Camry :: 2007 2.4L Engine - Valve Lifters Order
I've got a 2007 2.4L Camry engine that I am rebuilding, and my son messed up the order that I took off that valve lifters. (the spacing thing that goes between the cam lob and the valve spring) I have my intake separate from my exhaust but I don't know where the individual one's go on the intake and on exhaust side. The book I have for the car does not tell me where they go.
View 3 RepliesSanta Fe (CM - 2007-12) :: 2008 - Random Cylinder Misfire / Vehicle Shuttered And Driving Power Lost
I have 62,500 on my 08 Santa Fe... never had any engine problems, but today, started the vehicle, drove 1/2 mile in town at 25 mph, turned a corner and the vehicle shuttered and lost driving power. At the same time, the check engine light came on and flashed continuously. I drove 1/2 block (around two corners in town) with the on/off studder and loss of power. I pumped the accelerator just to keep it from killing. As I stopped at the next corner and idled the vehicle regained power. I pulled over and called the dealership service department and they recommended I drive it home (blocks away) and turn the engine off, then try to restart it and if it started drive it 30 miles to dealership.
Did that, engine light came on steady and vehicle had full power. Long and short... the code was P0300 Random CYL Miss Fire Fault (random cylinder miss fire). After scanning the vehicle, test driving it and inspecting it as they do, they could not find a source of the problem or duplicate it. They cleared the code and promised that if it happened again they would credit me the $90 diagnostic fee I paid today for them to find nothing and apply it to a problem they couldn't find. They were willing to try and warranty it even though it is 2,500 over warranty if it had needed parts. Has this cylinder misfire happened to any of you? I've never had a problem like this really go away, so I'm expecting it will show up again. Also, they want to replace the timing belt (at 60K) as a preventative measure. What do you think? Can I wait till 80K?
GTI 337/20th Anniversary :: Engine Failure While Driving - Cylinder 1 Misfire
I am having this failure in my engine that is making me crazy while I am driving. Yesterday i took my car to a shop to see what was it. my MAF was gone ( I replaced it ) and the failure still going on. The mechanic connected his computer in my car and we went for a ride. HE told me cylinder 1 misfire.
This is what i did.
-change spark-plugs position (failure still)
-change coilpack (failure still)
What can i do ?
-clean injectors
-check for any carbon in valves
Tiguan :: 2.0 VW Engine - Breather Valve Stuck Causing Oil To Enter The Cylinder / Misfires
We have a 2009 2.0 Tiguan with approximately 60,000 miles. About 6 months ago, the check engine light came on so we took it in and found out the breather valve was stuck causing oil to enter the cylinder and causing misfires. Had this fixed an about a week later, the car acted up again. Took it in and removed & reinstalled the intake manifold. Both pricey fixes. The dealership said it was a problem with the 2.0 engine design. Now we have taken it in again to a local shop who is now informing us we will need to replace the intake manifold. He said the same thing about the engine design. Our concern is that this problem will need to be fixed on a fairly regular basis. We really love the vehicle but cannot afford the cost of this maintenance if it becomes routine and are considering trading it in for a Passat.
View 3 RepliesToyota - Camry :: 2007 - Untraceable Brake Failure
I drive a 2007 toyota camry. This winter the brake light has come on twice - each time after driving for at least 30 minutes on very slushy, cold conditions. The first time, the brakes were still working fine - I pulled into work, topped off the fluid and the light went off. Flash forward two months later. Same conditions, the light came on and as I was looking for parking, the brakes went out. Pedal was soft, emergency lights went on the car said to "CHECK VSC". I pulled into a parking lot and the brakes were once again working, but the lights were still on.
I had the car towed to a Firestone where they were unable to determine a problem. The next day, all the lights were out on the dash. I had the car towed to the Toyota dealership and not only can they not recreate the issue, but when they pull the numbers from the car, there is no indication that anything has ever been wrong with any system in the vehicle. They told me they've called Toyota Tech and there has never been a report of this issue. They want to release the car back to me, but I do not feel safe driving this car.
Camry :: 2007 V6 - Ignition Coil Failure / Multiple Misfires On All Cylinders?
I'm getting Codes: P0300-306 (Misfires) and P0356.
I have researched the definitions of these codes and see that P0356 indicates an ignition coil failure on coil "F" (which would be Cylinder 6?)... but how is it possible only one coil is failing but I'm getting multiple/random misfires on all cylinders?
I've looked at the wiring diagrams and the only place that I can see a "single point failure" that can cause such a thing, would be the ECM itself...
Camry :: 2002 V6 - PVC Valve Replacement On 1MZ Engine
I have the 2002 V6 camry and I want to replace the PVC valve. I read through the FYI/stickies, and I can see exactly how to do it on the 4 cylinder engine, are there any instructions for the 6 cylinder engine, I just want to make sure I do the right thing?
View 14 RepliesSanta Fe (CM - 2007-12) :: Engine Lost Power / Shut Down
I was headed down the highway in my 2007 Santa Fe last night. All of the sudden, I lost engine power. I pushed the gas peddle and nothing. We coasted down to a stop on the side of the road. I attempted to restart, all it did was turn over. I noticed the OIL light was on, so I got out and double checked my oil level. Right up to the full mark. Probably about a year ago, I had a check - engine light. I have a code that indicates that my gas level sender has failed, so my gas gauge does not work. I am sure you are saying.....he just ran out of gas. Well, not the case. I filled up the day before, and figured I had another 100 miles left on this tank.
Over 171000 miles on it and I have no intention of giving it up soon.
Camry :: 2007 XLE 4 Cylinder - P2195 Code (A/F Sensor B1 S1)
2007 camry xle 4 cylinder engine, 2.4 liter I'm getting a P2195 code, which is the A/F sensor B1 S1. I have a few questions:
1. Any diagram of the location?
2. I've been trying to figure out the correct part number, so I can search for a replacement. I've found 4 or 5 different numbers already. What is the correct part number?
3. Should I only by the OEM part? Or do the aftermarket brands like Denso work?
Camry :: 2002 - Car Lost Power And Engine Started To Knock When Going Up
I bought a 2002 camry xle a couple of days ago. The oil light was flickering so I had the oil change yesterday. I drove it around for a little while and everything was fine. The oil light only came on if I had to hit the brakes harder than normal.
So today I decided to take a drive outside of town and everything was fine until I was going up a hill. The car lost power and the engine started to knock. I was able to get it off the road and shut it down really fast. Decided to check the oil and it was hard to tell where it was at on the dip stick. With the dipstick pulled out I notice that there was steam/smoke coming from the dip stick tube.
After I let it cooled down and waiting for a tow truck to come to the rescue, I tried to start it. It ran for a few seconds and then died. During that time I had no power when pressing the gas and it sounded like it was knocking. It was hard to tell the type of noise it was making. Not one did the oil light, check engine light come on until it stop running.
Passat (B6) :: 07 - Pressure Regulating Valve Failure
Our 2007 Passat 2.0T had the 30K service and the fuel pressure sensor and pressure regulating valve (PCV valve) recalls done several months ago. Several weeks ago the check engine light came on so we took it in to the dealer yesterday. By the way, the car also felt subtly sluggish, had a slightly unstable idle and sometimes seemed to "stick" in gear on deceleration (ie, not shift down normally).
Here are all the DTC codes that were stored:
P0300, P0301, P0302, P0303, P0304, P0507, P2187, P2279, P3138, 02635
The service adviser said the problem was that the recall valves that VW sent them were no good (I think he said it was the -F valve) and that they now have an updated valve.
The new part number is 06F-129-101-K
By the way, our Passat is driven "conservatively," ie, no high boost levels or anything else that would stress the PCV valve.
Camry :: 2 Ignition Coil Failure - Engine Code P0302
Just a few weeks ago I replaced a bad ignition coil because I got the engine code P0302. I replaced the spark plugs with NGK Laser Iridium and the second Ignition coil. Now a few weeks later the Ignition coil 1 has died on me.
View 1 RepliesLexus ES 2007-12 :: ES350 / 60K Miles - Engine Head Failure
Have a lexus es350 (2007). While driving to work, engine light came on. after reaching work tighted the gas cap and while driving back , light was not on for sometime and then came on. Didnt drive to work car after that. Next day evening drove to dealership and they diagnosed as waterpump replacement requird. Overheating indicator never went high while we were driving. After water pump replacement, dealer said engine wont start and compression test failed. Need new heads and gasket at a cost of $7184 additional. Dealer and I spoke to customer service case manager and they refused with such a high expense. Tried to tell them that we have owned 4 Toyota/Lexus cars , have been loytal Toyota customers (last one bought in 2012) etc. , but, nothing seems to make a difference to them. The decision was already made before they talked to me. Car has only 60K miles. Last maintenance was done at 56K (oil change, fluid levels etc). I owned 3 Toyotas for 100K before I sold and 2 Hondas. None had such a high expense at 60K.
View 7 RepliesSanta Fe (CM - 2007-12) :: Engine Light Stuck On / Lost Drive And Reverse
I was driving my santa fe at 80 k's per hour when the revs started to climb towards 3500 thousand revs. I pulled of the road and stopped, I had noticed the engine light stuck on. then i lost drive and reverse, let it idle for 4 min and they come back. What's gone wrong with the car?
View 3 RepliesCamry :: 2007 / 4 Cylinder - Oil Sprayed On Passenger Side Towards Front Of Vehicle
Was cold this morning...started up my car, and noticed oil kind of sprayed on the snow on passenger side towards front of vehicle. Vehicle is a 2007 camry le with about 80k on it. Guess I will park it until I find out what it might be.
View 1 RepliesCamry :: 2006 Toyota Solara V6 - Check Engine Light Came On And Car Lost All Power
I have a 2006 Toyota Solara V-6. I was driving down the street with no indication of what was about to happen. All of the sudden my check engine light came on and the car lost all power. I had the car towed home and had a mechanic look at it he put his scanner on it and I'm not sure what codes if any came up but he decided it was the ECM so he found a used one with a warranty and ordered it, he put it in and it did the same thing it turns over but wont start. What could it be ?
View 13 RepliesCamry :: 2007 XLE 4 Cylinder - E Appeared In Multi-function Display And Will Not Shift Out Of Park
The wife was driving the 07 XLE 4 cylinder the other morning. Temperature was around 2 F. She started the car. It started right up. Drove for around 5 minutes and shut the car off and went in to a store for 5 minutes. When she came back out and restarted the car an "E" appeared in the XLE's multifunction display and the low tire pressure light was also on. The car would not shift out of Park. The wife called me. I told her to shut it off and try restarting it. Same thing.
I then told her to shut it off and take the key out of the ignition and then try reinserting it and restarting it. That worked; it eliminated both codes and the car was able to be shifted normally out of Park. Since I still have about 10 months coverage left on my Platinum Extended Warranty the wife and I took the car over to the dealer. When I had my wife explain what happened to the dealer's service writer he just said I have never even heard of the "E" symbol. The tech said he never heard of it either. They did check out the car's shift/interlock system including the brake light switch, but could find nothing wrong.
Golf IV / Jetta IV :: Lost Power - New Forge Diverter Valve Installed
So the other day I replaced my N75 valve and upgraded my DV to the Forge 007. For some reason the turbo doesn't spool like it did before, it's lost it's pep.
I've tried the Yellow and Green springs, also I tried them with the shim too. No luck. The car got turbo back exhaust, intake, and stage one program.
Santa Fe (CM - 2007-12) :: Valve Or Lifter Knock Continues Until Engine Gets Warm
I have a 2007 SantaFe Limited with 40k miles on it, first thing in the morning when I start it up there is what I can describe as an valve or lifter knock and it continues until the engine gets warm then all is fine. Oil and filters have been changed on a regular schedule,,,,,is this normal??
View 23 Replies