Ford Ranger / B-Series :: 2004 - Revs Engine When Clutch Engages?
2004 Ford Ranger revs the engine when you engage the clutch then when you place it in gear it's like the cruises on it want to drive without you touching the Accelerator?
View 4 RepliesNissan - Maxima :: 2004 - Transmission Slipping / While Driving Engine Revs And Then Engages Again
When the car is cold it runs fine. After driving for 10-15 minutes the transmission slips, while driving the engine revs and then engages again.I have only noticed the disengaging/engaging as speeds less than 40 MPH. When the car is in neutral and placed into drive it may take several seconds to engage which happens about 60% of the time. Could this be a sensor failure or time for a new transmission?
View 4 RepliesFord Super Duty (1999-2016) :: 2008 F250 - Trans Occasionally Slam When Shift From Drive To Reserve
I have a 2008 for 250 6.4 powerstroke. Issue I am having is occasionally when I shift from drive to reserve it will slam when I shift to reverse. It is an intermittent issue. What causes this and what to do?
View 1 RepliesTouareg :: Engine First Revs Up And Then Transmission Engages When Going Downhill
V10 - When you shift into tiptronic to brake going downhill, the engine first revs up and then the transmission engages. Sort of an automatic double clutch!
View 2 RepliesFord F-150 (2004-2008) :: Engine Turns Over And The Starter Engages But It Won't Fire
My 2008 F150 5.4l SCrew wouldn't start this evening. The engine turns over and the starter engages, but it won't fire. Oddly enough the starter stays engaged after I take my hand off the ignition! I have to physically turn the key off for it to quit (didn't want to burn out the starter). The culprit may be the wet weather....it's been a lot milder today and we've had some freezing rain that turned to drizzle. My truck has only done this once before (last year I think). I eventually got it to start tho.
View 13 RepliesChevy - C10I :: Engine Revs Kind Of High Before Transmission Engages
1983 chevy c10I bought this old truck about a week ago and I noticed a few things right from the start. Engine revs kind of high before the transmission engages (about 1,200+ rpms).at highway speed the truck shakes and vibrates really bad at times. the steering wheel doesn't vibrate so I dont think it`s ball joints or tie rods.The truck barely goes backwards when in reverse, the engine revs high (over 2000 rpm) but the truck barely moves backwards.It almost feels like the emergency brake is on.
yesterday the truck (transmission?) started slipping and then it stopped working. I was stopped on the side of the road and this old guy stopped.I told him what happened and he said it was probably the transmission but he knew a way to get it working again long enough to get me home. He picked up a handful of sand from the side of the road and put it in the transmission dip stick hole and then poured half a bottle of brake fluid in.He said the transmission is gone anyway so the sand and brake fluid wont do it any more harm.The truck ran again but not far enough to get me home I had to get it towed. Now I am wondering if it really was the transmission and not just the torque converter. I guess it doesn't matter now because the transmission is probably toast now.
Escort :: 1986 Ford Transmission - Engine Revs But Won't Accelerate More Than 25mph In Drive
In Drive the engine revs but wont accelerate more than 25mph. D1, D2, and reverse work as usual. Fluid is dark, but no debris, no burnt smell. Should I change the fluid & filter? The shop said that would make it worse.
View 1 RepliesFord Transmission :: 2005 Expedition - No Forward / Engine Revs And Barely Pulls In Drive
Reverse works great....engine revs and barely pulls in drive. Not sure yet if it actually changes gears. I am planning on replacing tranny. I have a few questions :
1: Could it be something more simple like a selonoid or ???
2: What all trannys will fit? this is the 2wd 5.4 liter xlt ...
Ford F-150 (2004-2008) :: Shuttering / Sputtering At 40 - 60 MPH After Decelerating And Slowly Accelerating
I recently bought an 04 lariat crew cab with 56K miles 5.4 and auto trans. Before i bought it i complained about an exhaust noise and acceleration issue at 40mph and 1100 rpm as well as the ac not being very cold. They replaced the exhaust manifold on the passenger side, coil pack on the #3 cylinder, a transmission flush, a flash drive update and recharged the ac. This seemed to take care of the problem but i mostly drove under 30mph and did not notice it. I took it on a few road trips, and country roads and noticed the problem of sputtering and shuttering between 40-60 mph's after decelerating and slowly accelerating. The problem occurs consistently with ac and over-drive on in the above mentioned conditions and mph range. Problem is less noticeable with ac off and have not noticed it at all with over-drive off. It feels like a limited slip kicking in or driving on dry pavement in 4wd. Tranny shifts fine through all gears in a straight pull of acceleration and even full throttle pulls. Problem only occurs after decelerating and slowly accelerating. I don't know of any codes as I don't have a code reader, but I have not had any check engine lights come on nor has the dealer mentioned any codes.
View 7 RepliesFord F-150 (2004-2008) :: Clutch Engages And Releases About 2 Inches From The Floorboard - Adjustment?
2006 4.2L The pedal is good and the fluid is full but the clutch engages and releases about 2 inches from the floorboard. Is there possibly a rod that can be adjusted at the slave cylinder that moves the engage/release point along the pedal travel? Any thoughts before I get out the creeper?
View 1 RepliesFord F-150 (2004-2008) :: Rattle From Engine Area When Let Off Gas While In Traffic Or In A Drive-through
My 2008 F150 rattles (from engine area) when I let off gas while in traffic or in a drive-through. It almost feels as though it's going to stall. Drive thru, parking lot, traffic are all examples. "Stop and go" push the gas to move forward and quickly let off gas. I let off the gas there is a large rattle coming from my engine. Not sure if it's miss-firing or if it's an exhaust leak or a timing chain issue. I'm having trouble trying to figure this out because it does not happen all the time and have been unable to re-create when I go to the mechanic.
View 4 RepliesNissan - Altima :: 1997 - Shift Car Into Drive And Engine Just Revs But Won't Move?
I have a 1997 Nissan Altima that I just barely got and it has started to show signs of trouble.
Sometimes when I put the vehicle into drive and step on the gas the car will not move and instead the engine will rev.I'll put the car back into park and then into drive and it'll work fine.
I checked the ATF, which was incredibly low and refilled it. The engine oil was also very low, which was refilled. The problem still persists. So I decided to add a bottle of Fuel Injector Cleaner to the gas tank.
I took the car for a short drive and nothing happened aside from the fact that the Check Engine light now comes on and off. The car also idles between 1000-1500 rpms.
Accent LC (2000-05) :: Slam And Stop Briefly When Put In Reverse Then Change Into Drive
'05 Accent, 19k miles. Car has been great, except suddenly I'm getting a weird shifting issue when I first start the vehicle. After I put the car in reverse, then change into drive, the car SLAMS and stops briefly, as if I've hit something. This has started to happen a lot lately.
View 1 RepliesFord F-150 (2004-2008) :: 2005 - Idle Really Rough / Revs Will Rise And Then Drop Again If Blip The Throttle
I just locked out the cam phasers on a 2005 f150 with a 5.4. It now idles pretty rough. If I blip the throttle the revs will rise and then drop again, and it barely catches in time to prevent a stall. If I continue to tease it this way I can usually get it to stall. I'm getting no CELs or anything, but I intermittently will get a P035x code (it seemed to rove. I've gotten cylinder 1, 4, 6, but not consistently.). I have chased those around by swapping coils, checking/cleaning the connectors, etc.
I am kind of thinking that these codes are a symptom of my idle issues, and not the actual problem. What could I have done wrong? Could it be a vac issue? I had basically the entire ECU harness and all the vac lines disconnected to do the job, but as far as I can tell everything has been reconnected to the correct locations. I did have an SCT tune done to remove the phasers in the ECU. I installed it and still have the issue, so for now I am on the stock tune just to eliminate any variables.
Could my tune be the issue? Is this how you would expect the engine to behave with locked out phasers and no corresponding ECU tune?
Lexus GX 2004-09 :: GX470 Engine Noise When Decelerating - RPM Drops
How to diagnose the engine issue I am having. The gx currently has 96k miles and I am planning on doing a timing belt and water pump replacement as I plan on keeping it as long as possible.
One new issue that crept up is that when going down the hill the car engine sounds like it's actually accelerating and the RPM drops to as if it was idling.
Normally when going down the hill it usually stays around 1 or 2 on the rpm, it's noticeably different and just started happening recently. What might be the cause of this?
Lexus GX 2004-09 :: 2005 GX470 - Surge In Engine As Transmission Engages
I just purchased a used a Lexus GX470. The transmission seems to do something fairly consistently that seemed unusual to us, but we are new to this car so I'm not sure if it is normal, abnormal, or a sign of something big to come.
When starting from a complete stop, upon removing your foot from the brake, there is a noticeable mini-surge in the engine as the transmission engages, and the sensation seems to repeat when the transmission is disengaging as you brake to stop.
Does this sound normal? From searching on google, I have read that there are issues with "hard shifting" but this does not seem to happen with shifting...just when the transmission engages or disengages, and it isn't a big 'bump' as much as a mini-surge. I have also read where it could be related to something electrical such as the air conditioner.
The car is under warranty, but the service department notes no error codes when they scanned the engine.
Accent LC (2000-05) :: Buzzing When In Drive While Decelerating After Getting To Speed
A few months ago my automatic 2000 hyundai accent GL was having problems reversing. Some times it would, sometimes it would move a few feet then fall out of gear and stop, sometimes it would not move at all.
The reversing problem fixed itself about a month ago.
Recently i started having problems accelerating, it was noticeably slower to get to speed and had problems upshifting.
Today, it started to make a buzzing when in Drive, while decelerating after getting to speed. This buzz is nonexistent in neutral, 2nd, or low gear.
Here is a video of the sound it is making, with captions to explain what i am doing... 2000 accent transmission problem - YouTube
Honda - Accord :: From Reverse To Drive / 2 - 3 Second Pause Before It Engages - Code P0506
I have a 2003 Honda Accord with 207,000 miles on it. It's been doing the following:
- From Reverse to Drive, there’s a 2 - 3 second pause before it engages
- Sometimes when driving at higher speeds (55 - 70mph) then slowing down for a light or an exit, the car will sort of lurch/jerk around 30mph on the slow down. It’s very noticeable.
- Check Engine light has been coming on off for months. I thought it was a gas cap issue but the mechanic said it’s a P0506 code.
- Hard shifting in my day-to-day driving- Just fyi, we had the transmission rebuilt a year and a half ago.
We’ve taken it to the transmission shop twice and they said they don’t feel the things we describe and are getting no codes. We’ve taken it to the Honda dealer twice and the honda mechanic did a software update that didn’t fix the issue. I took it back and then he said he felt the hard shift/delay from R to D and that it is a transmission issue because the engine wouldn’t be engaged at all from R to D. The CE light wasn’t on for that visit and wasn't giving a code but then the CE light came back on when I was on my way back to the transmission shop. I read that there are specific things to do to try to clear the P0506 code (clean the throttle body, check for vacuum leaks, etc.) but our Honda dealer didn’t do any of those things.
Is there an engine issue related to the P0506 code that could make my car do these things but feel like a transmission issue even if it’s not (since I’m not getting any transmission codes)? Could I have two separate issues - whatever is triggering the P0506 code and then whatever is making the car shift hard, slow to engage, and jerk when slowing down? My transmission guy told me since they’re not feeling anything or getting any codes, the only thing left for them to do is take out the transmission. I’m at a loss and feel like I’m wasting their time, but there’s definitely something wrong.
Ford - Explorer :: 1999 - Loud Clunk / Thump Noise - Shifts Into Drive And Revs But Won't Move?
My boyfriend bought a 1999 ford explorer, he put about 2,000 miles on it in four months... I believe it now has roughly 110,000... Now the other day, he was pulling out and shifted from reverse to drive, we heard like a loud clunk/thump noise... It shifts into drive, and revs but won't move, it feels like neutral... If you shift to second, first, or reverse it's fine... Tranny fluid is good... O/D is always engaged...
View 3 Replies