Caravan/Voyager :: Codes P0700 And P0704 - Clutch Switch Malfunction
I have a 2005 Grand caravan with a 3.3L. Over the summer I was having issues with the transmission.Got the codes reaf, P0700 and P1726( I think). After this had an input speed sensor replaced and the TCM. The van worked for about 3 months, but now is acting up again. This time I got codes P0700 and P0704. Was told it was a clutch switch malfunction. Can't seem to find any details about this code.
View 1 RepliesCaravan/Voyager :: 1996 - Electrical Malfunction - Gauges Aren't Working
My 1996 Caravan gauges do not work at all. I have checked the fuse(s), and thay are all fine.The rest of the van works just fine. The fuel, temp,tach, and speed gauges do not work. The odo does not show up either. What to do?
View 14 RepliesCaravan/Voyager :: P0700 And P0740 - Trans Control System / TCC Circuit Malfunction
The first is a trans control system malfunction and the 2nd code(0740) is tcc circuit malfunction- but what exactly do these codes mean? and the o2 sensor needs to be replaced, it said bank 1 sensor 1- does that mean the one BEFORE the catalytic converter?
View 4 RepliesCaravan/Voyager :: 1996 - Brake Pedal Keeps Going Down To Floor
I have a 96 voyager, it has been a great car for the last 10 years I've had it. My brake pedal goes down to the floor, it gives brake but I think barely and my brake light comes on. I have Bled it twice and changed the master cylinder , neither worked, I'm perplexed, my mechanic thinks it is the abs.
View 3 RepliesCaravan/Voyager :: 2006 Grand / Only Runs With Foot On Gas Pedal?
Have a 06 Grand Caravan 3.8L that suddenly quit and would start back up easily enough, but one had to keep foot on the gas to keep it going.
I pulled two codes:
P0123-throttle postion sensor 1 high
P0508-IAC valve sensor circuit low/undercurrent
So far I have removed the IAC and cleaned it with throttle body cleaner, cleaned throttle body out as well with the spray, installed new EGR since it got mangled trying to remove it for cleaning. Removed the TPS connector and with key on, took measurements and I am getting a reference voltage proper ( almost 5 volts). I then back probed the connector once it was plugged back in and again things checked out, the reference lead was varying between .7 and 4.7 volts as I manually moved the throttle plate.
I had switched out the IAC with a used one, from an engine that had been running before being parked, but it made no change.
Note: I have a new TPS but am holding off on changing it until I investigate whether or not it may have a clogged fuel filter causing it to stall at idle speed. Now if can just locate where it is..the sketchy diagrams in my Alldata program are useful.
Caravan/Voyager :: Additional Pressure Required On Pedal To Brake Normally
My old 1997 Dodge Caravan (150k miles) has weak brakes. During normal driving, it needs more pressure on the pedal to brake normally, than any other car that I have driven. This would be ok as I can push hard on the pedal... But the problem is that, past some point, I get no additional braking power no matter how hard I push.
So in case of an emergency, I cannot come anywhere close to lock the wheels (and this car does not have ABS). So basically, the braking power is proportional to how hard I push, up to a point where the braking power remains the same no matter how hard I push. At that point the pedal is maybe 1/3 down, still very far from the floor.
I have just replaced the front pads and rotor with no improvement. And when the engine is not running, the pedal gets really hard after I depress the brakes 3 times, indicating that the booster is doing something. The car will stay in the driveway for now as this is a dangerous situation.
Caravan/Voyager :: 2000 / 3.3L - Gauge Cluster Quit Working (Code P1698)
I'm having trouble with my 2000 Grand Caravan 3.3L. The gauge cluster was working intermittently & recently quit. I have the P1698 trouble code & looked up info online. I of course found out about the solder joint problem & figured that would be the culprit. I took the dash apart & found the solder joints were fine, but when coming apart, the wire plug on the back side came out on it's own. The retaining clip was broke & I thought maybe that was my problem. There's enough room to install a zip tie to hold the plug in & I put it back together. It still doesn't work though.
Here's the symptoms- I turn the key to ignition & nothing in the instrument cluster comes on. When I start the engine, everything lights & works as normal except for the trans indicator- the letters light, but no position shown (regardless of any gear selection). This continues for about 5-10 seconds & the trans position indicator lights up around EVERY letter. A few seconds later the entire dash goes down. I then shut off the engine by only turning the key back 1 notch. At this key position the odometer & trans indicator come on & the trans indicator will properly display every selected position correctly. It is consistently working this way every time now. The heat is also stuck on hot & the rear window wiper/ washer is not working.
I've also pulled the body module to check for connection problems & don't find anything with that. I've pulled the fuse under the hood too. So far no luck.
Caravan/Voyager :: 2008 GC - Pedal Goes To Floor After Changing Brakes And Rotors
I have a 2008 GC with the E-Brake calipers in the back. I changed the brakes and rotors all around and now the petal goes to the floor. I know it has something to do with the rear brakes, because I did the fronts first and after a few pumps I had good petal.
I've done these types of rear brakes before, you use a tool to turn the caliper in. Is there anything I missed? Did I turn it in too much? I don't think it is the master cylinder because it was fine before I started and fine after I did the fronts.
Also, the e-brake doesn't hold at all now, so that's another reason I think the problem is in the rear calipers. Maybe an Adjustment? There's nothing leaking, either.
Caravan/Voyager :: 2005 - Vibration On And Off Then Smooth
2005 town country, on interstate, cruise a 85, drives smooth, then vibrates pretty good, it will vibrate for a few seconds then smooth, then vibrate. the vibration is felt everywhere, steering wheel, seats, even the outside mirrors vibrate, at 60 we don't feel it much, at 45 nothing. we notice when coming to a slow stop or just scooting up in traffic that it seems to have a little wobble to it too.
All brakes and rotors and all motor and transmission mounts are new, struts, strut mounts, sway bar, sway bar end links and bushings are new, have had it checked and nobody can find anything wrong. no clunking noise moving the tires left to right and up and down. alignment is perfect. the tires are crappy but am thinking if it was a tire problem it would vibrate all the time and not on and off. its never been wrecked either. it is a 3.8, front and rear sway bars, long wheel base, nivomat rear.
Wheel bearings? I don't know but would think they'd make noise moving the tires back and forth and side to side. and hear no clunking over bumps at any speed.
Caravan/Voyager :: 2005 GC - Headlights Only Work Intermittently
2005 GC. My headlights work some of the time. All all other lights work fine. Turning the switch on and off repeatedly sometimes get the lights on but sometime I just have to wait/drive abit before they come on. They also do not shut off automatically after the alotted time.
View 8 RepliesCaravan/Voyager :: 2005 Dodge Smoke From Engine?
I have a 2005 dodge caravan and today after taking my kids kids to school, I noticed white smoke coming from the hood of the engine. I managed to get home and check it out. With further inspection, smelled like some type of fluid is burning off I can't tell if it's oil or anti freeze. There seems to be some type of condensation in the inside of my van on the passenger windshield. I looked to check to see any leaks inside on the floor mat and underneath the van itself and nothing. What seems to be the issue?
View 6 RepliesCaravan/Voyager :: 2005 - Thumping Noise At Very Low Speed
Dealer replaced rack,twice. Still thumping,they installed new struts and 4 sway bar links and bushings same thump still there. I unhooked swap bar links and tied them to brake line and backed it out is my shop and thump is still there and sounds like both sides. This van has 56,000 miles on it and the ball joints and control arms feel and look tight. Is there anything about how frame mounts that might cause this?
View 2 RepliesCaravan/Voyager :: 2005 Heater Blower Doesn't Seem To Be Working
I have a 2005 Dodge Caravan with a heater blower that doesn't seem to be working. Whether the heater knob is on low or high, it does nothing, but you can feel a little heat coming out, though. I was told it may be a resistor behind the glove box. I've already checked the fuse, and it seems OK. What do I do?
View 6 RepliesCaravan/Voyager :: 2005 Dodge Anti-theft Reset Won't Start?
Anti-theft alarm was triggered inadvertently and now won't allow vehicle to start. When ignition is turned there is just a click...does not turn over. Is there a reset???
View 7 RepliesCaravan/Voyager :: 2005 - Can Hear Solenoid Click But No Starter Engagement
A couple of years after buying this I had problems with door locks and power windows. (No locking or unlocking or up/down) after looking this up as recommended I removed and replaced all the relays in the power distribution panel. (No fix) I next removed the battery so I could turn this power distribution panel over, then unplugged all the plugs and reseated them. (Wiring plugs) this got everything working. About 1 year later the same issue, with the same fix. About one more year later I encountered a starting issue... you could hear the solenoid click, but no starter engagement.
I checked the starter and it was good. So on a hunch I flipped the fuse panel over, reseated the wire plugs and it started right up, but it was intermittent for a few weeks. After several unplug and reseat the wires it was good again. Six months later it would spin the starter fine, but wouldn't start up. I first checked for fuel and it was good. Next I checked for spark and there wasn't any. Just a hunch... I went after the power distribution again and ended up taking it completely apart, also computer on the end of it, cleaned up all the connections and it fired right up.
Caravan/Voyager :: 2005 Dodge Blowing Smoke When Cold Even In Warm Weather
Alright, dodge grand caravan 3.8. Year: 05' ... Just broke 100k miles on this thing, last time i changed the plugs i noticed plug 2 had oil all down in it. I completely forgot about the problem cause i got side tracked with bad sway bar bushings. Anyways, what is the cause of the oil leakage? It has gotten so bad that I am blowing smoke when its cold, even is warm weather. There is also caked on oil and dirt on a lot of the parts down the front left side of the motor. Blown head gasket? Bad valve cover gasket? I want the best way to approach this . The smoke is white, but not enough smoke to be a completely blown head gasket.
View 3 RepliesCaravan/Voyager :: 2005 Town Country - P0032 Oxygen Sensor Heater Circuit High Voltage
P0032 Oxygen Sensor Heater Circuit High Voltage (Bank 1, Sensor 1)
I have read that in 2005 chrysler changed the ohms levels for the oxygen sensors and may need to have bcm reflashed to get a new oxygen sensor to work wheither its dealer item or not, is this true if i were to buy a mopar oxygen sensor? aftermarket is out of the question being the ohm readings would require me to spend some time at the dealer. is this code a defective sensor? or could it be related to the thermostat being faulty? am not low on antifreeze and temp gauge reads normal.
Nissan - Pathfinder :: 2005 - Oil Pressure Gauge Drops To L When Slow Down Or Press On Brakes
I have a 2005 Nissan Pathfinder that has 79,896 miles on it. I have done a lot of warranty repair to the car (transmission, radiator, oil leaks and other fun stuff). My latest problem is when the car is running for more that 20 minutes and I slow down or press on the brakes my oil pressure gauge drops to L. I have taken it to two dealers one -- said that the 'pressure was in normal range" and could not do a thing and the other fixed a leak in the oil cooler and replaced the seals behind the manifold. This still has not fixed the problem. At this point they feel there is nothing else they can do but this is not normal.
View 7 RepliesDodge - Ram1500 :: 2005 - Squeaking Noise When Press Down On Gas Pedal And Accelerate
Truck is a 2005 Dodge Ram 1500 Quad Cab, 2 wheel drive, automatic transmission. When I press down on the gas pedal and accelerate, an audible squeaking noise is made in the rear of the truck. It sounds like it is coming from somewhere near the rear axle or wheels. The sound is a high pitched metallic squeak, as if metal parts are rubbing against each other. The noise only occurs when I am accelerating. While accelerating, if i momentarily take my foot off the gas pedal, the noise stops. Also, once a constant steady speed has been reached the noise stops. Also, the truck makes the same noise when accelerating in reverse.
View 5 Replies