Caravan/Voyager :: 1996 - Brake Pedal Keeps Going Down To Floor
I have a 96 voyager, it has been a great car for the last 10 years I've had it. My brake pedal goes down to the floor, it gives brake but I think barely and my brake light comes on. I have Bled it twice and changed the master cylinder , neither worked, I'm perplexed, my mechanic thinks it is the abs.
View 3 RepliesCaravan/Voyager :: 2006 Grand / Only Runs With Foot On Gas Pedal?
Have a 06 Grand Caravan 3.8L that suddenly quit and would start back up easily enough, but one had to keep foot on the gas to keep it going.
I pulled two codes:
P0123-throttle postion sensor 1 high
P0508-IAC valve sensor circuit low/undercurrent
So far I have removed the IAC and cleaned it with throttle body cleaner, cleaned throttle body out as well with the spray, installed new EGR since it got mangled trying to remove it for cleaning. Removed the TPS connector and with key on, took measurements and I am getting a reference voltage proper ( almost 5 volts). I then back probed the connector once it was plugged back in and again things checked out, the reference lead was varying between .7 and 4.7 volts as I manually moved the throttle plate.
I had switched out the IAC with a used one, from an engine that had been running before being parked, but it made no change.
Note: I have a new TPS but am holding off on changing it until I investigate whether or not it may have a clogged fuel filter causing it to stall at idle speed. Now if can just locate where it is..the sketchy diagrams in my Alldata program are useful.
Caravan/Voyager :: 1999 Cannot Get Started - No Pressure On Fuel Rail
A friend has a 1999 Caravan with the 3.0L engine. He couldn't get it to start and to make a long story short, I checked the fuel pump relay and fuse and they were good but there was no pressure on the fuel rail. Turning the key I couldn't here the fuel pump come on and determined the fuel pump was bad.
I changed the fuel pump and fuel filter put in 1/4 tank of gas and turned the key, and it turned over but wouldn't start. I can audibly hear the fuel pump come on for a second or so, and feel the vibration when I put my hand on it, but there is still no pressure at the fuel rail.
Caravan/Voyager :: 2008 GC - Pedal Goes To Floor After Changing Brakes And Rotors
I have a 2008 GC with the E-Brake calipers in the back. I changed the brakes and rotors all around and now the petal goes to the floor. I know it has something to do with the rear brakes, because I did the fronts first and after a few pumps I had good petal.
I've done these types of rear brakes before, you use a tool to turn the caliper in. Is there anything I missed? Did I turn it in too much? I don't think it is the master cylinder because it was fine before I started and fine after I did the fronts.
Also, the e-brake doesn't hold at all now, so that's another reason I think the problem is in the rear calipers. Maybe an Adjustment? There's nothing leaking, either.
Caravan/Voyager :: 2005 - Stalling When Press Down On Pedal - Gas Gauge Malfunction
First, about a month ago the gas gauge started to malfunction. The low fuel light will come on and the gauge will show low even though it has nearly half a tank left. When will fill it the gauge only goes to 7/8 full.
Second, today is started stalling when I press down on the pedal. If I wait a few minutes it will restart. Has stalled twice but then will run fine.
Caravan/Voyager :: Brake Shudder On A Downhill Slope
2008 Dodge Grand Caravan SXT 4.0L 47K miles. I am having a bad issue with the brakes.
I have had to replace the front brake pads and rotors 3 times and going on the 4th time IN LESS THAN 47K MILES. The brakes seem to work fine in city driving where the streets are flat. The problem is when driving on any kind of a downhill grade. If you try to brake on a downhill slope the brakes shudder so bad that you cannot only feel the steering wheel shake, you can SEE it shake.
The Dealerships say the problem is warped rotors and everything is fine after installing a new set or turning the old set. After the 2nd set of "OEM" rotors supplied by the dealerships (two different Dealerships to be exact), I got fed up and installed top of the line NAPA Ceramic pads and Rotors, which do the exact same thing after less than a year/7k miles. This van is not a commercial vehicle, and is not overloaded or used for towing.
Caravan/Voyager :: 2008 Brake Warning Light On Dash Is On
I'm working on a 2008 Grand Caravan SE 3.3L Brake warning light (!) on dash is on. Datastream on my OTC Genisys shows that the Brake fluid level switch is 'ON'.
The van does not have pad wear indicators; fluid is full; there are no leaks in the system; no brake pull, uneven braking or other performance issues.
Scantool says Park Brake is off and I disconnected it to be sure.
When checking connector at switch on the master, one wire has continuity to ground and the other has about 12.5V on the DMM but won't light my test light.
Caravan/Voyager :: 1999 - Rusted Brake Lines Near Gas Tank
Just have a quick question. I am replacing some rusted brake lines near the gas tank. I already have the rusted ones cut out. I want to know if this junction box is really needed. If not it would sure take out alot of bending the lines. It looks like the line only come down the frame and bolt into the block and then straight out to the rear wheels.
[IMG][/IMG]...
Caravan/Voyager :: Front Brake Caliper Frozen And Cannot Turn The Tire
My right front brake caliper is frozen and I cannot turn the tire. This happened about a month ago and I went to Autozone and they gave me a new caliper, rotor and brakes, under warranty, and now the caliper is frozen again and I cannot turn the tire when jacked up. It seems to release after a period of time. I am not sure if it has a proportioning valve for the front brakes, but the driver side wheel turns freely and is not stuck.
View 2 RepliesCaravan/Voyager :: 99 - Fluid Is Leaking Under Center Of Vehicle When Brake Pressed
Wife telling the brakes went out but fluid is leaking under center of vehicle when brake is pressed. Is this just a rear brake line issue?
View 2 RepliesCaravan/Voyager :: 1998 Dodge V6 - Driver Side Brake Light Not Working
98 dodge caravan 3.3L v6 ..... All lights work including driver's side tail lights. only problem is that when pressing brake pedal, the driver's side brake light does not light up. i changed the bulb and checked the brake light fuse under the hood, but it was fine (as i guessed since the passenger side and middle brake lights work). I took the assembly off and reseated the connector to the tail light assembly, but same issue.
View 2 RepliesSilverado :: 2000 - Brake Pedal Spongy And Has Very Little Pressure
I have a 2000 Silverado 1500 replaced calipers, master cylinder, and ABS Pump/Modulator. Bled all four calipers. Brake pedal spongy and has very little pressure and travels all the way to the floor. What am I missing here?
View 8 RepliesLexus LS 2007+ :: Less Brake Consistency - Can't Get Constant Pressure On The Pedal
Replaced my rotors and pads and I still do not like the braking feel as I apply constant pressure to the pedal. No matter what I do, I cannot apply even or consistent pressure to pedal and get the car to slow down smoothly or in a linear way. It feels like some power assist component applies varying force to the calipers no mater how slowly or quickly I try to slow the car down. It just isn't smooth like other cars I own. The brake pads grab fine, no warped rotor issues. Does your car brake smoothly from 40 MPH to 0? Is there some power assist unit that may be going out?
View 2 RepliesCaravan/Voyager :: 2012 - Programming New Key
We just purchased a 2012 Grand Caravan and was wondering where to get a key and program it. I know the key will be an arm and a leg if i get it from the dealer. Is there a tutorial that tells how to program it as well?
View 3 RepliesCaravan/Voyager :: Heat Comes And Goes Every Minute Or So
2006 Caravan. Heat comes and goes every minute or so. Also noticed the temp gauge goes from normal operating range to cold and back again frequently. Hasn't overheated. Does that sound like a thermostat problem?
View 2 RepliesCaravan/Voyager :: ABS Light Keep Coming On
On my 2005 3.3L Grand Caravan the ABS light keeping coming on. I inspected the sensors for the front and used my compressor to give them a quick puff of air to get rid of dust. The light went off for about 5 days. Now it is back on.
How does one read ABS codes? If I knew for sure that the problem is a speed sensor and which one I could clean or replace the faulty sensor.
If I clean to sensor are there any special precautions I need to take? As far as I could see they didn't look very dirty.
Sonata NF (2006-10) :: Brake Pedal Sinking If Pressure Applied After A Stop
I have only 42k km or 26 k miles. Brake stops but soft. The brake pedal sink if you apply pressure after a stop. Feels like someone open a valve. The pedal go to very low. I am find the stopping power is poor. Brake fluid is brownish. I hope it is not the master cylinder.
View 20 RepliesChevrolet - 2500 :: 2005 - Fading Brake Pedal With Constant Pressure
MY 2005 chevy silverado 2500 developed brake problems. The power steering pump, master cylinder, and Hydro static something or other has bee replaced.Now the pedal fades with constant pressure. The shop tells me this is ok but today at at a downward sloping boat ramp with the pedal at the floor, it was very scary.Before the parts were replaced this problem did not exist.
View 2 RepliesGolf IV / Jetta IV :: 2001 - Brake Pedal Goes Halfway Down Before Pressure Builds
My mom's Jetta has had a squishy brake pedal ever since we got it a couple years ago. I figured it went down so far because the brake pads were wearing thin.
After having just replaced the pads and rotors, I flushed the fluid with the Motive power bleeder. I cycled the ABS pump with VCDS, then hooked the power bleeder back up and opened all four corners again until fluid was flowing clean and bubble-free.
Everything went well with the change, but the brake pedal never got as firm as I expected it to. Before the change, the pedal felt like it would get dangerously close to the floor. The brakes always worked, but the pedal hit about 60-70 percent of its travel before the car started slowing down. After the change, it has improved slightly, but it feels like its going about half-way before the brakes start working.
The pedal doesn't drop when you hold pressure on it like I figured it would if the master cylinder was leaking. Is this normal for a mk4 or does it sound like there's something wrong?
Car is a late 2001 2.0 Jetta Automatic with the MK60 ABS pump.