With the heater, it will work for 2-3 minutes, at which point it starts to blow cool air. I can leave it running, but it never gets warm again, if I turn the fan off for 3-5 minutes, when I turn it back on, I get a good amount of heat that goes for about 2-3 minutes before blowing cold air again.
View 1 RepliesCaravan/Voyager :: 2002 - Crankshaft Position Sensor Replacement
I need to replace the crankshaft position sensor. On my 2002 Grand Caravan Sport 3.3liter. Where it is in laymans terms.
Is it better to approach from the underside Or from the hood side? I will know it when I see it but I haven't seen it yet!!
Ford Super Duty (1999-2016) :: 2000 - Oxygen And Heater For Oxygen Monitors Will Not Show Ready
I have a 2000 motorhome on a f450 chasis. It has a V-10 with only two oxygen sensors up-stream from the catalytic converter. The monitors for the oxygen and oxygen heater sensors will not show "ready". I replaced both sensors and have driven it over 200 miles. They still show "not ready".
View 5 RepliesPassat (B5) :: 2002 - CEL Code For Bank 1 Sensor 2 Heater Circuit Fault
Got the CEL Bank 1 Sensor 2 heater circuit fault. Is that the rear right post-cat oxygen sensor? What is correct part number or possibly a link? 2002 2.8l Passat V6...
View 3 RepliesCaravan/Voyager :: Idle (RPMs) Were Very High - Check Engine Light On
My check engine light came on today and while driving, the idle (RPM's) were very high. At about 80KMs, it was about 3500 and when I accelerated, the engine would race along with the RPMs. While stopped, idling seems fine. I couldn't get over 80KMs/Hr without the idle going too high.
What it could be? Haven't had time to check codes as it is long weekend and garages are now closed till tuesday.