Camry :: 2002 V6 - ( P1135 Code) Air / Fuel Sensor Heater Circuit Response Malfunction
Just got a P1135 Code on the 1MZ-FE 2002 Camry.
My code reader pulls it up as (no typo below) : AirCFuel Sensor Heater Circuit Response Malfunction.
So I know it's a bad Air/Fuel sensor. Which one though? I replaced the rear sensor by the firewall about 6 months ago which fixed the check engine code (I don't remember the code). Would it make sense that the front one failed now or the back one failed again? Most of my research points me to a bad rear sensor however a lot of people also report that a code reader would report the sensor as "Bank 1 Sensor 1".
The rear sensor was replaced with a Denso 234-9042 Sensor.
I would play the replace and test game... however inspection is due within the month and after resetting the code, it usually takes about 50 miles to return. Being in college, 50 miles takes about 2 weeks.
Camry :: 2002 - CEL Came On - Fixing Code P1135
My 2002 camry 4cyl auto, jap built, with near 190k miles, check engine light just came on, P1135, has not replace any sensor since I own at 125k, 7 years ago, did noticed last 3 to 6 months, mileage drop to 25 or 26mpg average, used to be around 30+mpg, I thought it was change season for gasoline mix.
View 3 RepliesCamry :: 2002 LE V6 With Codes P1135 And P1155 - Replaced Sensors Still Fails
I have a 2002 Toyota Camry LE V6 with codes p1135 and p1155. Both sensors that are supposedly faulty have been replaced.
The new sensors are denso 234-9043 and 234-9047. I am confident that the second one was the right one replaced as both the new and the old had a little green marker(the location is near the firewall.) not 100% sure about the other one.
The sensors were brand new so I don't know what the problem is.
GTI 337/20th Anniversary :: 04.5 GLI 02 Keeps Throwing Code For 02 Sensor
I have an 04 GLI and keeps throwing a code for the 02 sensor, and after putting the car on the lift, and disconnecting the 02 sensor harness, a fine oil leaks out at the end of the connector and smells and looks like power steering fluid.
View 9 RepliesGolf IV R32 :: Throwing Code P0160 / O2 Sensor Is Shot
Last weekend I installed a usp test pipe with a hfc welded in and now I am throwing the code p0160......
What this is and maybe some ways that I can fix it?? I have a hard time believing an o2 sensor is shot since the car only has ~27k miles....
Ford Super Duty (1999-2016) :: ABS Light Came On And Throwing A Rear Speed Sensor Code
I've got a 2006 F350 5.4L.
The ABS light came on and it was throwing a 'rear speed sensor' code. I searched around and it seemed to be a common issue that the sensor goes bad and needs to be replaced.
I bought a sensor and replaced it, but in doing so, I saw that while the sensor was indeed bad (cracked) the wire right at the connector was corroded.
I replaced the sensor but the ABS light is still on the dash. Is it possible that they code simply needs to be cleared? I was able to read it with my OBD2 dongle and Dash Command App, but maybe I'm not able to clear it?
Or is it more likely that the corroded wire on the connector is the issue? (it wasn't fully corroded and I cleaned it up and sealed it.). It didn't look like I could pull the wires out of the connector, so I assume I'll need a new connector. What is the part number?
Camry :: Toyota 2002 LE 2.4L - Code P1379 Camshaft Position Sensor
The computer is returning P1379 camshaft position sensor. Where is this sensor located on a 2002 Toyota Camry 2.4L and how easy would you rate the job of replacing it?
View 3 RepliesCamry :: CEL Came On And Throwing Code P0430
My CEL came on and is throwing code P0430. Is it just an o2 sensor? if so which one primary or secondary?
View 2 RepliesSanta FE SM (2001-06) :: 2002 V6 Is Throwing A CEL That Reads Code P0018
My 2002 v6 is throwing a cel that reads p0018. What the code description is? the general ob2 scanner mentions a coolant sensor issue but I did some research and i saw where it is a timing sensor for the newer hyundais.
View 4 RepliesToyota - Solara :: 1999 - Getting CEL And Error Code P0125 / P1133 / P1135?
The check engine light for my V6 Toyota Solara is on for the codes P0125, P1133, and P1135. I changed the Bank 1 oxygen senor in addition to the temperature coolant sensor. During the drive back home from the mechanic the check engine light came back on, so I went back to the mechanic and was told that maybe the sensor was defective. The Denso sensor was exchanged, but again, the check engine light came back on. Have I been buying faulty parts or is there a different problem? The first time the oxygen sensor was changed smoke started coming out from the exhaust and from under the hood.
View 6 RepliesAccent LC (2000-05) :: 2002 - Code P0106 / Map Sensor Code
Ok had a check engine light. It directed me to replace the IAT sensor.. After some research I found it was integrated into the MAP sensor. Purchased a new sensor and replaced. Drive about 15 miles CEL throws another code. P0106 (sensor i just replaced) faulty Map sensor.
Followed procedure to replace sensor.. unhook battery cable reset ecm. After reset engine is hard to start. Followed by RPM changes (assuming its the ECM re-adjusting). Then CEL flashes 5-6 times and goes out, Drive 15 miles. Map sensor code reappears. (note i only purchased one sensor But repeated install 2 times).
My thought is against wiring. since the codes refer to different signal wires one for IAT one for MAP sensor. Faulty replacement sensor?
2002 Accent 1.6L
Golf IV / Jetta IV :: 2001 - Throwing Codes For Misfire / O2 Sensor?
So my girlfriends's 2001 2.0 Golf (engine code AVH, 153k miles) began throwing codes for misfire on cylinder 4 and for the o2 sensor (post-cat) recently. I went ahead and replaced the spark plugs, wireset, and the coil pack. They were way overdue. The CEL went away for like 30 miles, and then came back. Now it's reading misfire on cylinder 3 and the same thing for the o2 sensor. What else it could be? Search is coming up blank, most people replaced the coil pack and the CEL went away.
View 2 RepliesPassat (B5) :: 2002 - Cat Warm Up Threshold Low Code / O2 Sensor
I have a 2002 GLX Wagon 2.8 30v, and was getting Cat warm up threshold low code, on the driver side due to the cat being bad. As a temp fix I decided to use spark plug haulers to gap the sensor. When I removed the O2 sensor I wiped the dirt off with a paper towel, which was clean and dry. I put the sensor back on, but now I am getting 4 codes which won't go away. p0036 p0056 p0141 p0161. These are O2 heater circuit codes both bank 1 and 2. I did not touch bank 2 so I don't know how I could have caused this error. I tried to take off bank 2 sensor but it is really stuck on there.
View 3 RepliesGolf IV / Jetta IV :: 2002 GLX V6 Misfiring When Cold - CEL With Cam Sensor Code
I just got this car it a 2002 jetta glx vr6 12v 5 spleed. It has a miss new plugs wires gas and used coil pack. It misses especially when cold check engine light on says cam sensor changed it and still same thing if I clear the code it comes right back.
View 1 RepliesElantra XD (2001-06) :: 2002 - Cam Sensor Fault Code P0340
I recently took my car to the Hyundai dealer who told me that my engine light was from a bad cam sensor (Fault Code = P0340). I bought the sensor from the Hyundai parts dealer and replaced it myself. After having the code erased, the check engine light comes back on (with the same code) when I turn the car off and turn it back on, after driving it for a while (30 minutes or more).
View 5 RepliesPassat (B5) :: 2002 / 1.8T - Knock Sensor Code 16711 (P0327)
So a letter history about the car and this car is a friends car. They owned the car and drove without changing the timing belt when the car hit 109k. So the timing belt snapped and they went out and bought a timing belt and also the timing belt kit with the pulleys and all. They installed it.. didnt turn over or what so ever.
They towed the car to us which we own an auto repair shop. We knew the valves was bent and so we tore off the heads send them off to have them put new valves and etc etc.. We put the car back together for them and now the car runs fine. They pick it up and about a few days later they brought it back due to a check engine. It threw the code:
16711 - Knock sensor 1-G61 Signal too low. (p0327)
now we replaced both knock sensors and when they came and got the car... the check engine light came back one showing the same code. We cleared it out and the next day it came back on showing the same code Again! So now we don't have a clue why that code keeps coming up because we replaced both sensors with a new one. Any clue why the code keeps popping back up?
Ford - Explorer :: 2002 XLT - O2 Sensor Replacement - Code PO136
My 02 Explorer (XLT, 4.0) decided to throw a new code today. PO136, O2 Sensor Circuit (Bank 1 Sensor 2).
While it may be a wire issue, I still plan to replace the sensor. So the question is;
Can I get to it from under the vehicle or is there an access panel under the console like on the 2nd gens?
I have the sensor on order and plan to get it done on my days off next week.
Camry :: O2 Sensor And Error Code P0137
Had my Check Engine light come on so I went by a local AutoZone to see if they could read the code. He said it was P0137, but what his reader can't tell is which one it is.
A co-worker pointed out where it was on my 2006 2.4, but I'm not sure if it's the sensor in the engine bay or the one closest to the catalytic converter. The engine bay looks easy to change out but I'm in no condition to be crawling around underneath.
Which sensor the P0137 is referring to?
Passat (B5) :: 2002 - CEL Code For Bank 1 Sensor 2 Heater Circuit Fault
Got the CEL Bank 1 Sensor 2 heater circuit fault. Is that the rear right post-cat oxygen sensor? What is correct part number or possibly a link? 2002 2.8l Passat V6...
View 3 Replies