Accent LC (2000-05) :: Rough Idle While Drive Or Reverse
I have a 2000 Accent with about 150,000 miles on it. Recently I have noticed that when my car is sitting in an intersection, the car appears to idle roughly. I would't exactly say that the car is idling rough, cause it stays at a consistent RPM while in drive or park, but the engine gets louder and the steering wheel starts to vibrating. When I slightly step on the gas, the vibration goes away. Also, when I put my car in park or neutral, the car quiets down and the vibrating stops.
I was wondering if it could be the throttle position sensor, or maybe a broken motor mount, but I haven't had a chance to look into it it. I did replace the purge control valve last week, which slightly improved the vibrations.
Accent MC (2006-11) :: Rumble And Vibration In Reverse
Like the title says. All of a sudden when I put the car in reverse I got a rumble and the car vibrates some.
View 41 RepliesAccent MC (2006-11) :: Rattle Sound In Reverse
[URL] .... You have to crank your speakers to hear properly, the mic in my phone was trying to cancel the engine noise I think... Someone suggested an exhaust hanger in another thread, I still have to get under the car next oil change and check that.
View 1 RepliesAccent MC (2006-11) :: 2010 SE Grinds When Shift Into Reverse
I've had my new left over 2010 SE for couple weeks now. done 600 miles.
I noticed at first a couple times when shifting from 1st to reverse while parallel parking and still slightly rolling forward, the the gear grinded a bit, despite the clutch being fully depressed. I figured maybe with this manual tranny compared to others i've driven that you just have to be dead still before shifting into reverse.
But then yesterday morning from my driveway, from a standstill I shifted into reverse and it grinded too, again with the clutch fully depressed. Is this normal with these cars? I've driven manual gtis and a ford focus and never experienced this before? Is this a problem?
the fact that it's happened three times now within a couple weeks tells me it's not me being sloppy on the clutch, it is definitely grinding with my foot all the way down on the clutch.
Accent MC (2006-11) :: Couldn't Engage Reverse When Put Shift Knob On
So I just installed my short shifter and everything works great, all the gears engage, however, when I put my shift knob on I noticed I couldn't engage reverse because it sits down too low and doesn't allow the reverse lockout to get over the rail and engage reverse. I have to loosen the knob so it sits higher and then I can engage reverse, but it moves around, so I can't leave it like this...right now my plan is to make some sort of spacer for the knob to sit on and then put loctite on it...seems like it would solve my problem. I have a Hyundai Aluminum shift knob and the short shift is OEM so I don't see what could be wrong ...
View 8 RepliesAccent MC (2006-11) :: 2007 - CEL Coming On / Stalling When Putting In Reverse
My Accent is a 2007. It regularly has the check engine light come on. They continually claim it's the fuel cap. When it's colder, even when it's been running it continually stalls when your putting it in reverse. They also claim that's not a problem. It's only got 25K on it. So the fact that it's already have problems is rather annoying.
View 5 RepliesAccent MC (2006-11) :: 2007 - Engine Vibration When Putting The Car In Reverse
My mechanic noticed an engine vibration when he was installing my new brake pads and rotors. He noticed the vibration when putting it in reverse. He then checked the engine and mounts. He then asked about the timing belt. I told him the belt was changed at 62,000 miles. The Accent currently has 76,000. He thinks that the belt may have jumped or a counter balancer is not working right. I do not know if the 2007 has a counter balancer. Any diagram of the timing belt, pulleys and counter balance (if it has one). It is a 2007 GLS with auto trans.
View 15 RepliesAccent MC (2006-11) :: Clutch Went Out - No Reverse / Goes Into 1st Gear After Lot Of Coaxing And Grinding
Ok, so I got my car at 60k miles, and the clutch went out almost instantly so I had the entire clutch replaced, and it was working just fine until now. It has been 25k miles since I did the full clutch replacement so it shouldn't be messing up again already. It is not going in to reverse at all, it goes in to 1st gear, but only after a lot of coaxing and grinding, and the clutch feels strange. The clutch is too soft (too easy to push down), but after a while it seems to get better.
2007 Hyundai Accent GS
Manual, hatchback
85k miles
Accent MC (2006-11) :: Tail / Reverse And Brake Lights All Stopped Working
My taillights, reverse lights and brake lights all stopped working! What the problem is. The fuses are fine and the bulbs are good too. How to fix this or what I should look for to try to fix it?
View 1 RepliesAccent MC (2006-11) :: Shaking And Idling Really Rough
I have a 2006 Hyundai Accent that won't start. My wife was driving home the other day, and while she was sitting at the light she said she noticed a sudden change in the idle. She said the car starting shaking a little and idling really rough. When she tried to accelerate after the light changed, she said the car sputtered and would barely go.
She was only a couple of blocks from the house so she continued home. The car made it the rest of the way home, but she said it never went over about 5 mph even though she was pressing the accelerator as she would if she were going about 30...the car just never responded. When she pulled into the garage the car died as she was turning. Now it will crank but it won't start at all.
I tested the crankshaft position sensor with my multimeter and it was bad. I bought a new one and put it on, and I tested it immediately. The new one works, so I plugged everything back in and tried to start the car...nothing, just cranks and won't start. It's getting fuel and fire as well (tested both), but it's not hitting on any of the cylinders.
Accent MC (2006-11) :: Rough Idle At Stops
My 2011 Hyundai Accent 1.6 runs fantastic and has since I purchased it three year's ago until two weeks ago when my domestic partners friend changed the spark plugs, oil, air filter and stuff so I could go on a short trip and back. About 200 miles into it I pulled into a rest stop and noticed it was rough before I put it in park. As soon as I put it in reverse it was running rough and sounded like it was going to die. Forty miles later the check engine light was on and it was running terrible. A parts store recommended different spark plugs. A nice man who was there overheard the conversation and offered to put them in for me since I know nothing about doing. He said he gapped the spark plugs at 0.40? When I started it it ran like a dream until about 75 miles later and it began doing it again but the light never came on. It is doing the same thing which is a rough idle when stopped but it smooths out when I put it in park.
View 3 RepliesAccent MC (2006-11) :: Occasional Rough Shift Every Now And Again
So, back when my car was my dad's, he used to drive a lot on the freeway for his job. He said that after getting off the freeway and transitioning to in-city driving, the transmission would start to act up. It only happened when the car was hot, and it's generally fine for just driving a couple miles to work like I do, albeit the occasional rough shift every now and again, but I'd like to be able to hit the freeway if I need to without worrying about the transmission badly misbehaving.
Also, I'm not sure if it's even relevant to that issue, but I've been aware of the fact that at least two of my ignition coils are bad, a common problem in MC Accents to my knowledge, and the engine hasn't been running as smoothly as it could be for the past several months. Is it at all possible that a long-standing misfire issue could play havoc with shifting patterns when the transmission changes from freeway to in-city shifting behavior?
Accent MC (2006-11) :: Running Very Rough / Won't Pass 3000 RPM
I have a 2008 Accent 1.6L automatic that is running very rough when it accelerates. First of all there was some engine check light, I got the codes and it was a Cylinder misfire. Then I checked the following:
1.- Spark plugs (replaced them same NGK but I didn't gaped them, same result)
2.- Fuel injectors (removed them, cleaned them and installed in different order, same result)
3.- IGN coils (measure resistance, swap them in different places, same result)
4.- Checked most of the sensors including TPS, Crankshaft PS, MAF, Camshaft PS and nothing.
5.- I checked for any type of vacuum leak and I couldn't find one
After all that troubleshooting I cleaned the codes, started the car again and I have the same problem with no check engine lights on except that sometimes I would get a "running rich" code.
I also noticed that the air intake is LOUD like a performance air intake, is that something normal on the accent? (I checked the air filter and its not clogged FYI). I could only think of:
Gap spark plugs to .035
check timing belt
check fuel filter (I don't think so)
Accent MC (2006-11) :: Rough Shifting From 1st To 2nd Gear In Low RPMs
My 2009 Accent has some very rough shifts from 1st to 2nd when I'm in the low RPMs.
Hyundai performed a transmission fluid flush and the other gears shift completely effortlessly. Is my tranny dying or what?
Accent MC (2006-11) :: Rough Idle But Fine When Air Conditioner Off?
I've had my 2010 Accent for about 9 months. It's got about 63K miles on it. Serviced regularly, no issues there. Yesterday while coming home from a road trip....6 hours there, heavy driving while in town, 6 hours back 2 days later, the check engine light came on the dash. I then noticed that the car was idling very rough. When I put it in gear after starting, I can visibly see the car the shake. Having major problems accelerating, I have to mash the gas to the floor to make it go. Shutting off the air conditioner seems to work a bit, but not totally.
I should note that I live in the South East US, it was over 95 degrees when we left town and the destination was over 100 the entire time we were there. I was told this could be vapor lock, but am not sure about what to do to clear that when the temps won't drop around here for some time. I took it to AutoZone this morning to have them read the codes on the check engine light and was told that their code reader was incompatible with my car.
Accent MC (2006-11) :: 2009 - Super Rough Idle / CEL Came On
I have a 2009 Accent and after about 20 minutes of driving it started running really rough and my check engine light came on. It's worse at an idle (feels like it's going to stall out) but isn't quite as bad when I rev it. My first thought is water in the gas tank since we've had a lot of rain for the past week or so and I filled it up a day or two ago.
View 2 RepliesFord F-150 (2004-2008) :: 2006 - Rough Idling When Warm And Dying At Stops Or In Reverse
My brother's 5.4 has been rough idling and dying at stops and in reverse for a few weeks now. Today it threw a code and he finally had me look at it and it's a P0345 code. I was thinking cam phasers possibly, but I didn't think that would cause a code to throw. Also, all I hear about cam phasers is that it makes the truck sound like a diesel, but his when it's about to die sounds like the engine is about to drop out the bottom of the engine bay. Really rough, REALLY loud knocking, etc... What we should be looking at replacing to get this thing back into shape?
View 3 RepliesAccent MC (2006-11) :: 2007 - Rough Sounding For A Minute Or Two Then Died
My daughters 07 Accent quit a few days back. She managed to get it home but it was making a noise on the left side of the block before it died again. I started it the next morning and it was rough sounding for a minute or two before it died. There has been a check engine light on for quite some time that I was unaware of. A friend had a brand new fuel pump he sold me (very cheaply) so I installed that yesterday but the starter just cranks with no combustion at all. I will check for spark this AM and if there is none I will likely replace the crank sensor.
I've checked any and all fuses under the hood and all seem fine (although I've never seen the type with the two little "balls" but they seem to by fine also) My question concerns the timing belt. If I have spark and fuel pressure, how do I check for a bad timing belt ? I looked in through the oil cap filler for cam lobes but can't see past what looks like an oil "spout" part at the filler. Also, if the belt is gone would it bend the valves on this motor ? If the belt has stripped teeth and screws the timing I should still get some sort of very rough firing in a cylinder or two, shouldn't I ?
Accent MC (2006-11) :: Started Rough And Shuts Off When Accelerate / Won't Start
I have a 2009 Hyundai Accent with 52000Km (32932miles) The car was parked since 2011 and now when I started it, it started really rough and would not accelerate (it would die if i pressed the acceleration pedal) but now after multiple attempts the car sounds like it wants to start but it doesn't unless I press the acceleration pedal when starting the car then the car revs to 2000rpm and dies within 1-2seconds,I also hear a odd sound from the intake its like a loud rumble. So far I have tried
- changing the spark plugs
- changing the coils
- checked spark
- cleaned intake manifold
- cleaned throttle body
- replaced PCV valve (because originally there was alot of oil in the intake)
- checked if fuel pump is pumping gas
I also checked the engine codes and there is a code for crankshaft position sensor abnormal -P0336 I unplugged the crankshaft sensor and the car wont start at all further more I also checked if it was sending the correct rpms with my obd tool and it seems like it is ...