Camry :: Can't Remove License Plate Screw
Was trying to remove the licenses plate screws today. One comes out easily, the other won't budge. I've sprayed a couple of times with WD40 but its still stuck.
View 14 RepliesLexus RX 2010-15 :: How To Change Light Bulb On License Plate
How to change the license plate light bulb for lexus rx 350 2010.
View 4 RepliesGolf/GTI VI :: License Plate Bulb Out Error With Stock Bulbs?
I have an intermittent error that comes on most of the time I have my headlights on, but sometimes goes off and comes back while I am driving. It shows me the bulb out light, and says on the screen "Number plate Check license plate lighting!" I have never touched the oem factory bulbs on the license plates, and if i get out and look at the plate, both lights are on over the plate.
The only change I have made was about a year ago, I installed an LED bulb in the trunk, and ran a second OEM trunk light in the left side and installed an LED bulb in that too, tee'd off the factory trunk light housing. But like I said, that was 1 year and 30,000 miles ago, and my bulb our error for the license plate has only just started, so I doubt they are related.
Lexus RX 2010-15 :: Replacing Bulb On License Plate Of 2014 RX350?
Replacing license plate bulb on a 3rd gen rx? I tried taking off the interior lining on the rear hatch but no luck. There's access covers for taillight & reverse, but none for license plate light. I also tried "popping" out the plate light cover right above the license plate... don't think they are designed to be popped out.
View 3 RepliesLexus ES 2007-12 :: How To Replace License Plate Bulbs
I'm trying to change my license plate bulbs to LED but cant figure out how get to the bulb. I've already removed the carpeted cover but cant seem to figure out how to get the bulb out..... 2007 ES350....
View 3 RepliesAccent MC (2006-11) :: 2009 - How To Replace License Plate Light
I found some threads about changing the license plate light on a 2009 Hyundai Accent and all of them involved removing the plastic trim inside of the hatch. However, I saw a few people mention that they broke a few plastic clips. I want to prevent breaking any clips.
Also, this ( hyundai-forums.com/184-mc-2006-2011-accent/94825-2009-accent-replacement-bulbs.html ) thread says that the replacement lights for the license plate are 168 or 168LL, but other posters say that they replaced them with white lights. What code are they?
Camry :: How To Replace Light Bulb In Glove Box On 2002 V6
I have a 2002 Camry LE V6 (Made in Japan) and wanted to replace the glove box bulb. The manual does not mention how to change it and the local dealership was not sure on how to do it. What is involved in it and what size bulb is needed?
View 1 RepliesLexus SC430 :: 2002 - From Where License Plate Lights Get Power
Where the license plate lights get thir power from? I have a 2002 SC430 and the plug is just dangling. It goes behind the plate and then if I look under the car, it is just there by the bumper and I cannot find a connector that it can reach.
View 3 RepliesCamry 2012+ :: Front License Plate Mounting?
Mounting front license plate somewhere other than the "official" mounting location? I don't like the thought of putting holes in my front bumper. I can move it down a bit such that the holes are in the bumper just above the air opening. So, they would be less noticeable. This would block some of the airflow through the lower opening. But, unless I'm driving in 100+ deg temps, it probably won't matter.
I could also offset it to the right or left in the lower opening.
Camry 2012+ :: Tow Hook License Plate Mount?
where to get it? I want to plug up my bumper holes and just put the plate on the tow hook.
View 14 RepliesGolf V R32 :: Should Remove Taillight To Replace Bulb?
Got the light bulb symbol in the tach this afternoon. After checking it out, the LR inner bulb seems to be out. Am I correct in assuming I have to pull back the carpet, then remove 2 nuts/washers, and then remove the taillight lens/housing to replace the bulb? Any recommendations on bulb or just stay with OEM? My R32 has 88K+ miles and this is the first bulb to go...
View 5 RepliesCamry 2012+ :: One Of License Plate Lights Doesn't Turn On Until Tap It
One of my license plate lights doesn't turn on until I tap it..
What could be causing this? I installed LED's in them but a few months later I noticed this happening.
Camry 2012+ :: License Plate Rattle At The Back Of The Car Whenever Shut The Trunk?
I have a 2013 Camry SE and I am experiencing the annoying license plate rattle at the back of the car whenever I shut the trunk or drive over bumps. It's really getting to me as of late?
[URL]
Camry 2012+ :: License Plate Creates Contact With The Rear When Slam Truck
I know this might not seem important but everytime I slam my trunk the license plate is making contact with the rear so it makes that rattle noise everytime I close it. It's annoying because sometimes I just want to close my trunk without being noticed. Toyota should've made two more holes at the bottom of the plate so this wouldn't happen.
View 10 RepliesPassat (B5) :: How To Remove Front Turn Signal Socket To Replace Bulb
I have a 2003 W8 wagon and my front turn signal bulb went out. I need to replace it, but am having some problems. I removed the high beam cover to get to the turn signal socket, but I am having problem removing the socket. I was able to turn the socket slightly and was hoping I could just pull it back, unfortunately it doesn't seem to want to move. Is there a trick to remove the turn signal socket so I can remove the bulb? I don't want to force anything in fear of breaking something. there has to be a way.
View 1 RepliesCamry :: 2007 XLE - Bulb In Overhead Dome Light Has Burnt Out
The bulb in my overhead dome light has burnt out. I have the 194 wedge bulb. I have a moon roof. The owners manual gives no instructions to replace the bulb. I have looked the area over and do not see any easy way to gain access. Any instructions to replace the bulb?
View 2 RepliesPassat (B5) :: 2002 - Replaced Burnt Tail Light Bulb But Only 3 Sockets Were Filled
I just replaced a burnt out tail/brake lightbulb and found that I had sockets for 5 lights yet only 3 were filled....two were empty. How could this have happened and shouldnt they all be filled? I replaced the blown one but I feel like I should get 2 more per side to make it a full housing. I also am not certain what kind I need . The turn signal bulbs are fine....it's just the tail/brake light bulbs. Why were they not filled? 2002 V6 Passat.
View 7 RepliesGolf/GTI VI :: 2002 - How To Remove The Cover Over The Blinker Bulb On Headlight
2002 Jetta, how do you remove the cover over the blinker bulb on headlight? There is a rectangular black cover with a tab at the top. I have tried everything, short of breaking it off, to get the tab to release the cover. What is the trick?
View 1 RepliesRegal :: 99 - How To Change License Plate Bulbs
How to change license plate bulbs? The little clear covers dont seem to pop off ........
View 3 Replies