Lexus ES 2007-12 :: Vehicle Speed Sensor Location - Code P0500
Where the vehicle speed sensor is located on the 2007 es350. Reomoved battery and air filter box but just can't find it.
View 1 RepliesAvalon 2005-12 :: 2006 - Transmission Speed Sensor / Engine Code P1705
Have the P1705 engine code (Direct Clutch Speed Circuit Fault) on 1996 Avalon.
I have removed it and trying to examine connectors and unit for problems.
Seems simpler to replace but cannot see spending the money on a crap shoot. Here is what I know:
Took voltage reading from each of the 2 connectors on the harness each with the key on but car not started. 1 probe to 1 connector and other probe to battery ground. Each connector displayed 0.76V.
Checked resistance across connectors on removed Sensor and it was 600+.
So...are these results determine whether the sensor is bad or the connector harness has an issue? Am I measuring incorrectly? Finally, is there only one of these sensors? I see on later models there are 2. Toyota P/N: 89413-08020
Avalon 2005-12 :: P0051 Code - Hidden Sensor Replacement On Firewall Side
So, my '06 XL just popped up a P0051 code, which is the bank 2, sensor 1 (the upstream A/F sensor that you can easily view upon opening the hood in the front exhaust manifold. Easy enough of a replacement on that one, but what about bank 1, sensor 1 (the upstream A/F ratio sensor on the firewall side of the engine)? I changed my oil today and I can access three of the four oxy/A/F sensors, but the upstream rear looks like a bitch! Out of curiosity, I called a local Toyota dealer and they said it would be 300.00 total to replace the hidden sensor on the firewall side. Does this amount seem realistic? I know that there is a TSB for this sensor that states to replace the exhaust manifold/cat assembly. I def. can't afford no 1700.00 crap right now!!
View 3 RepliesLexus RX 2010-15 :: Code P0500 - Speed Sensor A
2010 RX350 check engine light is on code P0500 came up it said speed sensor A...
View 1 RepliesCorolla / Matrix 2009-13 :: P0500 Code - Vehicle Speed Sensor Malfunction
My car is now 24/7 with this error which is Vehicle Speed Sensor malfunction an there seems to be no way of solving it, symptoms are:
*Speedometer not working, needle always in 0
*Power steering not working
*Car wont past 3rd gear
*Check engine light and power steering light on
I checked all 4 speed sensors and the wiring looks good and they look good. Also if i hit a bump, issue goes away for a couple of minutes, until i hit another, etc, so looks like a wire or short circuit, cant tell. Is there a speed sensor on the transmission as well? where is located?
Ford F-150 - 1997-2003 :: 1999 - Code P0500 - Speed Sensor Has Been Broken Off
So I'm getting code p0500 the question I have is will the speed sensor on the tail on my transmission cause this code on my 99 f150 4x4 . the reason I ask is because this sensor has been broken off . I'm hopeful it only control's my speedometer and is not related to the code . I've tried to remove what is left however in fear if I get it loose it may fall into the transmission. I will be replacing the speed sensor on the pumpkin this weekend . but the transmission it's the upper one is broke off below the surface of the transmission this is a manual transmission....
View 2 RepliesFord Aerostar :: 1996 - OD Light Blinking / Code P0500 Speed Sensor A Malfunction
Vehicle is a 1996 Aero* XLT, 4.0 engine with 155000+ miles. I'm getting the P0500 code with the OD light blinking. Tranny is not shifting properly. Did not look at the speedo or check the cruise due to worry about making it to my driveway. I have had ocasion to set the cruise to 45MPH and at times it will drop out. I don't know the lower limit on the cruise. Is this speed sensor the same as the VSS...
View 9 RepliesFord Transmission :: Speed Sensor Location?
Also posting here as my question falls in both forums.
[URL]
Santa FE SM (2001-06) :: Code P0715 - Input Speed Sensor Location?
My Santa Fe indicated P0715 for input speed sensor problem. I purchased both sensors and based on forum input I removed the air box and battery to access senors. Output speed sensor is easy to see and access. I am having a problem locating the input sensor. I see wires going to a sensor under both the main wiring harness and shift cable. Is that the location of the input sensor? If so how do you move the wiring harness and shift cable to allow access? If not, where is the input speed sensor located? The Santa Fe is 2001 V6 2.7L.
View 8 RepliesFord 6.0L Power Stroke Diesel :: Transmission Speed Sensor Location
I've been searching and searching but I just cant find out the location of the Transmission Speed sensor, It would be the one that controls your speedo and Transmission pressure? Is it located on top of the rear differential?
View 4 RepliesCamry :: 2002 XLE - CEL P0500 / Vehicle Speed Sensor A Malfunction
Recently, my I4 XLE camry with abs came up with a cel P0500 - Vehicle Speed Sensor A Malfunction. Where the vehicle speed sensor is located? i doubt this thing's hard to service, but so far i have no luck finding it.
View 13 RepliesAvalon 2005-12 :: P0031 Error Code / Part Number For O2 Sensor?
I have a check engine light come on in my 07 Avalon and had the car scanned. It was throwing error code P0031. I'm gonna go ahead and replace this O2 sensor, however, I'm having a hard time finding the correct part# for this sensor.
View 1 RepliesAccent LC (2000-05) :: Transmission Temperature Sensor Location / P0711 Code
Wife's car threw a p0711 code. It says temp sensor failure or whatever. I found the part on rockauto for 22 bucks but that's not the issue. I've tried searching about this and I seem to find some stuff about elantras and sonatas. I can't seem to find anything specific to a accent. I've read that it's inside the transmission which is fine I've changed valves before and such on old rwd transmissions. But some things I find say it's on the bottom and some say the side. Also wiring is mentioned pretty often with service bulletins.
View 28 RepliesCelica :: 2001 Toyota GT - Speed Sensor A P0500 / P0770 Shift Solenoid E
I have a 2001 Toyota Celica GT, automatic with 177,000 miles, it has been very well maintained. I started having a problem usually just after starting when it is still not completely warmed up. I try and shift it into reverse or drive, and the shifter says it is in those gears, but the car acts like it is in neutral. Once it gets a little warmer I can try it again and it will slowly shift into reverse or drive, usually though the rpm's seem to go a little higher than normal while it shifts. It seems to drive pretty well after this, shifting-wise, but not exactly perfect.
When it is completely warm though it usually drives really well - mostly I do a lot of highway driving. The transmission fluid is full, and looks perfect, nothing in it, not burnt. Previous owner had it changed a few years ago I believe. The check engine light is on and the codes are Speed Sensor A P0500, P0770 Shift solenoid E. My speedometer also works perfectly by the way. I don't have a lot of good shops around and I feel like the ones that are closest to me will see dollar signs in their eyes when they see that transmission code and will just try and replace the whole transmission right off the bat.
Avalon 2005-12 :: Check Engine Light On And Code Is P0327 (Knock Sensor)
So, I have my check engine light and the code is p0327 (knock sensor). Clear cose but it returns. Going on for 3 days now. I was suspicious that something else is going on. I also remembered I've been using a little more antifreeze in the reservoir. So, today I needed to watch the coolant. I ran the car for an hr and I found a lot. Red coolant on my belt, the back passenger side of my engine and it was caked on with coolant. I think the water pump is going up.
I was concerned that coolant was also leaking from the intake manifold but it's only the right side, so I'm pretty sure the coolant is being slung around from the belt. I rinsed the engine down and the knock sensor code went away. Temporarily, until more coolant got back there. Do you think I will need to replace the knock sensor along with the water pump or should the sensor work ok after some intense cleaning after the water pump replacement?
Avalon 2005-12 :: 2006 - Error Code P0031 / Heated Oxygen Sensor Is Bad
I received error code P0031 on my 06 Avalon the other day. It states that the HO2S (Heated Oxygen Sensor) is bad. Bank 1 Sensor 1. I located the sensor but have a few questions...
Just to give an over view for those that don't know where these are, there are 4 sensors the one in the front on the manifold (upper - B2, S1), (lower - B2, S2) and the rear manifold (upper - B1, S1), (lower - B1, S2).
All of the sensors look the same with 4 wires. what the part number is for the sensor? Also since this is the hardest one to get to, I would like to know where the wire routes to. I found the wire up to the connector on every other sensor except the one I need (B1S1). It looks like it runs towards the top of the engine but from the top I don't see it.
Avalon 2005-12 :: CEL Error Code P0440 Error Code / Charcoal Canister Replacement
So of course it has to happen 3 weeks after my warranty expires. My CEL comes on and I have it read and the result is P0440. I find out that my wife has a habit of topping off the gas tank and so I am thinking that she has probably ruined the charcoal canister. It is something easy to replace?
I have an 06 limited edition... Yes, she will not be topping off any gas tank anymore.
Ford Ranger / B-Series :: Code P0500 / Speedo Works / ECM Gets No Speed Signal
97 ranger 2.3l 5spd ... I keep getting p0500 code. the speedometer and odometer work fine. I understand they get they're reading from the OSS on the transmission. Now I also have the vss in the axle housing which I believe is what gives the ultimate speed reading to the pcm that way there is no need to ever adjust for axle ratio.
When using the torque app with my obd reader my OBD MPH guage does nothing until I get to about 55 then it bounces around randomly between 20 and 55 and once I hit 60 mph it reads correctly. I have tried 3 different vss sensors checked wire continuity from sensor to firewall examined the teeth/sprocket that gives the vss it's reading and it all checks out...
My questions are:
- What volts or ohms are supposed to come out of the plug end so I can test if the signal to the sensor is working
- Looking for wiring schematics for this sensor to pcm...my schematic only has the oss.
Accent LC (2000-05) :: Code For Output Shaft Speed Sensor - Transmission Rebuild
I had a rebuild done on my 2002 Accent. My question is now we get a code for the output shaft speed sensor. Would this have been replaced as part of the transmission rebuild?
View 2 Replies