Ford Fuel System :: Fuel Filter Is Clogged When Turn Over The Engine

Is it fair to assume that my filter is clogged when I turn over the engine and fuel does NOT come out of the filter with the uphill line disconnected. I was able to disconnect the rear line from filter and fuel DID pump out of line when I cranked it over. Been dealing with a crank no start, I'm in the process of trying to test my CPS properly but not sure if I'm testing it right.

2000 f 150 4.2 v6 232,000 miles....

View 7 Replies

Nissan - Frontier :: Dripping After Engine Shut Down - Fuel Injector Is Leaking

If after you shutdown a engine, and a fuel injector is leaking. Is there any sign to look for, that can pin point this problem.

View 1 Replies

Nissan - Frontier :: 1999 - Air Conditioner Kept Going Off

I have a '99 Nissan Frontier 4cyl. p'up and the air conditioner kept going off. The truck has three drivebelts, all inline. The first is Crankshaft to the Power steering pump , the second goes from Crankshaft to the water-pump & the alternator and the third one goes to the air-conditioning compressor; the one that keeps coming off my truck & shutting down the A.C. I replaced it three times and the last time it went off within a couple of miles. I know the crankshaft and the A.C. compressor pulley's are out of line and believe that's my problem. A mechanic friend of mine looked at it and said he thought it was something called a belt-leveler that keeps all the belts from slipping off.

View 2 Replies

Nissan - Frontier :: 1999 - Overheating Over 45mph

I have read two other threads that indicate a leaky head gasket for Nissan Frontiers overheating...but I'd like an opinion on my problem: I have a 1999, v6 3.3L, 4x4, manual Frontier that I have owned since 2001, always well-maintained, timing belt, water pump and thermostat already replaced a couple of years ago; currently has 129k mi. I rarely drive it (about once or twice a month).

Last time I drove it (I'm in AZ and heat was over 100 degrees) it started right up and was fine until I'd gone about 3 miles on the freeway doing about 65mph. Started to climb in temperature, but not into the red zone. I drove with it hovering just above the midway point (midway meaning perfectly normal temperature on my gauge) for a couple of more miles, when it started to climb just a bit more, I got off the freeway and dropped under 45 mph, the temperature went down to normal. I drove about 40mph back home and haven't driven it since.

I checked my coolant, which was extremely clean and not low, and was not boiling when I checked it soon after the temp went up on the freeway. What is the most likely cause?On a side note, since I do not drive it that often, what is recommended as to the gas that has been sitting in my tank since? How long does the gas stay good for? Further wondering how often it is recommended I drive it, for how long and at what sustained speed to keep my truck up and running?

View 3 Replies

Ford Super Duty (1999-2016) :: 2010 F250 - DPF Filter Keeps Getting Clogged Up / Engine Just Shut Off

I'm in having emission problems with my 2010 F250 lariat 6.4 diesel truck my DPF filter keeps getting clogged up engine just shut off on me then I sent it to get cleaned professionally got it installed drive it for 20 miles and my pick up shut off on me and left me stranded and I can't seem to pass inspection...

View 3 Replies

Nissan - Frontier :: 1999 4x4 3.0 V6 - Gauge Shows The Truck Is Overheating

I am working on this 99 Nissan and the issue is that the gauge shows the truck is over heating ,so we changed the thermostat ,the temp sending unit and that other thing next to that,and flushed the coolant system and bleed the system with new antifreeze and fresh water for the correct mixture..The truck still says its over heating ,the top hose hot and the bottom hose not anything more then it is when the truck hasn't been running.The truck starts right up and seems to run very well,then the gauge maxes right out and then wait for it to cool according to the temp gauge and drive a bit more,with in a mile its over heating again according to the gauge..I checked the oil and its perfectly fine and normal !I am so lost here,the radiator is like new and the clutch fan works right ,checked all the hoses and they are not collapsing ,water pump replaced a year ago...

View 1 Replies

Nissan - Frontier :: 1999 - Intermittent Clack Sound Similar To Loud Compressor When It Shuts On And Off

I have a '99 Frontier (3.3L V6) just had the radiator, hoses, fan clutch and 3 exterior belts replaced. Car's not overheating anymore, BUT, now I hear intermittently a "clack" (which sounds similar to a loud compressor when it shuts on and off). Car never made this sound before the repairs mentioned above were made.

I took pictures and could use finding out what the part is called that is making the noise. I see the 3 discs on the front side of one of the belt pulleys (i think?) spinning, then they will stop, making the clack sound. It seems to me that sometimes the sound is loud and then other times it is extra loud --are there two sets of these discs and the other set is somewhere I can't see?

View 6 Replies

Nissan - Quest :: 2001 - Won't Start After Replacing Fuel Pump And Filter

Replaced fuel pump and filter on our 2001 Nissan Quest. It started up for a few minutes but once it got hot it sputtered out. We sprayed some starter fluid in it. Still nothing.

View 13 Replies

Ford Super Duty (1999-2016) :: 2002 - Gas Engine Won't Start After Replacing Fuel Filter / Pump Relay / Air Filter?

After replacing fuel filter, pump relay, and air filter for good measure my 2002 f250 v10 gas engine still wont start. What to do?

View 13 Replies

Golf IV / Jetta IV :: Clogged Air Intake Before Air Filter

I only removed the standard air filter housing and fresh air intake yesterday to get access to the VSS and Speedo drive to change the differential fluid on my 01M transmission. I was surprised to find that there was a fine metal mesh screen installed at the entrance to this air intake tube. This would be located behind the battery and just behind the drivers side headlight is where this metal mesh screen is located. Anyways, this was easily disassembled to clean and reassemble. However, I did not find anything about this mesh screen in my Chilton's manual, but this is now on my annual maintenance list. I added some pic's to show the clogged air tube. There was also a spring loaded door on this air intake tube...

View 5 Replies

Ford 7.3L Power Stroke (1999-2003) :: Clogged Fuel Pick Ups In Tank

From diagnosis we are pretty sure we have clogged fuel pick ups in the tank of my 99 7.3 Dually. So in I go to clean and repair or replace depending on what it looks like once we get in there.

We have most of the fuel out of the tank, pumped out just over 30 gallons.

I don't have a lift so this is being done on the ground, any easier way ? The bed bolts look pretty rusty and funky but we have been spraying them down with Kroil, the magic elixir, for a couple days to see if that will ease the removal of the fasteners.

Take the Bed Off and work with the tank in the frame or drop the tank out and work away from the truck ?

View 12 Replies

Ford 6.7L Power Stroke Diesel :: Exhaust Filter Clogged Message On Display

My truck started to display exhaust filter clogged and cleaning exhaust filter multiple times today. The cleaning exhaust message stayed on until I hot OK and then it comes back later. Not sure what this means?

View 14 Replies

Ford Super Duty (1999-2016) :: Low Fuel Pressure - Engine Power Reduced After Fuel Filter Change?

I had my fuel filters changed at the dealership today on my '15, and then I bought fuel and headed home (70 miles). About half way home I got a "Low Fuel Pressure" message and a little while after that "Reduced Engine Power" along with the check engine light.

I pulled over to see if they did something like leave the drain open, thinking it might be sucking air. Of course it was dark and I could not see anything. However I did hear a buzzing sound and could feel a vibration when I touched the fuel line going into the top of engine filter.

While it is possible I got bad fuel, I suspect they did something wrong installing the filters. Even after cycling the fuel pump multiple times they had a hard time getting it started afterwards; I think they finally disconnected the top fuel line to bleed the air out.

I continued home and made it, but not sure what to do now; its 70 miles back to the dealer.

What is the most likely problem? Improper fuel filter installation or bad fuel?

Should I pull the filters in the morning see if there is something obvious like an out-of-place gasket? If so, top or bottom filter?

Is this a tow truck affair or should I drive 70 miles back to the dealer?

What the heck is the buzzing sound?

View 7 Replies

Nissan :: 1986 - Stumbling Like Running On 3 Cylinders When Started Cold

My 1986 Nissan 300ZX Turbo has 60,000 careful miles on the odometer. It began stumbling, like running on 3 cylinders, when started cold. Time of day and moisture make no difference. New Cold Start and Air Flow Sensors have worked a little, but it still has the stumbles about half the time when started cold.

View 5 Replies

Nissan - Frontier :: 2000 V6 Just Randomly Die Going Down The Road

It's a 2000 Frontier V6 4x4 CC with 104k miles. It just randomly dies going down the road. Sometimes it restarts. Sometimes it doesn't. Sometimes I just get a small blip (loss of spark or fuel - unsure which) when going down the road then it's fine again. It seems seems like a loose connection somewhere to me but I have checked and repaired everything I can find.

A little history of problems...

Fall 2014 - Fuel Sending Unit; I had similar problems a little over a year ago and I replaced this at ~90k miles. The stock one was corroded and the fuel pump wasn't getting power. Got the part from Nissan directly. Truck ran great for a year then started having same issues in fall of 2015. I am thinking this couldn't have gone bad again in only a year, but who knows? No engine codes at the time.

December 2015 - Distributor #1; I replaced it with one from Auto Zone. Had the same problems that day. Returned that and replaced with one from Napa Distributor #2 (New - house brand - supposedly made by Altrom - which is supposedly comparable to OEM) This seemed to fix it for a little while. At the same time I did the timing belt, spark plugs, wires, valve cover gaskets, a bunch of suspension work, etc. so I had the harness off. Did I knock something loose? I feel like I have checked it up and down.... doesn't seem that way.

January 2016 Bad Wire?; Same issues. Wiggling the harness into the distributor seemed to have an effect on restarting so I pulled the harness apart from the dist to the main and found a small cut on the casing of one of the ground wires. The wire was not damaged, just casing. Fixed that with a double layer of shrink tube and it ran fine again for a couple weeks. In this same period my catalytic converters also went bad. My exhaust manifolds cracked, next thing I knew I had catalytic converter codes on both sides of the engine. Ran it like this for a few months.

April 2016 Distrbutor #3 Same problem. Randomly dies. Gets progressively worse over a couple day period. I gave up and took it to a shop (Downing St. Garage in Denver, CO) They diagnosed it as a bad distributor so I had it replaced AGAIN (they were nice enough to use the Napa part I bought and get a free warranty part)

June 2016 Distributor #4 Same problem again. Still have not replaced cats - did not want to spend the money when the ignition problem seems un-related. Replaced distributor with another warranty part from NAPA. This time the one that I took off made a crunching sound when you turned it by hand.

August 2016 Finally replaced cats. CEL codes were gone for an afternoon then the truck started sputtering down the road again... CEL P1320 and CEL P0325 BACK AGAIN!

I am at a loss on what to do. I have read that the MAF sensor can get dirty... but this doesn't seem to explain the P1320. Anyway, I ordered some cleaner, a new knock sensor and another distributor (this time Nissan brand but re-manufactured... they no longer sell new ones.)

View 4 Replies

Nissan - Frontier :: 2003 - Runs Hot When Idling

Our mechanic is stumped. The Frontier runs hot when idling. The clutch fan and thermostat have been replaced. The radiator has been flushed. When you are driving or you turn off the A/C, the temp goes down. The next suggestion is to replace the radiator, but I'm already hundreds into this so I hate to do anything else unless I'm pretty sure it is going to fix it.

We do know that the catalytic converter needs replacing. Could this have anything to do with it?

View 5 Replies

Nissan - Frontier :: Engine Shuts Down Will Restart Only After A While

When I cut off the engine by mistake (shift slip ie ) the restart comes around but only after about 5 to 15 minutes . The last time this happened the car was at an intersection and this situation is getting dangeous.Why is the restart taking so long ?

View 2 Replies

Nissan - Frontier :: 2000 - A/C Malfunction - Not Cooling In Hot?

I have a 2000 Nissan Frontier that is a 4X4 and has the V6 engine. Mileage is 172,000+. For a few years, I have had problems with the AC no longer cooling after I drive 20 or so miles and stop the truck, go in a store and start back up only to find that the AC will not cool after the stop. This seems to happen more when the weather is hot. Only once has it gone out without stopping the car and it was on I40 driving trough Oklahoma in 100+ degree weather. Once it quits cooling, after driving 20 to 30 minutes, it usually starts to cool again. It sometimes speeds up the process if I roll the windows down.Coolant levels are fine.

So...is there a faulty sensor somewhere? What could it be that is the problem?

View 3 Replies

Nissan - Frontier :: AC Compressor Clicking / No Cooling

We have a 2003 Nissan frontier pickup (automatic).The AC recently stopped cooling, but the fan works. It was cooling perfectly great when all of a sudden, it stopped. If we turn the AC on, the compressor (I'm guessing) starts to click and continues to click until turned off. (started to grind under hood). It's not a rattle, definitely a click as if it wants to turn on but can't make the electrical connection. It kind of sounds like when a starter has gone bad and it clicks. Except, it does it repetitively until turned off. This doesn't happen if we turn on the fan but leave the AC off. Does it sound like the compressor went out? How can we troubleshoot it?

View 19 Replies