Golf IV / Jetta IV :: Transmission Knocking When Clutch Pedal Released
I've done a bit of research both here and on other sites. I originally thought that I had a bad flywheel but I'm not convinced. First I'll give a little backstory. I just installed steel shift forks because one broke and got jammed in the gears. None of the gears are damaged and I assumed that when it slammed to halt, the flywheel got messed up. So anyways, the complaint is that when the clutch pedal is released I start to hear a knocking sound which becomes more rapid with RPM. When the pedal is depressed the sound goes away. This sound seems to be coming more from the driver's end of the trans. The car still moves in all gears so I can't imagine that I put it together wrong.
View 6 RepliesElantra XD (2001-06) :: Clutch Engages When Pedal Is Almost Fully Released
In every other manual transmission vehicle I have ever driven, the clutch pedal engages/disengages within an inch of the floor. Is it normal that the clutch in my 2002 Hyundai Elantra engages when the pedal is so far away from the floor? When I say far away from the floor I mean within an inch of the pedal being fully released.
View 21 RepliesCorolla / Matrix 2009-13 :: Throw-out Bearing - Noise Comes And Goes As Clutch Pedal Is Released
Title should say Throw-out bearing aka Release bearing.
I have a 2010 5 speed Corolla CE. Having problems with their Throw-out bearings. At around 8000 miles the sqeaking/chirping noise of the bearing was too much so I brought in it to the dealer to fix. They agreed and made the repair.
Now it is only at 10000 miles (22000km) and I can hear it starting again. Just wondering if it is a common problem?
Noise comes and goes as the clutch pedal is released. If you push it in it will go away. It also will happen in all gears but easiest to hear in neutral.
Accent LC (2000-05) :: Light Grinding Noise When Let The Clutch Out / Pedal Super Hard
Yesterday I was driving home and my clutch started acting up. To start I was unable to press the pedal. The pedal was super hard, then let up but didn't feel right.
I removed the slave and the pedal went down fine. Both the master and the slave have no leaking and fluid levels are good. I haven't been able to have a buddy look at the levels when I press the clutch, but....
Here is a little more, the car shifts fine with the car off, it goes into all the gears, but with the car on it will not shift into gear. Also there is a light grinding noise when I let the clutch out..
I ordered a clutch kit already, but don't want to pull the trans if I don't have to, I would love to hear the issue is with the master or slave.....
2005 Hyundai accent with 138,000 miles
Golf IV / Jetta IV :: Stalls Out In Stop And Go Traffic / Bang And Clutch Pedal Drops To The Floor
I have a 2005 VW jetta 2.0 engine 5 speed. Just replaced right control arm spark plugs wires and coil pack. I had a misfire only when it rained and it got rid of it! Driving home in stop and go traffic and My car stalls out a hear a bang and my clutch pedal drops to the floor. I had noticed some fluid loss but nothing was low I checked everything before I left work. I finally get it towed but I can not shift to first I can shift to 2 3 4 5 and reverse. I was in first when it stalled out during stop and go traffic while it was in first gear and i had the clutch pressed in. Everything Ive google says it is more than likely the Slave cylinder that is right below the air box. I found some that said it could be the release bearing in the gearbox for the tranny...
View 4 RepliesAccent LC (2000-05) :: RPMs Goes Up When Car Is In Neutral
i have accent 2000. RPMs goes up when car is in neutral. Why is this?
View 3 RepliesAccent MC (2006-11) :: Clutch Engages When The Pedal Is Right At The Top
Just bought a 2009 Accent 5 speed I have 2500 miles on it .The clutch engages when the pedal is right at the top. Is there an adjustment on this vehicle I would prefer it to engage about mid stroke.
View 9 RepliesAccent RB (2012+) :: Creaking Noise On Releasing Clutch Pedal
On releasing the clutch pedal, a creaking noise can be heard, which:
- sounds and feels like a rusty spring being unloaded
- occurs for the entire range of pedal travel, but worse near the bottom
- is louder outside the car than inside
- happens not only when driving, but also when stationary with the engine off
I don't think anything is wrong with the clutch itself, or any bearings, or major components... It just feels like something needs to be lubed. I've lubed the spring above the pedal inside the car, with no real effect.
Accent LC (2000-05) :: Neutral Safety Switch Exact Location
I can't seem to find the location of the neutral safety switch on my 2005 accent 5 speed manual. I removed the air filter box and looked all around the top, bottom, and sides of the tranny. I have the new part so I do know what it looks like.
View 6 RepliesAccent LC (2000-05) :: Trans Slipping Out Of 5th Gear / Drops Out To Neutral
It does not like to stay in 5th gear, drops out to neutral. 2001 Accent Hatchback. 1.5l 5-speed
The other day it started slipping out of 5th gear on the expressway. Held good for the first 10 to 20 minutes. Afterwards I had to hold it in 5th for it to stay in gear. While holding I noticed it pushed on the shifter when applying throttle, and let up some when I let of the gas.
I inspected the pivots at the transmission. The forward / back bushing was not installed properly by the previous owner. I rigged it up better with a fender washer and cotterpin. It previously had just a pin and the bushing had expanded out. This removed the play from shifting I had previously noticed. It also halfway fixed the popping out of gear. It stays in gear a little longer, and when I put it back into 5th it stays there for a while most of the time.
I have not inspected the lubricant level yet. Where to check next?
Accent MC (2006-11) :: Brake Pedal Won't Depress - Seized Clutch Bearing
2007 Accent pedal won't depress. Bearing making noise for a few months. Is tranny snout toast or is it fixable?
View 2 RepliesAccent RB (2012+) :: 2013 - Clutch Pedal Adjustment So That Engagement Isn't So Far Away From The Floor?
In most other manual tranny cars that I have ever driven, the clutch pedal engages/disengages within an inch of the floor. Not my accent. is it possible to adjust the clutch pedal so that engagement isn't so far away from the floor? it pretty much fully engages at the near top of the pedal.
View 2 RepliesAccent LC (2000-05) :: GL Stalls And Will Not Start
I have a 2000 hyundai accent. I shut it off in my driveway earlier and went in long enough to use the bathroom and when i came back the car would not start. I squirted gas in the intake and it fired right up. A little later i was in town and it stalled and would not re-start. I had to walk to the store and get some ether to get it started back up. I have noticed since the first time that it will cut out every now and then for just a second and then go again while running down the road at around sixty mph... im at a loss as the local mechanic's computer wont hook up to it and there is no place to check the fuel pressure as i had wondered if maybe that was the problem having had another car do that before. the check engine light is not on either
View 2 RepliesAccent LC (2000-05) :: Clicking Noise When Rolling In Neutral With / Without Brake Applied
I have an 2002 Hyundai Auto.
My car has the clicking noise under the following situations:
1) rolling in neutral with/without brake applied
2) rolling/decelerating without gas pedal pressed (I guess the same as rolling in neutral) with/without brake applied
The noise is the most noticeable when going at around 20 to 30mph, and would be gone under very low speed <5-10 mph. The weird thing is when I press the gas pedal and the car is accelerating, the noise is gone too.
My mechanics said it is because the wheel cylinder which is noisy. But I don't quite understand why the noise is gone when the car is accelerating.
Accent LC (2000-05) :: Stalls After A Short Distance
I have an automatic 2000 Accent.. It stalls after a short distance. I changed the wires, spark plugs, and today I changed the fuel filter and put some injector cleaner but no change.. right after the filter change, it seemed to be OK but I drove about 10 minutes on highway and it stalled again.
If I wait about 10 minutes it starts again but not for long.. According to this, what else can it be?
Accent LC (2000-05) :: Stalls At Low Speed / No Coughing Or Sputtering
3 times now in the last week, my 2000 accent has stalled. each time it was at a low idle, slow moving speed. I was rolling up to a red light twice, and gliding into a parking spot the other. There was no coughing or sputtering. It just stopped. Each time, after about 20minutes or so, the car fires right up. it happened twice today after about 4 miles of driving. If the car sits for a day without running (on an off day from work) its a bit hard to start sometimes, but not consistently. Does this sound like a Crankshaft position sensor? or possible a fuel filter?
View 5 RepliesAccent LC (2000-05) :: Hyundai Consistently Stalls While Driving
Have a Hyundai accent 2000 manual. The vehicle inconsistently stalls while driving. One day it will drive all day without stopping. The next it will stall while driving 10 or more times.
I`ll pull over, turn ignition off. Turn the key 1-2 times. It starts. Drive sometimes 5-10 minutes will stall again, sometimes will stall an hour later. Some days not at all.
What I should be checking and how to go about it. Have the car booked in to get it put on the computer, but would rather do it myself especially if its just a sensor that needs replacing.
Passat (B7) :: Beep Sound After Clutch Has Been Released
It happened again this morning while putting the tranny into reverse and backing into my slanted/graded driveway about 60'. After the clutch has been released all of the way, a BEEP...BEEP...BEEP. aural sound comes from either the engine bay or under the dash. It's not happening when driving out fresh in the morning. It only occurred when I was backing up and on a grade. First, I had thought that it was my clutch telling me - Or, maybe it was the Hill Assist actuator in conflict when the car is actually moving. No smoke or burning coming from underneath nor any idiot lights flashing on the Dash.
I left a message for the Service Manager at the VW Dealer that I purchased the car from. I haven't heard back yet if he has ever heard of or witnessed this freak of nature event. Today was the second time in a week that this "Anomaly" has occurred.
Ford - Thunderbird :: 1979 V8 Suddenly Not Starting / Engine Turns Over But Stalls When Key Is Released
I have a 1979 Ford Thunderbird with a V8 5.0 liter engine. Here's the mysterious problem... the engine turns over when I turn the key but stalls when the key is released. Thinking that the alternator died, I replaced it with a new re-manufactured unit and the car's symptoms stayed the same. Also checked the fuses and the fuel filter and found that plenty of fuel is getting to the carburetor. This issue with the car not starting appeared literally overnight after I attempted to install a new radio. Prior to this the car ran reasonably well – always started easily and ran without a problem. Wondering if there is a possibility that I fried some part of the electrical system when I fussed around with all the wiring under the dash. Someone else had attempted the radio installation previously so the wiring there was already a mess of cuts and re-connections and was hard to sort out.
View 7 Replies