Passat (B6) :: 2007 - Multi-function Pixel In Display Shift Vertically And Warp?

Just picked up a CPO '07 Passat Wagon (Sport Pkg2, 30k on the odo) and recently found the multi-function display between the tach and speedo has a malfunction. It sort of behaves like a melting screen saver where all the pixels in the display shift vertically and warp, or it blanks out all together and throws up a vertical stripe about 5 pixels wide. All the steering wheel controls work fine and index through the functions as expected. It has done this pretty much every time I drive the car since I picked it up.

The car obviously has plenty of warranty left so I have a service appointment at the dealer next week, but just curious if this is a common issue- a forum and google search yielded nothing. I've had a couple A4's in the past that had trip computer displays that acted up in hot weather, but not like this. Also, my in-laws have a MkV GTI with the same/similar trip computer and it hasn't ever done this.

View 9 Replies

Prius (2004-09) :: Gauge Stayed At One Pip And Fuel Display On Multi-Function Display Won't Reset

Not the usual. I stopped on my way home to get gas tonight when the gauge was showing one pip. Naturally it wasn't low, but I'm used to that.

The odd thing is that after I got in the car and turned it back on the gauge stayed at one pip and the fuel display on the multi-function display didn't reset.

View 2 Replies

Prius (2004-09) :: Multi-Function Display Is Starting To Work Intermittently

I have a 2004 Prius with 108,000 miles on it. The MFD is starting to spaz out and work intermittently. It just started to stop working, would be listening to some music and all the sudden would die, no temp, no climate control, no avg mpg, no miles driven, no battery info, the base screen would be there without any data. So its sometimes there when I start the car and sometimes not, sometimes it dies and others it cames back. I called my local Toyota dealer they suggested I needed to replace the Multi-Function-Display with a refurb. I am wondering if there might even be a way to fix the glitch in my current unit...

View 9 Replies

Gen 2 Prius (Audio/Electronics) :: Multi-Function Display (MFD) Only Shows Toyota Logo

My MFD now only shows the Toyota Logo, whatever I do. Also, I cannot play music. The trick with pressing (hold) INFO and headlights three times does not bring up a diagnostic screen. My theory is that the MFD is waiting for some signal over the network before showing the usual screen (and it never gets that signal). Some years ago, I had a third party fit a new audio tuner and player (non-Toyota), and that worked more or less fine for years.

They had to leave the old faulty Toyota audio in the circuit to make it all work, and they said to leave the graphic equaliser on even settings, and then forget it. The old Toyota audio CD changer had failed, but the rest was OK. My 'guess' is that they had to leave the old audio device connected because it terminates the AVC-LAN with a 60 ohm resistor. Maybe that connection came off, and now the LAN signals are not good, and the MFD is locked up 'always waiting' for the signal from an ECU.

View 4 Replies

Camry 2012+ :: Multi Informational Display Screen Blank

Recently brought a 2015 camry SE and wouldn't you know it, someone pulls out in front of me on the highway within a week of buying it. After getting the car back from the auto body shop, I've noticed that my multi information display has a blank screen. Didn't notice that before the accident. The first 3 screens I can set up as I want, the 4th screen is tire pressure and the 5th screen is blank. I've tried to find out what the 5th screen should be but I haven't been able to find an answer.

View 2 Replies

Prius (Gen 2) :: 2007 Multi Information Display Stopped Working

In my 2007 Prius my multi information display didn't come on when I started it up.

View 4 Replies

Camry 2012+ :: 2015 SE - Entune Audio Plus / Multi Information Display?

I had the basic Entune radio but recently upgraded to the Entune Audio Plus with navigation after talking with a tech at the dealership. I unfortunately don't have the audio tab at all, how to add it to my display. No one at the dealership knows how and they referred me to Toyota Corporate about my situation. Any button sequence that can add or delete tabs on the display?

View 9 Replies

Camry 2012+ :: Icon Or Symbol On Left Side / Temperature On Multi Information Display

what does that icon or symbol on the left side the temperature on the the multi information display? I only noticed it yesterday when the temperature was around 2'C.I'm not sure if it is a malfunction since I can not see it on the manual.

View 4 Replies

Lexus RX 2004-09 :: Non Multi-information Display Panel To Touch Screen Display?

Recently, i just bought an multi-information display panel (with touch screen support) to integrate into my RX330 which is a non touch screen NAV display panel.

The 2nd hand multi-information display panel is from a 2004 RX330 and what are the socket behind the display panel meant for.

what is the 4 socket connectors as indicated in the red circle in the image should be connected to?

View 1 Replies

Lexus ES 2007-12 :: XM Installed - Radio ID Appeared On Display

I have a 2007 bottle fed EX 350. I am installing XM into it. SAT/AM button scrolls thru SAT 1 2 3. Display sometimes shows 184 or 255. Occasionally is says Radio Err, It has displayed "radio id" with nothing else, And I managed to get it to display a cryptic looking F W1 4 30 .

NO XM ID

Siriusxm cannot work with my vin.

Cannot tune to ch0 as there is no XM preview going on.

View 1 Replies

Camry 2012+ :: 2014 Touch Display - Distance Until Empty Function?

I've recently upgraded my wife's car to a 2014 Camry; Our problem comes with the touch display; since this was her car, she sat with the guy at the dealer while they showed her all of the cool touch functions, while I was outside and talking with my brother-in-law. She swears they showed her a function on the display that would show her the distance until the gas tank was empty, but she was unable to find it afterwards, when the low gas level light came on. I've read the manual, and poked and prodded the display trying to find it myself, but I've had no luck either.

How to find the "distance until empty" function on the display? Is there a tutorial available on how to use the display from Toyota? I'm sure there must be one, but I haven't been able to find it.

View 13 Replies

Aurora :: Parking Lights Go On And Off - Bad Multi Function Switch Or Module?

My parking lights go on and off when the car is off. I had problems with the headlights flashing about 3 years ago and fixed it with spaying contact cleaner and air in the multi function switch and that fixed that. I tried the same thing several times to try and fix the blinking tail lights but doesn't work. I just replaced the (LCM) lamp control module but still does it. Somebody told me today that it could be the security module. I'm thinking that the multi-function switch needs to be replaced. Is there a fuse or a way to shut down the (LCM) and just turn the lights on and off manually?

View 2 Replies

Prius (2001-03) :: Won't Start / Multi Function Goes Off / Ready Light Doesn't Come On?

Multi function goes off and ready light doesn't come on when turn key to start.

View 1 Replies

Ford Super Duty (1999-2016) :: 2000 - Multi-function Switch Won't Working?

I have a 2000 Excursion LTD with a V10, auto, 2wd. My problem is in the multifunction switch...I have no high beam flash function when the headlights are off, nor will the high beams illuminate when the lever is pushed forward. All other functions work as expected. I feel that the malfunction is minor and may be nothing more than a poor contact or bad fuse. I would rather not have to buy a new switch.

View 6 Replies

Ford F-150 (2009-2014) :: Wiper / Turn Signal Multi-function Switch Replacement

Looking for a tutorial on how to remove the multi-function switch? I have the, seemingly, common issue of wipers not turning off. I bought the new switch, but don't see how to get it out without taking the whole steering wheel off. I can't get to the screws on it at all. I got the plastic covers off, but can't see how to get the switch out.

View 3 Replies

Ford - Ranger :: 1999 - Gear Shift Display Reflects It Is In R When In Park?

My 1999 ford ranger pick up is an automatic. Recently the gear shift display reflects it is in R when in park, N when in drive and D when it is 2. Does it just need transmission fluid or is the transmission going?

View 6 Replies

Ford - Explorer :: 2010 - Park Aid On / Off Message In The Display When Shift Into Reverse

I bought a 2010 V8 Explorer on Monday and aside from the apparent "known issue" with the hard 2-1 shift (which I'm trying to get it to "unlearn" by driving differently), it's a really nice truck.

When I shift into reverse it says "Park Aid On/Off" in the display, and sure enough, it beeps when I get close to something. That said, there aren't the normal "dots" in the bumper that I normally associate with backup sensors.

Everything works just fine with it, I just am a guy who likes to know how things work and I don't see anything on the outside that would indicate it's a parking sensor.

View 7 Replies

Prius (Gen 3) :: Multi Information Display Blank / Not Working

My wife on her way home from work called me to say that the MID screen was blank - not working. I asked if she could drive the car, she could, but the energy monitor screen that she has on usually was not coming on. Her concern while driving was that she could not tell how fast she was going.

Fortunately, just a week ago I had installed Scangauge II in her car and had her convert one of existing gauge to MPH. This is a new 2012 Prius IV that is about 2 months old. I'm pretty sure that MID can't be turned off.

View 19 Replies

Prius (2010-12) :: Lights Goes On - Multi Informational Display Goes Off

When I have my daytime running lights on, all is fine. When I switch to anything else on the stalk, including my night time head lights, it goes off, along with some temperature control background illumination. Only the shift icon stays on the MID. When I switch back to daytime running lights, everything goes back on.

View 6 Replies