Prius (Gen 3) :: 2011 - Smart Key (FOB) Is Not Functional After Replacing Battery

2011 Toyota Prius Two, not II,smart key device (FOB) is not funational (can not open doors, etc) after replacing battery, and now how to fix, re-sync, etc?

View 17 Replies

Camry :: 2011 Camry: How To Check The Transmission Oil On 2011 LE (2ARFE)

how do I check the transmission oil on my 2011 Camry LE (2ARFE). I am curious as this car has 98K miles now and I cannot locate the dipstick for the Transmission oil. I got the car 2 years ago at 89K miles.

A technician once told me it's going to be a flush.

I only do 135 miles every week and I am located in Africa.

How do I check the transmission oil and how often should I change it?

View 1 Replies

Ford F-150 (2009-2014) :: 2011 - Replacing Spark Plug?

This is Just an FYI. I replaced the plugs in my 2011 F-150 3.5 Ecoboostwith 50,000 miles. I had a miss under heavy acceleration. Turns out the plugs had a gap over .090" and the side electrode was burned. Replaced them and all is well.

View 8 Replies

Subaru - Outback :: 2011 - Intermittent Rattle - Replacing Catalytic Converter

Heard a funny intermittent rattle and my mechanic told me that my check engine light should be going on any time now as my cat converter is bad. The part is about a thousand bucks! Looked on line and see some aftermarket ones from walker and some other retailers. My car has 103K miles on it,.

View 17 Replies

Ford Audio/Video System :: 2011 F250 - Replacing Radio With OEM Navigation

I have a 2011 F-250 Xlt that came with the standard radio/CD player and I wanted to replace it with a OEM Navigation Unit. I was going to have FORD install it once I can get my hands on one.

My question is:
1) Do I (just) need the head unit, or will I need wiring harness and other accessories? (the truck has sync, had xm radio)
2) Will the steering wheel buttons still function.
3) Is there anything I should know before attempting this
4) Will there be any repercussions.

View 3 Replies

Camry :: Replacing Instrument Light?

I wish to install LED for my instrument light but how? I remove every bolt I can and I can't see any light bulb area.

Another thing I seem to have lost one of my screws for my instrumental light holder. Where can I get another one? Do you see that gold thing on the right? That is the screw and I seem to have dropped it while trying to screw back the other one in my car and can't seem to find it so anywhere to buy the exact same one? It has a little washer that is already on it.

View 5 Replies

Camry :: Replacing Control Arms On 04 Solara?

I am going to start on the control arms on my 04 V6 Solara this afternoon since the bushings are beyond gone.I have done control arms on my 98 corolla but i didnt have to deal with the stupid motor mounts being in the way.I have done a search and it seems(if i have this right)that i need to

1.Remove Dog Bone

2.Loosen right and left side motor mounts but dont remove the bolts.

3.Jack up the engine just enough to get a wrench on the hidden bolts on each side.

Am i missing anything?I already have the Mevotech control arms with new ball joints already attached.I plan on renting a ball joint removal tool from autozone.

View 2 Replies

Camry :: 2009 - Replacing Rear Speakers

How do I replace the rear speakers in the 09 Camry? I put in door speakers no problem but can't find anything on for an 09 camry rear deck.

View 5 Replies

Camry :: 2014 - Replacing Of Rear Shoes - 4mm

I have no experience with drum brakes. I have no clue how long they are good for and what to look for in terms of wear. I assumed last week that with 226K miles on the car that the shoes must be reaching the end of their life. I went on Ebay and bought the spring kits and new shoes.

The last time I inspected the shoes was when the car had 100K miles on it. They didn't look too bad. When I started to replace the shoes after just buying all of the parts they looked almost the same as they did when the car had 100K on it. The rear facing shoes are about 5mm thick and the forward facing shoes at the thinnest part near the middle are 3mm thick. The specs in the maintenance manual give 5mm normal and 1 mm minimum.

Since I already have all of the parts and can't return them should I replace the shoes anyway? The manual says if the shoes show uneven wear to replace them. The rear facing shoes have even wear from top to bottom while the forward facing shoes are thicker on the ends and are thinner in the middle. The only issue that I have with the rear brakes is with the parking brake. I have the parking brake cable adjusted all the way and it will barely hold the car in place while in neutral. The shoes that I purchased are made by Wagner and being brand new are not even all the way across. They are also only 4mm thick.

View 3 Replies

Camry :: 2007 - Replacing Broken Air Intake Box?

On a 2007 Camry CE i4. My air intake box broke, either age or the mechanics that worked on my car broke it. And ones on ebay cost 100+ dollars. Either a customer cai will be cheaper, or the junk yard. I know a cai does nothing but changes the sound of your car.

View 2 Replies

Camry :: 2002 Starts Once Then Just Click After Replacing The Starter

I've replaced the started the starter several times now and the car will start once then just click. I found that if I disconnect and reconnect the battery cable it'll start one time and then just click. So something seems to be getting reset when the battery is disconnected.

View 4 Replies

Camry :: Replacing Seals And Water Pump On 2005 V6?

I am bringing in my V6 2005 Camry XLE in for a pulley recall and have reached 90,000 miles. The dealer told me I should also have the timing belt, water pump and engine seals replaced since they are all under the same engine side cover. I am considering the timing belt, but do I need to replace the oil seals and water pump?

View 4 Replies

Camry :: 2008 LE - Replacing Trunk Latch / Actuator

Recently, after using the key fob to gain entry, my 2008 Camry LE trunk latch refused to "catch" when closing the trunk lid. Can I replace the trunk latch (for non-keyless entry models) at $65 without having to fork out the $200 for the trunk latch/actuator combo piece for keyless entry models?

View 1 Replies

Toyota - Camry :: Replacing Lower Control Arms?

I have been told by a couple of mechanics that the bushings on the lower control arms on my 95 Camry are worn. They recommend replacement of the lower control arms and ball joints.Is this a repair I can do myself? I have reasonable mechanical competency. I figure that I will have to rent a tool at the auto parts store for the ball joint, remove a few nuts and bolts, and bring the car in for an alignment once I get the parts installed.Now my wife is adamantly against me doing this myself. She thinks that I am going to mess this up, the parts will fail at high speeds, and I will die in a fiery crash. She apparently has more confidence in the repair shop grease monkey than her engineer husband. So is she right? Is this a repair which is best left to the shop?

View 7 Replies

Camry :: 2006 Shaking After Replacing New Spark Plugs

I have a 2006 Toyota camry v6 1mz-fe engine. My buddy changed the all 6 spark plugs using Toyota oem denso.

The car drive weird after that. When I am on the stop light, the car is shaking ( coming from the engine area ).

When I am driving 60 mph, it shakes .

View 14 Replies

Toyota - Camry :: 1993 Won't Start After Replacing Starter

Last week the coil went out. The housing had several cracks, and the heavy oil had filled the distributor cap. So the coil, rotor, and distributor cap were replaced. About 4 days later, all my engine would do was make a grating sound when I turned the key. My boyfriend said that it sounded like my starter had gone. It wouldn't start with hitting it or anything. So, he and I, while trying to save some money because we're both on disability, replaced the starter. Now, when I turn the key, nothing happens! We're pretty sure the battery is dead. We have it on a trickle charge right now. But a funny thing happened, all of a sudden the open door alarm started going off! The door had been open for several minutes when it started. So we think that it may be a short. The starter relay, when you look at it, has a spot of corrosion on the indicator. Tomorrow we're going to try cleaning them.

1993 Toyota Camry DX with 170,000 miles ....

View 4 Replies

Camry :: 2005 XLE - Change Engine Oil After Replacing Water Pump?

2005 Camry XLE with 4 cylinder. Is it a good idea to change engine oil after replacing the water pump? Another words, is there a chance of getting antifreeze or debris in the engine oil when changing the pump or are the 2 separate in the 4 cyl. engine?

View 1 Replies

Camry :: 2007 LE - Replacing Indicator Light Bulb In AC Controls?

The little mark on the control knob to select air flow is unlit at night with the headlights on in my 2007 Camry LE. Apparently there is a bulb in there somewhere which needs to be replaced. How to change that bulb and get an indicator at night so that I can position the knob in the correct position?

View 1 Replies

Camry :: 2007 2.4L - Code P0138 And P0606 After Replacing Exhaust

A few days ago I managed to replace the front and intermediate exhaust pipes using new hardware and new gaskets. Prior to this (see my other thread about the rusted flex line), I did get P0137, but that was probably due to the fact the pipe broke before the O2 sensor, giving it a strange reading.

Two days ago after replacing the exhaust with Dealer parts, ensuring everything was tight, and putting the old O2 sensor back, I started the vehicle up, and upon idle, there were no lights whatsoever. Today several minutes after I started driving, I received the check engine light, and with the code reader, came up with the codes P0138 and P0606.

P0138 is O2 Circuit High Voltage (Bank 1, Sensor 2), which is the sensor I removed and put back.

I assume that this sensor needs to be replaced, and I assume that this has caused the P0606 ECM code as well.

Before ordering a new sensor, is there anything else I should check? I did make sure to plug the old sensor back in properly, and checked all the connections on the exhaust to ensure they were tight. All parts were Dealer parts, and nothing else was touched, changed, or modified.

The car sounds, and drives great since the exhaust change.

View 2 Replies