Ford Excursion :: A/C Shaft Seal Leaking?
Well, the ac in my truck has been less than exciting since I've owned it and its time to address it before another trip.
I crawled under last night to explore the Ac clutch air gap and found that the shaft seal is leaking and clutch is grooved pretty bad and covered in oil.
I'm thinking it's time for a compressor, clutch, orifice tube, expansion valve and reciever/dryer. Does that about sum it up? I haven't messed with AC systems much outside of my simple jeep system that was as easy as two seals and recharge in my garage to fix it.
Do I need to flush the lines out? Should I do that at all? Motor craft worth the cost over something like four seasons? Its almost twice the cost but in the end if something goes I'm further downstream after freon etc to charge it and the possible shop charge if I pay to have to done.
Ford Excursion :: Drips Coming From Rear Axle Input Shaft Seal
I have noticed a few drips coming from the rear axle input shaft where the drive shaft connects. It has only done it once and there is no residue on the trailer hitch so I know it didn't dump everything on the road. If change this seal, how difficult is it and do you have any information which might make it easier.
View 14 RepliesFord 6.0L Power Stroke Diesel :: Front Axle Shaft Seal Leaking?
I took the front axle shafts out a couple months back and remember NOT seeing any differential fluid in the axle shaft housing. But then when I took the tire off tonight.. I noticed diff fluid leaking from from the axle shaft dust seal ?
1. I didn't think diff fluid flowed up near those front dust seals ?
2. That's a brand new dust seal so I'm guessing some debri must be in the connection causing the leak ?
Ford Excursion :: 2001 - Replacing Outer Axle Stub?
I think I ran a wheel bearing dry on the front end of my 2001 Ford Excursion. Do I need to replace the outer axle stub when I replace the hub/bearing assembly? Where's the least expensive place to buy one?
I think this has the Dana 50.
Ford 6.0L Power Stroke Diesel :: 2003 F350 - Drive Shaft Noise / Rear Pinion Seal Is Leaking
I was getting ready to replace the carrier bearing and noticed the rear pinion seal is leaking. Before attempting the replacement myself, I would like some opinions on the noise in the video below. Is this normal? I am confidant I can replace the carrier bearing and pinion seal, but not sure I have the tools for anything else.
YouTube ...
Ford Excursion :: Front Axle Shaft U-Joints Won't Come Apart
its a 2000 limited 4x4, must have been in the snow a lot because it was from up north and is pretty rusty on the underside. my dad and i have tried everything to get these caps off but nothing will work. lots of pb blaster, hammering, even cutting the one of the four joints and trying to wedge something from the inside. If we cant get it could a shop do it? and how much might they charge?
View 9 RepliesFord Excursion :: 2000 V10 - Front Differential (Inner Seal) Leak
2000 Excursion, Limited, 4X4, 6.8L, V10. My right front inner differential seal is leaking. I have researched and found out that I have to remove the pumpkin gear assembly from the front differential to get at the seal.
Do I need any special tools to get the seals seated back into the differential? Any instructions or a list of parts needed?
I went to fordparts.com and entered my vin number but it makes no reference to the parts of the front differential only the rear.
Ford Excursion :: 2004 - Front Axle Inner Seal Replacement
I have an 04 Limited, 6.0 PSD, 4x4 which I need to replace the front inner axle seals, the right side is leaking out the shaft. I have watched a couple of YouTube videos on how it is done but would like to get some first hand knowledge and recommendations.
First, how important is it to check the backlash before beginning the removal of the gear assembly? Do I need to remove the pinion gear as well or just the gear assembly?
How difficult is it to get everything back on place once the seals are replaced? I have not done this type of repair before and am concerned I might miss something.
I am planning to replace all the ball joints at this time also, this was the primary reason for this maintenance in the first place.
Ford Excursion :: Transfer Case Input / Front Seal Replacement
Noticed some fluid on the bottom of the Ex a few months ago and have been watching it since. Drained and refilled with the XL-12 fluid at the time and based on what I can see the likely culprit is the input seal on the transfer case. I have searched high and low both here and via the almighty google with little info to be found. Is it simply remove transfer case, replace input seal, reseal case connection, and refill?
View 2 RepliesFord Transmission :: Small Leak Around Tail Shaft Seal
I got a fmx mated to 351w, trans was on back of a 302 and no problems other than small leak around tail shaft seal but shifted great. Now I decided to install mildly built 351w so figured it'd be a good time to build tranny. Installed after build and immediately it was slipping. Pulled trans out took it back to shop and he said the forward seal was blown. Installed again, after about 15 miles same result! What could be causing this. It is fine in reverse, but slips bad in forward gears.
View 2 RepliesFord Excursion :: Small Puddle Under Passenger Side Tire / Wheel Area - Front Seal Leaking
So this morning is just getting better and better. Was coming back in from getting the mail and noticed a small puddle under the passenger side tire/wheel area.
I never ever have a puddle of any sort in my drive way so...I start crawling around the truck and this is what I find. I can free spin the dust seal, but its all the fluid that has be worried. With less then 4 days till I have to haul everyone to the airport this is not what I need.
IF (man I feel stupid for asking) IF I leave it in 2 wheel drive how big of an issue would it be to drive it?
None of the parts will be in before I have to drive everyone out to the airport, this is the only reason I'm even considering this..
Plus would this explain a sudden lost of MPG?
Ford Ranger / B-Series :: 1999 - Output Shaft Seal Won't Stay?
I replaced the seal the other day on my ranger because I noticed my fluid disappearing. Went ahead and changed the filter and fluid as well. Flushed the system, and I go back to my truck tonight and there's a huge puddle of trans fluid. And the output shaft seal is once again, up against the drive shaft. I've spent like $150 on trans fluid since Friday, and $1000+ to get the truck running again last month, so pardon me if I get edgy about her.
99 2.5 auto. I changed the trans pan gasket too. No leaks from it.
Ford Ranger / B-Series :: 1989 - Tranny Input Shaft Seal Replacement?
I'm replacing my clutch components in my 89 Ranger with an M5OD transmission. While I'm doing it I'm going to replace the input shaft seal on the transmission. I'm looking for the torque specs for the housing that holds the seal.
Also, should there be any play on the input shaft? My transmission has never made any noise but I noticed some slight play in the shaft.
Ford Excursion :: O-Ring Seal Was Broken - Low Pitched Hum Noise From Power Steering
When I was going through the engine compartment of the recently acquired 7.3 yesterday, I noticed the power steering pump cap was not on properly and only had one of the two tabs locked. I pulled it off and discovered that the o ring seal was broken.....so I went to advance and found an o ring that fit properly and replaced it. Noticed that the PS fluid was very dark and discolored. When I would start it up whenever I turned the wheel it made a weird noise, not a whine but more of a low pitched sound. Then it went away. Figured I needed to address it asap.
I had the power steering system flushed today through the pump at a local fluid change company with Mercon V before any further damage could be done and they told me the extracted fluid had water in it because some of the fluid was a light pink. As well as very dirty. I bet that the loose cap let all sorts of dirt and water in. The rest of the fluids looked good.
I have no issues with steering or brakes, but there is now a slight hum at times now that I did not notice before. Mainly at low rpms. Brakes are actually better now than they were before. The more I drive it the less it seems to hum.
Eventually am going to flush near the booster and put in a magna filter and synthetic but I couldn't leave it the way it was.Should I be concerned with the low, intermittent "hum" at times or is that just air that needs to be worked out of the system over the next few days?
Ford 7.3L Power Stroke (1999-2003) :: Transmission Output Shaft Seal Removal
I'm trying to replace my transmission output shaft seal on my 2wd and I can't seem to get the seal removed. I couldn't find anything to rent from O'rielly's or Advance Autoparts that would work. It's in there really tight ....
View 10 RepliesCamry :: 2003 - Fog Lights Not Connected / Wires Dangling In Front Bumper
I see some wires dangling in the front bumper which looks like fog lights plugs but I don't get it so is it just plug and play buy a new bumper with fog lights or something? My car doesn't have fog lights but it looks like there is wires for fog lights.
View 10 RepliesCorolla / Matrix 2009-13 :: Rattling Sound Like Something Dangling In Front Of Radiator
So while I was driving I thought I heard a rattling. I checked under my front bumper and there is this piece dangling kind of on the driver's side in front of the radiator. What is this piece? It is initially connected towards the front bumper.
View 2 RepliesDodge - Neon :: Leak At Cam Shaft Seal
we have a 97 dodge neon soc that keeps leaking at the cam shaft seal. it has been replaced 3 times now? It keeps working it's way out and leaks oil.
View 1 RepliesPassat (B5) :: Cam Shaft Adjuster Seal Leaking
Passat, 2003, 5 speed, turbo, 1.8T engine, 4 door, 66K miles.
No oil on garage floor and tiny amount of oil at rear of engine, Is this urgent?
(I have had many cars with no seal or gasket issues- especially at 66K).