Touareg :: How To Replace Reflector In Lower Front Bumper
One of my reflectors is cracked in the lower front valence. The part is $30 but labor to replace it is $50-60. How easy it is too do. I am fairly mechanically inclined as long as I don't have the take the bumper off...
View 4 RepliesCamry 2012+ :: SE V6 - Front Bumper Cover Loose
I have a 2012 SE v6 with 1600 miles on it. About a week ago, I noticed my bumper cover pulled away from the corner of the headlight and there was a noticeable gap. I pushed on it, and heard a click. The bumper stayed in place. After a couple days driving, it came loose again. I didnt touch it so the Service Writer would see it first hand. Of course, his first instinct was to puch on it, but I got loud quickly, so he kept his hands to himself, and heard me out. I knew if he clicked it back into place I would be SOL. He admitted something needed to be done, not just click it back.
When I picked it up, he said it was a known issue, and there is a TSB on it. He claimed they replaced a bracket. The invoice reads, "ADDED FELT TO TIGHTEN FIT". Yeah, Im sure that will hold just long enough for them to wash their hands of it.
Camry :: 2013 - Front Bumper Detaching From The Clips
The front bumper keeps detaching from the clips on the side. Toyota has attempted to fix it 3 times with no success. The clips are not broken or cracked. The clips are the same on late 2012 Camry.
View 3 RepliesFord F-150 (2009-2014) :: Wasted Space At Front End Between Bumper / Grille And Radiator
My rig is a 2013 5.0 extended cab. Seems to me that there is some "wasted space" at the front end between the bumper/grille and the radiator. I'm thinking that some sheet metal/expanded metal work or maybe some fiberglass formed to fit that the space could make a neat storage area for stuff like jumper cables, an emergency road side kit and other stuff.
View 4 RepliesCamry :: 2003 - Fog Lights Not Connected / Wires Dangling In Front Bumper
I see some wires dangling in the front bumper which looks like fog lights plugs but I don't get it so is it just plug and play buy a new bumper with fog lights or something? My car doesn't have fog lights but it looks like there is wires for fog lights.
View 10 RepliesCamry 2012+ :: SE - Part Number For Screws That Hold Front Bumper?
I took apart my front bumper for my 2012 Camry SE a while back and swapped it when I hit a cone on the freeway.
I accidentally lost one of those metal nuts that goes underneath the bumper - its like a hexagon if I remember correctly. - I had to use a torque wrench to open them and there was like 8 or 10 total.
Camry 2012+ :: 2014 SE - Front Bumper Chrome Trim Removal
How to remove the chrome trim around the fog lights and the chrome bars beside them I have a 2014 SE
View 2 RepliesCamry :: 2012 Avalon - Extensive Scratches At The Front / Right Corner Of Bumper
I have a rental 2012 Avalon for two weeks. Yesterday I noticed extensive scratches at the front/right corner of the front bumper. The scratches could be covered with two hands. Some scratches are as deep as the primer, but not on the plastic.
I am pretty sure that they are not there until last one or two days ( it has been raining, they would not be very visible when wet). The scratches looks kind of old, could it be that they were fixed in a substandard way so that they are washed off in the rain and became visible?
Camry :: 2009 Vibration At Lower To Mid Speeds / Smooth Out At 60-70
Just bought a 09 Camry, 40k miles, nice car. Drove it very little before I put on the winter tires, different rims also. Notice a terrible vibration at lower (more of a pulse) to mid speeds, it smoothes out at 60-70 though.
I've read HIGH SPEED BALANCING, which I had a garage locally balance it on his machine, I think that is HS balancing? I believe the tire spinds at 50-100 mph??
Toyota - Highlander :: 2009 - Low Rumble / Vibration From Lower Front End
Just had front Rotors and 4 brake pads replaced. Afterward, I noticed after the car has been in motion for a few minutes, a low rumble sound and vibration occurs randomly and usually at low RPM 1500-2500. Vehicle is a 2009 Highlander 4 cyl at 72000 miles.
Toyota service dealer ran diagnostic check and could not find anything.
Second opinion - mechanic swears it's coming from transmission drum and beginning of trans going.
Third opinion- shocks are starting to go and likely root cause on the sound/sensation.
Fourth opinion, wheel alignment or warped rotor likely the cause.
Performed wheel alignment, slight improvement but rumble is still evident. One replaced rotor has a pronounced groove on exterior. Serviceman suggested we won the lottery and the groove came from a rock from the street hitting the rotor.
Finally, it was determined we need to replace intermediate drive shaft due to knocking sound when turning the steering wheel. Not likely related to the low rumble.
Gen 2 Prius :: Bumper Lower Lip Loose?
When I was spray painting my bumper lower lip. Wiggled it loose so I could tape better but it came loose. This is what it looks like after gluing back together. The issue is with the little rubber trim not wanting to stick and looking ugly. Had a few ideas.
1. Replace with factory parts and repaint.
2. Wide pin striping along the line,blue or black.
3. Reflective tape square.
4. Euro fog lights
5. Long LED strip,either red or white
6. New blinker/reflector
7. Putty/bondo the bumper to look like one piece then paint.
Camry :: 2009 XLE - Lower Engine Cover Hanging Loose In The Middle
After an oil change I noticed my lower engine cover hanging loose in the middle. Much searching has not found the part number. Underbody engine shield fasteners. Any quick reference for these? 2009 Camry 4 cyl XLE.
View 11 RepliesFord Excursion :: How To Get Lower Spring Leaf Bumper Out
I got the new ones, (as mentioned in another thread) and they're the same as the old ones. Well, the one that's still in one piece.
I guess I'm missing something very simple, but as easy as it would be to cut the old one out...how do I make room between the lower leaf and the other leaf pack to get it out?
I about hung from the lower leaf and it didn't move quite enough to give the room to remove the bumper.
Sonata NF (2006-10) :: Lower Front Lower Ball Joints Freeze And Creak When Turning
Would bad lower front ball joints freeze and creak when turning. I have noticed that my car(2010GLS) with 108k miles has a creaking sound when turning the wheels left to right. I poked a hole in the rubber boot covering the joint and sprayed WD 40 in there and now it seem to creak even more. Guess I am going to replace the l and r lower ball joints.
View 9 RepliesFord F-150 (2009-2014) :: Shock Absorber Leaking - Lower Control Arm On Front Driver Side Covered In Fresh Oil
I noticed a pool of very clear oil on my garage floor. Looking under the truck I can see the lower control arm on the front drivers side covered in fresh oil. It looks like it's the shock absorber leaking. I just rolled over the 4,000 mile mark. I'm dreading taking it in to my nearby dealer. This is most likely a week long fix with how they operate. 2014 FX2...
View 2 RepliesTouareg :: Installing Reflector On Right Rear Side Of Lower Rear Bumper?
How to remove/install a reflector on the right rear side of the 'lower' rear bumper? I don't see any screws. So, can I pop it out with a screwdriver? Or, is it attached from the inside?
View 2 RepliesPrius (2004-09) :: Front Bumper / Left Front Fender And Driver Door Replacement
Looking for info on these replacements and is there any manuals out there to assist with the process?
View 1 RepliesCamry :: 2009 SE V6 / Front End Clunking After Several New Parts?
2009 Camry SE V6
103,000 miles
New Monroe OESpectrum struts installed by Sears Auto in July, with new alignment. Original springs were not replaced.
Soon after I heard a clunk. Sears tightened a strut mount a week later. Clunk went away.
New Kumho Ecstas installed and balanced a week later.
Still hearing clunk sounds from front end, take it back to Sears to inspect the struts and suspension. They tell me struts must be removed and inspected. They ended up not removing the struts but they replaced the sway bar end links and bushings, which they said were in bad shape. Steering is a bit tighter now.
Im still hearing clunk sounds from front end. Now theyre louder. I get a clunk every time I brake in traffic or a parking lot. I also get a clunk when the car goes over a bumpy road without brakes applied. So doesnt appear related to brakes, calipers, and whatnot.
I can feel the clunk in the steering wheel. Sounds like two loose parts rubbing against each other which shouldn't be rubbing against each other.
Camry :: 2009 - Front End Noise When Go Over Bumps
My 09 camry 6 cyl with 126k miles had front end struts replaced with aftermarket ones. Now I have front end noise, banging, when I go over bumps?. Struts, mounts, springs all replaced. What can be the cause of the noise?
View 10 Replies