Lexus GX 2004-09 :: Front License Plate Mounting Holes?
I need to mount a plate on front bumper and there are dimples for 2 holes. Do I just use self tapping screws here as I've read you don't need a mounting frame?
View 3 RepliesCamry 2012+ :: Tow Hook License Plate Mount?
where to get it? I want to plug up my bumper holes and just put the plate on the tow hook.
View 14 RepliesCamry 2012+ :: One Of License Plate Lights Doesn't Turn On Until Tap It
One of my license plate lights doesn't turn on until I tap it..
What could be causing this? I installed LED's in them but a few months later I noticed this happening.
Camry 2012+ :: License Plate Rattle At The Back Of The Car Whenever Shut The Trunk?
I have a 2013 Camry SE and I am experiencing the annoying license plate rattle at the back of the car whenever I shut the trunk or drive over bumps. It's really getting to me as of late?
[URL]
Camry 2012+ :: License Plate Creates Contact With The Rear When Slam Truck
I know this might not seem important but everytime I slam my trunk the license plate is making contact with the rear so it makes that rattle noise everytime I close it. It's annoying because sometimes I just want to close my trunk without being noticed. Toyota should've made two more holes at the bottom of the plate so this wouldn't happen.
View 10 RepliesCamry :: Can't Remove License Plate Screw
Was trying to remove the licenses plate screws today. One comes out easily, the other won't budge. I've sprayed a couple of times with WD40 but its still stuck.
View 14 RepliesLexus RX 2010-15 :: 350 Front License Plate Holder?
After going through the car wash several times now in my 2010 RX 350, my front license plate has been bent in all different directions. Car wash guys say it's due to not having a full plate holder, where as 4 screws secure the plate vs. only the top 2 as we have. Any plate holder from another vehicle that I might adapt to overcome this?
View 14 RepliesPhaeton :: Filling Holes Of Front License Plate
I plan to remove the front license holder from my car, fill the holes, and paint/clear coat/sand them. Any recommendation as to what to fill the holes with (I'm not going to use a plug.) Exactly what the bumper cover is made of, I can find the right material to bond to it.
View 2 RepliesPrius (2004-09) :: How To Install Front License Plate
had a couple questions about installing the front license plate. I currently do not have any holes drilled in the front bumper (though I can see the places where they are supposed to go). I have the black plastic attachment. What is the best way to drill those holes? Can it be done if I don't have a drill (i.e., just with a screwdriver and force)? Is this something the dealer might do for free (I don't have a warranty, bought my car used)?
View 9 RepliesPassat (B5) :: License Plate Holes On Front Bumper?
How do I get rid of license plate holes on my front bumper? I took my front plate off and now I am stuck with annoying holes drilled into my front bumper. Its not noticeable but i know its there so it irritates me.
View 4 RepliesGTI 337/20th Anniversary :: How To Get Off Front License Plate Holder
Ok, Im trying to get my front licence plate holder off. I've looked in all the DIY forums and cant find what im looking for. My question is how do i get this thing off?? I've took the two screws that hold the thing to the bumper off, and its still soild as before i took the screws out. Is it held on by the rub strip?
View 24 RepliesPrius (Gen 3) :: 2012 - Stuck When Turning Stock License Plate Bulbs 1/4 Counterclockwise
I am trying to swap out my stock license plate bulbs on a 2012 Prius.
After getting to the bulb socket holding thing, I have read that you're supposed to turn it 1/4 counterclockwise and pull but mine is stuck and won't turn either way.
Lexus RX 2010-15 :: 450h / Front License Plate Frame?
I have a 2010 RX450h and live in Minnesota where it is hard to hand wash my car. The darn car washes tend to catch the front of my license plate frame and bend it and the license. I have tried several different plate frames and none worked. Minnesota plates are now the thin, non-stamped plates so they are very flimsy.
I even tried putting a plastic plate behind the license to make it more rigid but that failed too.
Lexus ES 2013+ :: Front License Plate Relocation On 2016 350?
yesterday I got the idea to move the plate bracket on the front all the way down so it gives it a much cleaner look and doesn't obstruct the grille. To do so test mount the bracket on the lowest position, then have someone hold it. Then you take a 1/8 drill bit and make the two new wholes then put everything back together.
View 8 RepliesCamry :: 2002 - Remove And Replace Burnt License Plate Bulb
02 Camry, how to I remove the burnt license plate bulb? Took off the underside trunk carpet and disconnected bulb harness, but I don't know how to remove the plastic piece that holds the bulb in place. Does it pull out, or twist out? I don't want to break it!
View 1 RepliesLexus SC430 :: Removed Front License Plate - Filling Holes In Bumper?
replacing the entire front bumper.I have removed the front license plate holder, and would like to fill the holes where it was screwed into the front bumper.
View 8 RepliesRegal :: 99 - How To Change License Plate Bulbs
How to change license plate bulbs? The little clear covers dont seem to pop off ........
View 3 RepliesPassat (B6) :: LED License Plate Lights Not Working?
So I bought LED license plate lights, the same ones Track5tar has (who sent me the link to get them). I got em off the bay, and I put them in and they don't work! The Heatsink gets hot but the lights don't light up in both of them!
View 24 RepliesPassat (B6) :: License Plate Lights Won't Turn On
So I was replacing the lights with the new leds change one toke some pics to compare. Everything fine...
Removed the other feston put the new led and they won't turn on anymore..
Change them back. Put them upside down, up, sideways... Nothing
Check all three fuse boxes all ok
Every other light on, inside trunk on, side markers on...
Everything but the license plate lights.